Geometry and accuracy of reflecting points in bistatic satellite altimetry

The analysis of the time and space distribution of specular (reflecting) points in bistatic altimetry between GPS and CHAMP satellites or SAC-C (taken as examples) is extended from Wagner and Klokočník (2003 J. Geod 77: 128–138). We demonstrate a significantly higher number and density of reflecting points in bistatic altimetry in comparison with traditional monostatic altimetry. After an outline of our older accuracy assessment for the vertical position of the reflecting point, we add a new independent derivation and compare both approaches. We account for orbit errors of both the transmitters (GPS) and receiver (CHAMP) satellites, and the measurement (delay) error. We found that the accuracy of the vertical position of the reflecting point decreases only slowly with increasing off-nadir angle and that the orbit errors must be accounted for if decimeter and better accuracy is required. In this paper, we do not study errors such as state of the ocean, technical parameters of the receiving system, and atmospheric corrections.     

Quality Assessment Of Digital Surface Models Generated From IKONOS Imagery

The growing applications of digital surface models (DSMs) for object detection, segmentation and representation of terrestrial landscapes have provided impetus for further automation of 3D spatial information extraction processes. While new technologies such as lidar are available for almost instant DSM generation, the use of stereoscopic high-resolution satellite imagery (HRSI), coupled with image matching, affords cost-effective measurement of surface topography over large coverage areas. This investigation explores the potential of IKONOS Geo stereo imagery for producing DSMs using an alternative sensor orientation model, namely bias-corrected rational polynomial coefficients (RPCs), and a hybrid image-matching algorithm. To serve both as a reference surface and a basis for comparison, a lidar DSM was employed in the Hobart testfield, a region of differing terrain types and slope. In order to take topographic variation within the modelled surface into account, the lidar strip was divided into separate sub-areas representing differing land cover types. It is shown that over topographically diverse areas, heighting accuracy to better than 3 pixels can be readily achieved. Results improve markedly in feature-rich open and relatively flat terrain, with sub-pixel accuracy being achieved at check points surveyed using the global positioning system (GPS). This assessment demonstrates that the outlook for DSM generation from HRSI is very promising.     

Hyper Redundancy for Accuracy Enhancement in Automated Close Range Photogrammetry

A generic network design in close range photogrammetry is one where optimal multi-ray intersection geometry is obtained with as few camera stations as practicable. Hyper redundancy is a concept whereby, once the generic network is in place, many additional images are recorded, with the beneficial impact upon object point precision being equivalent to the presence of multiple exposures at each camera position within the generic network. The effective number of images per station within a hyper redundant network might well be in the range of 10 to 20 or more. As is apparent when it is considered that a hyper redundant network may comprise hundreds of images, the concept is only applicable in practice to fully automatic vision metrology systems, where it proves to be a very effective means of enhancing measurement accuracy at the cost of minimal additional work in the image recording phase. This paper briefly reviews the network design and accuracy aspects of hyper redundancy and illustrates the technique by way of the photogrammetric measurement of surface deformation of a radio telescope of 26 m diameter. This project required an object point measurement accuracy of σ  = 0·065 mm, or 1/400 000 of the diameter of the reflector.     

Analysis and classification of hyperspectral data for mapping land degradation: An application in southern Spain

Desertification is a severe stage of land degradation, manifested by “desert-like” conditions in dryland areas. Climatic conditions together with geomorphologic processes help to mould desert-like soil surface features in arid zones. The identification of these soil features serves as a useful input for understanding the desertification process and land degradation as a whole. In the present study, imaging spectrometer data were used to detect and map desert-like surface features. Absorption feature parameters in the spectral region between 0.4 and 2.5 μm wavelengths were analysed and correlated with soil properties, such as soil colour, soil salinity, gypsum content, etc. Soil groupings were made based on their similarities and their spectral reflectance curves were studied. Distinct differences in the reflectance curves throughout the spectrum were exhibited between groups. Although the samples belonging to the same group shared common properties, the curves still showed differences within the same group.Characteristic reflectance curves of soil surface features were derived from spectral measurements both in the field and in the laboratory, and mean reflectance values derived from image pixels representing known features. Linear unmixing and spectral angle matching techniques were applied to assess their suitability in mapping surface features for land degradation studies. The study showed that linear unmixing provided more realistic results for mapping “desert-like” surface features than the spectral angle matching technique.     

土壤热异常对地表能量平衡影响初探

将来自土壤深部的热通量引入off line的陆面过程模式 (NCAR—LSM ) ,通过长达 2a的数值试验对比分析了它对各层次土壤温度和地表能量平衡的影响。　　在土壤底部引入 5W /m2 的热通量使底层土壤显著升温 ,但升温随着接近表层而迅速衰减。积分 3个月后 ,由地下进入地表的热流量增幅可达 1W/m2 以上 ,并持续增大到 5W /m2 ,地表最大升温约 0 .5K ,同时地表感热、蒸发潜热及长波辐射通量均有 1W /m2 左右的正异常 ;若将土壤热传导系数放大一个量级以加速热量交换 ,则地表升温提高到 1K以上 ,长波辐射增加 3W /m2 以上 ,超过了气溶胶全球平均的辐射效应。结果表明 :一定量值的土壤热异常对地表能量平衡和短期气候变化 (10 -1～ 10 1a)有着不可忽略的影响。同时 ,深入的资料分析、完善的陆面过程模式以及它与大气模式的耦合试验也是亟待进行的相关工作。     

土壤热异常影响地表能量平衡的个例分析和数值模拟

The statistical relationship between soil thermal anomaly and short-term climate change is presented based on a typical case study. Furthermore, possible physical mechanisms behind the relationship are revealed through using an off-line land surface model with a reasonable soil thermal forcing at the bottom of the soil layer.In the first experiment, the given heat flux is 5 W m-2 at the bottom of the soil layer (in depth of 6.3 m)for 3 months, while only a positive ground temperature anomaly of 0.06℃ can be found compared to the control run. The anomaly, however, could reach 0.65℃ if the soil thermal conductivity was one order of magnitude larger. It could be even as large as 0.81℃ assuming the heat flux at bottom is 10 W m-2. Meanwhile, an increase of about 10 W m-2 was detected both for heat flux in soil and sensible heat on land surface, which is not neglectable to the short-term climate change. The results show that considerable response in land surface energy budget could be expected when the soil thermal forcing reaches a certain spatial-tem poral scale. Therefore, land surface models should not ignore the upward heat flux from the bottom of the soil layer. Moreover, integration for a longer period of time and coupled land-atmosphere model are also necessary for the better understanding of this issue.     

Atmospheric Surface-Layer Processes During the Total Solar Eclipse Of 11 August 1999

The central path of the total solar eclipse (TSE) of 11 August 1999 mostly passedthrough a region of active monsoon in India, with the eclipse ending around localsunset. Measurements in the surface layer (SL) were carried out close to the eclipseaxis at Akola (20°42' N, 77°2' E) in central India. The globalradiation flux reaching the surface vanishes around totality at 1803:24 (LT), followedby a small recovery before again dipping to zero at sunset. The temperatures in the SL, and subsoil at 50-mm depth, show a local minimum with a lag of about 10 min after the second contact, whereas the lag appears to vanish when the temperature series is detrended. The SL exhibits near-neutral, though generally stable, conditions from about 1500 hr itself due to heavy cloud cover followed by the eclipse-induced cooling of the surface. The wind component across the eclipse axis vanishes at totality, the wind vector aligning with the azimuth of the traversing moon shadow. The deceleration of the mean flow can be due to the combined effect of the colder surface and downward heat flux, where the locally altered horizontal temperature gradients may cause, as in this instance, the cessation of the cross flow.The oscillations in temperature and wind that show significant peaks, around 90–100 min as well as the semi-period of the eclipse near 60 min, persist for several hours past the eclipse event. A fresh analysis of the published data on the TSE of 7 March 1970 shows spectral peaks in the temperature nearly coincident with those already reported from the surface pressure records. The oscillations in the SL fields during the two TSE events are very similar implying that the source mechanism is also likely to be the same in both the cases.     

The Production of Methanol by Flowering Plants and the Global Cycle of Methanol

Methanol has been recognised as an important constituent of the background atmosphere, but little is known about its overall cycle in the biosphere/atmosphere system. A model is proposed for the production and emission to the atmosphere of methanol by flowering plants based on plant structure and metabolic properties, particularly the demethylation of pectin in the primary cell walls. This model provides a framework to extend seven sets of measurements of methanol emission rates to the global terrestrial biosphere. A global rate of release of methanol from plants to the atmosphere of 100 Tg y^–1 is calculated. A separate model of the global cycle of methanol is constructed involving emissions from plant growth and decay, atmospheric and oceanic chemical production, biomass burning and industrial production. Removal processes occur through hydroxyl radical attack in the atmosphere, in clouds and oceans, and wet and dry deposition. The model successfully reproduces the methanol concentrations in the continental boundary-layer and the free atmosphere, including the inter-hemispheric gradient in the free atmosphere. The model demonstrates a new concept in global biogeochemistry, the coupling of plant cell growth with the global atmospheric concentration of methanol. The model indicates that the ocean provides a storage reservoir capable of holding at least 66 times more methanol than the atmosphere. The ocean surface layer reservoir essentially buffers the atmospheric concentration of methanol, providing a physically based smoothing mechanism with a time constant of the order of one year.     

确定边坡最危险滑动面的计算机模拟

边坡稳定性分析 ,关键是确定潜在的滑动面 ,目的是有利于工程安全。本文编制了二、三维计算机模拟程序 ,在二维模拟中提出了四种计算模式 ,三维模拟中考虑了空间、荷载、渗流效应 ,结合工程实例对边坡进行模拟并对土层抗剪强度参数进行了反演 ,模拟计算与实测结果吻合 ,模拟出的抗剪强度参数平均值与实测的抗剪强度参数标准值相当     

古—中生代之交的全球变化与生物效应

古—中生代之交是显生宙以来最大的一次生物绝灭期 ,其形成机制一直是地学界长期探讨的热点课题之一。地史重大转折期是地球内、外各圈层长期作用下 ,各种量变达到阀值 ,加之可能的外因激化 ,在短时间内以连锁反应形式相继质变 ,形成了全球变化 (包括生物绝灭 )的地球突变期。文中从可能的外因 (外星体撞击事件 )及内因 (岩石圈的变化 ,地球表层的变化和生物圈的变化 )两个方面探讨了古—中生代之交的全球变化与生物效应