桥梁沉井基础抗震性能研究现状及展望

随着国内外大跨桥梁特别是跨海桥梁建设的迅速发展,沉井基础在桥梁基础中所占的比例越来越大。虽然沉井基础作为1种刚性基础具有良好的力学性能,然而震害实践表明沉井基础在地震作用下也并非万无一失。通过分析国内外典型桥梁沉井基础的震害特征发现,沉井基础的地震破坏与桩基础有显著差异,且与埋置深度有直接关系;研究表明:地震作用下沉井基础的破坏机理及地基承载力与静力作用下明显不同,但目前在该方面的研究还较为欠缺;总结和对比了现有几种沉井基础-土相互作用研究方法,并分析了几种研究方法的优缺点和适用场合;同时也归纳和对比了各国抗震规范对桥梁沉井基础的基本规定、适用范围、计算方法和构造规定等方面的内容。最后结合现有的研究现状对沉井基础抗震性能研究的发展方向进行了展望,此外,随着我国跨海、跨江及跨库区大跨桥梁建设的发展,地震力和波浪力等多灾害因素共同作用下深水沉井基础桥梁破坏机理及设计方法的研究势在必行。     

厚垫层-砂桩复合地基现场试验研究

以瓯江北口大桥南锚碇巨型沉井场地地基处理为科研背景,研究厚垫层-砂桩复合地基的适用性及其承载力的影响因素,针对不同的垫层材料、垫层厚度和砂桩间距共进行了9组静载试验。为得到砂桩施工对周围已完成砂桩的影响程度,还进行了砂桩施工相互影响试验。试验结果表明：厚垫层-砂桩加固软土地基效果非常好,是大型沉井地基处理较为理想的方式;垫层含水率、垫层材料和垫层厚度对其承载力的影响程度均大于砂桩间距;砂桩施工过程对周围已完成砂桩的影响和对周围土体的影响具有很大差别,利用传统沉桩挤土理论分析砂桩施工对周围已完成砂桩的影响将产生较大偏差;砂桩施工对周围已完成砂桩会产生较大影响,最大影响范围主要集中在地表以下1/3桩长范围内,影响程度与土层的种类和性质有密切关系,土性越好,影响程度越小;可利用增大砂桩间距和已有砂桩的阻隔效应减小影响程度。     

Expected Sliding Distance of Vertical Slit Caisson Breakwater

Evaluating the expected sliding distance of a vertical slit caisson breakwater is proposed. Time history for the wave load to a vertical slit caisson is made. It consists of two impulsive wave pressures followed by a smooth sinusoidal pressure. In the numerical analysis, the sliding distance for an attack of single wave was shown and the expected sliding distance during 50 years was also presented. Those results were compared with a vertical front caisson breakwater without slit. It was concluded that the sliding distance of a vertical slit caisson may be over-estimated if the wave pressure on the caisson is evaluated without considering vertical slit.     

Evaluation of pullout load capacity of suction caissons in sand using a three-dimensional displacement approach

An investigation was conducted to obtain analytical solutions for the pullout behavior of a suction caisson undergoing inclined loads in sand. The inclined load is transformed into an equivalent load system in which the vertical, horizontal, and moment loads are applied on the center of the lid of the suction caisson. The vertical and lateral stiffness coefficients along the skirt of the suction caisson in sands are presented using the new three-dimensional elastic solutions taking into account the nonhomogeneous and nonlinear properties of the sand. The vertical, lateral, and rocking stiffness coefficients on the base of the suction caisson are presented considering the solutions of a hollow rigid cylindrical punch acting on the surface of a soil. The yield, pullout, and failure for sands with the nonhomogeneous and nonlinear characteristics are taken into consideration. The effects of the load inclination, the loading depth, and the aspect ratio on the pullout load capacity of the suction caisson are presented. Behaviour of the suction caisson in sand prior to failure is clarified from the relationship between tensile load, displacement, and rotation and that between depth, vertical pressure, and lateral pressure.     

Model tests on installation and extraction of suction caissons in dense sand

A series of model tests were performed on steel- and Perspex-made suction caissons in saturated dense marine sand to explore installation and extraction behaviors. The extractions of the caisson were conducted by applying monotonic loading or by pumping water into the caisson. Responses of suction caissons to pullout rates, aspect ratios, and extraction manners were examined. Test results show that a cone-shaped subsidence region occurs around the suction caisson during the suction-assisted installation. The pullout bearing capacity of the suction caisson in sand is dominated by the loading rate and the loading manner. For the suction caisson subjected to monotonic loading, the maximum bearing capacity is reached at the pullout rate of about 20.0?mm/s. The mobilized vertical displacement corresponding to the pullout capacity increases with increasing the pullout rate. The passive suction beneath the suction caisson lid reaches the maximum value when the pullout bearing capacity is mobilized. In addition, during the suction caisson extracted by pumping water into the caisson, the maximum pore water pressure in the caisson is obtained under the displacement of approximately 0.04 times the caisson diameter. The absolute values of the maximum pore water pressures for the suction caissons approximately equal those of the maximum vertical resistances at the monotonic pullout rate of 5 mm/s. When the vertical displacements of the suction caissons with the aspect ratio of 1.0 and 2.0 reach 0.92 and 1.77 times the caisson diameter, respectively, the seepage failure occurs around the caissons. Using a scaling method, the test results can be used to predict the time length required for the prototype suction caisson to be extracted from the seabed.     

压入式沉井施工对环境影响的现场监测研究

结合工程实例,介绍软土中压入式沉井的施工技术并研究其对周边环境的影响。对沉井压沉过程中周边土体及管线的监测数据进行分析,结果表明：压沉施工能有效控制沉井的几何姿态,保持下沉速度稳定,但具有一定的挤土效应;沉井下沉初期挤土效应占主导地位,开挖效应随下沉深度的增加逐渐显著;土体水平位移和地表沉降均随沉井下沉深度H的增加而增大;地表沉降呈三角形分布,影响范围约为1.7H;土体分层沉降中,淤泥质粉质黏土的单位沉降量最大;管线沉降可控制在毫米级。基于对无量纲化地表沉降数据的拟合分析,提出了分别采用指数函数和二折线表示的压入式沉井周边地表沉降经验公式,并用工程实例验证了其合理性。     

考虑吸力变化的非饱和高液限黏土-土工织物界面剪切特性研究

以高液限土为填料的加筋挡墙广泛在南方地区应用,加筋挡墙土体吸力经常随气候变化而发生变化,直接影响筋土界面强度特性,考虑吸力变化的非饱和高液限黏土-土工织物界面强度特性亟待深入研究。利用ZFY-1A型非饱和土应变控制式直剪仪对非饱和高液限黏土-土工织物界面进行控制吸力的剪切试验,探讨吸力循环变化（干湿循环）对筋-土界面剪切特性的影响。研究表明,高液限黏土-土工织物界面的抗剪强度随着净法向应力的增加而增大;随着循环次数的增加,界面强度呈现先升高而后衰减的变化规律。经历3次干湿循环的界面强度低于未经历干湿循环的强度。随着循环次数的增加,界面强度总体上呈降低趋势。吸力增加的速率 随吸力循环次数的增加先增大后减小,有效界面摩擦角 、界面有效黏聚力 、界面综合摩擦系数 、综合摩擦系数比K与此类似。 含水率变化量的最大值随着净法向应力、循环次数的增加而增大。最大剪胀量 随循环次数的增加先增大后减小,随净法向应力的增大而减小。最后通过对数拟合,得出经历若干次基质吸力循环后的界面强度计算公式。     

Suction force below plate anchors in soft clay

The results of a number of laboratory model tests for the short‐term ultimate uplift capacity of a circular plate anchor embedded in saturated soft kaolinite and montmorillonite are presented. The tests were conducted with and without venting the bottom of the plate anchor in order to determine the variation of the suction force with embedment ratio. The variation of the suction force is presented in terms of the undrained shear strength of the clay and also the net ultimate uplift capacity.     

Influence of Seawater on the Suction and Swelling Behavior of Clayey Soils

The present study examines the suction characteristics and swelling behavior of clayey soils when exposed to natural seawater with respect to distilled water. The effects of saline waters on the engineering behavior of soils need to be determined since the salinity of the pore fluid of soils near coastal areas increases continuously. Six clayey soil samples with different mineralogy and characteristics were gathered and tested to determine the suction and swelling characteristics in the presence of natural seawater and distilled water. The results show that the total suction values of the samples are higher in the presence of seawater than in distilled water. The samples with high swelling potential have lower matric suction values than nonswelling soils. Moreover, in contrast to swelling-type soils, the matric suction values of the nonswelling soils remain similar in the presence both distilled water and seawater. The modified free swell index (MFSI) of the samples is well correlated with the liquid limit (LL), plasticity index (PI), and cation exchange capacity (CEC) in distilled water. However, coefficients of determination decreased in the presence of seawater. Also, there is no significant correlation existing between total and matric suction values and the MFSI values of the samples.