Room-temperature equation of state of Li<Subscript>2</Subscript>VOSiO<Subscript>4</Subscript> up to 8.5 GPa

High-pressure single-crystal X-ray diffraction measurements of lattice parameters of the compound Li₂VOSiO₄, which crystallises with a natisite-type structure, has been carried out to a pressure of 8.54(5) GPa at room temperature. Unit-cell volume data were fitted with a second-order Birch-Murnaghan EoS (BM-EoS), simultaneously refining V ₀ and K ₀ using the data weighted by the uncertainties in V. The bulk modulus is K ₀ = 99(1) GPa, with K′ fixed to 4. Refinements of third order equations-of-state yielded values of K′ that did not differ significantly from 4. The compressibility of the unit-cell is strongly anisotropic with the c axis (K ₀(c) = 49.7 ± 0.5 GPa) approximately four times more compressible than the a axis (K ₀(a) = 195 ± 3 GPa).     

Biaxial test simulations using a packing of polygonal particles

The mechanical response of cohesionless granular materials under monotonic loading is studied by performing molecular dynamic simulations. The diversity of shapes of soil grains is modelled by using randomly generated convex polygons as granular particles. Results of the biaxial test obtained for dense and loose media show that samples achieve the same void ratio at large strains independent of their initial density state. This limit state resembles the so‐called critical state of soil mechanics, except for some stress fluctuations, which remain for large deformations. These fluctuations are studied at the micro‐mechanical level, by following the evolution of the co‐ordination number, force chains and the fraction of the sliding contacts of the sample. Copyright © 2007 John Wiley & Sons, Ltd.     

Influence of Structural Non-Stationarity of Surface Roughness on Morphological Characterization and Mechanical Deformation of Rock Joints

Summary Structural non-stationarity of surface roughness affects accurate morphological characterization as well as mechanical behaviour of rock joints at the laboratory scale using samples with a size below the stationarity threshold. In this paper, the effect of structural non-stationarity of surface roughness is investigated by studying the scale dependence of surface roughness and mechanical behaviour of rock joints. The results show that the structural non-stationarity mainly affects the accurate characterization of the surface roughness of the fracture samples. It also controls the amount and location of the contact areas during shear tests, which in turn affects the mechanical properties and asperity degradation of the samples. It is concluded that for accurate determination of the morphological and mechanical properties of rock joints at laboratory and field scales, samples with size equal to or larger than the stationarity threshold are required. Author’s address: Nader Fardin, Rock Mechanics Group, Department of Mining Engineering, Faculty of Engineering, University of Tehran, P.O. Box: 11365/4563, Tehran, Iran     

江苏潮滩沉积物激光粒度仪与移液管-筛析分析结果的对比

激光粒度仪的广泛应用带来了与历史数据的对比问题,因此需要建立激光粒度仪与早期分析结果之间的关系。根据江苏海岸潮滩沉积物样品的激光粒度仪和移液管-筛析法分析,对粒度参数、粒度组分等进行了对比,对两种方法的差异进行了分析。结果表明,对于江苏潮滩沉积物粒度参数中平均粒径的激光粒度仪与移液管-筛析分析结果之间有良好的线性关系;筛分法测得的粗颗粒物质较激光法偏少,而移液管法法测得的细颗粒物质较激光法偏多;将样品分类之后再进行两种方法所获粒度参数的回归分析,相关性得以提高,说明不同粒度组成的沉积物对分析结果的对比有不同的影响。两种方法之间的换算关系不仅与研究区域有关,而且与沉积物本身的粒度组成有关。     

饱和粉砂不稳定性的试验研究

通过对净砂和级配良好粉砂(含10 %粉土)进行一系列三轴固结不排水试验（CU）,研究了粉土、孔隙比和围压对饱和粉砂不稳定性的影响。试验结果表明,净砂与粉砂在不排水剪切条件下均会出现应变软化现象（即不稳定性）。同一围压下脆性指数(IB)随孔隙比增加,但不稳定线的应力比随孔隙比增加而减小。引用等效粒间孔隙比(ege)后,净砂和粉砂在ege-ln p?平面上拥有基本相同的临界状态线。在临界状态理论及等效粒间孔隙比的基础上,提出在同一修正状态参数(?ge)下净砂和级配良好粉砂有相似的不稳定性。     

基于Mindlin理论Winkler地基参数的Kalman滤波识别

提出了Winkler地基参数的Kalman滤波识别方法。引入Mindlin理论后,推导了Winkler地基上板的控制微分方程。利用Fourier变换,推求了Winkler地基上简支板的Fourier闭式解。推导了Winkler地基参数的Kalman滤波方程,研究了Winkler地基参数的Kalman滤波识别的具体计算步骤。研究表明,运用Kalman滤波理论进行Winkler地基参数的识别,能有效地估计Winkler地基参数;Winkler地基参数的滤波收敛速度和精度受地基参数初始值选取和位移实测资料的影响,且Kalman滤波理论也可用于其他地基模型地基参数的识别。     

秦山核电站邻近水域的流况分析

本文分析了秦山核电站邻近水域各测站的实测流、潮流和佘流分布及季节变化。结果表明:测区内潮流为非正规丰日浅海潮流,其运动形式呈往复流。核电站二期工程取水口附近(L_1,18站)为一大流速区,而一期工程出水口周围(L_2,L_2′站)有一相对小的流速区。大流速区落潮流历时大于涨潮流历时,而相对小流速区则相反;大流速区的余流较小,而小流速区的余流大。在四个季节中,涨潮流速秋季最大,春季次之,夏季最小;落潮流速秋季最大,夏季次之,春季最小。余流冬、秋两季较大。在实测流中以潮流为主,径流和季风的作用也相当显著。     

地震折射波的虚拟射线理论及其应用

本文提出了一种地震折射液的虚拟射线理论,根据该理论,只要已知地表层的速度,即可直接由折射波信息提取地震参数,从而可实现折射界面的反演。 文中通过实际介质模型的计算机实验结果,验证了该理论的正确性。     

Wave run-up and overtopping on smooth and rough slopes of coastal structures

A series of hydraulic model tests has been carried out in a glass wave flume to investigate the influences of wave height, wave period, wave steepness, surf similarity parameter, roughness, layer thickness and porosity on wave run-up and overtopping of 1:2 sloped impermeable and permeable breakwaters fronted by a 1:10 gentle, smooth beach slope. The analysis of results involves the correlation between the overtopping energy transfer with the relative wall height and the relationship between wave run-up and overtopping rate. Further, measured wave run-up and overtopping rates are compared with the results given in the Shore Protection Manual (1984), Automated Coastal Engineering System (1992)and results of other investigators.     

A note on estimation of the Jacobian elliptic parameter in cnoidal wave theory

A new and simple calculating technique for the Jacobian elliptic parameter is presented in this study. The technique is very useful in generating a train of cnoidal waves in both laboratory and numerical wave tanks. Upon specification of water depth, the wave height and either the wave period or the wavelength, the proposed technique uses the Newton–Raphson method to estimate the Jacobian elliptic parameter directly, without trial and error procedures or look-up in tables. It is shown that the technique provides equally accurate results as the ad hoc methods previously used.