Teacher''s Aide: Modeling Hole-Effect Variograms of Lithology-Indicator Variables

Common variogram models, such as spherical or exponential functions, increase monotonically with increasing lag distance. On the other hand, a hole-effect variogram typically exhibits sinusoidal waves that form peaks and troughs, thereby conveying the cyclicity of the underlying phenomenon. In order to incorporate this cyclicity into a stochastic simulation, hole effects in the experimental variogram must be fitted appropriately. In this paper, we recommend use of several multiplicative-composite variogram models to fit hole-effect experimental variograms. These consist of a cosine function to provide wavelength and phase of cyclicity, multiplied by a monotonic model (e.g., spherical) to attenuate amplitudes of the cyclical peaks and troughs. These composite models can successfully fit experimental lithology-indicator variograms that contain a range of cyclicities, although experimental variograms with poor cyclicity require special considerations.     

Storm deposits and storm-generated coarse carbonate breccias on a pelagic outer shelf (South-East Basin, France)

Uppermost Jurassic limestones of the South‐East Basin (France) are organized into four facies associations that were deposited in four distinct zones: (1) peritidal lagoonal limestones; (2) bioclastic and reefal limestones; (3) pelagic lime mudstones; (4) lime mudstones/calcarenites/coarse breccias. Calcarenite deposits of zone 4 exhibit sedimentary structures that are diagnostic of deposition under wave‐induced combined flow. In subzone 4a, both vertical and lateral transitions from lime mudstone/calcarenite to breccia indicate in situ brecciation under wave‐cyclic loading. Breccias were produced by heterogeneous liquefaction of material previously deposited on the sea floor. Deposits in subzone 4a record relatively long periods (>400 kyr) of sedimentation below wave base, alternating with periods of deposition under wave‐induced currents and periods of in situ deformation. In this zone, storm waves were attenuated by wave–sediment interaction, and wave energy was absorbed by the deformation of soft sediment. With reference to present‐day wave attenuation, water depths in this zone ranged between 50 and 80 m. Landwards of the attenuation zone, in zone 3, storm waves were reduced to fair‐weather wave heights. Storm wave base was not horizontal and became shallower landwards. As a consequence, water depth and wave energy were not linearly related. On a small area of the seaward edge of subzone 4a, cobbles were removed by traction currents and redeposited in subzone 4b. There, they formed a 100‐m‐thick wedge, which prograded over 3 km and was built up by the stacking of 5‐ to 20‐m‐thick cross‐stratified sets of coarse breccia. This wedge records the transport and redeposition of cobbles by a high‐velocity unidirectional component of a combined flow. The increase in flow velocity in a restricted area is proposed to result from flow concentration in a channel‐like structure of the downwelling in the gulf formed by the basin. In more distal subzone 4c, the hydrodynamic effect of wave‐induced currents was quasi‐permanent, and brecciation by wave–sediment interaction occurred only episodically. This indicates that, seawards of the attenuation zone, hydrodynamic storm wave base was deeper than mechanical storm wave base. Uppermost Jurassic carbonates were deposited and soft‐sediment deformed on a hurricane‐dominated ramp of very gentle slope and characterized by a zone of storm wave degeneration, located seawards of a zone of sedimentation below wave base.     

SOURCE RADIATION AND RESPONSES OF WAVE PROPAGATION

Recordings of seismic waves propagating from earthquake source to a station at the earth's surface are a system response function.The convolution operator in time domain can be simplified as a multiplication operator in frequency domain.We discuss in frequency domain the separation of source,path and site effects for global scaling of earthquake source radiation.Also discussed are source scaling model,faulting mechanism,and the H/V inversion problems with crustal and near surface structures.Gross features of apparent source spectra appear to be not much region-dependent although there may be difference between tectonic styles within a region of tectonic mixture for which we need further study as data accumulate.Vertical spectra may be a better approach to approximate source radiation,as it has less crustal amplification effects than horizontal spectra.The H/V ratio is evidently a comprehensive indicator of amplification effects from near surface to deep structure.This gives it potential as an inversion tool to deduce site crustal structure.     

大气谱模式中质量守恒格式的研究

当前在世界上广泛采用的谱模式，是以地面气压ps取对数作为展谱变量，模式大气总质量不守恒。本文研究这样的问题，提出了以热力学变量比容α代替温度变量T的方法，并以地面气压ps本身作为展谱变量，这样可以保持大气总质量守恒。同时，由于以α作展谱变量，可使重要项气压梯度项为二阶变量组成，截谱后，不会出现混淆误差。计算结果表明，这样改变后，大气总质量保持守恒。同时消除了混淆误差的出现。     

兰州冬季气溶胶光学特性的参数化

兰州冬季气溶胶的谱分布用双谱模式拟合，即Junge谱加Deirmendjian谱；气溶胶的平均折射率为1.549-0.1i；气溶胶浓度随高度的分布根据天气条件取为高斯、均匀、指数分布三种类型。以此为基础，计算出兰州冬季气溶胶光学厚度的平均值。 经实测的气溶胶光学厚度与本文的计算值比较后发现，我们的参数化方案基本上是成功的。     

实际预报可预报性的时空依赖性分析

本文利用国家气象中心1990年1月1日至1992年2月29日的1～5 d、500 hPa高度场业务预报结果研究了不同球谐函数谱分量和经验正交函数(EOF)谱分量的可预报性。对球谐函数谱分量的研究表明可预报性并不是随着空间尺度的增加呈现单调的递减关系，主要表现为在总波数n等于5附近具有最大可预报性。可预报性主要依赖于总波数n，经卷大圆上的波数和纬向圆周上的波数对可预报性具有完全相同的重要意义。对EOF谱分量的分析表明，随着EOF指数(即序号数)的增大，可预报性依次减小。从EOF和球谐函数的关系发现前几个EOF分量正是对应着最可预报的球谐函数分量。进一步分析表明，最可预报的分量对应大气运动的慢变流型。这些结果对如何使用数值预报产品以及如何进行延伸预报具有重要意义。     

The Q value variations in the preparing pro－cess of rock rupture

ＴｈｅＱｖａｌｕｅｖａｒｉａｔｉｏｎｓｉｎｔｈｅｐｒｅｐａｒｉｎｇｐｒｏ┐ｃｅｓｏｆｒｏｃｋｒｕｐｔｕｒｅＢＩＮＷＡＮＧ１）（王彬），ＺＨＡＯ－ＹＯＮＧＸＵ１）（许昭永），ＪＩＮ－ＭＩＮＧＺＨＡＯ１）（赵晋明）ＹＩ－ＬＩＨＵ２）（胡毅力）１）Ｓｅｉ...     

Inversion of Q value structure beneath the Tibet Plateau

A total of 11 earthquakes with 15 Rayleigh wave paths, recorded at 11 broadband digital PASSCAL seismometers installed in the Tibet Plateau by the Sino-U.S. joint research group, were used to determine the phase velocity and attenuation coefficient of surface waves in periods of 10–130 s. The average shear wave velocity and quality factor {ie271-1} structures in the crust and upper mantle were obtained in this region. The result shows the average {ie271-2} is low and there exists a high attenuation ({ie271-3}=93–141) layer in the crust. The depth range of the low {ie271-4} value layer (16–42 km) is consistent with the range of low velocity layer (21–51 km) in the crust. Below 63 km in the lower crust, {ie271-5} decreases with depth from 114 to 34 at depth of 180 km. The low shear wave velocity and low value of {ie271-6} at the same depth range in the crust indicate that the rocks in the range is probably melted or partially melted. According to the shear wave velocity structure, the average thickness of the crust is about 71 km and a clear velocity discontiniuty appears at the depth of 51 km. The low-velocity zone (4. 26 km/s) at depth of 96–180 km may be corresponding to the asthenosphere. Contribution No. 96A0047, Institute of Geophysics, SSB, China. This study was supported by the National Natural Science Foundation of China.     

CodaQ as a combination of scattering and intrinsic attenuation: Numerical simulations with the boundary integral method

Numerical modelling ofSH wave seismograms in media whose material properties are prescribed by a random distribution of many perfectly elastic cavities and by intrinsic absorption of seismic energy (anelasticity) demonstrates that the main characteristics of the coda waves, namely amplitude decay and duration, are well described by singly scattered waves in anelastic media rather than by multiply scattered waves in either elastic or anelastic media. We use the Boundary Integral scheme developed byBenites et al. (1992) to compute the complete wave field and measure the values of the direct waveQ and coda wavesQ in a wide range of frequencies, determining the spatial decay of the direct wave log-amplitude relation and the temporal decay of the coda envelope, respectively. The effects of both intrinsic absorption and pure scattering on the overall attenuation can be quantified separately by computing theQ values for corresponding models with (anelastic) and without (elastic) absorption. For the models considered in this study, the values of codaQ ^–1 in anelastic media are in good agreement with the sum of the corresponding scatteringQ ^–1 and intrinsicQ ^–1 values, as established by the single-scattering model ofAki andChouet (1975). Also, for the same random model with intrinsic absorption it appears that the singly scattered waves propagate without significant loss of energy as compared with the multiply scattered waves, which are strongly affected by absorption, suggesting its dominant role in the attenuation of coda waves.     

Study on the characteristics of crust－mantle transition zone in Western Yunnan Province

Ｓｔｕｄｙｏｎｔｈｅｃｈａｒａｃｔｅｒｉｓｔｉｃｓｏｆｃｒｕｓｔ┐ｍａｎｔｌｅｔｒａｎｓｉｔｉｏｎｚｏｎｅｉｎＷｅｓｔｅｒｎＹｕｎｎａｎＰｒｏｖｉｎｃｅＨＯＮＧ－ＸＩＡＮＧＨＵ（胡鸿翔）ＺＨＯＮＧ－ＹＡＮＧＬＩＮ（林中洋）ＹＩＮ－ＪＵＢＩＡＮ（边银...