GPS signal acquisition using the repeatability of successive code phase measurements

This paper introduces a new method for GPS signal acquisition, which is based on the repeatability of successive code phase measurements and the M-of-N search algorithm. The performance of the proposed method in terms of probability of signal detection is similar to that of traditional methods, except that the calculation of the probability of detection does not rely on the noise distribution or the Carrier-to-Noise ratio (C/N₀). The code phase repeatability-based method is presented along with equations for probability of detection and probability of false detection. If the distribution of the noise is known, it also provides an estimate of the C/N₀. The proposed method is illustrated for coherent and non-coherent acquisition and C/N₀ estimation.     

矿山固体废弃物对地质环境的影响分析

在山西省重点地区固体废弃物现状调查研究的基础上,通过试样试验,分析研究了固体废弃物对土壤、大气、水环境的污染,探讨了对固体废弃物的治理及利用,为研究矿山生态环境地质研究提供参考,同时积累工作经验。     

矿产预测中成矿信息的提取和强化

成矿信息的提取是矿产预测的重要手段,其方法的有效性直接影响到预测成果的可靠性。在成矿规律研究的基础上,有意识地干预模型的构成,突出与成矿有关的信息;抑制某些成矿意义不明显和属干扰的信息,有目的地使模型向反映成矿信息的方向逼近,提高模型与矿床实际赋存地质环境的吻合程度,均是成矿信息提取和强化的内涵。本文从研究实践中总结了先验约束模型和非先验约束模型的强化方法,在新疆阿勒泰地区的地质－找矿工作中已取得     

用褶积滤波处理井水位对固体潮响应的滞后

本文给出了一种用褶积滤波处理井水位对固体潮响应滞后的新方法。鲁07井水位观测资料用这种方法处理比一般回归方法的平均中误差少4.6mm。文中讨论了褶积滤波积分区间长度与水井含水层渗透系数的关系及褶积滤波比别尔采夫滤波的优越性。     

On some problems of seismic crustal phase

ＯｎｓｏｍｅｐｒｏｂｌｅｍｓｏｆｓｅｉｓｍｉｃｃｒｕｓｔａｌｐｈａｓｅＨｕａｎ－ＣｈｅｎｇＧＥ（葛焕称）（ＳｅｉｓｍｏｌｏｇｉｃａｌＢｕｒｅａｕｏｆＪｉａｎｇｓｕＰｒｏｖｉｎｃｅ,Ｎａｎｊｉｎｇ２１００１４,Ｃｈｉｎａ）Ａｂｓｔｒａｃｔ：Ｉｎｔｈｉｓ...     

井下记录的PP和SS震相

本文在系统分析静海台井下地震记录图的基础上,发现并解决了具有一定实际和理论意义的两个问题:其一是证明了最初误认为是干扰的“双脉冲”图形实际上均是微地震。从而指出研究静海周围地区的地震活动性应考虑微震活动问题。其二确认静海周围地区微震波形的4个主要震相是P、PP、S和SS,并对地面反射波PP和SS能够观测到的条件作了初步分析,其结果进一步说明井下地震记录较之地面记录更为“逼真”,复杂和丰富。     

Scattering of elastic waves by a fracture zone containing randomly distributed cracks

We theoretically study the scattering ofP, SV andSH waves by a zonal distribution of cracks, which simulates a fault fracture zone. An investigation is conducted how the geometrical properties of the crack distribution and the frictional characteristics of the crack surface are reflected in the attenuation and dispersion of incident waves, as well as in the amplitudes of the transmitted and reflected waves from the zone. If the crack distribution within the fault zone changes temporally during the preparation process of the expected earthquake, it will be important for earthquake prediction to monitor it, utilizing the scattering-induced wave phenomena.We consider the two-dimensional problem. Aligned cracks with the same length are assumed to be randomly distributed in a zone with a finite width, on which elastic waves are assumed to be incident. The distribution of cracks is assumed to be homogeneous and sparse. The crack surface is assumed to be stress-free, or to undergo viscous friction; the latter case simulates fluid-filled cracks. The opening displacement of the crack is assumed to be negligibly small. The idea of the mean wave formalism is employed in the analysis, and Foldy's approximation is assumed.When the crack surface is stress-free, it is commonly observed for every wave mode (P, SV andSH) that the attenuation coefficientQ ^–1 peaks aroundka1, the phase velocity is almost independent ofk in the rangeka<1 and it increases monotonically withk in the rangeka>1, wherek is the intrinsicS wavenumber anda is the half length of the crack. The effect of the friction is to shift the peak ofQ ^–1 and the corner of the phase velocity curve to the low wavenumber range. The high wavenumber asymptote ofQ ^–1 is proportional tok ^–1 independently of model parameters and the wave modes. If the seismological observation thatQ ^–1 ofS waves has a peak at around 0.5 Hz in the earth's crust is combined with our results, the upper limit of crack size within the crust is estimated about 4 km. The information regarding the transmitted and reflected waves, such as the high wavenumber limit of the amplitude of the transmitted wave etc., allows estimation of the strength of the friction.     

Mitigation of municipal solid waste leachate contamination at Payatas, Metro Manila, Philippines： A technical proposal

The gross environmental condition of the Payatas Disposal Facility in Metro Manila, Philippines, implores the need for sustainable technologies to control and abate toxic municipal solid waste leachate and protect public health. A team of environmental engineers recognized this need by selecting the site as a design project for the Mondialogo Worldwide Engineering Award, sponsored by the United Nations and Daimler Chrysler. The project culminated in a technical proposal that highlighted the following design features： an impermeable dumpsite cap to control leachate generation; vertical impermeable barriers for containment and isolation of leachate; a drainage system to divert clean, surface water from the cap and prevent its contamination prior to discharge; a leachate recirculation system to enhance stabilisation of the waste deposit; and a facultative lagoon and constructed wetland system to treat excess leachate.     

Microwave-assisted extraction of organochlorine pesticides from sediments and determination by gas chromatograph with electron capture detection

A simple and rapid procedure to extract organochlorine pesticides （OCPs） from sediments by means of microwave energy is proposed. Sediment samples were irradiated with microwaves in a closed vessel system while immersed in hexane-acetone （1 ： 1, v/v）. The sample extracts were cleaned up using solid phase extraction with Florisil as adsorbent. Pesticides were eluted with hexane-ethyl acetate （80 ： 20, v/v） and determined by gas chromatographic separation with electron capture detection. Three oven programs were assayed with two different solvent mixtures in order to achieve adequate experimental conditions for the complete extraction of organochlorine pesticides from the matrix. Different variables such as the composition of extraction solvent,     

Speciation analysis and significance of ecological geochemistry

Different species of one element have different activities, so it has different effects on environment and human health. To analyze qualitatively and quantitatively the speciation of a special element in sample, which is the important basis for appraising the toxicity and studying the rule of transfer and translation of elements. Since the 1970＇s, the scheme of sequential extraction has already been used at many laboratories both at home and abroard, to get the information about heavy metals＇ activity in polluted soils. Because this method has the experimental nature, many schemes of problem has taken place, the absence of consistency of these sequential extraction have been formed. Thus the complexity of the schemes, the lack of selectivity of reagent, the lack of quality control, the result mainly related to the extraction scheme used, and so on. In the face of these problems, the study of experimental methods of sequential extraction on three different soils, sediment in Dongting Lake, soil in Jiangsu Province and loess in Shanxi Province was made. Reference materials of heavy metal speciation following sequential extraction in soil and sediment had been developed. Nowadays two kinds of sequential extraction methods which are widely used are BCR （three steps） and improved Tessier methods （seven steps）. Based on three steps of BCR, water-soluble speciation and the residual speciation were increased in our research. BCR701 was determined eight times at different laboratories using BCR three steps. The results showed that determined data obtained eight times were identical to the standard value, and it is indicated that this method has good reproducibility. The stability and homogeneity experiments indicated that the preparation of three types of candidates accorded with our requirements. Eight laboratories had afforded the determined values of 12 heavy metal elements （Cu, Pb, Zn, Mn, Co, Ni, Cd, Cr, Mo, As, Sb, Hg, Se et al.） using BCR three steps. Also, these three candidates afforded the determined values by seven steps, and 12 laboratories had participated.