东构造结墨脱关键区域地应力场特征及其构造稳定性分析

为获取东构造结关键构造部位地应力特征、分析其构造稳定性,采用水压致裂法开展了墨脱断裂带西让段1个地应力孔、11个测试段的原位地应力测量工作。结果表明：61.43~121.34 m测试段最大、最小水平主应力值（SH、Sh）分别为3.05～14.50 MPa和2.16～9.87 MPa,垂向主应力值（Sv）为1.63~3.31 MPa,即SH>Sh>Sv;测点处应力场以水平挤压作用为主,均处于逆断层应力状态,且其主应力值随深度增加而逐渐增大,测点的最大水平主应力优势方位为北东东向;在整个地应力测量深度范围内,侧压系数值（Kav）为1.39~4.38,最大水平应力系数值（KHv）均大于1,且比值随深度的增加而增大,该关键部位区域应力场以水平应力为主导,方向性较强,所有测试段水平应力系数值（KHh）为1.23~1.66,与林芝−通麦段地应力特征参数计算结果基本相似;测点位置98 m以浅地层水平构造应力作用程度较小,应力积累水平较低,保持断层稳定所需的摩擦系数值小于实际断层的临界摩擦系数值,构造环境相对稳定,超过98 m深度地层由于水平构造应力起主要作用,保持断层稳定所需的摩擦系数值接近于实际断层的临界摩擦系数值,存在小概率发生断层失稳滑动的风险;区域强震在墨脱断裂带断层面上造成的左旋走滑方向上及逆冲方向上的库仑应力变化值的叠加量均为负值,抑制了断层的滑动,未能增加墨脱关键区域断层活动的危险性。     

深圳市景亿山庄滑坡特征及成因分析

根据现场工程地质调查和勘察,论文深入分析了景亿山庄滑坡的变形特征、性质、变形机制,并探讨了滑坡的成因。指出在具有剥蚀残丘地貌特征的场地开挖以砂岩残积物为主要组成物质的边坡时,边坡高陡是造成边坡变形破坏的主要因素。长时间的持续降雨是诱发因素。对于陡倾原生节理裂隙发育的土质和类土质边坡,滑坡周界受边坡体内原生节理裂隙控制,滑坡后缘常沿该陡倾的节理裂隙发育。在深圳等降雨量大的亚热带气候区,若坡体内没有不利于边坡稳定的各种结构面,当边坡开挖高度不超过20m,总体坡率不陡于1∶1时,边坡能够保持短期稳定。但长期稳定性受当地降雨量和降雨强度的控制,开挖后若不采取适当的加固措施,易发生滑坡等浅层病害。其病害从孕育到发生可持续长达10a之久。通过论文的研究,可供在类似地区开挖边坡、整治边坡病害借鉴。     

芦山地震崩滑灾害空间分布及相关问题探讨

由于逆断层作用,2013年芦山M_S 7.0地震诱发的崩滑地质灾害分布表现出了明显的上盘效应与方向效应。在震后应急科考中未发现发震断层的地表破裂带,然而灾区大量出现的地震诱发滑坡、崩塌,加之密集的余震分布、地震烈度调查结果等,提供了确定芦山地震宏观震中、地震动错动方向以及研究地震发震构造等的诸多线索。 统计结果表明,芦山地震诱发的滑坡、崩塌具有明显的优势滑动方向（135°～144°）,该方向揭示了地震断层的错动方向,与震源机制解反映的一致,大体垂直于发震断层的走向;从地震诱发崩塌、滑坡灾害点的分布与密度判断,宏观震中位于宝盛乡北,在仪器记录震中东北约3.6km处;从余震群分布、地震诱发滑坡分布特点及地震等烈度线等,结合以往强震如汶川地震等的调查经验,推测当震级足够大时,发震断层地表破裂带可能通过地质灾害、余震密集区东侧的边缘地带,总体平行于双石-大川断裂。另外,通过分析地层岩性与崩滑地形条件之间的关联性,发现崩滑灾害在某些地层岩性中易发,灾害点呈线性排列的原因是不同地层岩性之间抗风化能力的差异性,造成在地层分界线上形成线性陡崖或高坡度地带,使之在强震作用下容易发生崩塌、滑坡。     

Emplacement mechanisms of the South Kona slide complex,Hawaii Island: sampling and observations by remotely operated vehicle Kaiko

Emplacement of a giant submarine slide complex, offshore of South Kona, Hawaii Island, was investigated in 2001 by visual observation and in-situ sampling on the bench scarp and a megablock, during two dives utilizing the Remotely Operated Vehicle (ROV) Kaiko and its mother ship R/V Kairei. Topography of the bench scarp and megablocks were defined in 3-D perspective, using high-resolution digital bathymetric data acquired during the cruise. Compositions of 34 rock samples provide constraints on the landslide source regions and emplacement mechanisms. The bench scarp consists mainly of highly fractured, vesiculated, and oxidized aa lavas that slumped from the subaerial flank of ancestral Mauna Loa. The megablock contains three units: block facies, matrix facies, and draped sediment. The block facies contains hyaloclastite interbedded with massive lava, which slid from the shallow submarine flank of ancestral Mauna Loa, as indicated by glassy groundmass of the hyaloclastite, low oxidation state, and low sulfur content. The matrix facies, which directly overlies the block facies and is similar to a lahar deposit, is thought to have been deposited from the water column immediately after the South Kona slide event. The draped sediment is a thin high-density turbidite layer that may be a distal facies of the Alika-2 debris-avalanche deposit; its composition overlaps with rocks from subaerial Mauna Loa. The deposits generated by the South Kona slide vary from debris avalanche deposit to turbidite. Spatial distribution of the deposits is consistent with deposits related to large landslides adjacent to other Hawaiian volcanoes and the Canary Islands.     

Turbulent fluxes from Helipod flights above quasi-homogeneous patches within the LITFASS area

Turbulent fluxes of sensible and latent heat were measured with the helicopter-borne turbulence probe Helipod over a heterogeneous landscape around the Meteorological Observatory Lindenberg during the STINHO-2 and LITFASS-2003 field experiments. Besides the determination of area-averaged heat fluxes, the analysis focused on different aspects of the response of the turbulent structure of the convective boundary layer (CBL) on the surface heterogeneity. A special flight pattern was designed to study flux profiles both over quasi-homogeneous sub-areas of the study region (representing the major land use types—forest, farmland, water) and over a typical mixture of the different surfaces. Significant differences were found between the heat fluxes over the individual surfaces along flight legs at about 80 m above ground level, in agreement with large-aperture scintillometer measurements. This flux separation was still present during some flights at levels near the middle of the CBL. Different scales for the blending height and horizontal heterogeneity were calculated, but none of them could be identified as a reliable indicator of the mixing state of the lower CBL. With the exception of the flights over water, the latent heat flux measurements generally showed a larger statistical error when compared with the sensible heat flux. Correlation coefficients a nd integral length scales were used to characterise the interplay between the vertical transport of sensible and latent heat, which was found to vary between ‘fairly correlated’ and ‘decoupled’, also depending on the soil moisture conditions.     

Diurnal SST warming in the Bay of Biscay: satellite measurements and model prediction

INTRODUCTIONIt has long been recognized that a diurnal thermal cycle occurs in the upper layer of the ocean(Stommel et al., 1969; Price and Weller, 1986). Interest in the subject has revived in recentyears due to the importance of resolving the diurnal cycle for correctly coupling the ocean and atmosphere (Lukas, 1991 ). While the study of the diurnal cycle is of intrinsic scientific interest, italso offers the benefit to remote sensing scientists of identifying the bias caused by the di…     

激电测量在苏吉泉东金矿勘查中的应用

对苏吉泉东金矿进行激电测量,获得激电异常数据(电阻率ρ_s和视极化率η_s)。把不同测线上性质相同的电阻率ρ_s和视极化率η_s的反交点按对应关系联接起来,分别作为相应的破碎带和极化体位置,同时结合地质资料多次反馈,逐步逼近真实地质体。圈定了PSD1,PSD2两个破碎带和Jht1,Jht2,Jht3三个极化体,通过ρ_s和η_s的一维反演及二维反演,拟合出破碎带和极化体的形态特征及相对深度,为矿产勘探提供了较为明确的地球物理依据。     

GNSS接收机晶振参数对载波相位测量的影响分析

分析了射频与基带时钟不同源对载波相位测量的影响,构建了由晶振各类误差源引起的载波环跟踪误差模型。分析与实验结果表明,时钟不同源会导致载波相位测量出错,晶振引起的载波环测量误差随环路噪声带宽增大而减小,减小晶振的h系数和g灵敏度可提高测量精度。选用单一稳定度高、g灵敏度小的晶振作为GNSS接收机时钟,可改善载波相位精度。     

NOAA WP-3D instrumentation and flight operations on AGASP-II

The second Arctic Gas and Aerosol Sampling Program (AGASP-II) was conducted across the non-Soviet Arctic in March and April 1986, to study the aerosol, gaseous, chemical, and optical properties of Arctic haze. One component of the program was supported with an instrumented NOAA WP-3D atmospheric research aircraft. Measurements of wind, temperature, ozone, water vapor, condensation nucleus concentration, and aerosol scattering extinction coefficient were used to determine the locations and properties of haze layers. The first three NOAA WP-3D research flights were conducted north of Barrow, Alaska, and over the Beaufort Sea northeast of Barter Island, Alaska. The next three sampled conditions in the high Arctic near Alert, Northwest Territories, Canada. All basic meteorological, gas, and aerosol systems are described. The WP-3D flight tracks and operations are presented.     

Investigating the Halogen Chemistry From High-Latitude Nighttime Stratospheric Measurements of OClO and NO2

Two cases of simultaneous nighttime measurements of NO₂ and OClO in the winter polar stratosphere are analyzed in order to test our present knowledge of halogen chemistry in the presence of high amount of NO₂ at low temperature. Comparisons with Lagrangian model calculations using several hypotheses are performed. First simulations, using the admitted constant rates of chemical reaction, strongly underestimate the measured OClO while the NO₂ profiles are correctly reproduced. If uncertainties in actinic fluxes calculations are taken into account, simulation results do not show a significant reduction of the underestimation. A better agreement can be achieved if the formation of unstable isomers of ClONO₂ and of BrONO₂ occurs in the cold conditions of the polar stratosphere. An approximate value of the branching ratios of the channels leading to ClONO₂ and ClOONO, and to BrONO₂ and BrOONO, necessary to reproduce both OClO and NO₂ is given and discussed.