大理岩破坏的声发射双主频特征及其机制初探

因试样制备、试验操作等限制,获得饱和岩石的直接拉伸强度较为困难。为对饱和硬岩的直接拉伸强度进行合理估算并验证其可靠性,同时分析水对估算误差的影响,设计完成了干燥、饱和状态下两种硬岩的单轴压缩和直接拉伸声发射试验。基于Griffith理论和Hoek-Brown(H-B)强度准则,通过裂纹体积应变法确定岩石起裂应力,估算饱和硬岩的直接拉伸强度和H-B强度参数m_i。结合声发射波形信号频谱特性,分析两者估算结果的准确性。结果表明,基于Griffith准则并采用起裂应力估算饱和硬岩的直接拉伸强度是一种较可靠的方法。对于干燥硬岩,该方法确定的直接拉伸强度估算值比试验值偏小。饱和硬岩直接拉伸强度估算值与试验值基本接近,这是因为硬岩饱和后,延性和蠕变趋向增强,并发生更多的微观拉破裂。饱和硬岩的m_i值增大与增多的微观拉破裂有关,m_i值变化可用于描述饱和硬岩的软化程度。基于Griffith准则并采用起裂应力估算的岩石直接拉伸强度和H-B强度参数m_i可用于岩体工程的早期设计。     

节理峰值后归一化位移软化模型

切向荷载作用下贯通节理岩体峰值强度后的剪切应力、位移变形规律一般呈双曲线形式发展,即峰值后强度衰减速率逐步变小而趋于0,到达残余强度。直剪试验表明,非贯通节理岩体峰值后剪切应力、位移呈“S”型趋势发展,即强度衰减速率先是逐步增大,到达一定程度后逐步减少,最后趋于稳定达到残余强度值。贯通节理岩体峰值强度后的本构关系并不适合于描述该特征。提出一个新的非线性归一化位移软化本构模型,通过归一化剪切应力R与归一化剪切位移D的指数函数关系体现峰值后剪切应力、位移的发展趋势,即模型采用无量纲表达式。归一化剪切应力R是峰值后强度降? p-? 与峰值强度、残余强度差值? p-? r的比值;归一化位移D是峰值后剪切位移、峰值位移差值? -? p与残余位移、峰值位移差值? r -? p的比值。对含不同起伏角的非贯通节理岩体在常法向荷载条件下的直剪试验数据进行拟合分析,模型预测结果与实测值具有相当高的吻合度,验证了模型的正确性     

深海潜器耐压圆柱壳结构计算和校核方法研究

文中比较了中美两国潜器规范中各特征量的计算方法和校核准则,分析了异同点,并给出数值算例。针对潜器特性,对目前我国潜器规范中可能需要修改的地方进行了初步分析。     

Effect of Silica Fume on Compressive Strength of Oil-Polluted Concrete in Different Marine Environments

In the present research, effect of silica fume as an additive and oil polluted sands as aggregates on compressive strength of concrete were investigated experimentally. The amount of oil in the designed mixtures was assumed to be constant and equal to 2% of the sand weight. Silica fume accounting for 10%, 15% and 20% of the weight is added to the designed mixture. After preparation and curing, concrete specimens were placed into the three different conditions: fresh, brackish and saltwater environments (submerged in fresh water, alternation of exposed in air & submerged in sea water and submerged in sea water). The result of compressive strength tests shows that the compressive strength of the specimens consisting of silica fume increases significantly in comparison with the control specimens in all three environments. The compressive strength of the concrete with 15% silica fume content was about 30% to 50% higher than that of control specimens in all tested environments under the condition of using polluted aggregates in the designed mixture.     

抛石防波堤人工护面块体强度模拟研究

本文主要研究了混凝土人工护面块体在模型试验中的强度模拟问题，根据不同比尺要求的强度指标，确定新型材料组成成份及其配比，并针对已有防波堤护面块体的破坏情况，进行了水槽模型验证试验。     

Measurement and modeling of bed shear stress under solitary waves

Direct measurements of bed shear stresses (using a shear cell apparatus) generated by non-breaking solitary waves are presented. The measurements were carried out over a smooth bed in laminar and transitional flow regimes (~ 10⁴ < R_e < ~ 10⁵). Measurements were carried out where the wave height to water depth (h/d) ratio varied between 0.12 and 0.68; maximum near bed velocity varied between 0.16 m/s and 0.51 m/s and the maximum total shear stress (sum of skin shear stress and Froude–Krylov force) varied between 0.386 Pa and 2.06 Pa. The total stress is important in determining the stability of submarine sediment and in sheet flow regimes. Analytical modeling was carried out to predict total and skin shear stresses using convolution integration methods forced with the free stream velocity and incorporating a range of eddy viscosity models. Wave friction factors were estimated from skin shear stress at different instances over the wave (viz., time of maximum positive total shear stress, maximum skin shear stress and at the time of maximum velocity) using both the maximum velocity and the instantaneous velocity at that phase of the wave cycle. Similarly, force coefficients obtained from total stress were estimated at time of maximum positive and negative total stress and at maximum velocity. Maximum positive total shear stress was approximately 1.5 times larger than minimum negative total stress. Modeled and measured positive bed shear stresses are well correlated using the best convolution model, but the model underestimates the data by about 4%. Friction factors are dependent on the choice of normalizing using the maximum velocity, as is conventional, or the instantaneous velocity. These differ because the stress is not in phase with the velocity in general. Friction factors are consistent with previous data for monochromatic waves, and vary inversely with the square-root of the Reynolds number. The total shear stress leads the free stream fluid velocity by approximately 50°, whereas the skin friction shear stress leads by about 30°, which is similar to that reported by earlier researchers.     

海洋导管架平台的极限强度分析

海洋导管架平台的极限分析是一项较新的研究课题，随着海上采油事业的飞速发展，它已越来越受到海洋工程设计及维修部门的重视。其研究成果不仅能用于设计结构的应力校核，尚可用于现有平台结构的整体安全估算。本文利用非线性模拟技术及线性分析程序的完美结合。成功地分析计算了受集中哉茶作用的空间框架结构，及受静载荷和环境载荷作用下的真实导管架平台极限强度。