Undrained monotonic shear behavior of marine soft clay after long-term cyclic loading

Abstract

In the coastal area, nearshore and offshore structures have been or will be built in marine soft clay deposits that have experienced long-term cyclic loads. Therefore, the mechanical behavior of marine clay after long-term cyclic loading needs to be investigated. In this research, a series of monotonic and cyclic triaxial tests were carried out to investigate the postcyclic mechanical behavior of the marine soft clay. The postcyclic water pore pressure, shear strength and secant stiffness are discussed by comparing the results with the standard monotonic test (without cyclic loading). It is very interesting that the postcyclic behavior of marine soft clay specimen is similar to the behavior of overconsolidated specimen, that is, the specimen shows apparent overconsolidation behavior after long-term cyclic loading. Then relationship between the overconsolidation ratio and the apparent overconsolidation ratio is established on the basis of the theory of equivalent overconsolidation. Finally, a validation formula is proposed which can predict the postcyclic undrained shear strength of marine soft clay.     

常德-张家界高速公路某大桥桥基砂土液化评价

结合常德张家界高速公路某大桥桥基工程,在DSD160型电磁式振动三轴试验仪上,通过往返加荷三轴试验,对饱和砂土进行了液化试验研究,探讨了基于动三轴液化试验结果判断饱和砂土液化的方法。并尝试了这种室内研究反应分析的液化可能性估计方法与地震剪应力时程相结合的综合判断方法。在该高速公路大桥桥基的饱和砂土液化评价中,采用这种综合判断方法,对大桥桥基砂土液化进行了判断。在判断场地是否液化后,对其液化危害程度进行了等级划分,给出了该工程场地在未来遭受到不同超越概率下的地震作用时发生液化的危害程度,得到了一些有工程实用意义的结果。     

T形短肢剪力墙静力性能有限元仿真分析

利用有限元分析软件ANSYS,首先采用其中三维实体单元SOLID65建立了T形短肢剪力墙有限元分析模型,从弹性到混凝土开裂直至破坏的全过程进行了仿真试验分析。分析了影响短肢剪力墙受力的几种因素:混凝土强度等级、配筋率、轴压比、墙肢截面高厚比对短肢剪力墙承载能力、变形能力及延性的影响,剖析了短肢剪力墙破坏过程及其原因。比较真实的反映了短肢剪力墙在轴压力和逐步加载侧向力共同作用下的响应。试验结果表明:增加混凝土等级和轴压比能提高试件的开裂、屈服和极限荷载,但应综合考虑其与变形能力、延性的关系。截面配筋率具有其特殊性,配筋率在1.4%1.6%之间时试件的承载能力、变形能力及延性较好。墙肢截面高厚比是不稳定因素但在高厚比为6.57.1时,延性及变形能力较强。     

Geometry and kinematics of brittle deformation in the Central Cameroon Shear Zone (Kékem area): Implication for gold exploration within the Central Africa Fold Belt in Cameroon

The Central Africa Fold Belt (CAFB) is a collision belt endowed with gold deposits in Eastern Cameroon area mined for about 50 years. However, favorable areas for gold exploration are poorly known. This paper presents (1) the kinematics of the brittle deformation in the Kékem area in the SW portion of the Central Cameroon Shear Zone and (2) constraints gold mineralization events with respect to the collisional evolution of the CAFB. The authors interpret that the conjugate ENE to E and NNW to NW trending lineament corresponds to the synthetic (R) and the antithetic (R’) shears, which accompanied the dextral slip along the NE to ENE striking shear. The latter coincides with the last 570–552 Ma D₃ dextral simple shear-dominated transpression, which is parallel to the Bétaré Oya shear zone hosting gold deposits. Gold mineralizations, which mainly occurred during the last dextral shearing, are disseminated within quartz veins associated to Riedel’s previous structures reactivated due to late collisional activities of the CAFB as brittle deformation. Gold mineralizations occurred mainly during the 570–552 Ma D₃ event. The reactivation, which might be due to dextral simple shear during mylonitzation, plausibly remobilized the early gold deposits hosted in syn-compressional rocks and/or possibly focused deep-sourced fluid mixed with those released by dehydration. Therefore, the Central Cameroon Shear Zone where Kékem is located, and which shows similar petrographical and structural features to those controling Batouri gold district, is a target area for gold exploration in Cameroon.     

南沙海域万安盆地地质构造特征

利用在南沙海域万安盆地所采集的地震、重磁资料及钻井、地质资料，对该盆地的地震反向特征，沉积特征、区域地质、构造特征及构造发展史进行了的简要的论述，本文以该区Ｔｇ深度资料为基础，并利用ＣＣＯＰ年刊发表的新生代基底深度资料，初步圈定了万安盆地的边界，并对盆地二级构造单元进行了划分，将盆地划分为５坳３隆、坳隆相间的构造格局。     

具有内波特性的渤海南部次重力波

次重力波(infragravity waves)是频率范围介于局地平均Brunt-V¾is¾l¾频率和0.05Hz(涌浪频率)之间的一种海洋波动,其能量在深水大洋中一般甚低,但在浅海中却很强.该波动的研究对于浅海海洋内部混合、近岸海洋工程、海洋生态学、海洋沉积学及军事海洋学均有重要的意义.Munk[1]很早就开始研究这类波动,然而主要由于观测技术的限制,对于该类波动的动力学机制的研究进展迟缓.     

A Moored Underwater Energy Conservation System for Profiling Measurement

There is a need to obtain the hydrologic data including ocean current,wave,temperature and so on in the South China Sea.A new profiling instrument which does not suffer from the damage due to nature forces or incidents caused by passing ships,is under development to acquire data from this area.This device is based on a taut single point mid-water mooring system.It incorporates a small,instrumented vertically profiling float attached via an electromechanical cable to a winch integral with the main subsurface flotation.On a pre-set schedule,the instrument float with sensors is winched up to the surface if there is no ship passing by,which is defined by an on-board miniature sonar.And it can be immediately winched down to a certain depth if the sonar sensor finds something is coming.Since,because of logistics,the area can only be visited once for a long time and a minimum of 10 times per day profiles are desired,energy demands are severe.To respond to these concerns,the system has been designed to conserve a substantial portion of the potential energy lost during the ascent phase of each profile and subsequently use this energy to pull the instrument down.Compared with the previous single-point layered measuring mode,it is advanced and economica1.At last the paper introduces the test in the South China Sea.     

黄河口快速沉积及其动力过程

现场观测资料和卫星遥感校准图像计算表明 ,185 5年以来 ,黄河三角洲新淤陆地 36 99km2 ,生长速率为 2 6 8km2 /a ,黄河输入三角洲 1× 10 8t泥沙形成 3 14 4km2 的陆地。进入河口区的泥沙约 88 4 %堆积在水下 8km宽的三角洲前缘。研究表明 ,这一堆积比例是河口切变锋、异重流和潮流场相互作用的结果 ,异重流在黄河汛期一直存在 ,大约搬运黄河来沙的 6 0 %沉积在三角洲前缘 ;一个潮周期内 ,切变锋出现两次 ,它能够捕获异轻羽状流中的悬浮泥沙堆积 ,也能够限制异重流的远距离扩散。切变锋消失后 ,少量悬浮泥沙才能远距离扩散 ,随潮流离开三角洲水下斜坡。     

基于新型高频声学多普勒流速剖面仪的河口近底部边界层观测初探

河口物质输运、能量交换与底边界层内的水动力过程密切相关,底边界层参数(如切应力、拖曳系数)的确定至关重要。挪威Nortek公司生产的新型声学多普勒流速剖面仪AD2CP相比传统ADCP具有高频、低噪的优点,可用于高频(16Hz)流速剖面观测,而被广泛应用于底边界层观测的ADV只能测量单点高频流速。本文采用AD2CP在长江口南槽最大浑浊带区域进行座底式观测,并与同步近底部三脚架上ADV的观测结果进行对比。结果表明,使用AD2CP测得的近底部平均流速与ADV的测量结果吻合良好;使用惯性耗散法计算了底切应力,基于ADV的单点高频流速数据计算结果为2.16×10~(-2)～5.69×10~(-1)N/m~2,基于AD2CP的结果为2.09×10~(-2)～4.26×10~(-1)N/m~2,二者范围大致相当。在此基础上,基于AD2CP数据计算出摩阻流速为4.55×10~(-3)～2.06×10~(-2)m/s、底拖曳系数范围为1.84×10~(-4)～2.49×10~(-3),与ADV的计算结果基本一致。此外,由于AD2CP可以获得高频的流速剖面数据,优于单点ADV,具备观测近底部边界层参数和边界层内湍流剖面的潜力。     

Effect of sand on the vacuum consolidation of dredged slurry

Vacuum preloading is often used to improve the geotechnical properties of dredged slurry. Although the performance of this method has improved with rapidly developing technology, soil columns usually formed on the drainage boundary induce the decrease of permeability around the boundary, thereby limiting the further development of this method. To address this issue, this paper proposes a method for pretreating the slurry combined with sand prior to vacuum consolidation. This method partially replaces the fine particles with sand to reduce the formation of soil columns. Two groups of vacuum preloading tests were performed to investigate the effect of sand content and sand grain size on the vacuum consolidation of dredged slurry. The test results revealed that for a given sand grain size, increasing the sand content of the sand–slurry mixture increased the pore water drainage and accelerated the dissipation of pore water pressure, thereby increasing the vane shear strength. In contrast, for a constant sand content, the samples containing coarse sand exhibited increased pore water drainage and accelerated dissipation of pore water pressure, thereby increasing the vane shear strength of the soil.