基于耦合场分割算法的ANSYS二次开发及其应用

耦合场分割算法是当前研究的热点之一。本文首先对比研究了瞬态热传导方程和孔压增长消散方程,提出了一种适用于ANSYS二次开发的分割算法,并对2种不同的预测值计算模式对计算稳定性的影响进行了分析。然后,据之对ANSYS温度—结构耦合场模块进行了开发,形成了岩土工程有效应力计算模块。数值实验表明,这种方法具有较高的计算精度和良好的计算稳定性,并且能够充分利用现有程序资源,具有较高的工程应用价值。     

基于性能的抗震设计方法在剪力墙结构中的应用

本文对基于性能的抗震设计方法中最具有代表性的直接基于位移的设计方法在剪力墙结构中的应用进行了研究。采用结构非线性分析程序探讨了墙厚、混凝土强度等级、纵筋配筋率、钢筋级别、轴压比、墙长等因素对单肢剪力墙屈服位移的影响,从而对现有的屈服曲率计算公式进行了改进。另外将按顶点荷载作用下的屈服位移计算公式求出的屈服位移与实际倒三角形荷载作用下的剪力墙屈服位移进行了比较,,从而推导出倒三角形荷载作用下的屈服位移计算公式。     

高地应力围岩分区碎裂化的时间效应分析和相关参数研究

本文阐述了高地应力围岩分区碎裂化现象的形成需要经过一定的时间,但这段时间不会很长;采用蠕变理论对岩石分区碎裂化的时间效应进行了分析;推导了能够描述加速蠕变阶段的流变模型-改进的西原模型的本构方程和蠕变方程,在此基础上求出了岩石分区碎裂化发生时破裂带半径(破碎带距巷道中心的距离)的公式。      

印度-澳大利亚板块应力场数值模拟及其动力学分析

印度-澳大利亚板块的边界类型和性质十分复杂。本文采用伪三维有限元方法,利用WSM2000观测应力场数据的应力取向和应力状态作为主要约束,建立了印度-澳大利亚板块岩石层三维模型,对印度-澳大利亚板块构造应力场进行了数值模拟,进而探讨印度-澳大利亚板块所受边界力对板块内部应力场的影响。结果显示,印度-澳大利亚板块的构造应力场主要受到两个因素的控制:①软流层静压推力;②来自碰撞带的阻力,包括喜马拉雅、巴布亚新几内亚、新西兰和印度-澳大利亚板块与欧亚板块的西北边界。而来自俯冲消减带的拉张作用力对板内应力场的作用相对较小。      

低级序复杂断块构造应力场定量模型与油气分布

在对现河低级序帚状断块构造体系研究的基础上,建立了沙一、东营及现今3期构造应力场定量模型,研究了构造应力场特征及其与油气分布的关系。研究表明,不同地质时期应力强度不同,应力的方向和大小都有变化,认为应力值由老到新呈增大趋势。最大水平主应力在平面上自帚状构造的撒开端向收敛端逐渐变低,在剖面上随深度增加而增加,断裂带是应力低值区,也是油气富集区。提出应力转换带为应力低值区,也是低幅断鼻构造的有利分布区,还是开发中后期复杂断块油藏剩余油富集区。      

安宁河-则木河断裂带地震视应力研究

利用四川和云南数字遥测地震台网的数字地震记录资料。研究了包括地震视应力在内的震源参数。首先对资料进行预处理,然后计算地动位移和速度的功率谱积分,再计算地震辐射能量和视应力等震源参数。根据计算结果分震级区间研究了视应力值沿安宁河-则木河断裂带的分布情况,及该断裂带上中等地震的震源谱及参数差异,认为安宁河断裂带视应力相对更高。     

华清4#泉水溶气体百分含量合计的强震远场前兆特征

华清4#泉水溶气体百分含量合计(QB)的取值范围为100±5.按4舍5入法取整数值,将其分为11个区段.以年为单位,统计QB落在每个区段内的频次.频率分布直方图显示,在QB取值区间内,分区段频率呈近似正态分布.将落入QB频率最高的区段称为轴,将轴在不同区段上位置的变化称为轴漂.研究表明,QB在不同区段上轴的漂移,反映了区域应力场的不同状态.轴落入99区段上,反映的是区域应力场的增强,与远场M≥7.0地震及伴生中强地震、鄂尔多斯块体周边后继中强地震有很好的相关性;轴落入98区段上,反映的是区域应力场的相对稳定;轴落入97区段上,反映的是巨大地震后,区域应力场的调整及中强地震活动格局的变化.文中还阐述了99区段轴值与地震对应关系的几个特征.     

大同地区3次地震序列构造应力张量变化特征的研究

利用1989~2002年间3次大同地震序列中共计700多次中小地震的震源机制解资料,应用Gephart(1990)的应力张量反演方法研究了这3次地震序列的构造应力张量的总体变化特征和时序变化特征,研究发现3次主震发生前震源及附近地区的构造应力作用较强,主震发生前后,应力方向存在细节差异,但是最大主压应力方向与华北地区的构造应力场方向基本一致,只有1999年震前阶段的最大主压应力方向为226°(SW向),分析认为这可能是华北地区构造应力场与大同地区局部构造应力场相互作用的结果。     

Preliminary seismic anisotropy in the upper crust of the south segment of Xiaojiang faults and its tectonic implications

The Xiaojiang faults,striking north-to-south(NS),and the Honghe faults,striking north-to-west(NW),are first-order block boundaries that intersect to form a concentrated stress zone at an acute angle in the southern part of the Sichuan-Yunnan rhombic block(SYB).It is also a crucial zone for material escaping from the Tibetan Plateau(TP)due to the collision between the Indian Plate and the Eurasian Plate.In December 2017,the Institute of Earthquake Forecasting of the China Earthquake Administration(CEA)deployed a linear temporary seismic broadband array,the Honghe-Xiaojiang temporary Seismic Array(HX Array),across first-order block boundaries in the southern SYB.By using the waveform data of small earthquakes recorded by stations in the HX Array across Xiaojiang faults from 2017 to 2019,and by permanent seismic stations of the China National Earthquake Networks from 2012 to 2019,this paper adopts the systematic analysis method of shear-wave splitting(SWS),SAM method,to obtain preliminary results for seismic anisotropy in the upper crust.The study area can be divided into two subzones according to the spatial distribution of the directions of polarization of the fast shear-wave(PFS)at the stations:the northern zone(zone A,where the HX Array is located)and the southern zone(zone B,to the south of the HX Array).The results show that the directions of the PFS at stations in zone A were highly consistent,dominant in the NE direction,correlated with the in-situ principal compressive stress,and were seemingly unaffected by the Xiaojiang faults.The directions of the PFS as recorded at stations in zone B were more complicated,and were dominant in the NS direction parallel to that of the regional principal compressive stress.This suggests the joint influence of complex tectonics and regional stress in this narrow wedge area.By referring to the azimuthal anisotropy derived from seismic ambient noise in the southeast margin of the TP,the NS direction of the PFS in the middle and lower crust,and its EW direction in the upper mantle,this paper concludes that azimuthal anisotropy in the upper crust differed from that in the lower crust in the south segment of Xiaojiang faults,at least beneath the observation area,and azimuthal anisotropy in the crust was different from that in the upper mantle.The results support the pattern of deformation of ductile flow in the lower crust,and the decoupling between the upper and lower crusts as well as that between the crust and the mantle in the study area.The crustal directions of the PFS appeared to be independent of the Xiaojiang faults,suggesting that the influence of the South China block on the SYB passed through the Xiaojiang faults to the Yimen region.The results of this study indicate that anisotropic studies based on data on the dense temporary seismic array can yield clearer tectonic information,and reveal the complex spatial distribution of stress and deformation in the upper crust of the south segment of Xiaojiang faults.     

黄河三角洲潮滩剖面特征

利用验潮、潮滩水准测量、沉积物分析和遥感资料,分析了黄河三角洲不同岸段潮滩的特征。水准测量表明,侵蚀潮滩剖面形态为下凹,而淤积潮滩则上凸,由高潮线至低潮线,潮滩沉积物均变粗,这种变粗趋势在北部侵蚀岸段和河口侧缘明显,在河口南侧稳定海岸则不明显。潮滩沉积物含水量为12.2%~32.2%,平均为21%,海滩表层沉积物不排水剪切强度在0.1~0.35 kg/cm2之间。受局限岸滩的平面形态和剖面形态受到周围大坝地形影响,具有和砂质海滩类似的形态,显示波浪对该潮滩的作用强烈,根据剖面测量结果与遥感图像,发现河口北侧有一个小的冲积扇。