全珊瑚骨料海水混凝土力学性能试验研究

为了探讨全珊瑚骨料海水混凝土的基本力学性能,并比较其与普通混凝土和轻集料混凝土的差异,通过实验系统测定了珊瑚混凝土的基本力学性能,建立了其轴心抗压强度(f_(c,m))、劈裂抗拉强度(f_(sp,m))、抗折强度(f_(t,m))与立方体抗压强度(f_(cu,m))之间的线性关系与计算公式。结果表明:在强度等级C20~C50的范围内,珊瑚混凝土的f_(c,m)和f_(sp,m)分别比普通混凝土的f_(c,m)和f_(sp,m)高出10%~48%和9%~33%,随着强度等级的提高,两种混凝土之间的差距在减小。珊瑚混凝土的f_(t,m)与普通混凝土的ft,m之间的差异规律与强度等级有关,较低强度等级的C30珊瑚混凝土ft,m比普通混凝土的f_(t,m)要高4%,而较高强度等级的C55珊瑚混凝土f_(t,m)比普通混凝土的f_(t,m)低13%。较高强度等级的C50珊瑚混凝土f_(c,m)、f_(sp,m)和f_(t,m)分别比页岩陶粒轻集料混凝土的f_(c,m)、f_(sp,m)和f_(t,m)低11%、0.9%和4%。     

The Effect of Concrete Deformation on Displacement of an Axially Loaded Drilled Shaft

This article presents the settlement of drilled shafts resulting from their structural deformations. Although drilled shafts are widely used as foundations for settlement-sensitive structures such as bridges and high-rise buildings, the structural deformations of drilled shafts are not typically taken into account in the design process. However, if unexpected structural deformations of drilled shafts cause additional settlement to the foundation, the serviceability of the superstructure can be jeopardized. Unfortunately, very few research efforts have been made to quantify the structural deformation of drilled shafts; this needs to be addressed to accurately predict the settlement of drilled shafts. In this study, we investigate the effect of structural deformation on displacement of axially loaded drilled shafts. Finite element analyses were performed to quantify the structural deformation of drilled shafts. The analysis results indicated that the structural deformation of drilled shafts could be quite significant for long drilled shafts. The main factors that affected the structural deformation of drilled shafts were found to be pile length, the material properties of drilled shafts, and the relative humidity of surrounding soil. An approximate equation is proposed to estimate the long-term deformation of drilled shafts.     

高陡岩石边坡软体护坡技术设计及施工实践

为了消除济南市燕翅山北侧采矿遗留的高陡岩石边坡的地质灾害隐患,恢复自然植被,通过施工砼基座、施工砼格构梁、砌筑软体生态袋和挂网喷播等多种技术方法进行了综合治理,消除了滑坡和崩塌等地质灾害隐患,整个坡面植被覆盖率超过99%,消除了视觉污染,恢复了当地生态环境,该工程成功的设计及施工实践对类似高陡岩石边坡有很好的指导和借鉴作用。     

低剖面紧凑的圆盘加载单极子天线

本文介绍了一种低剖面小型化圆盘加载单极子天线.通过盘加载的方式,在中心频率5.8 GHz处,首先将单极子天线的剖面从大约12.9 mm（0.25λ₀）降低到2 mm（0.039λ₀）,实现了低剖面的特性.加载在单极子天线上方的圆盘,尺寸大概为21 mm（0.41λ₀）,因此天线具有结构紧凑的特点.接着,为了使天线具有良好的匹配,在加载圆盘四周加入4个接地通孔,并且在馈电端口加入集总电感.最终,天线在中心工作频率5.8 GHz处实现了反射系数-15 dB的匹配性能.     

Bearing capacity of strip foundations reinforced with geogrid sheets by using upper bound finite‐element limit analysis

By using the upper bound finite‐elements limit analysis, with an inclusion of single and two horizontal layers of reinforcements, the ultimate bearing capacity has been computed for a rigid strip footing placed over (i) fully granular, (ii) cohesive‐frictional, and (iii) fully cohesive soils. It is assumed that (i) the reinforcements are structurally strong so that no axial tension failure can occur, (ii) the reinforcement sheets have negligible resistance to bending, and (iii) the shear failure can take place between the reinforcement and soil mass. It is expected that the different approximations on which the analysis has been based would generally remain applicable for reinforcements in the form of geogrid sheets. A method has been proposed to incorporate the effect of the reinforcement in the analysis. The efficiency factors, η_c and η_γ, to be multiplied with N_c and N_γ , for finding the bearing capacity of reinforced foundations, have been established. The results have been obtained (i) for different values of ? in case of fully granular and cohesive‐frictional soils, and (ii) for different rates at which the cohesion increases with depth for a fully cohesive soil. The optimum positions of the reinforcements' layers have also been determined. The effect of the reinforcements' length on the results has also been analyzed. As compared to cohesive soils, the granular soils, especially with higher values of ?, cause a much greater increase in the bearing capacity. The results compare reasonably well with the available theoretical and experimental data from literature. Copyright © 2013 John Wiley & Sons, Ltd.     

Internal erosion of chemically reinforced granular materials: a mathematical modeling approach

Internal erosion (IE) affects the stability of natural and reinforced materials by causing instability within their granular structure. The dislodgement and transport of eroded particles affect both the particulate concentration of eroding fluid and the pore network of eroded material. In this study, we examined these modifications using a transport model with a finite element code. First, IE tests on chemically reinforced sand columns were performed to obtain information about eroded material loss of mass, particulate concentration of effluent, porosity and permeability modifications, and existing IE stages. Second, based on experimental results, a mathematical one‐dimensional model has been formulated to monitor the evolution and spatial distribution of erodible solids, fluidized particles, porosity, permeability, and seepage stresses. The model consists of a set of coupled nonlinear differential equations solved in sequence. It provides valuable information about the extent and the dynamics of structural changes, which can be used to estimate an IE time for the hydraulic work to reach failure. Copyright © 2011 John Wiley & Sons, Ltd.     

Finite element analysis of the effect of corrosion on the behavior of reinforced earth walls

A simple model for the corrosion‐induced loss of stiffness and strength of the steel strips of earth‐reinforced walls was introduced in a finite element simulation of the long‐term behavior of the wall, in which the backfill‐strips interactions are taken into account by means of a generalized homogenization procedure (called a multiphase model). The results show an initial phase of slow displacements induced by the loss of stiffness, followed after a few decades by a steep acceleration of the displacements, leading to wall failure. The influences of the parameter controlling corrosion, the backfill cohesion and the heterogeneity of the corrosion process are discussed. Results are used to discuss a strategy for reinforced earth wall surveillance. Copyright © 2011 John Wiley & Sons, Ltd.     

Analytical solutions for Euler–Bernoulli beam on visco‐elastic foundation subjected to moving load

Analytical solutions for the steady‐state response of an infinite beam resting on a visco‐elastic foundation and subjected to a concentrated load moving with a constant velocity are developed in this paper. The beam responses investigated are deflection, bending moment, shear force and contact pressure. The mechanical resistance of the foundation is modeled using two parameters k_s and t_s — k_s accounts for soil resistance due to compressive strains in the soil and t_s accounts for the resistance due to shear strains. Since this model represents the ground behavior more accurately than the Winkler spring model, the developed solutions produce beam responses that are closer to reality than those obtained using the existing solutions for Winkler model. The dynamic beam responses depend on the damping present in the system and on the velocity of the moving load. Based on the study, dynamic amplification curves are developed for beam deflection. Such amplification curves for deflection, bending moment, shear force and contact pressure can be developed for any beam‐foundation system and can be used in design. Copyright © 2012 John Wiley & Sons, Ltd.     

Study of bond stress–slip relationship and radial dilation in prestressed concrete

This paper presents two test procedures for evaluating the bond stress–slip and the slip–radial dilation relationships when the prestressing force is transmitted by releasing the steel (wire or strand) in precast prestressed elements. The bond stress–slip relationship is obtained with short length specimens, to guarantee uniform bond stress, for three depths of the wire indentation (shallow, medium and deep). An analytical model for bond stress–slip relationship is proposed and compared with the experimental results. The model is also compared with the experimental results of other researchers. Since numerical models for studying bond‐splitting problems in prestressed concrete require experimental data about dilatancy angle (radial dilation), a test procedure is proposed to evaluate these parameters. The obtained values of the radial dilation are compared with the prior estimated by numerical modelling and good agreement is reached. Copyright © 2012 John Wiley & Sons, Ltd.     

粉煤灰碎石混凝土灌注桩法加固软弱地基效果的分析与检验

对由深厚软弱土层组成的地基,采用粉煤灰碎石混凝土灌注桩法予以加固处理时,其施工机具相对简单,工期短,节约“三材”,投资省,具有显著的经济效益。由粉煤灰碎石混凝土灌注桩和深厚软弱土层共同构成的复合地基的工程特性,介于一般碎石桩复合地基与混凝土桩桩基之间,其基本特征是:承载力的提高,主要是置于深厚软弱土层中的粉煤灰碎石混凝土灌注桩的排水和垂直加筋作用的结果;其承载机理,部分具有一般碎石桩复合地基的特征;在结构物荷载作用下,其桩、土荷载分担特征,比较接近于普通混凝土桩桩基。