沼泽沉积剖面特征元素比值及其环境意义——盐碱化指标及气候干湿变化

沼泽发育过程中堆积的各类沉积物真实地记录下区域环境演变与沼泽发育过程的信息。以向海沼泽湿地为研究对象,由¹³⁷Cs、²¹⁰Pb法定年实现沉积层深度坐标向年代坐标的转换,对典型沉积剖面特征元素比值进行了综合剖析。结果表明: Sr/Ba、Rb/K、(CaO+K₂O+Na₂O)/Al₂O₃等比值具有盐碱化和气候干湿变化的指示意义。该区域的盐碱化并非只发生在近几十年,而是由来已久,只是近年来人类活动促进了盐碱化进程。霍林河流域近240年来气候存在冷干-暖湿-冷干的多次波动,1880年之前气候以冷干为主,并有小幅度波动;1880年后气候开始转暖,但仍以冷暖波动振荡为主。     

刚性桩复合地基水平承载力特性

利用三维非线性弹性有限元方法,研究了刚性桩复合地基在不同垂直荷载作用下的水平承载力特性,分析了不同褥垫层厚度及其地基土的性质对复合地基水平受力特性的影响,得出了水平荷载作用下桩身弯矩和挠度的分布规律。研究表 明,垂直荷载的大小改变了复合地基水平荷载作用下的破坏模式,直接影响着其水平承载力;适当的垫层厚度可降低桩所分担的水平荷载,有利于桩身的安全。     

黑龙江省达连河油页岩地球化学特征及成因探讨

论述了达连河含煤段油页岩及油页岩段油页岩的地球化学特征,探讨了两套油页岩成因。这两套油页岩地球化学性质有很多相似之处,主要表现为油页岩都属于中熔或难熔的硅质灰分,SiO₂、Al₂O₃及Fe₂O₃含量很高;无机元素 Mn/Ti小于0.1,Sr/Ba为0.1～0.5,V/Ni为2.6～7.0;有机质类型以腐泥腐殖型为主,正构烷烃OEP值为1.55～3.67,具奇碳数优势,主峰碳为nC₂₃和C₂₉,Pr/Ph比值平均高达2.30,具强烈的姥鲛烷优势,Pr/nC₁₇比值为1.18～3.20,说明这两套油页岩都形成于淡水、近岸及弱氧化-弱还原的湖沼相沉积环境。但含煤段油页岩沉积时期高温、湿润的古气候条件下的喜湿植物面貌,使油页岩母质类型具有较多的富氢组分,这是造成两套油页岩品质差异的主要原因。     

半干旱区沼泽沉积剖面特征元素比值及其物源、氧化还原变化信息

沼泽发育过程中堆积的各类沉积物真实地记录了区域环境演变与沼泽发育过程。以霍林河下游漫流区--向海沼泽湿地为研究对象,由¹³⁷Cs、²¹⁰Pb法定年实现沉积层深度坐标向年代坐标的转换,对其典型沉积剖面特征元素比值进行了综合剖析。结果表明：稳定元素对比值Ti/Al是判断不同沉积物来源是否一致的较好指标。剖面上下Ti/Al比值在一定层序的波动变化表明物源的波动性,洪水成因可能性较大。综合比较,V/(V+Ni)比值用于沼泽湿地缺氧沉积环境的判别标准可靠性较好。贫氧环境是向海沼泽湿地主要特征之一,其次是缺氧或含氧环境,各环境之间频繁振荡,体现了内流河下游半干旱区沼泽地表水周期和干湿环境转换频繁的特征。     

浑善达克沙地种子植物属的地理成分分析

运用植物区系地理学的基本原理,通过对浑善达克沙地种子植物属的组成、地理成分统计、排序和分析,结果表明:浑善达克沙地物种的多样性较高,属的分布区类型以温带成分占绝对优势,其中北温带分布型所占的百分比数最高,占本区种子植物区系中非世界属数的37.2%,其次是旧大陆温带分布,反映出该区系的温带性质,体现了浑善达克沙地植物分布与本地区的气候带相适应的结果。本区系具有一定数量的古老成分,地理成分混杂且具有明显的过渡性,同时该区系又具有明显的脆弱性;特有程度较低。     

无锡马山抽水蓄能电站地面厂房边坡稳定性分析

以无锡马山抽水蓄能电站地面厂房建筑过程中形成的人工边坡为例,在对其工程地质剖面分析并找出可能的滑动模式后,利用极限平衡法和有限元法分析了4个典型地质剖面的稳定性安全系数以及应力应变关系。结果表明,通过对该边坡的极限平衡法得到了2-2剖面的安全系数和通过有限元法得到的计算结果比较接近,且都满足相关规范的要求;坡体的最大位移发生在高程为－20 m和－5.0 m附近,其值为－22 mm;最大主应力位于高程－45.0 m处,值为0.134 MPa;最小主应力位于坡内深处,其值为－6.22 MPa。同时,提出了下一阶段应考虑时间效应,对边坡的变形进行分析。     

墙土摩擦对基坑变形影响的模拟和分析

研究墙土之间的摩擦作用对合理计算基坑变形和估算支护结构竖向承载力都有重要的意义,文中运用有限元的方法对摩擦力的作用做了比较全面的分析,得出一些结论,以便实际工程参考。     

Crustal contaminants in the Permian Oslo Rift, South Norway: constraints from Precambrian geochemistry

During the late Paleozoic Oslo rifting event, the SW part of the Baltic Shield was penetrated by mantle-derived magmas from a depleted lithospheric or sublithospheric source. Along the way to their final emplacement, these magmas may have interacted with a heterogeneous continental crust, consisting of a mosaic of continental terranes, each with its unique composition and internal crustal history. Information on radiogenic isotope ratios and trace element distributions in the Precambrian terranes surrounding the rift can be used to define characteristic crustal components. These components may be used as endmembers in petrogenetic modelling of the Oslo Rift magmatic system. Based on available data, six endmember components can be identified, and (semi) quantitatively characterized in terms of Sr, Nd and Pb isotopes and selected trace elements. Data on the distribution of rock-types along the rift flanks allow estimates to be made of the relative importance of the components in different parts of the rift. Combining these data with petrological information may allow a realistic understanding of crust–magma interaction in the Oslo Rift magmatic system.     

Factors controlling the groundwater transport of U, Th, Ra, and Rn

A model for the groundwater transport of naturally occurring U, Th, Ra, and Rn nuclides in the²³⁸U and²³²Th decay series is discussed. The model developed here takes into account transport by advection and the physico-chemical processes of weathering, decay, α-recoil, and sorption at the water-rock interface. It describes the evolution along a flowline of the activities of the²³⁸U and²³²Th decay series nuclides in groundwater. Simple sets of relationships governing the activities of the various species in solution are derived, and these can be used both to calculate effective retardation factors and to interpret groundwater data. For the activities of each nuclide, a general solution to the transport equation has been obtained, which shows that the activities reach a constant value after a distance ϰ_i, characteristic of each nuclide. Where ϰ_i is much longer than the aquifer length, (for²³⁸U,²³⁴U, and²³²Th), the activities grow linearly with distance. Where gKⁱ is short compared to the aquifer length, (for²³⁴Th,²³⁰Th,²²⁸Th,²²⁸Ra, and²²⁴Ra), the activities rapidly reach a constant or quasi-constant activity value. For²²⁶Ra and²²²Rn, the limiting activity is reached after 1 km. High δ²³⁴U values (proportional to the ratio^ɛ234Th/^W238U) can be obtained through high recoil fraction and/or low weathering rates. The activity ratios²³⁰Th/²³²Th,²²⁸Ra/²²⁶Ra and²²⁴Ra/²²⁶Ra have been considered in the cases where either weathering or recoil is the predominant process of input from the mineral grain. Typical values for weathering rates and recoil fractions for a sandy aquifer indicate that recoil is the dominant process for Th isotopic ratios in the water. Measured data for Ra isotope activity ratios indicate that recoil is the process generally controlling the Ra isotopic composition in water. Higher isotopic ratios can be explained by different desorption kinetics of Ra. However, the model does not provide an explanation for²²⁸Ra/²²⁶Ra and²²⁴Ra/²²⁶Ra activity ratios less than unity. From the model, the highest²²²Rn emanation equals 2ɛ. This is in agreement with the hypothesis that²²²Rn activity can be used as a first approximation for input by recoil (Krishnaswamiet al 1982). However, high²²²Rn emanation cannot be explained by production from the surface layer as formulated in the model. Other possibilities involve models including surface precipitation, where the surface layer is not in steady-state.     

A mixed finite element method for the solution of the magnetostatic problem with highly discontinuous coefficients in 3D

This paper present a new a mixed finite element method for the simulation of magnetostatic problems with highly discontinuous permeability. The method is derived from the well studied mixed formulation for the div-grad system that is known to be accurate for very large discontinuities. The method robustness is demonstrated on a test model problem.