惠民凹陷大芦家地区馆陶组三段沉积微相类型及空间展布

针对惠民凹陷大芦家地区各断块地层单元划分不一致,沉积相认识存在分歧等问题,依据旋回级次、旋回性质等,将馆陶组三段划分出2个四级旋回、4个五级旋回、16个六级旋回;并以岩芯及室内分析资料、测井资料等为主要依据,综合分析岩石类型、粒度及结构特征、垂向粒序变化、层理构造类型及自然电位曲线形态等。结果表明:惠民凹陷大芦家地区馆陶组三段主要发育冲积扇及辫状河;冲积扇主要发育辫流砂岛、辫流沟道、辫流带、漫流席状砂、远端砂丘等微相;辫状河主要发育心滩,辫状河道充填,天然堤、漫滩和道间洼地沉积,泛滥平原沉积,废弃河道等微相;2个四级旋回的沉积相类型及空间展布特征相似;第Ⅰ五级旋回在研究区中偏西部属冲积扇沉积,主要发育辫流砂岛、辫流沟道、辫流带微相,在东部属扇前平原沉积;第Ⅱ五级旋回早期以辫状河沉积为主,河道规模较大,仅在第Ⅱ1六级旋回的东北部位见冲积扇的辫流砂岛及辫流沟道微相;第Ⅱ五级旋回中期属辫状河沉积,河道规模减小,2个河道群自NW向SE方向流动;第Ⅱ五级旋回晚期河道规模更小,逐渐向曲流河沉积过渡。     

模糊划分矩阵在岩土参数概率分布中的应用

讨论如何在小样本条件下用已有的过程经验与试验资料确定岩土参数概率分布,用模糊划分矩阵与BAYES方法相结合,给出由小样本试验数据确定岩土参数的概率分布。     

福建地区环境噪声特性研究

为进一步加强对福建地区噪声特性的认识以及提升台站地震观测质量,计算了2014年福建地震台网宽频带地震仪连续观测数据的功率谱概率密度函数,并分析其影响因素和不同频段时空变化特性。结果表明:人文噪声平均水平最高地区位于福建沿海福州至厦门一带,07:00—18:00的功率谱密度要明显高于其它时间段,12:00左右出现间歇性低谷期,夜间有不同程度的降低,日变化除了在春节假期大幅下降外,均处于较为稳定态势;福建地区次级微震主要成分是Rayleigh波,主频约为2.7 s,主微震主频约为16 s,次级微震平均水平最高地区也位于沿海一带,向内陆方向呈衰减趋势,其日变化明显,与台风和潮高有较高的相关性。     

广东省地方防震减灾工作思路与实践

防震减灾的四个环节,包括地震重点监视防御区的工作和实现全省防震减灾十年目标的任务,最终实施都得依赖市,县地地震工作机构的落实。根据广东省的政治,经济,社会发展以有震情特点,介绍了近两个来地方防震减灾工作的思路与实践,为今后的工作有益的借鉴。     

Oil dispersal modelling: reanalysis of the Rena oil spill using open-source modelling tools

ABSTRACT

Oil spill forecast modelling is typically used immediately after a spill to predict oil dispersal and promote mobilisation of more effective response operations. The aim of this work was to map oil dispersal after the grounding of the MV Rena on Astrolabe Reef and to verify the results against observations. Model predictions were broadly consistent with observed distribution of oil contamination. However, some hot spots of oil accumulation, likely due to surf-zone and rip current circulation, were not well represented. Additionally, the model was run with 81 differing wind conditions to show that the events occurring during the grounding represented the typical likely behaviour of an oil spill on Astrolabe Reef. Oil dispersal was highly dependent on prevailing wind patterns; more accurate prediction would require better observations of local wind patterns. However, comparison of predictions with observations indicated that the GNOME model was an effective low-cost approach.     

三维地闪监测数据分析与校验

选取福建省2015年三维系统地闪资料,采用同期雷电定位系统(ADTD)资料对其时空分布特征进行分析,利用雷电流峰值记录仪数据对2套系统地闪探测效率和定位误差校验,同时结合IEEE工作组和电力行业推荐的概率公式对三维系统地闪雷电流分布特征进行分析。结果表明:(1)2套系统监测到全省地闪密度空间分布趋势比较一致,在三明西南部地区及福州西部零星地区,三维系统地闪密度更低。(2)2套系统地闪频次年变化和日变化均呈单峰变化特征,但年变化中的10—12月,以及日变化中的09:00—12:00,三维系统监测到地闪频次更少。(3)三维系统地闪回击探测效率为40%,平均定位误差为2.75km。(4)在0~50kA区间,相比于负极性地闪,三维系统正极性地闪雷电流幅值分布更加集中,在26~84kA区间三维地闪雷电流幅值相比于IEEE推荐值和规程推荐值偏大。     

不同轴压比钢筋混凝土圆柱桥墩地震易损性分析

以墩顶漂移率为指标运用ABAQUS有限元软件对钢筋混凝土桥墩进行地震易损性分析。对钢筋混凝土桥墩模型进行精细网格划分,运用循环往复Pushover方法模拟钢筋混凝土桥墩破坏界限值,以此界限值为标准对轴压比为0.20、0.22、0.24、0.26和0.30钢筋混凝土桥墩进行增量动力分析（IDA）。研究结果表明:结构的破坏超越概率,随着轴压比的增大而增大;考虑钢筋混凝土桥墩延性抗震性能,设计轴压比不宜超过0.30;轴压比为0.24~0.26时,钢筋混凝土桥墩破坏概率增加不大,宜为合理的轴压比。     

松辽盆地西部张裂缝预测的应力场方法

以松辽盆地地质资料为基础，介绍了应力场和张裂缝预测的计算方法。通过了各种岩性的张破裂概率隶属函数，预测松辽盆地酉部张裂缝区的分布。据此，为今后的油气勘探提出了几点认识和建议。     

Bed-load transport rate based on the entrainment probabilities of sediment grains by rolling and lifting

A function for the bed-load sediment transport rate is derived. This function is obtained by using the entrainment probabilities of the rolling and lifted sediment grains, and by introducing two travel lengths, respectively. The predictions from the new bed-load function agree well with experimental results over the entire experimental range and show significant improvement over the commonly used formula for the bed-load transport rate. The new function shows that, in terms of contributing to the bed-load transport rate, the total entrainment probability of the sediment grains is a weighted summation of those for the lifted and rolling grains, rather than a simple addition of the two. The function is also used to predict the total entrainment probability, saltation length, and the bed layer thickness at a high bed-load transport rate. These predictions all agree well with the experimental results. It is found that, on average, the travel length for the rolling sand grains is about an order of magnitude less than that of the lifted grains.     

Multi-Scale Texture Modeling

Patterns of crystallographic preferred orientation are referred to as texture. The specific subject of texture analysis is the experimental determination and interpretation of the statistical distribution of orientations of crystals within a specimen of polycrystalline material, which could be metals or rocks. The objective is to relate an observed pattern of preferred orientation to its generating processes and vice versa. In geosciences, texture of minerals in rocks is used to infer constraints on their tectono-metamorphic history. Since most physical properties of crystals, such as elastic moduli, the coefficients of thermal expansion, or chemical resistance to etching depends on crystal symmetry and orientation, the presence of texture imparts directional properties to the polycrystalline material. A major issue of mathematical texture analysis is the resolution of the inverse problem to determine a reasonable orientation density function on SO(3) from measured pole intensities on , which relates to the inverse of the totally geodesic Radon transform. This communication introduces a wavelet approach into mathematical texture analysis. Wavelets on the two-dimensional sphere and on the rotational group SO(3) are discussed, and an algorithms for a wavelet decomposition on both domains following the ideas of Ta-Hsin Li is given. The relationship of these wavelets on both domains with respect to the totally geodesic Radon transform is investigated. In particular, it is shown that the Radon transform of these wavelets on SO(3) are again wavelets on . A novel algorithm for the inversion of experimental pole intensities to an orientation density function based on this relationship is developed.