花岗岩风化料弃土快速堆填过程中不排水抗剪强度评估

沿海沿江城市地下开挖产生的工程渣土含泥量大、含水率高且较松散,主要运往渣土场进行堆填处置。由于产量巨大而处置场地有限,许多渣土场在运营过程中存在堆填速度快、缺乏排水设施、超高超库容堆填等问题,容易引发堆填体失稳事故。目前对于非饱和工程渣土堆体在快速堆填过程中的失稳机制认识尚不清晰,尤其是对这一过程中的高饱和度工程渣土强度增长规律缺乏足够的认识。以深圳红坳渣土场填料——花岗岩风化料(CDG)填土为研究对象,对不同初始饱和度土样进行三轴不排水不排气等向压缩和剪切试验,结果表明:非饱和CDG填土不排水抗剪强度随围压增大呈非线性增长,增长速率与试样初始饱和度密切相关;当土样压缩后的饱和度超过0.7,不排水强度随围压的增长速率显著降低。基于有效固结应力法的原理,结合Hilf孔压公式和修正剑桥模型,提出了一种工程渣土不排水抗剪强度估算方法,并通过与试验结果对比验证了该方法对初始饱和度高于0.6的CDG填土的适用性。利用该方法确定的不排水强度cu与正应力σn的关系可应用于高饱和度工程渣土快速堆填中的稳定性分析。     

库车坳陷克拉2气田异常流体压力演化史

根据克拉2气田现今实测地层压力分析了异常高压发育的特征,并通过流体包裹体测试求取包裹体形成时期的古压力。计算结果表明:下白垩统和古近系库姆格列木群砂岩储层在距今8～6Ma(康村组沉积期末)时,古压力系数大致为1.09～1.18,发育过剩压力为4.6～9.6MPa的异常高压。在此基础上,以古、今压力数据为约束条件,利用数值模拟技术定量恢复出下白垩统与侏罗系异常流体压力的演化历史。研究发现:下白垩统储层流体压力经历了沉积型异常流体压力形成发展(白垩纪-库车组沉积期末)和沉积型异常流体压力萎缩—构造挤压型异常流体压力孕育(库车组沉积期末至今)两个阶段。康村组沉积早期沉积型超压开始出现,库车组沉积期末达到顶峰,过剩压力达40～50MPa;此后,在沉积型超压萎缩—构造挤压型超压孕育过程的耦合下,过剩压力曾降至25～30MPa,更新世起超压略有升高。侏罗系流体压力演化较为简单,吉迪克组沉积期开始出现超压,至库车组沉积期末达到高峰,此后异常高压逐渐萎缩。在克拉2气田的主要成藏时期(距今3～1Ma),烃源岩较储层具有更高的异常压力,源—储压力差为10～30MPa。     

真空预压法加固吹填土的孔隙水压力试验研究

利用真空预压法处理吹填土时,孔隙水压力变化常常反映土体固结程度的好坏。通过6个模型箱试验,监测不同排水系统下孔隙水压力变化,确定有效排水体间距。研究发现0.4m间距的土内孔压下降效果比0.8m间距的土内孔压下降效果好;排水体内的孔隙水压力与排水体类型有关,且距离排水体10 cm处土体内的孔隙水压力仅为排水体内孔隙水压力的1/2弱;滤膜排水系统中的吹填土孔隙水压力下降幅度最快,B型排水板系统次之,而砂井系统最慢。另外,对于吹填土而言,排水体有效间距介于0.4m与0.8m之间,其中滤膜的有效间距最大,B型排水板次之,砂井远小于前两者。     

体应变观测中的气压干扰机制和排除方法的研究

建立体应变理论气压干扰模型,通过实际观测资料研究了气压对体应变月变和日变的干扰过程,探讨消除干扰的方法,且和水位资料作了对比分析。     

储层毛细管压力曲线在东海油气储量计算中的应用

本文阐述了利用储层毛细管压力曲线计算含油炮和度的方法,该方法在东海油气储量计算中取得良好的结果。     

Geomechanical modelling to assess fault integrity at the CO2CRC Otway Project,Australia

This paper presents the first published 3D geomechanical modelling study of the CO2CRC Otway Project, located in the state of Victoria, Australia. The results of this work contribute to one of the main objectives of the CO2CRC, which is to demonstrate the feasibility of CO₂ storage in a depleted gas reservoir. With this aim in mind, a one-way coupled flow and geomechanics model is presented, with the capability of predicting changes to the in situ stress field caused by changes in reservoir pressure owing to CO₂ production and injection. A parametric study investigating the pore pressures required to reactivate key, reservoir-bounding faults has been conducted, and the results from the numerical simulation and analytical analysis are compared. The numerical simulation indicates that the critical pore fluid pressure to cause fault reactivation is 1.15 times the original pressure as opposed to 1.5 times for the comparable analytical model. Possible reasons for the differences between the numerical and analytical models can be ascribed to the higher degree of complexity incorporated in the numerical model. Heterogeneity in terms of lateral variations of hydrological and mechanical parameters, effect of topography, presence of faults and interaction between cells are considered to be the main sources for the different estimation of critical pore pressure. The numerical model, which incorporates this greater complexity, is able then to better describe the state of stress that acts in the subsurface compared with a simple 1D analytical model. Moreover, the reactivation pressures depend mainly on the state of stress described; therefore we suggest that numerical models be performed when possible.     

不同温压条件下蛇纹岩和角闪岩中波速与衰减的各向异性

在实验室中研究了蛇纹岩和角闪岩样品在不同温压条件下的纵、横波速度和Q值．这两种岩样对应的主要组成矿物叶蛇纹石和普通角闪石都具有很强的晶格优选方位（LPO）．随着围压的增加,波速和Q值均增大,但是在相互正交的三个方向上（垂直或平行于层理面及线理方向）增大的速度并不相同,这与微裂隙的逐渐闭合密切相关．在600MPa的围压下升高温度直到600℃以上,由于微裂隙的热扩张受到约束,波速和Q值下降幅度很小．观测到的波速和Q值的各向异性具有不同的机理,波速各向异性主要与定向分布的微裂隙和主要矿物的LPO等构造因素有关;高围压下纵波Q值各向异性与速度各向异性正好相反,可能是由于形成层理面的定向排列的平板状矿物晶体沿不同方向边界之间接触程度不同造成的．     

Biogeographic characterization of Mediterranean and Black Seas faunal provinces using GIS procedures

To identify Mediterranean and Black Seas areas where similar marine faunal provinces occur, geographical distribution maps of 536 species of actual or potential interest to fisheries have been digitized, using GIS software, and three different ecological areas have been delimited by depth, separated by the 200 and 1000 m isobaths. Information on the species ranges was taken mainly from the maps and the texts of the FAO Species Identification Sheets covering the region, and complemented by other sources when necessary. All the distribution maps have then been overlaid by a grid of points at regular intervals every half degree of latitude and longitude. This allowed creation of a matrix of presence or absence of the species at each point from which species richness maps have been generated. The species richness in the Mediterranean proper shows the same negative gradient eastwards that has been observed for nutrients, while the low number of species in the Black Sea could be linked to the fragility and recent fast degradation of this ecosystem. Through the calculation of 65 dissimilarity indices from 50 contiguous points along the coastline and the species richness maps, the region has been divided into nine faunal provinces. These faunal provinces have then been compared with the ten Mediterranean and Black Seas divisions used by the GFCM for statistical purposes, revealing few differences between the two classifications. The definition of faunal provinces in a region when deciding upon Natural Management Areas, and the appropriate GIS approach to be followed, are discussed.     

不同破碎波对沙质海床作用的实验研究

破碎波对近海海岸地形以及海岸建筑物影响强烈,通过物理模型实验对孤立波、规则波作用下破碎带的床面形态以及孔隙水压力进行分析。破碎波冲击海床,破碎处床面上形成沙坝和沙坑,与规则波相比,孤立波破碎时对床面的冲刷更加剧烈,床面形成的沙坝和沙坑尺度更大,且土体内孔隙水压力幅值也较大。同时研究了波面变化对孔隙水压力的影响,发现波面变化历时曲线与孔隙水压力历时曲线相似,与孔隙水压力梯度历时曲线更为相似,说明波面变化更能反映海床内部孔隙水压力梯度的变化。通过探讨波浪与海床之间相互耦合作用,发现破碎带地形变化使得波浪出现不同破碎类型,分析得出卷破波比崩破波作用下孔隙水压力幅值大。     

沉积物孔隙毛细管压力与甲烷水合物饱和度关系研究

To better understand the relationship between the pore capillary pressure and hydrate saturation in sediments, a new method was proposed. First, the phase equilibria of methane hydrate in fine-grained silica sands were measured. As to the equilibrium data, the pore capillary pressure and saturation of methane hydrate were calculated. The results showed that the phase equilibria of methane hydrates in fine-grained silica sands changed due to the depressed activity of pore water caused by the surface group and negatively charged characteristic of silica particles as well as the capillary pressure in small pores together. The capillary pressure increased with the increase of methane hydrate saturation due to the decrease of the available pore space. However, the capillary-saturation relationship could not yet be described quantitatively because of the stochastic habit of hydrate growth.