软弱结构面水流冲刷形成集中渗漏通道机制研究

软弱结构面塑性程度高、强度低,在地下水长期作用下,很易导致岩体产生变形、形成集中渗漏通道及渗透破坏。软弱结构面的渗透稳定性,一直是水利水电工程的重要工程地质及水文地质问题之一,目前对其渗透破坏机理的认识还存在不少尚未解决的问题。针对已有对基岩软弱结构形成集中渗漏通道研究的不足,本文在软弱结构面内讨论渗透变形问题,主要探讨了软弱结构面受水流冲刷发展的机制,以及土粒起动处于不同位置时的临界流速及相应隙宽。最后介绍了在适当地质等条件下,基岩软弱结构面可形成集中渗漏通道的实例。     

Seismic waves in cracked two-phase anisotropic medium with fourfold rotation symmetry

IntroductionBasedontheresearchresultSofmanyintemalandextemalseismologiSts,mediuminseis-mogeniczonemaybethecrackedinordermediumsaturatedwithfluid(airorwater),namely,two-phaseanisotropicmedium.Inseismicprospecting,oilorgasreservoirrockmayaPproachtothecrackedtwo-phaseanisotropicmediumtoo.Therefore,thefiJrtherstudyonpropagaiontheoryofseismicwavesintWo-phaseanisotropicmediumpossessestheoreticalsignificanceandaPPlicationprospects-Inthispaper,onthebasisofthetheoryofseismicwavesinanuid-sbedporousso…     

提高浅层地震反射静校正精度的一种方法与数值模拟

浅层地震反射法是一种常用的勘探方法.在浅层地震资料处理中,静校正的精度直接影响速度反演的结果和叠加剖面的质量,在地形平缓时,固定基准面静校正可以满足勘探精度的要求,但在复杂地形条件下,其存在较大误差,即使采用浮动基准面,仍会由于地表一致性假设而残余静校正量,不能消除地形起伏引起的影响,为了提高浅层地震反射静校正的精度必须在常规静校正后进行一次剩余静校正,本文给出起伏地形条件下,滑动基准面(过共中心点的水平面即为该共中心点的滑动基准面)的剩余静校正量,该校正量与炮检距、反射层埋深、地层波速以及炮点和接收点高程有关,适用于单一介质和层状介质情况,本文通过对典型地形起伏的3个水平均匀层状介质理论地质模型的速度谱计算和分析,阐明在复杂地形条件下,应用本文提出的剩余静校正方法可以消除地形起伏的影响,提高静校正精度,在此基础上做动校正可以得到高质量的水平叠加剖面.     

A quantitative study of the energy release in the aftershocks of the Bhuj earthquake, 2001, India, using Lg phase

The devastating earthquake on 26 January 2001 at Bhuj, India, resulted in large-scale death and destruction of properties of several million US dollars. The moment magnitude of the earthquake was 7.7 and its maximum focal intensity exceeded X in MM scale. The rate of aftershocks of this earthquake, recorded at Gauribidanur seismic array station (GBA), shows a monotonic decay with time superposed with oscillations. For the Indian continent the Lg phase is a prominent arrival at regional distances. The estimate of Lg amplitude is obtained by optimally fitting the Lg wave train to a exponential decay curve. The logarithm of these amplitudes and logarithm of root mean square (rms) value of actual amplitudes of the Lg are calibrated with USGS m_b to create a local m_bLg magnitude scale. The energy released from these aftershocks is calculated from the rms value of Lg phase. The plot of cumulative energy release with time follows the power law of the form t^p, superposed with oscillations. The exponent of the power law, p, is estimated both by a time-window scanning method and by an interpolation method. The value of p is 0.434 for time-window scanning method and 0.432 for the interpolation method. The predominant periods found in the oscillatory part of the cumulative energy, obtained by differencing the observed from the power law fit, are 10.6, 7.9, 5.4, 4.6 and 3.5 h for time-window scanning method. The corresponding periods for interpolation method are 13.4, 11.5, 7.4, 4.2, 3.5, 2.6 and 2.4 h.     

Identification of soil degradation during earthquake excitations by Bayesian inference

A Bayesian inference approach is introduced to identify soil degradation behaviours at four downhole array sites. The approach of inference is based on a parametric time‐varying infinite impulse response filter model. The approach is shown to be adaptive to the changes of filter parameters and noise amplitudes. Four sites, including the Lotung (Taiwan), Chiba (Japan), Garner Valley (California), and Treasure Island (California) sites with downhole seismic arrays are analysed. Our results show two major types of soil degradation behaviour: the well‐known strain‐dependent softening, and reduction in stiffness that is not instantaneously recoverable. It is also found that both types of soil degradation are more pronounced in sandy soils than in clayey soils. The mechanism for the second type of soil degradation is not yet clear to the authors and suggested to be further studied. Copyright © 2003 John Wiley & Sons, Ltd.     

台阵地震计程控化正弦标定系统设计

为满足台阵地震计标定要求,通过对程控化标定测控仪和标定测控软件的研究,采用一种适用于台阵地震计的程控化正弦标定方法,对中国地震局地球物理勘探中心负责管理的台阵地震计进行标定。台阵地震计标定实验结果显示,采用程控化正弦标定方法,在缩短标定时长、提高标定效率方面具有显著效果。     

Preliminary seismic anisotropy in the upper crust of the south segment of Xiaojiang faults and its tectonic implications

The Xiaojiang faults,striking north-to-south(NS),and the Honghe faults,striking north-to-west(NW),are first-order block boundaries that intersect to form a concentrated stress zone at an acute angle in the southern part of the Sichuan-Yunnan rhombic block(SYB).It is also a crucial zone for material escaping from the Tibetan Plateau(TP)due to the collision between the Indian Plate and the Eurasian Plate.In December 2017,the Institute of Earthquake Forecasting of the China Earthquake Administration(CEA)deployed a linear temporary seismic broadband array,the Honghe-Xiaojiang temporary Seismic Array(HX Array),across first-order block boundaries in the southern SYB.By using the waveform data of small earthquakes recorded by stations in the HX Array across Xiaojiang faults from 2017 to 2019,and by permanent seismic stations of the China National Earthquake Networks from 2012 to 2019,this paper adopts the systematic analysis method of shear-wave splitting(SWS),SAM method,to obtain preliminary results for seismic anisotropy in the upper crust.The study area can be divided into two subzones according to the spatial distribution of the directions of polarization of the fast shear-wave(PFS)at the stations:the northern zone(zone A,where the HX Array is located)and the southern zone(zone B,to the south of the HX Array).The results show that the directions of the PFS at stations in zone A were highly consistent,dominant in the NE direction,correlated with the in-situ principal compressive stress,and were seemingly unaffected by the Xiaojiang faults.The directions of the PFS as recorded at stations in zone B were more complicated,and were dominant in the NS direction parallel to that of the regional principal compressive stress.This suggests the joint influence of complex tectonics and regional stress in this narrow wedge area.By referring to the azimuthal anisotropy derived from seismic ambient noise in the southeast margin of the TP,the NS direction of the PFS in the middle and lower crust,and its EW direction in the upper mantle,this paper concludes that azimuthal anisotropy in the upper crust differed from that in the lower crust in the south segment of Xiaojiang faults,at least beneath the observation area,and azimuthal anisotropy in the crust was different from that in the upper mantle.The results support the pattern of deformation of ductile flow in the lower crust,and the decoupling between the upper and lower crusts as well as that between the crust and the mantle in the study area.The crustal directions of the PFS appeared to be independent of the Xiaojiang faults,suggesting that the influence of the South China block on the SYB passed through the Xiaojiang faults to the Yimen region.The results of this study indicate that anisotropic studies based on data on the dense temporary seismic array can yield clearer tectonic information,and reveal the complex spatial distribution of stress and deformation in the upper crust of the south segment of Xiaojiang faults.     

上海地震台阵的F-K分析

频率－波数（F－K）谱分析是地震台阵数据处理基本方法之一。采用该分析方法，可以从地脉动背景中提取有用的地震信号，提高地震的定位精度。本文列举了F－K功率谱的不同计算方法，并将该方法应用于上海地震台阵所记录的地震事件。对地震和地脉动的F－K分析结果得出，地震的方位角和慢度值分别对记录长度的分布呈线性特征，而地脉动的方位角和慢度值则呈不规则分布。     

台阵和噪声源分布对微动成像的影响及其在盐矿溶腔探测中的应用

随着节点地震仪的发展, 被动源地震成像方法在不同尺度的地下结构成像中得到了越来越广泛的应用.对于小尺度浅地表成像, 因高频噪声源时空分布不均, 一般采用基于台阵平均的方法, 即所谓的微动成像方法提取高频被动源面波频散数据, 但是不同类型的台阵一定程度上也会受到噪声源分布不均匀的影响.本文以水溶型盐矿溶腔探测为例, 通过实测数据较为系统地分析了不同台阵的响应函数及其对噪声源方向不均匀性的适应能力.研究发现, 当噪声源分布不均时, 三角形台阵可以获得更可靠的频散数据, 但对应的数据采集效率较低, 而其他类型的台阵虽然布设相对简便, 但是提取的相速度与真实速度存在较大的误差.当线性台阵和噪声源方位一致时, 可以提取与三角形台阵一致甚至更好的频散数据.在这个基础上, 我们分别采用三角形台阵和考虑噪声源的线性台阵在湘衡盐矿开展了两条剖面的数据采集, 并利用适应性更好的扩展空间自相关方法(ESPAC)计算面波频散数据.最后, 利用蒙特卡洛方法生成的随机初始模型进行了频散数据反演, 获得研究区600 m以浅的横波速度结构, 并刻画了盐溶腔的发育位置和空间分布形态.

     

粘弹性介质中的地震波

给出了三元件的标准线性粘弹性固体在半平面内传播的地震波的解析解，它是由已知的弹性半平面内的解析解迭粘滞性解而得，从而克服了视地壳为二元件粘弹性体的Voigt模型或Maxell模型的缺点。