卫星摄影三线阵CCD影像的EEP法空中三角测量（三）

4 平差方案及模拟数据平差实验4.1 自由网+控制点空中三角测量由前方交会(2.1)式,后方交会(2.2)式以及外方位元素平滑制约条件(2.3)式,可以构成类似经典的光束法空中三角测量,但由于EFP像点坐标是推算出来的,所以控制点不宜直接参与平差过程.于是平差要分成自由网平差及利用控制点作三维线性变换两个步骤.另一方面,卫星摄影中起始角元素大约在±0.5°左右,对于经典空中三角测量,角元素起始近似值均可按零处理.但在EFP平差中,φ角起始值φ0对空中三角测量,像元素起始近似值均可按零处理.在EFP平差中,φ角起始值φ0对整条航线的几何状态影响很大,必须采用特殊的程序预先加以确定.我们采用不断步进φ角值,比较由前方交会及(1.2)式计算的Y视差的均方根值最小者,即作为φ的最佳起始值.平差框图见图4.     

Monitoring of fault healing after the 1999 Kocaeli, Turkey, earthquake

The North Anatolian fault zone that ruptured during the mainshock of theM 7.4 Kocaeli (Izmit) earthquake of 17 August 1999 has beenmonitored using S wave splitting, in order to test a hypothesisproposed by Tadokoro et al. (1999). This idea is based on the observationof the M 7.2 1995 Hyogo-ken Nanbu (Kobe) earthquake, Japan.After the Hyogo-ken Nanbu earthquake, a temporal change was detectedin the direction of faster shear wave polarization in 2–3 years after the mainshock (Tadokoro, 1999). Four seismic stations were installed within andnear the fault zone at Kizanlik where the fault offset was 1.5 m, about80 km to the east of the epicenter of the Kocaeli earthquake. Theobservation period was from August 30 to October 27, 1999. Preliminaryresult shows that the average directions of faster shear wave polarization attwo stations were roughly parallel to the fault strike. We expect that thedirection of faster shear wave polarization will change to the same directionas the regional tectonic stress reflecting fault healing process. We havealready carried out a repeated aftershock observation at the same site in2000 for monitoring the fault healing process.     

A UT1-Like Quantity from Analysis of GPS Orbit Planes

This paper discusses a UT1-like quantity, UTGPS, determined daily from Earth-referenced GPS satellite orbits from the International GPS Service (IGS). For each satellite considered, the observed relation between the satellite's IGS orbit and a model of its orbit plane in inertial space is used to estimate UT1. This modeled orbit plane is initialized using the satellite's IGS orbit and the actual UT1 at an initial time. It is then propagated using standard models of gravitational forces and an empirical model representing the orbit-normal radiation pressure observed during several years of in-flight experience with the satellite. To estimate UT1, an a-priori transformation from terrestrial to true-of-date celestial coordinates is applied to the satellite's IGS orbit. The geocentric angular deviations of points of the resulting transformed orbit from the modeled orbit plane are analyzed, giving the angle between the ascending nodes of the satellite's transformed and modeled orbit planes. To this observed angle between nodes, converted to a UT1 difference, is added the a-priori UT1 value used in the transformation. From the result is subtracted a model of the angle, again converted to a UT1 difference, between the ascending nodes of the actual and modeled orbit planes. The final result is the estimate of UT1 from this satellite, and the median of the UT1 estimates from all satellites considered is UTGPS. The root-mean-square difference between UTGPS-UT1 at the beginning and at the end of an interval of one to four weeks is approximately 30 s times the square root of the interval's duration in weeks.This revised version was published online in October 2005 with corrections to the Cover Date.     

麦兹地区火山沉积岩型铅-锌矿床地质特征与找矿方向

阿尔泰山南缘的铅-锌矿床主要分布于麦兹地区,为了在其找矿空间和找矿类型上有所突破,详细地阐明了麦兹地区铅-锌矿床的主要地质特征、成因类型及其控矿因素,并结合区域构造演化背景,总结了麦兹地区铅-锌矿床的成矿规律,指明了铅-锌矿床的找矿方向。     

视觉测量中相机外参数近似值的快速求解

提出了利用3个不共线的控制点对相机外参数近似值进行快速求解的一种方法.利用3个控制点与其像坐标间的几何关系求得3个控制点在摄站坐标系下的坐标;由控制点的已知控制坐标与求得的摄站坐标系下的坐标,进一步求得两坐标系的转换参数的初值;通过解析法或光束法对相机外参数用初值进行精确标定.并通过一组模拟数据验证了该方法的正确性.     

基于图像方向性信息测度的图像水印技术

数字水印是图像信息版权保护的一种新兴的技术手段,水印的不可感知性和鲁棒性是相互制约的两个对立面.结合人类的视觉系统特性,提出了一个新的图像水印方案——基于图像方向性信息测度的图像水印,在水印嵌入时根据图像块的局部特性,自适应地调整水印的嵌入强度,达到了在鲁棒性和不可感知性之间的较好折衷.最后结合实例说明了算法的实用性.     

视觉测量中相机外参数近似值的快速求解

提出了利用3个不共线的控制点对相机外参数近似值进行快速求解的一种方法。利用3个控制点与其像坐标间的几何关系求得3个控制点在摄站坐标系下的坐标;由控制点的已知控制坐标与求得的摄站坐标系下的坐标,进一步求得两坐标系的转换参数的初值;通过解析法或光束法对相机外参数用初值进行精确标定。并通过一组模拟数据验证了该方法的正确性。     

橄榄石的晶格优选定向、含水量与地震波各向异性:对大陆俯冲带变形环境的约束

橄榄石在不同热动力学条件下形成的晶格优选定向是认识上地幔塑性变形与地震波各向异性的基础。本文通过总结橄榄石的晶格优选定向、含水量与地震波各向异性的研究进展,探讨大陆俯冲带的变形环境。绝大部分天然变形橄榄岩中的橄榄石都发育了[100](010)组构:[100]轴近平行于线理,(010)面平行或近平行于面理,使橄榄岩的最快P波速度近平行于线理,最大S波分裂平行面理并垂直线理。但来自超高压变质带的石榴石橄榄岩可发育[001](100)组构,使橄榄岩的最快P波速度和最小S波分裂方向垂直面理。近年来的变形实验与理论计算表明:超高压和低温是橄榄石组构从[100](010)向[001](100)转变的关键因素,而水对橄榄石流变行为的影响还有待进一步研究。对170个天然橄榄石结构水含量的统计结果表明:橄榄石含水量变化很大(0～170×10~(-6)H_2O),玄武岩中橄榄岩包体的橄榄石比较贫水,而所有富水橄榄石均来自克拉通金伯利岩中的石榴石橄榄岩。因此,除了水在上地幔的不均匀分布,橄榄岩折返过程中氢的扩散会强烈影响橄榄石的含水量。苏鲁芝麻房橄榄岩提供了以超高压、低温、贫流体为特征的大陆俯冲带中[001](100)橄榄石组构的实例。在俯冲的大陆板片中,橄榄石组构在120～220 km从[100](010)向[001](100)的转变可导致地震波各向异性突然降低,而且最快P波速度垂直于俯冲方向。     

利用测日实现快速天文定向

介绍了天文方位角测量原理,给出了实用的计算太阳视位置的方法;研究了在白天恒星无法应用的情况下,利用电子经纬仪测日进行快速天文定向及方位角测量,给出了具体的实施方法及数据解算过程,并对实际测量数据进行了精度分析。     

POS数据辅助的航空影像变化检测方法研究

提出了一种利用机裁定位定向系统（POS）数据辅助航空影像进行影像匹配和变化检测的方法。首先利用带POS数据的老影像解求新影像的外方位元素，然后在老立体影像上提取特征点，根据前方交会和共线条件方程得到新影像上同名点的近似位置，再与新影像进行匹配，寻找匹配不好的点作为变化区域的初始位置。以此为基础选择精检测窗口，进行边缘提取和跟踪，并进行链码匹配，最终确定发生变化的区域。试验证实，本文方法是可行的。