Evaluation of the response modification coefficient and collapse potential of special concentrically braced frames

Special concentrically braced frames (SCBFs) are commonly used for seismic design of buildings. Their large elastic stiffness and strength efficiently sustains the seismic demands during smaller, more frequent earthquakes. During large, infrequent earthquakes, SCBFs exhibit highly nonlinear behavior due to brace buckling and yielding and the inelastic behavior induced by secondary deformation of the framing system. These response modes reduce the system demands relative to an elastic system without supplemental damping using a response modification coefficient, commonly termed the R factor. More recently, procedures put forth in FEMAP695 have been made to quantify the R factor through a formalized procedure that accounts for collapse potential. The primary objective of the research in this paper was to evaluate the approach for SCBFs. An improved model for SCBFs that permits simulation of brace fracture was used to conduct response history analyses. A series of three‐story, nine‐story and 20‐story SCBFs were designed and evaluated. Initially, the FEMAP695 method was conducted to estimate collapse and the corresponding R factor. An alternate procedure for scaling the multiple acceleration records to the seismic design hazard was also evaluated. The results show significant variation between the two methods. Of the three variations of buildings studied, the largest vulnerability was identified for the three‐story building. To achieve a consistent margin of safety against collapse, a significantly lower R factor is required for the low‐rise SCBFs (three‐story), whereas the mid‐rise and high‐rise SCBFs (nine‐story and 20‐story) may continue to use the current value of 6, as provided in ASCE‐07. Copyright © 2013 John Wiley & Sons, Ltd.     

Molecular phylogenetic analysis of sulfate-reducing bacteria from deep sediment layers of the tropical West Pacific warm pool

1IntroductionThe tropical West Pacific warm pool(TWP-WP),which spans an area roughly between10°Nto10°S of the equator from Indonesia to the dateline,has the world’s warmest sea surface temperature ofbeing greater than29℃.With the increase of recog-niz…     

有机蒙脱石层间微结构的分子模拟

采用分子动力学模拟方法,对舍烷基长链阳离子表面活性剂改性有机蒙脱石的层间域内分子环境及烷基长链排列状况进行模拟研究,并考察改性剂负载量与层间域含水量的改变对烷基链排列方式和活动性以及表面活性剂离子中N,C原子的分布状况的影响.1.0倍阳离子交换容量改性的有机蒙脱石在含少量水的情况下(干态),N,C原子均呈双层分布,表明烷基长链为双层平卧排列.含水量的提高(湿态)会导致烷基链从双层分布向在层闻域内均匀分布转变.2.0倍阳离子交换容量改性的有机蒙脱石在舍少量水的情况下(干态),烷基链呈双层倾斜分布于层间域内,烷基链的头部靠近四面体片层.含水量的提高(湿态)对烷基链在层间域内分布状态影响有限,但会导致烷基链整体向层间域中心平面移动,水分子优先占据靠近四面体片层的位置.     

基于18S和ITS-5.8S rDNA基因序列的白色霞水母(Cyanea nozakii)的分子鉴定与检测

采用通用引物PCR扩增法,测定了辽东湾海域的白色霞水母(Cyanea nozakii)螅状体、碟状体及水母体的18S以及ITS-5.8S r DNA序列,同时利用Gene Bank数据库中已有同源序列对其进行序列分析及系统分析。结果显示,白色霞水母3个个体的18S和ITS-5.8S r DNA序列完全一致。白色霞水母样品的ITS-5.8S r DNA序列与Gen Bank中未知真核生物的序列高度相似(≥99%),推测该物种可能是早期发育阶段(卵、浮浪幼虫或碟状体)的白色霞水母样品。霞水母属不同种间18S r DNA序列经比对后同源序列长度为1709bp,多态位点数33个;比对后ITS1同源序列长度为368bp,其中变异位点203个,简约信息位点数178个,单变异位点21个。基于18S r DNA基因序列的霞水母属种内和种间平均遗传距离分别为0、0.008,而基于ITS1序列的霞水母属种内和种间平均遗传距离分别为0.019、0.284。基于ITS1的种间遗传距离是种内遗传距离的15倍,适合于进行物种鉴定。NJ系统树的结果也表明同种的不同个体各自聚枝,其聚类结果大致与形态分类吻合。研究表明,ITS基因片段在霞水母不同种间变异较大,更适于大型水母种类鉴定、检测及属内种间水平的系统进化研究。     

银纳米杆高温熔化断裂弛豫性能的原子级模拟研究

采用分子动力学模拟方法,研究了不同长度银纳米杆在不同温度弛豫过程中的结构演变过程.结果表明:银纳米杆存在一与杆长相关的临界熔断温度,该临界熔断温度随杆长增加而显著降低.当温度大于熔点而小于临界熔断温度时,体系形成一个高度无序的球形团簇,而温度大于临界熔断温度时,体系则熔断成两个球形团簇.并给出了银纳米杆的产生该熔断现象的机理.     

天然磁铁矿化学改性及其在水体除砷中的应用

铁氧化物及其复合氧化物(如菱铁矿、水铁矿)的表面电荷高、比表面积大,在特定条件下对亚砷酸盐和砷酸盐有较强的结合能力和亲和性,以铁氧化物作为吸附剂处理高砷水已经成为研究热点之一。天然磁铁矿的主要成分为Fe_3O_4,但其本身活性较弱,直接应用于处理高砷水的除砷率低。本文对天然磁铁矿采取酸化、碱化、不同温度灼烧、不同灼烧时间等简易的方法进行改性,达到有效去除水中砷的目的。实验结果表明:经0.5 mol/L盐酸浸泡、150℃灼烧10 min的改性磁铁矿分别处理As(Ⅲ)溶液和As(Ⅴ)溶液时,As(Ⅴ)去除率达98%,吸附能力显著增强,达到预期目标;溶液中As(Ⅲ)浓度从1000μg/L下降到250μg/L,去除率达75%,即As吸附能力明显优于未改性的天然磁铁矿,与其他改性铁矿除砷能力相近,而改性方法更加简便、易行。本文研究的改性天然磁铁矿吸附剂为控制高砷水的砷含量提供了一种切实可用的吸附材料。     

原子掺杂对单元材料结晶能力的影响

2009年我们建立了一个凝结势模型用以预测材料形成单晶体的能力,表明单元体材料(Ni,Al,Cu,Ar,Mg)的结晶能力随凝结势的增大而单调增强.本文将凝结势模型应用于二元材料体系,并结合分子动力学模拟研究了6% Al原子掺杂对于Ni单晶材料结晶能力的影响.模拟结果发现,Al元素的掺杂会大大减弱Ni单晶的结晶能力,在此基础上提出了二元材料体系凝结势的定义,表明凝结势模型可广泛应用于预测二元体材料的结晶能力.     

利用屏幕截取技术制作人降作业炮点环境示意图

介绍利用屏幕截取技术制作人降作业炮点四周环境坐标示意图的方法。     

不同云天条件下水汽含量特征及其变化分析

大气中水汽含量的探测，是人工影响天气的基础条件之一，我们利用2002年6月18日到28日期问，安徽屯溪站的GPS水汽监测数据分析了该站出现不同云天条件下的水汽含量的特征，提出了适合人工影响天气作业的云天条件。以及分析该时段内水汽含量时间变化序列，发现发生降水前，水汽含量会有一个跃变，一般会达到60mm以上，这是实施人工增雨作业的最佳时问。     

Ice in the Southern Coalsack

To better understand the conditions under which ice mantles form on grains in molecular clouds, three globules in the Southern Coalsack have been searched for the presence of H₂O ice. Given the total lack of star formation in the Coalsack, it is an ideal site for studying unprocessed icy molecular mantles. In our sample of eight field stars lying behind the Coalsack we detect strong H₂O ice absorption in the lines of sight to two stars and possible weak absorption in four others. We estimate H₂O ice column densities or upper limits for these lines of sight. Compared to dark clouds such as Taurus, the Coalsack H₂O ice column densities are lower than expected given the quiescent nature of the Coalsack region. It is possible that the chemical evolution of the Coalsack may simply be at too early a stage for significant ice mantles to appear on the grains, except perhaps in the densest parts of some of the globules. Alternatively, the presence or absence of ice absorption may be related to the distribution of dust along each line of sight, specifically, the relative contributions of dense globules and a more extended diffuse component. For example, our observations are consistent with an ice threshold extinction similar to that observed in the Taurus dark cloud if extinction amounting to   A _V∼5  towards Globules 2 and 3 arises in the extended component. Globule 1 appears to have no extended component.