腾冲地热水化学特征及腐蚀机理探讨

本文从腾冲地热成因的角度,分析其地热水化学的总体特征和赋存规律。在此基础上对地热水ｐＨ值、流速、溶解氧、ＣＯ２及Ｃｌ＾－、ＳＯ４＾２－、ＳｉＯ３＾２－、Ｃａ＾２等对金属材料的腐蚀机理进行讨论。     

济南典型地区地基土污染腐蚀性质变异研究

随着城市化进程加快,济南市面临日益严重的环境岩土工程问题。以济南市典型地区的地基土为研究对象,在室内开展了水-土化学作用的物理力学效应实验,在现场对已经污染腐蚀的地基原状土样进行了物理力学性质实验。结果表明,地基土腐蚀后其物理力学性质有显著地变化。遭受污染腐蚀的地基土和无腐蚀的地基土相比,前者液塑限和压缩模量减小,液性指数和压缩系数增大。     

鄂尔多斯盆地周边地区野外溶蚀试验结果讨论

2003到2004年,在国土资源部地质调查项目“鄂尔多斯盆地地下水勘查”工作中,作者在鄂尔多斯盆地周边地区建立了8个野外溶蚀试验站,采用不同岩石的600多枚试片开展了为期1年的野外溶蚀试验观测。通过试验并结合前人的野外溶蚀试验成果分析,得出了如下几个重要的结论: ( 1)试验区灰岩较白云岩的溶蚀量大20%以上; ( 2)与我国南方的试验结果相反,即北方土下碳酸盐岩样品溶蚀量远远小于地上样品的溶蚀量; ( 3)从华北到西北存在一个碳酸盐岩样品由溶蚀变为沉淀的地带;同理,从我国北方碳酸盐岩样品土下溶蚀量小于地上溶蚀量到南方土下溶蚀量大于地上溶蚀量区域变化过程中,又存在土下与地上溶蚀量接近的地带,这两个地带是控制我国现代岩溶作用机制的重要分界线,对岩溶地貌的发育与演化研究具有重要意义。      

氧化铬对铝型材厂碱蚀渣制备铝方柱石材料结构的影响

利用铝型材厂碱蚀渣为主要原料,采用二步煅烧工艺制备铝方柱石材料。探索二次煅烧温度对铝型材厂碱蚀渣制备铝方柱石材料相组成、结晶度、微观结构的影响,进而研究氧化铬对铝方柱石材料相组成、微观结构的影响。采用同步热分析、X射线衍射、扫描电镜及相关分析软件表征制备的铝方柱石材料的相组成和显微结构。结果表明：铝型材厂碱蚀渣中有大量可烧失成分,物料需要进行致密化处理,再经过1500℃煅烧后的铝方柱石材料结构中具有明显的铝方柱石条柱状结构,结晶度增大,铝方柱石相对含量达到91%。随着氧化铬加入量增加,结构中的铝铬酸钙相增加。当氧化铬加入量为2%时,试样中结晶相的结晶度最高,形成条柱状铝方柱石相与立方状铝铬酸钙相共存的结构。当氧化铬加入量4%时,试样中铝方柱石相几乎消失,结晶度降低。     

EH36钢在黄海的初期腐蚀速率的空间变异特征的地统计分析

以黄海海域为研究区,通过动电位极化曲线法获取了出海实测的EH36钢材在2017年8月及12月黄海43个站位的初期腐蚀速率的数据,并以地统计学方法对数据进行分析,探索研究区内EH36钢材的腐蚀速率的空间分布及其变异特征,绘制初期腐蚀速率预测图。结果表明:初期腐蚀速率的分布状况在夏季、冬季呈现不同的特征,夏季分布呈现近岸低、远岸高,中心高、周围低的特点,冬季分布呈现中心及东南部分低、周围高的特征。同时,统计分析表明, EH36钢在黄海的平均初期腐蚀速率,夏季为0.11 mm/a,冬季为0.25 mm/a,并且在夏季和冬季里, EH36钢在黄海初期腐蚀速率分布的空间变异特征明显,空间自相关性强,其中8月的块金值/基台值为0.062,12月的块金值/基台值为0.138,变程在100 km左右。     

渭北区块煤层气井抽油杆腐蚀影响因素

为明确鄂尔多斯盆地东缘渭北区块H矿区煤层气井腐蚀影响因素,以抽油杆为研究对象,通过对实际开采过程中产出气、采出水、抽油杆表面腐蚀产物成分和抽油杆质量损失检测分析,总结了抽油杆腐蚀类型和腐蚀强度,并对比分析了不同排采阶段、开发层系和采出液矿化度对抽油杆腐蚀的影响。研究结果表明：渭北区块煤层气井抽油杆主要受到CO₂和H₂S的腐蚀,其来源主要为5号煤和11号煤。在初期排水阶段抽油杆腐蚀程度低,主要是由少量CO₂溶解气引起;憋套压和产气之后,抽油杆受到产出的酸性气体CO₂和H₂S的共同腐蚀作用,且腐蚀不断增强;同时地层水矿化程度对抽油杆腐蚀有明显的促进作用。由于腐蚀影响因素复杂且强度不断变化,因此,对抽油杆表面进行包覆或涂上防腐层是直接有效的防腐手段。     

大庆长垣以西地区扶余油层次生孔隙预测

为了在普遍低孔、低渗的背景下寻找次生孔隙发育的储层,在次生孔隙形成机制分析和储层成岩作用研究的基础上,结合考虑影响次生孔隙形成的多种因素,对大庆长垣以西地区扶余油层次生孔隙发育区进行预测。研究表明,该地区次生孔隙的形成主要受青山口组下排有机酸和碳酸的影响,且受到断层的控制和超压的影响,次生孔隙主要分布在齐家地区和龙虎泡阶地等凹陷周边区域,在西部斜坡区亦发育由大气水淋滤所形成的次生孔隙。在次生孔隙发育区,若发育岩性圈闭或构造圈闭,则为有利的油气聚集场所。      

Testing a spatially distributed tracer‐aided runoff model in a snow‐influenced catchment: Effects of multicriteria calibration on streamwater ages

Integrating stable isotope tracers into rainfall‐runoff models allows investigation of water partitioning and direct estimation of travel times and water ages. Tracer data have valuable information content that can be used to constrain models and, in integration with hydrometric observations, test the conceptualization of catchment processes in model structure and parameterization. There is great potential in using tracer‐aided modelling in snow‐influenced catchments to improve understanding of these catchments' dynamics and sensitivity to environmental change. We used the spatially distributed tracer‐aided rainfall‐runoff (STARR) model to simulate the interactions between water storage, flux, and isotope dynamics in a snow‐influenced, long‐term monitored catchment in Ontario, Canada. Multiple realizations of the model were achieved using a combination of single and multiple objectives as calibration targets. Although good simulations of hydrometric targets such as discharge and snow water equivalent could be achieved by local calibration alone, adequate capture of the stream isotope dynamics was predicated on the inclusion of isotope data in the calibration. Parameter sensitivity was highest, and most local, for single calibration targets. With multiple calibration targets, key sensitive parameters were still identifiable in snow and runoff generation routines. Water ages derived from flux tracking subroutines in the model indicated a catchment where runoff is dominated by younger waters, particularly during spring snowmelt. However, resulting water ages were most sensitive to the partitioning of runoff sources from soil and groundwater sources, which was most realistically achieved when isotopes were included in the calibration. Given the paucity of studies where hydrological models explicitly incorporate tracers in snow‐influenced regions, this study using STARR is an important contribution to satisfactorily simulating snowpack dynamics and runoff generation processes, while simultaneously capturing stable isotope variability in snow‐influenced catchments.     

Geochemistry of rare earth elements in a marine influenced coal and its organic solvent extracts from the Antaibao mining district, Shanxi, China

Twenty-six samples including roof, bottom and coal plies of a marine influenced coal bed were collected from the Antaibao mining district, Shanxi, China. The rare earth elements (REEs) were determined in solids and organic solvent extracts. The distribution pattern showed three distinct patterns: shale-like, LREE-rich and HREE-rich. This is attributed to the variable microenvironment of peat-forming swamp, the degree of marine influences and different REE sources. REEs in the coal are mainly controlled by detrital minerals but also affected by seawater. The chondrite-normalized REE patterns of the organic solvent extracts are distinctly different from those of corresponding original coal samples, which show a negative Eu anomaly, a depletion of middle REEs and an enrichment of HREEs. The LREEs in coal extracts are likely adsorbed by hydrogen-containing functional groups, and HREEs are likely bonded to carbon atoms.     

Mg2B2O5晶须增强AZ91D镁基复合材料在Cl-溶液中腐蚀行为*

用电化学方法测量了Mg_2B_2O_5晶须增强AZ91D镁基复合材料在3.5%NaCl溶液中的开路电位、动电位极化曲线和交流阻抗,研究了晶须体积分数对镁合金基体耐腐蚀性能的影响,并利用SEM和XRD表征了腐蚀后复合材料表面的微观形貌和相组成。结果表明,随着Mg_2B_2O_5晶须体积分数的增加,AZ91D镁基复合材料的耐腐蚀性逐渐提高。当硼酸镁晶须的体积分数为35%时,材料的自腐蚀电位提高0.2V以上,自腐蚀流密度降低了1个数量级;SEM测试表明,复合材料表面生成了一层晶须增韧的腐蚀钝化膜,对基体起到保护作用。