动力定位系统与单波束测深仪在科考船定点作业中的应用

科考船定点作业时会受到海洋风、涌、浪、流等外界环境因素影响，导致工作效率降低，原位测量精度下降，甚至影响作业安全。动力定位系统 （DP） 具有自动定位功能，能够抵抗外界环境因素的影响，可实现科考船高精度定点控位。 单波束测深仪不仅可以测量水深，也可反映水下设备深度信息，可以起到辅助监控水下设备功能。本文在介绍定点作业施工现状与局限性的基础上，分析 DP 系统与单波束测深仪工作原理，以“向阳红 01”船为载体，在定点作业时开启 DP 系统与单波束测深仪，发现该方法可以提高科考船定点作业工作效率、原位测量精度并保障作业安全，可为其他科考船定点作业提供参考。     

南黄海及相邻陆区松散沉积层磁性地层的研究

本文通过研究区5个钻孔松散沉积岩心磁性地层的划分对比,获知布容与松山极性带的界线,南黄海和陆区北部位于80.0—99.5m。陆区的南部此界线于270.4m深处。松山和高斯极性带的界线,海区未揭露到,其沉积起始时间都小于1.7Ma。而陆区的南、北部分别位于117m和328.2m。高斯和吉尔伯特极性带的界线,陆区北部为140m,而南部区为460.15m。沉积起始时间为3.4Ma。吉尔伯特底界仅北部陆区所揭示,为190.5m。松散沉积层与下伏白垩纪(?)石灰岩接触面位于400.35m,沉积起始时间约17.0Ma。     

Comparison of Strain-rate Dependent Stress-Strain Behavior from Ko-consolidated Compression and Extension Tests on Natural Hong Kong Marine Deposits

This article presents results from a series of K_o-consolidated compression and extension triaxial tests on specimens from undisturbed samples of Hong Kong Marine Deposits (HKMD). To investigate the strain-rate effects, a total of seven K_o-consolidated triaxial tests were conducted including four compression tests and three extension tests. After K_o-consolidation, the triaxial test specimens were sheared at step-changed axial strain rates under three different confining pressures of 50 kPa, 150 kPa, and 400 kPa, respectively. The step-changed strain rates were applied in the following order: +2%/h, +0.2%/h, +20%/h, -2%/h (unloading) and +2%/h (reloading) for the four compression tests and -2%/h, -0.2%/h, -20%/h, +2%/h (unloading) and -2%/h (reloading) for the three extension tests. The results are reported and analyzed in the paper. The results show that the strain rate effects, the stress-strain characteristics, and the effective stress paths of the specimens for tests in a compression state are different from those for tests in an extension stage. One order of magnitude increase in axial strain rate causes an average 8.6% increase in undrained shear strength for compression tests and a 12.1% increase for extension tests. It is also found that the failure mode of the specimens in compression is different from that in extension. The stress-strain behavior of specimens shows strain-softening and a clear shear band in compression tests, but strain-hardening without any clear shear band in extension tests for the same absolute value of axial strain.     

黄海海域陆相中生界油气远景

黄海海域油气勘探已40余载，尚未实现油气突破，其找油前景引起石油地质学家的极大关注。根据前人的认识和最新研究成果，结合邻区油气地化资料，探讨了黄海海域中生界地层生、储、盖特征，特别是白垩系，它分布广，厚度大，烃源岩达到较好生油岩标准，并且生、储、盖组合理想，中生界是该区下部油气勘探首选目标。     

Application of Microbial BOD Sensors in Marine Monitoring

A strain of yeast, which can endure high osmotic pressure, is employed for the sensitive material of the microbial BOD sensor. Two immobilization methods are used, I.e. Calcium alginate gel be ads and PV A gel beads. The results show that the PVA gel beads is better. The influences of osmosis and heavy metal ions on the yeast entrapped in the PVA gel beads are also studied in the experiment.     

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

1999年以来台湾及邻近海域7.5级以上强震前的条带现象

中国台湾地区地处欧亚板块与菲律宾海板块之间,地震活动频繁．本文报道了 我国台湾地区及其邻近海域1985～2002年间5．5级以上地震的条带内外频度比分 布,并着重研究了1999—2002年中发生的3次7．5级以上地震前的条带现象．其结 果表明:台湾地区近期发生的3次7．5级以上大地震前,5．5级以上地震呈条带分 布．这些条带符合条带内地震个数Nin≥6的条件,符合条带内、外频度比Nin／(Nin Nout)≥75％的条件,也符合条带长宽比大于5的要求,只是与板内地震条带相比,条 带的长度较短．