关于修改港工钢筋混凝土规范小偏心受压构件正截面强度计算的建议

本文提出在小偏心受压构件正截面强度计算中，取消弯曲抗压强度ｆｃｍ（Ｒｗ），采用轴心抗压强度ｆｃ，这与构件的实际破坏形态相符。对小偏心受压构件正截面强度计算提出了设计建议。特别是对工程上大量应用的矩形截面对称配筋小偏压构件提示了简捷的设计方法，与以往的近似计算方法相比具有物理概念明确，精度高，方法简捷的特点。     

基于规则波波形的超声波非接触测量有关问题探讨

波浪波形的非接触测量近年来获得广泛的应用。本文以规则波为讨论对象，针对介质为空气的超声波测量方式进行波形测量误差分析，并结合实验室和实船试验进行对比分析。理论分析表明：在规则波取为坦谷波和ＳＴＯＫＥＳ波的前提下，超声波技术几乎产生相同的最大误差。定量分析表明，在对测量精度限制的条件下，对文中提及的各项参数应作有效的控制     

Calculation of transverse hydrodynamic coefficients using computational fluid dynamic approach

Computational Fluid Dynamic (CFD) based on Reynolds Averaged Navier–Stokes equation is used for determining the transverse hydrodynamic damping force and moment coefficients that are needed in the maneuverability study of marine vehicles. Computations are performed for two geometrical shapes representing typical AUVs presently in use. Results are compared with available data on similar geometries and from some of the available semi-empirical relations. It is found that the CFD predictions compares reasonable well with these results. In particular, the CFD predictions of forces and moments are found to be nonlinear with respect to the transverse velocity, and therefore both linear and nonlinear coefficients can be derived. A discussion on the sources of the component forces reveal that the total force and moment variations should in fact be nonlinear.     

Three-dimensional inversion of marine magnetic anomalies: Implications for crustal accretion along the Mid-Atlantic Ridge (28°–31°30′ N)

We present magnetic field data collected over the Mid-Atlantic Ridge in the vicinity of the Atlantis Fracture Zone and extending out to 10 Ma-old lithosphere. We calculated a magnetization distribution which accounts for the observed magnetic field by performing a three-dimensional inversion in the presence of bathymetry. Our results show the well-developed pattern of magnetic reversals over our study area. We observe a sharp decay in magnetization from the axis out to older lithosphere and we attribute this decay to progressive low temperature oxidation of basalt. In crust which is 10 Ma, we observe an abrupt increase in magnetic field intensity which could be due to an increase in the intensity of magnetization or thickness of the magnetic source layer. We demonstrate that because the reversal epoch was of unusually long duration, a two-layer model comprised of a shallow extrusive layer and a deeper intrusive layer with sloping polarity boundaries can account for the increase in the amplitude of anomaly 5. South of the Atlantis Fracture Zone, high magnetization is correlated with bathymethic troughts at segment end points and lower magnetization is associated with bathymetric highs at segment midpoints. This pattern can be explained by a relative thinning of the magnetic source layer toward the midpoint of the segment. Thickening of the source layer at segment endpoints due to alteration of lower oceanic crust could also cause this pattern. Because we do not observe this pattern north of the fracture zone, we suggest it is a result of the nature of crustal formation process where mantle upwelling is focused. South of the fracture zone, reversals along discontinuity traces only continue to crust 2 Ma old. In crust >2 Ma, we observe bands of high, positive magnetization along discontinuity traces. We suggest that within the discontinuity traces, a high, induced component of magnetization is produced by serpentinized lower crust/upper mantle and this masks the contribution of basalts to the magnetic anomaly signal.     

Evaluation of bending moments and shear forces at unit connections of very large floating structures using hydroelastic and rigid body analyses

This paper investigates the characteristics of bending moments, shear forces and stresses at unit connections of very large floating structures (VLFS) under wave loads. The responses of VLFS are calculated by solving multi-body motion equation considering hydroelasticity and connection stiffness. Hydroelastic responses are calculated by the direct method. Higher-order boundary element method (HOBEM) is used for fluid analysis and finite element method (FEM) is introduced for structural analysis. The equation of motion is modified to describe the unit connections by employing spring elements. Bending moments and shear forces at the connections are obtained from the dynamic equilibrium condition for pressures and inertia forces. Two types of VLFS units such as tandem arranged units and side-by-side arranged units are considered in the numerical examples. The influences of connection stiffness, wave frequency and heading angle on responses of VLFS are investigated through the numerical examples. Rigid body analysis along with hydroelastic analysis is also carried out in the numerical analysis and comparison of those two approaches is discussed.     

Strength Analysis of Turret Mooring Productive/Storage Tanker

The longitudinal strength of turret mooring productive/storage tanker is studied.A numeri-cal example has been implemented according to the method presented in this paper to give practical il-lustration.From the results of the numerical example,it is concluded that the turret hole located near theforward of the amidships has small effect on the longitudinal strength of the ship hull.As for design ex-treme value of wave bending moment of storage tanker,statistic method is a more reasonablemethodology,especially with the consideration of the servere environmental conditions.The primary esti-mation of design section modulus of turret storage tanker can be determined by this design bending mo-ment.     

Field measurements and monitoring of wastewater discharge in sea water

This paper reports a study of the field measurements and monitoring of wastewater discharge in sea water at Bari East (Italy). A wastewater sea outfall system is an integral and fundamental part of each wastewater treatment with ultimate sink in the sea water. The design of a water treatment plant and wastewater outfall must take into account the use of the environmental water, the values of physicochemical parameters to be respected in order to safeguard the use itself and the quality of the environmental water where wastewater is issued. In the present study measurements of sea current velocity components were carried out with a VM-ADP (Vessel-Mounted Acoustic Doppler Profiler). Salinity, wind directions and velocities were assessed with, for one survey, the total faecal coliforms and other biochemical parameters. It was emphasized that the measurements necessary for monitoring cannot be concentrated in the wastewater outfall pipe zone only, but should be extended to a neighbouring area of the outfall pipe, with an extension depending on the wastewater discharge, the polluting charge and the magnitude of the sea currents and the winds typical of the zone of interest. The analyses presented in this paper confirm that the sea zones close to the wastewater outfall pipe are particularly sensitive and vulnerable. Such results must be considered in the planning of a wastewater outfall pipe.     

动态基准实时测量系统的开发与应用

介绍了动态基准实时测量系统的硬件组成、站点上全站仪棱镜组合安装与检测方法、系统软件的开发及特点，最后对系统在广州地铁某地铁站结构变形自动监测中的应用情况进行了阐述。通过实际应用表明该系统能应用在自动化、高精度的变形监测领域。     

南沙群岛海域水体漫衰减系数Kd(490)的特性研究

对南沙群岛海区水体Kd(490）的特性进行了深入分析和探讨,研究结果表明：Kd（490）的垂直分布与同步测量的海水叶绿素a浓度的垂直分布有很强的相关性;Kd（490）的垂直分布反映出该区域海水存在较强的分层现象,研究中还发现上行辐亮度漫衰减系数KL（490）与Kd（490）垂直变化趋势相当一致,但是以二者达到最大值的深度为界,上层水体的KL（490）值稍大于Kd(490）值,在这一深度以下则相反。     

Magnetic anomalies in the canary basin and the Mesozoic evolution of the central North Atlantic

The data from a recent magnetic compilation by Verhoefet al. (1991) off west Africa were used in combination with data in the western Atlantic to review the Mesozoic plate kinematic evolution of the central North Atlantic. The magnetic profile data were analyzed to identify the M-series sea floor spreading anomalies on the African plate. Oceanic fracture zones were identified from magnetic anomalies and seismic and gravity measurements. The identified sea floor spreading anomalies on the African plate were combined with those on the North American plate to calculate reconstruction poles for this part of the central Atlantic. The total separation poles derived in this paper describe a smooth curve, suggesting that the motion of the pole through time was continuous. Although the new sea floor spreading history differs only slightly from the one presented by Klitgord and Schouten (1986), it predicts smoother flowlines. On the other hand, the sea floor spreading history as depicted by the flowlines for the eastern central Atlantic deviates substantially from that of Sundvik and Larson (1988). A revised spreading history is also presented for the Cretaceous Magnetic Quiet Zone, where large changes in spreading direction occurred, that can not be resolved when fitting magnetic isochrons only, but which are evident from fracture zone traces and directions of sea floor spreading topography.Deceased 11 November 1991