Cross-shore variation of long-term average longshore current velocity in the nearshore zone

The cross-shore variation of long-term average longshore current velocity was investigated on the basis of a 15-year data set of longshore current, wave and wind. The longshore current velocities were measured once a day along a 427-m-long pier. The results show that the direction of the long-term average longshore current velocity away (>200 m) from the shore was the opposite to that near the shore. The southward current was dominant offshore, whereas the northward current was dominant near the shore. The cross-shore variation of the long-term average longshore current velocity was formed owing to a difference between the wave and wind conditions when the northward and southward currents developed. When the northward current developed, the offshore wave height was relatively small and the frequency of the southward wind velocity was almost equal to that of the northward one. As a result, the northward current developed only near the shore and decayed outside the narrow surf zone. On the other hand, when the southward current developed, the offshore wave height was relatively large and the southward wind velocity was predominant, which resulted in the southward current developing not only in the wide surf zone but also outside the surf zone. The superposition of the two cross-shore variations produced a cross-shore variation of the long-term average longshore current velocity with a northward velocity near the shore and a southward velocity away from the shore.     

The Holocene Secche di Lazzaro phreatomagmatic succession (Stromboli,Italy): evidence of pyroclastic density current origin deduced by facies analysis and AMS flow directions

The edifice of Stromboli volcano gravitationally collapsed several times during its volcanic history (>100 ka–present). The largest Holocene event occurred during the final stage of the Neostromboli activity (∼13–5 ka), and was accompanied by the emplacement of phreatomagmatic and lahar deposits, known as the Secche di Lazzaro succession. A stratigraphic and paleomagnetic study of the Secche di Lazzaro deposits allows the interpretation of the emplacement and the eruptive processes. We identify three main units within the succession that correspond to changing eruption conditions. The lower unit (UA) consists of accretionary lapilli-rich, thinly bedded, parallel- to cross-stratified ash deposits, interpreted to indicate the early stages of the eruption and emplacement of dilute pyroclastic density currents. Upward, the second unit (UB) of the deposit is more massive and the beds thicker, indicating an increase in the sedimentation rate from pyroclastic density currents. The upper unit (UC) caps the succession with thick, immediately post-eruptive lahars, which reworked ash deposited on the volcano’s slope. Flow directions obtained by Anisotropy of Magnetic Susceptibility (AMS) analysis of the basal bed of UA at the type locality suggest a provenance of pyroclastic currents from the sea. This is interpreted to be related to the initial base-surges associated with water–magma interaction that occurred immediately after the lateral collapse, which wrapped around the shoulder of the sector collapse scar. Upward in the stratigraphy (upper beds of UA and UB) paleoflow directions change and show a provenance from the summit vent, probably related to the multiple collapses of a vertical, pulsatory eruptive column.     

Major and trace element geochemistry of neutral and acidic thermal springs at El Chichón volcano,Mexico: Implications for monitoring of the volcanic activity

Four groups of thermal springs with temperatures from 50 to 80 °C are located on the S–SW–W slopes of El Chichón volcano, a composite dome-tephra edifice, which exploded in 1982 with a 1 km wide, 160 m deep crater left. Very dynamic thermal activity inside the crater (variations in chemistry and migration of pools and fumaroles, drastic changes in the crater lake volume and chemistry) contrasts with the stable behavior of the flank hot springs during the time of observations (1974–2005). All known groups of hot springs are located on the contact of the basement and volcanic edifice, and only on the W–SW–S slopes of the volcano at almost same elevations 600–650 m asl and less than 3 km of direct distance from the crater. Three groups of near-neutral (pH ≈ 6) springs at SW–S slopes have the total thermal water outflow rate higher than 300 l/s and are similar in composition. The fourth and farthest group on the western slope discharges acidic (pH ≈ 2) saline (10 g/kg of Cl) water with a much lower outflow rate (< 10 l/s).     

人工洞室上直流电阻率法视电阻率的异常特征

直流电阻率法装置种类较多,根据实际地质条件选用不同的装置类型,通过对探测结果进行综合对比分析,可全面地反映地下洞室赋存状态.通过对一地下人工洞室进行多种装置类型直流电阻率法勘查,综合分析了各种装置类型探测结果的视电阻率异常特征,并论述了直流电阻率法探测地下人工洞室的有效性.     

The Polar Cap (PC) indices: Relations to solar wind parameters and global magnetic activity

The polar geomagnetic activity resulting from solar wind–magnetosphere interactions can be characterized the Polar Cap (PC) indices, PCN and PCS. PC index values are derived from polar magnetic variations calibrated on a statistical basis such that the index approximate values in units of mV/m of the interplanetary “geo-effective” (or “merging”) electric field (E_M) conveyed by the solar wind. The timing and amplitude relations of the PC index to solar wind plasma and magnetic field parameters are reported. The solar wind effects are parameterized in terms of the geo-effective electric field (E_M) and the dynamical pressure (P_DYN). The PC index has a delayed and damped response to E_M variations and display saturation-like effects for E_M values exceeding 10 mV/m. Steady or slowly varying levels of solar wind dynamical pressure have little or no impact on the PC index above the effects related to E_M for which the solar wind velocity is also a factor. Sharp increases in the dynamical pressure generate impulsive variations in the PC index comprising a initial negative impulse of 5–10 min duration followed by a positive impulse lasting 10–20 min. Typical amplitudes of both the negative and the positive impulses are 0.2–0.5 units. A sharp decrease in the pressure produces the inverse sequence of pulses in the PC index. Auroral substorm activity represented by the AL index level has a marked influence on the average PC/E_M level at the transition from very quiet (AL0 nT) to disturbed conditions while more or less disturbed conditions (AL<−100 nT) have no systematic effect on the average PC/E_M values. At distinct substorm events the PC/E_M ratio has a minimum (0.8) in the pre-onset phase at around 20 min before substorm onset. The average ratio gradually increases in the expansion phase to reach a maximum value (1.1) at around 40 min after substorm onset (or 20 min after the largest (negative) peak in AL). At substorm recovery during the next 2 h the PC/E_M ratio decreases. Finally, we report on the application of polar magnetic variations to model the disturbance storm time (Dst) index development during magnetic storms by using the PC index as a source function to quantify the energy input to the ring current representing accumulated storm energy and characterized by the Dst index.     

西台吉乃尔盐湖矿区地下卤水钾、镁、锂、硼的时空变化特征

分析了西台吉乃尔盐湖矿区地下卤水中K、Mg、B2O3、Li等4种组分的时空变化特征。结果表明,它们在矿区西北部表现出明显的高值且基本不随时间而变化,这很可能与该区域原始卤水成分有关。由于地表水对地下卤水的淡化作用,这些组分在南部或西南部表现为低值。观测时段的中后期,四种组分的变化较显著,显示出采卤活动对其变化产生了影响。B2O3的高值区主要呈N-W-SE向带状分布,这似乎与该地区的构造背景密切相关。     

吉兰泰盐湖卤水化学动态变化的灰色—马尔科夫过程预测分析

卤水中的化学成分因受多种因素影响,使其在时间序列上的变化波动强烈而规律难循。灰色—马尔科夫过程预测是预测事物在时间序列上发展趋势的一种良好有效的统计分析手段,它将灰色系统预测法和马尔科夫过程预测法有效结合,既弥补了两种方法各自的缺点,又能充分考虑数据给予的信息,可以大大提高随机波动较大数据序列的预测精度。本文用灰色—马尔科夫过程预测法对吉兰泰盐湖卤水中几种主要离子浓度的变化进行了趋势分析,分析结果发现几种离子浓度的变化均有一定的规律性,而且这些离子在预测数据的变化规律同原始实测数据变化规律有很好的一致性。     

Sedimentary pellets as an ice-cover proxy in a High Arctic ice-covered lake

Sediment aggregates (“sedimentary pellets”) within the sedimentary record of Lake A (83°00′ N, 75°30′ W), Ellesmere Island, Canada, are used to construct a 1000 year proxy record of ice-cover extent and dynamics on this perennially ice-covered, High Arctic lake. These pellets are interpreted to form during fall or early winter when littoral sediment adheres to ice forming around the lake’s periphery or during summer through the development of anchor ice. The sediment likely collects in ice interstices and is concentrated in the upper ice layers through summer surface ice melt and winter basal ice growth. The pellets remain frozen in the ice until a summer or series of summers with reduced ice cover allows for their deposition across the lake basin. Sedimentary pellet frequency within multiple sediment cores is used to develop a chronology of ice-cover fluctuations. This proxy ice-cover record is largely corroborated by a record of unusual sedimentation in Lake A involving iron-rich, dark-orange to red laminae overlying more diffuse laminae with a lighter hue. This sediment sequence is hypothesized to represent years with reduced ice cover through increased chemocline ventilation and iron deposition. During the past millennium, the most notable period of inferred reduced ice cover is ca. 1891 AD to present. Another period of ice cover mobility is suggested ca. 1582–1774 AD, while persistent ice cover is inferred during the 1800s and prior to 1582 AD. The proxy ice-cover record corresponds well with most regional melt-season proxy temperature and paleoecological records, especially during the 1800s and 1900s.

The role of iron and sulfur in the visual appearance of lake sediment varves

Easily discernible sediment varves (annual laminations) may be formed in temperate zone lakes, and reflect seasonal changes in the composition of the accumulating material derived from the lake and its catchment (minerogenic and organic material). The appearance of varves may also be influenced by chemical processes. We assessed the role of iron (Fe) and sulfur (S) in the appearance of varves in sediments from Lake Nylandssjön in northern Sweden. We surveyed Fe in the lake water and established whether there is internal transport of Fe within the sediment. We used a unique collection of seven stored freeze cores of varved sediment from the lake, collected from 1979 to 2004. This suite of cores made it possible to follow long-term changes in Fe and S in the sediment caused by processes that occur in the lake bottom when the sediment is ageing. We compared Fe and S concentrations using X-ray fluorescence spectroscopy (XRF) in specific years in the different cores. No diagenetic front was found in the sediment and the data do not suggest that there is substantial vertical transport of Fe and S in the sediment. We also modeled Fe and S based on thermodynamic, limnological, and sediment data from the lake. The model was limited to the five components H⁺, e^?, Fe³⁺, SO₄ ^2?, H₂CO₃ and included the formation of solid phases such as Fe(OH)₃ (amorphous), FeOOH (aged, microcrystalline), FeS and FeCO₃. Modeling showed that there are pe (redox) ranges within which either FeS or Fe(OH)₃/FeOOH is the only solid phase present and there are pe ranges within which the two solid phases co-exist, which supports the hypothesis that blackish and grey-brownish layers that occur in the varves were formed at the time of deposition. This creates new possibilities for deciphering high-temporal-resolution environmental information from varves.