Neuro‐control of seismically excited steel structure through sensitivity evaluation scheme

The neuro‐controller training algorithm based on cost function is applied to a multi‐degree‐of‐freedom system; and a sensitivity evaluation algorithm replacing the emulator neural network is proposed. In conventional methods, the emulator neural network is used to evaluate the sensitivity of structural response to the control signal. To use the emulator, it should be trained to predict the dynamic response of the structure. Much of the time is usually spent on training of the emulator. In the proposed algorithm, however, it takes only one sampling time to obtain the sensitivity. Therefore, training time for the emulator is eliminated. As a result, only one neural network is used for the neuro‐control system. In the numerical example, the three‐storey building structure with linear and non‐linear stiffness is controlled by the trained neural network. The actuator dynamics and control time delay are considered in the simulation. Numerical examples show that the proposed control algorithm is valid in structural control. Copyright © 2001 John Wiley & Sons, Ltd.     

埋藏基岩地形对地震波动影响的模拟研究

本文以超声地震模型试验为基础,着重从地震波的强度方面来阐明埋藏基岩地形对地震波动的影响,提出了利用振动能量分析地震动问题的重要性,理论分析及实验结果表明,埋藏基岩地形对地震波动的影响表现为:一方面基岩面凹凸不平,致使基岩面上不同部位接收能量大小不同;另一方面,基岩的凹凸面对地震波产生汇聚与发散作用,这两方面共同作用的结果使得地表不同地点表现出不同的地震动强度。     

System identification of a concrete arch dam and calibration of its finite element model

A magnitude 4.3 earthquake occurred near Pacoima Dam on 13 January 2001. An accelerometer array that had been upgraded after the Northridge earthquake recorded the motion with 17 channels on the dam and the dam–foundation interface. Using this data, properties of the first two modes are found from a system identification study. Modal properties are also determined from a forced vibration experiment performed in 2002 and indicate a significantly stiffer system than is estimated from the 2001 earthquake records. The 2001 earthquake, although small, must have induced temporary nonlinearity. This has implications for structural health monitoring. The source of the nonlinear behaviour is believed to be loss of stiffness in the foundation rock. A finite element model of Pacoima Dam is constructed and calibrated to match modal properties determined from the system identification study. A dynamic simulation of the 2001 earthquake response produces computed motions that agree fairly well with the recorded ones. Copyright © 2006 John Wiley & Sons, Ltd.     

爆破动力作用下边坡稳定性的积分解法与应用

岩质边坡在爆破开挖过程中的稳定问题是一个亟待解决的重要问题。对实际工程进行监测,得到适合该地区的能反应高程效应的爆破地震波传播规律,并采用拟静力法计算爆破地震惯性力,提出边坡在爆破动力作用下稳定安全系数的新计算方法———积分法,同时使用MATLAB程序搜索边坡最危险滑裂面并计算最小安全系数。实例证明,此方法是分析边坡动力稳定性的有效方法之一。     

强夯引起的振动规律及环境效应分析

强夯法是地基处理的一种常用方法,而强夯施工振动往往是制约强夯法应用的关键。综合国内外的研究成果,重点分析强夯引起的振动规律及振动对环境的影响,并结合某沿海地基处理中的强夯振动工程实例,根据实测结果,分析振动速度随距离的衰减规律及强夯安全距离的确定。     

松花江水下爆破孔施工技术

在东北严寒季节,在松花江上施工水下爆破孔。介绍了施工设备及施工平台,根据不同地层分别采用静压振动下套管护壁及潜孔锤钻进方法,设计了风路系统,改进了套管妆方法,并采取了科学的管理方法,取产好的效果。     

汤渡河大坝爆破振动及混凝土声波检测

运用爆破振动测试与混凝土声波检测相结合的方法,对汤渡河水库大坝混凝土拆除爆破进行了有效的控制,在保证大坝安全的前提下,大大加快了施工进度,是一种行之有效的方法,对同类工程有较大的借鉴作用。     

论桩基动力检验法

本文扼要地论述桩基动力检验方法中桩质量诊断及单桩承载力确定的理论,依据及其适用范围,有助于正确运用这一检验方法为工程建设服务。     

STC加筋砂水平循环剪切与竖向激振特性试验研究

随着中国汽车工业的发展,大量废旧轮胎带来的"黑色污染"问题日益显著。提出一种采用废旧轮胎柱(Scrap tire columns,STC)的加筋土结构,并初步探究其作为基础减隔振材料的可行性。通过室内水平循环剪切试验和竖向激振试验研究STC加筋砂(STCRS)的水平循环剪切和竖向激振特性。结果表明,最大剪应变为1%时STCRS的等效阻尼比未加筋前增加约10%,等效动剪切模量减小20%~25%,水平向减振性能得以提高;STCRS的竖向加速度衰减呈现出速度快、幅值大的特点,竖向减振效果较未加筋砂显著提高。STC加筋砂作为基础减振材料是可行的,且为原形废旧轮胎的资源化利用提供新思路。     

岩石爆破过程S波的产生机制分析

全面总结、分析了岩石爆破过程S波的产生机制,表明短柱状药包、炮孔周围岩体的开裂与破碎以及装药偏离球形或柱形空腔中心,均可诱发S波,并且诱发S波的幅值可超过P波;P波传播过程与岩体界面的相互作用,可产生次生的S波（透、反射SV波）。在此基础上,就爆破振动场模拟方法与计算模型选择中如何体现S波的产生机制方面提出了建议