“威马逊”台风暴潮增水及水动力响应数值模拟

基于河口海岸水动力三维数值计算模型,建立浙江沿海天文潮与风暴潮耦合预报模式。利用该模式,对经过浙江沿海海域的台风"威马逊"进行数值计算,风暴潮增水计算结果与实测值符合较好,误差基本在±20 cm以内。计算增水值与传统的调和分析法所得的增水结果相比,也较为一致。进一步对局部水动力响应的研究发现,风暴潮期间,局部地区从底到表各层水流流速均急剧增大或减小,其值达到了与天文潮流同等的数量级。当水流流向与风向相同或相近时,流速增大,相反时,则流速减小。且台风期间,各层水流流向也随风向发生改变,流态变得更加复杂。     

Oil dispersal modelling: reanalysis of the Rena oil spill using open-source modelling tools

ABSTRACT

Oil spill forecast modelling is typically used immediately after a spill to predict oil dispersal and promote mobilisation of more effective response operations. The aim of this work was to map oil dispersal after the grounding of the MV Rena on Astrolabe Reef and to verify the results against observations. Model predictions were broadly consistent with observed distribution of oil contamination. However, some hot spots of oil accumulation, likely due to surf-zone and rip current circulation, were not well represented. Additionally, the model was run with 81 differing wind conditions to show that the events occurring during the grounding represented the typical likely behaviour of an oil spill on Astrolabe Reef. Oil dispersal was highly dependent on prevailing wind patterns; more accurate prediction would require better observations of local wind patterns. However, comparison of predictions with observations indicated that the GNOME model was an effective low-cost approach.     

An Analytical Solution for Dynamic Response of the Plate with Different Impedances Subjected to Underwater Explosion

In this paper, the transmitted part of the incident wave is considered to revise Taylor’s solution, which is used to extend its application for analytical models to predict the response of the plate with different material properties. The influence of the material properties and the boundary condition of the plate on fluid and structural dynamics is systematically investigated. The analytical results are compared with those of detailed dynamic FE simulations and the two are in good agreement. The results indicate that the analytical method is valid and suitable for the plates with different material properties subjected to underwater explosion. It is found that Taylor’s results of the plate with small impedance are invalid, which indicates a potential application field for the analytical method.     

新型张力腿式储油处理平台的动力响应分析

针对目前小油田早期生产中存在的不足,提出一种适用于浅水海域的新型张力腿式储油处理平台,该平台主要由储油箱、浮箱、吸力桩、系泊链和甲板结构构成,具备原油处理和储存功能。应用非线性时域耦合分析法,研究了有义波高、平均波周期、水深对该平台的运动响应和系泊链张力的影响。计算结果表明,波高对平台动力响应有较大影响,有义波高每增加0.4 m,平台水平位移相应增加0.408 m,而系泊链力随有义波高的增加呈准线性增大;波周期对平台水平运动影响显著,平均波周期从6.5 s逐级变化至8.5 s时,最大水平位移自3.760 m渐增至5.467 m,而波周期对系泊链力影响较小,变化率一般小于10%;该新型平台对水深大于20 m的浅水海域有良好的动力特性,而对水深小于20 m的海域却表现异常。因此,该新型张力腿式平台能满足水深不小于20 m浅海区的油田早期生产需要。     

ON THE CHARACTERISTICS OF NON-LINEAR SOIL RESPONSE AND DYNAMIC SOIL PROPERTIES USING VERTICAL ARRAY DATA IN JAPAN

Non-linear response of the soil is investigated by comparing the spectral ratios (uphole/downhole) using weak and strong motions. Data from seven vertical arrays in Japan are analysed in this study. The frequency-dependent transfer function of soil is calculated as a ratio of the spectrum at uphole to the spectrum at downhole, considering the horizontal component of shear wave. In spectral ratio analysis auto- and cross-spectra are employed. The reduction in the predominant frequency of the transfer function with increases in excitation level reflects the non-linear response of the soil. Results of analysis demonstrate a significant non-linear ground response at six sites with surface PGA exceeding 90 gal. However, the results of one site show the linear response up to 130 gal surface PGA. Furthermore, the in situ strain-dependent soil behaviour is examined through the shear modulus – shear strain relationship. When compared, the actual and laboratory results of the shear strain – shear modulus relationship are in agreement. Additionally, a good consistency between the tendency of reduction in shear modulus ratio with shear strain increases, and reduction of predominant frequency with ground motion increases, confirms the significance of non-linearity in site effects study.     

芦山地震冶勒大坝强震监测资料分析

冶勒沥青混凝土心墙堆石坝最大坝高为124.5 m,坝址区地震烈度高,地质条件复杂,两岸坝基条件严重不对称。大坝上布设了9台强震仪组成的强震监测台阵,曾获得2008年汶川地震和攀枝花地震的大坝强震监测记录。2013年4月20日四川省雅安市芦山县发生里氏7.0级地震,冶勒大坝距震中约212.5 km,坝址区震感较为强烈,强震监测台阵获得了此次地震较为完整的有效记录。对芦山地震主震记录进行时域分析和频谱分析,总结冶勒大坝在芦山地震中的动力反应规律,并与汶川地震时坝体动力反应进行对比分析。研究表明,芦山地震主震时冶勒大坝最大加速度记录为47.043 cm/s2,最长持续时间为76.98 s,坝顶动力放大效应明显;芦山和汶川地震时大坝动力反应规律的差异与地震波频谱特性及大坝自振特性等密切相关。总体而言,冶勒大坝在震后运行安全稳定,芦山地震未对冶勒大坝造成明显不利影响。     

水平层状岩体边坡动力响应中的结构面效应研究

根据应力波传播原理分析了水平层状岩体边坡中应力波传播特征,建立了应力波在该类边坡中传播的模型.利用离散元软件UDEC分析了不同频率垂向压缩应力波作用下边坡动力响应规律中的结构面效应.结果表明:边坡中的水平层面对坡顶的动力响应有明显影响.低频应力波作用下,水平层状岩体边坡坡顶的垂向峰值速度较均质坡体相同部位的峰值速度的增...     

Transient analysis of wave propagation in non‐homogeneous elastic unbounded domains by using the scaled boundary finite‐element method

The scaled boundary finite‐element method has been developed for the dynamic analysis of unbounded domains. In this method only the boundary is discretized resulting in a reduction of the spatial dimension by one. Like the finite‐element method no fundamental solution is required. This paper extends the scaled boundary finite‐element method to simulate the transient response of non‐homogeneous unbounded domains with the elasticity modulus and mass density varying as power functions of spatial coordinates. To reduce the number of degrees of freedom and the computational cost, the technique of reduced set of base functions is applied. The scaled boundary finite‐element equation for an unbounded domain is reformulated in generalized coordinates. The resulting acceleration unit‐impulse response matrix is obtained and assembled with the equation of motion of standard finite elements. Numerical examples of non‐homogeneous isotropic and transversely isotropic unbounded domains demonstrate the accuracy of the scaled boundary finite‐element method. Copyright © 2006 John Wiley & Sons, Ltd.     

An answer to an important controversy and the need for caution when using simple models to predict inelastic earthquake response of buildings with torsion

This paper presents evidence that the extension of conclusions based on the widely used simplified, one story, eccentric systems of the shear‐beam type, to actual, nonsymmetric buildings and consequent assessments of the pertinent code provisions, can be quite erroneous, unless special care is taken to match the basic properties of the simplified models to those of the real buildings. The evidence comes from comparisons of results obtained using three variants of simplified models, with results from the inelastic dynamic response of three‐ and five‐story eccentric buildings computed with detailed MDOF systems, where the members are idealized with the well‐known plastic hinge model. In addition, a convincing answer is provided on a pertinent hanging controversy: For frame‐type buildings, designed in accordance with the dynamic provisions of modern codes (such as EC8 or IBC2000), which allow reduced shears at the stiff edge due to torsion, the frames at the flexible sides are the critical elements in terms of ductility demands. Copyright © 2009 John Wiley & Sons, Ltd.     

Depositional sequence architecture and filling response model of the Cretaceous in the Kuqa depression, the Tarim basin

The Cretaceous system of the Kuqa depression is a regional scale (second order) depositional sequence defined by parallel unconformities or minor angular unconformities. It can be divided into four third-order sequence sets, eleven third-order sequences and tens of fourth- and fifth-order sequences. It consists generally of a regional depositional cycle from transgression to regression and is composed of three sets of facies associations: alluvial-fluvial, braided river-deltaic and lacustrine-deltaic facies associations. They represent the lowstand, transgressive and highstand facies tracts within the second-order sequence. The tectonic subsidence curve reconstructed by backstripping technique revealed that the Cretaceous Kuqa depression underwent a subsidence history from early accelerated subsidence, middle rapid subsidence and final slower subsidence phases during the Cretaceous time, with the correspondent tectonic subsidence rates being 30-35 m/Ma, 40-45 m/Ma and 5-10 m/Ma obtained from northern foredeep. This is likely attributed to the foreland dynamic process from early thrust flexural subsidence to late stress relaxation and erosion rebound uplift. The entire sedimentary history and the development of the three facies tracts are a response to the basin subsidence process. The slower subsidence foreland gentle slope was a favorable setting for the formation of braided fluvial deltaic systems during the late period of the Cretaceous, which comprise the important sandstone reservoirs in the depression. Sediment records of impermanent marine transgression were discovered in the Cretaceous and the major marine horizons are correctable to the highstands of the global sea level during the period.