Na depletion in modern adakites via melt / rock reaction within the sub-arc mantle

Interaction between slab-derived melt and mantle peridotite and the role of slab melt as a metasomatizing agent in the sub-arc mantle is being increasingly recognized. Adakite, the slab melt erupted on the surface, usually exhibits anomalously high MgO, CaO, Cr and Ni contents that indicate interaction with mantle peridotitite. Here we note that Cenozoic adakites have Na₂O contents below 5.8 wt.% with ∼95% samples lower than 5.0 wt.%, and are generally depleted in this component relative to experimental basalt partial melts (mostly beyond 5.0 wt.% and up to 9.0 wt.% Na₂O) produced under 1.5-3.0 GPa conditions that are most relevant to adakite production. We interpret the adakite Na depletion to be also a consequence of the melt / rock reaction that takes place within the hot mantle wedge. During ascent and reaction with mantle peridotite, primary adakite melts gain mantle components MgO, CaO, Cr and Ni but lose Na₂O, SiO₂ and perhaps K₂O to the mantle, leading to Na-rich mantle metasomatism. Selective assimilation of predominately mantle clinopyroxene, some spinel and minor olivine at high T/P has been considered to be an important process in producing high-Mg adakites from primary low-Mg slab melts [Killian, R., Stern, C. R., 2002. Constraints on the interaction between slab melts and the mantle wedge from adakitic glass in peridotite xenoliths. Eur. J. Mineral. 14, 25-36]. In such a process, Na depletion in the assimilated melt is the result of dilution due to the increase in melt mass. Phase relationships in the reaction system siliceous melt + peridotite and quantitative calculation suggest that assimilation of mantle clinopyroxene, olivine and spinel and fractional crystallization of sodic amphibole and orthopyroxene, under conditions of moderate T/P and increasing melt mass, is also an important process that modifies the composition of adakites and causes the Na depletion.     

冲击凿岩钎杆的瞬态动力学分析

以ANSYS为平台，按照真实工作状态对凿岩钎杆进行了瞬态动力学分析，并对不同活塞形状下分析结果数据进行了比较，为冲击凿岩系统设计提供了理论依据。     

PDC钻头切削齿破岩载荷规律的分析

对PDC钻头冠部形状及不同的布齿密度和切削齿在不同的磨损状态下对PDC钻头切削齿受力的影响进行了分析；用相邻的3个切削齿之间的关系(不同的切削齿与切削齿之间的径向距离和切削齿之间的高度差)来分析PDC钻头冠部形状和切削齿布齿密度对切削齿受力的影响，以及将切削齿的磨损状态简化成与切削齿在钻头上装配方向垂直的平面来分析切削齿磨损状态对切削齿受力的影响。     

城市化过程中土地征用风险表征及对策

从土地征用基本概念和基本特征着手，描述了土地征用的主要风险，其表现为土地征用权力滥用、侵害失地农民的权益、诱发集体土地黑市、诱发社会矛盾等方面。分析了产生风险的“公共利益需要”缺乏明确界定、土地征用的补偿标准偏低或滞后、土地征用及相关制度不健全或存在缺陷等主要原因。提出了控制与规避风险的对策与措施：严格限定公益性用地范围，提高征地补偿标准，扩大补偿范围，完善相关制度，严格土地征用程序。     

Attenuation of aqueous metal transport at two natural acid rock drainage occurrences in the Yukon Territory, Canada

Naturally acidic drainage associated with pyritic black shale has been observed in many locations in the Yukon Territory. While not necessarily linked to known mineral deposits, most of these natural acid rock drainage occurrences show elevated dissolved concentrations of trace elements, especially zinc, nickel, copper, cadmium and arsenic. Based on field observations, microbial investigation, chemical analyses and geochemical modeling, the fate and transport of potentially deleterious elements at two natural acid drainage occurrences with slightly different settings are examined. The Macintosh Creek is a small, acidic stream （pH 2.98-3.40）, 2 km long, located in the Macmillan Pass area of east-central Yukon amidst known sedimentary exhalative massive sulfide mineralization but remains undisturbed by exploration activities. Its trace metal content is apparently derived from groundwater discharges, which gave as much as 5.0, 2.5, 0.7, 0.13 and 0.03 mg/L ofZn, Ni, Cu and As, respectively. Interaction and sorption reactions with algal mats, biofilms and iron oxyhydroxides appear to be the dominant mechanisms attenuating aqueous contaminant transport along the stream. Cryogenic precipitation further consolidates the ferricrete formation and reduces the mobility of the sorbed metals. The tributaries of the Engineering Creek along the Dempster Highway in northern Yukon drain through a series of dolomite, phyllite, argillite, limestone, black shale, sandstone and conglomerate with no known concentration of mineralization. In this area, the water chemistry fully reflects the local geology with acidic streams invariably associated with black shale occurrences. Groundwater seeps in the headwaters area of the km-180 Creek completely enclosed in black shale gave pH 3.0 and as much as 148, 39, 2.9 and 9.1 mg/L of Zn, Ni, Cu and As, respectively. Sorption with iron oxyhydroxide and organic matter appear to dominate the attenuation of contaminant transport along the stream. However, once entered into carbonate-dominated terrains, secondary carbonate minerals exercise additional geochemical control on the local water chemistry as a result of neutralization.     

Naturally acidic and metalliferous waters at unmined volcanogenic massive sulfide deposits in the Bonnifield mining district, Alaska Range, east-central Alaska

The Bonnifield district hosts 26 tmmined volcanogenic massive sulfide （VMS） occurrences. Environmental geochemical samples of water and stream sediment were collected at several occurrences, concentrating on the two best-exposed and largest deposits, Red Mountain （RM） and Sheep Creek （SC）. Limited samples were also collected at the poorly exposed WTF deposit. The deposits are Late Devonian to Early Mississippian, and are hosted by felsic metavolcanic and carbonaceous schist members of the Totatlanika Schist or Keevy Peak Fm. Spring and stream waters at RM and SC have pH values commonly 〈3.5 （as low as 2.4 at RM and 2.5 at SC）, high conductivity （up to 11000 μS/cm）, and very high （Is to 100s mg/L） dissolved contents of Al, Cd, Co, Cu, Fe, Ni, and Pb. Waters at RM are characterized by extremely high REE contents （summed REE median 3200 μg/L, n=33）. At both RM and SC, pyrite oxidation and dissolution produce low pH waters that interact with and dissolve bedrock minerals, resulting in acidic, metal-laden, naturally degraded streams that are mostly devoid of aquatic life. Ferricrete is common. In contrast, WTF barely produces a surficial environmental footprint, mostly due to topography and relief. RM and SC are well exposed in the areas of relatively high relief, and both exhibit extensive areas of quartz-sericite-pyrite-alteration. While WTF shares many of the same deposit-and alteration characteristics, it is concealed by tundra in a large, nearly flat area. Surface water at WTF is absent and outcrops are sparse. Even though WTF is roughly the same size as Red Mountain （both around 3 million tonnes） and has similar base- and precious-metal grades, the surficial geochemical manifestation of WTF is minimal. However, exposure through mining of the altered, mineralized rock at WTF potentially could initiate the same processes of pyrite oxidation, acid generation, and mineral dissolution that are observed naturally at RM and SC.     

Total gaseous mercury emissions from mercury-enriched soil in Guizhou, China

Guizhou is located in the Circum-Pacific Global Mercuriferous Belt, and mercury concentrations in soil in this area are enriched. In-situ total gaseous mercury （TGM） exchange fluxes between air and soil surface were intensively measured at four sampling sites in Guiyang from 21 May to 16 June, 2003, and five sites in the Lanmuchang mercury mining area in December 2002 and May 2003, respectively. The in-situ Hg flux measurement was conducted with a dynamic flux chamber （DFC） of quartz. Overall, net emissions were obtained from all sampling sites. Soil mercury concentration and solar radiation have been proved to be the two most important parameters to control mercury emissions from soil. Meanwhile, rain events can enhance mercury emission rate significantly.     

Origin and three-dimensional fluorescence spectrum of the chromophoric dissolved organic matter in Yangtze estuary, East China

Dissolved organic matter （DOM） is an important chemical component in natural water. Chromophoric dissolved organic matter （CDOM）, a fraction of optical properties, plays art important role in the biogeochemical cycle of nutrients in aquatic environment. People realized that DOM cycle is crucial in the global carbon and nitrogen flux, and also is inherently related to nutrients and trace metal elements. Therefore, CDOM was concerned by scientists in global oceanography and limnology fields. Water samples were collected from three sections （North Channel, South Channel and Zhuyuan） of the Yangtze （Changjiang River） estuary in March 2006 Three-dimensional excitation emission matrix （3-DEEM） fluorescence spectra were analyzed for those filtrates through Whatman GF/F filters. Dissolved organic carbon （DOC） was also measured by TOC analyzer. The tidal variety was also taken into account. The 3-D EEM fluorescence scans suggested the fluorescence characteristics of humic acid （Ex=332-344 nm, Em=439-451 nm） and fulvic acid （Ex=250-254 nm, Em=472-478 nm） were obvious, and the fluorescence group of protein-like and tyrosine （Ex=230 nm, Em=283 nm） was also found. They are mainly composed of CDOM in the Yangtze estuary. Further data analysis, especially the fluorescence index （f 450/500）, showed that terrestrial signal was rather strong （1.41-1.65） in the surface water, however, some terrestrial CDOM signals of bottom water showed excursions （1.28-1.39）. On the other hand, anthropogenic sign was impressed in the waters of Zhuyuan, which is one of the main drain outlets of Shanghai Metropolis. DOC concentrations ranged from 2.2 mg/L to 3.4 mg/L in Zhuyuan and South Channel, and from 2.0 mg/L to 2.4 mg/L in North Channel. The tide effect played a role in the composition of the CDOM measured by 3-D fluorescence scan technology.     

Rock fracturing by explosive energy: review of state-of-the-art

A study of the dynamic rock fracture initiation and propagation due to explosive energy is presented through a detailed state-of-the-art review. Explosive energy dissipation in crushing and fracturing is examined and the various means to enhance the explosive energy utilization for dynamic rock fracturing are reviewed. The study highlights the need for a better understanding of the dynamic fracturing process particularly in the presence of in situ stresses in the rock mass.     

Investigation of the effect of aggregate shape and surface roughness on the slake durability index using the fractal dimension approach

Argillaceous rocks cover about one thirds of the earth's surface. The major engineering problems encountered with weak- to medium-strength argillaceous rocks could be slaking, erosion, slope stability, settlement, and reduction in strength. One of the key properties for classifying and determining the behavior of such rocks is the slake durability. The concept of slake durability index (SDI) has been the subject of numerous researches in which a number of factors affecting the numerical value of SDI were investigated. In this regard, this paper approaches the matter by evaluating the effects of overall shape and surface roughness of the testing material on the outcome of slake durability indices.

For the purpose, different types of rocks (marl, clayey limestone, tuff, sandstone, weathered granite) were broken into chunks and were intentionally shaped as angular, subangular, and rounded and tested for slake durability. Before testing the aggregate pieces of each rock type, their surface roughness was determined by using the fractal dimension. Despite the variation of final values of SDI test results (values of I_d), the rounded aggregate groups plot relatively in a narrow range, but a greater scatter was obtained for the angular and subangular aggregate groups. The best results can be obtained when using the well rounded samples having the lowest fractal values. An attempt was made to analytically link the surface roughness with the I_d parameter and an empirical relationship was proposed. A chart for various fractal values of surface roughness to use as a guide for slake durability tests is also proposed. The method proposed herein becomes efficient when well rounded aggregates are not available. In such condition, the approximate fractal value for the surface roughness profile of the testing aggregates could be obtained from the proposed chart and be plugged into the empirical relation to obtain the corrected I_d value. The results presented herein represent the particular rock types used in this study and care should be taken when applying these methods to different type of rocks.