獐子岛养殖区夏季底层水温快速变化的机理分析

Rapid changes in the near-bottom water temperature are important environmental factors that can significantly affect the growth and development of species in the bottom culture. The object of this research is to investigate the mechanism causing these rapid changes within a bottom culture area near the Zhangzi Island. The hydrographic transects observations in the North Yellow Sea(NYS) suggest that our mooring station is very close to the tidal mixing front. The horizontal advection of the tidal front has induced the observed tidal change of bottom temperature at the mooring station. Analysis of the mooring near-bottom temperature and current measurements show that the angle between the tidal current horizontal advection and the swing of the tidal front is crucial in determining the variation trend of temperature. When the angle equals 90°, the horizontal tidal current advects along the isotherms so the temperature remains the same. When the angle is between 0° and 90°, the seawater moves from deep water to the warmer coastal zone and the temperature decreases. In contrast, the horizontal tidal advection moves the coastal warm water to the mooring station and the water temperature increases when the angle is between 90° and 180°. The amplitude of the temperature change is proportional to the magnitude of the horizontal temperature gradient and the tidal excursion in the direction of the temperature gradient. This study may facilitate the choice of culture area in order to have a good aquaculture production.     

Direct numerical simulation of flow over a slotted cylinder at low Reynolds number

Direct numerical simulation was conducted to investigate the flow past a slotted cylinder at low Reynolds number (Re) of 100. The slotting of cylinder affects the boundary layer separation, vortex formation position, recirculation region length and wake width, which are determined by the type of slit. The streamwise slit (SS1), T-shaped slit (SS3) and Y-shaped slit (SS4) act as passive jets, while the transverse slit (SS2) achieves an alternate self-organized boundary layer suction and blowing. The flow rate in slits fluctuates over time due to the alternate vortex shedding and fluctuating pressure distribution around the cylinder surface. One fluctuation cycle of flow rate is caused by a pair of vortices shedding for SS2, SS3 and SS4, while it is created by each vortex shedding for SS1. The wall shear stress and flow impact on the slit wall partly contribute to the hydrodynamic forces acting on the slotted cylinder. Taking into account the internal wall of slit, the transverse slit plays the best role in suppressing the fluid forces with drag reduction of 1.7% and lift reduction of 17%.     

Bragg reflection of water waves by multiple floating horizontal flexible membranes with submerged rectangular bars on the seabed

Bragg reflection of water waves by multiple floating horizontal flexible membranes is investigated based on the linear wave theory and the assumption of small membrane response. Under the floating horizontal membranes, periodical submerged rectangular bars are arranged on the flat seabed. The total reflection and transmission coefficients are obtained by using the eigenfunction expansion method and the wide spacing approximation. The calculated coefficients are validated with the results available in the literature, which shows that the present method is applicable. The characteristics of Bragg reflection are systematically investigated by changing various parameters including the height of the rectangular bars, the number, the tension, the spacing, and the length of the flexible membranes. The results can help designing multiple floating horizontal flexible membranes as effective floating breakwaters by taking advantage of Bragg reflection.     

Hydrodynamic forces on a partially submerged cylinder at high Reynolds number in a steady flow

The hydrodynamic forces on the stationary partially submerged cylinder are investigated through towing test with Reynolds number ranging from 5 × 10⁴ to 9 × 10⁵. Three test groups of partially submerged cylinders with submerged depths of 0.25 D, 0.50 D, and 0.75 D and one validation group of fully submerged cylinders are conducted. During the experiments, the hydrodynamic forces on the cylinders are measured using force sensors. The test results show a considerable difference in the hydrodynamic coefficients for the partially submerged cylinders versus the fully submerged cylinders. A significant mean downward lift force is first observed for the partially submerged cylinders in a steady flow. The maximum of the mean lift coefficients can reach 1.5. Two distinct features are observed due to the effects of overtopping: random distributions in the mean drag coefficients and a clear quadratic relationship between the mean lift coefficients and the Froude number appear in the non-overtopping region. However, the novel phenomenon of a good linear relationship with the Froude number for the mean hydrodynamic coefficients is clearly shown in the overtopping region. In addition, fluctuating hydrodynamic coefficients are further proposed and investigated. These results are helpful to have a better understanding of the problem and to improve related structural designs.     

Effects of long-term cyclic horizontal loading on bucket foundations in saturated loose sand

A 1-g model experimental study was conducted to investigate the accumulated rotations and unloading stiffness of bucket foundations in saturated loose sand. One-way horizontal cyclic loading was applied to model bucket foundations with embedment ratios 0.5 and 1.0. Up to 10⁴ cycles of loading were applied at a frequency of 0.2 Hz varying load amplitudes. The accumulated rotation of the bucket foundations increased with the number of cycles and the load amplitudes. Empirical equations were proposed to describe the accumulated rotation of the foundations. The unloading stiffness of foundations increased with the number of cycles but decreased with an increase in load amplitude. The initial unloading stiffness of L/D = 1.0 (L is skirt length; D is foundation diameter) was approximately twice that of L/D = 0.5. Excess pore water pressure difference of 50% was observed between L/D = 0.5 and 1.0. The suction and static capacity of the bucket increased with increase of bucket embedment ratio with a difference of 69.5% and 73.6% respectively between L/D = 0.5 and 1.0.     

钙质土中重力串锚水平承载力特性有限元研究

目前没有规范给出串锚的水平承载力计算公式,为了利用有限元法研究串锚水平承载力特性,采用相关理论计算以及室内试验的方法来验证有限元法模拟计算的可靠性。实践证明,有限元法具有较高的计算精度。利用有限元分析软件ABAQUS建立了串锚-土体模型,模拟串锚在水平荷载作用下破坏过程,研究了串锚在水平荷载作用下破坏机理,从而得到了串锚水平承载力特性。在相同的工况条件下,串锚的水平承载力与其锚链长度有关,在一定范围内,增加锚链的长度可以提高串锚的水平承载力;串锚的水平承载力不是相应的单个锚的水平承载力相加,其水平承载力小于相应的单个锚水平承载力之和,在进行串锚水平承载力设计计算时应给与相应的考虑。     

陀螺全站仪在隧道测量中的应用研究

随着我国经济和科技的蓬勃发展,隧道工程建设也呈现出规模化和多元化的趋势。本文首先总结了我国公路隧道、铁路隧道和水下隧道的增长状况;然后归纳了隧道测量中平面控制网的布设方法;最后通过分析发现:通过陀螺全站仪加测陀螺边来传递方位基准,可有效提高隧道贯通精度。     

三杯风速传感器非水平风场测量性能

为解决三杯风速传感器在计量检定条件下与观测场景中环境差异所导致的测量数据误差,致力于研究空气流速计量标准在量值传递过程中的真实性、准确性和一致性,为新一代三杯风速传感器作为计量器具的新产品型式评价提供思路和参考指标,依据杯式测风仪测量方法与自动气象站风速风向传感器检定规程,并在实验中加入了主体由角度编码器构成的自动化转盘系统,设计了三杯风速传感器在非水平风场内测量性能水平实验。通过调整三杯风速传感器在风洞试验段内的倾斜角度,模拟其在自然界非水平风场中的测量状态,同步采集风洞的标准指示风速、三杯风速传感器的实测风速以及其相应的倾斜角度,计算示值误差,利用方差分析、趋势分析、相关性分析和线性回归分析等统计方法,对不同倾斜角度下三杯风速传感器示值误差进行研究,得出了三杯风速传感器在风洞试验段内的示值误差与实测风速和倾斜角度之间的相关关系,提出了三杯风速传感器在非水平风场下的测量性能指标。研究了三杯风速传感器在非水平风场中实测风速与标准风速和倾斜角度的回归关系,提出了三杯风速传感器在计量环境下非水平风场中数据的量值传递修正算法。     

Estimates of global M_2 internal tide energy fluxes using TOPEX/POSEIDON altimeter data

TOPEX/POSEIDON altimeter data from October 1992 to June 2002 are used to calculate the global barotropic M2 tidal currents using long-term tidal harmonic analysis. The tides calculated agree well with ADCP data obtained from the South China Sea (SCS). The maximum tide velocities along the semi-major axis and semi-minor axis can be computed from the tidal ellipse. The global distribution of M2 internal tide vertical energy flux from the sea bottom is calculated based on a linear internal wave generation model. The global vertical energy flux of M2 internal tide is 0.96 TW, with 0.36 TW in the Pacific, 0.31 TW in the Atlantic and 0.29 TW in the Indian Ocean, obtained in this study. The total horizontal energy flux of M2 internal tide radiating into the open ocean from the lateral boundaries is 0.13 TW, with 0.06 TW in the Pacific, 0.04TW in the Atlantic, and 0.03 TW in the Indian Ocean. The result shows that the principal lunar semi-diurnal tide M2 provides enough energy to maintain the large-scale thermohaline circulation of the ocean.     

Urban three-dimensional expansion and its driving forces —A case study of Shanghai, China

Urban expansion is a phenomenon of urban space increase, and an important measuring index of the process of urbanization. Taking Shanghai as an example, the changes of urban average height and built-up area were studied to represent city’s vertical and horizontal increases respectively, and statistical methods were used to analyze the driving forces of urban expansion. The research drew following conclusions: 1) The urban expansion process of Shanghai from 1985 to 2006 had a clear periodic feature, and could be divided into three stages: vertical expansion in dominance, coordinated vertical and horizontal expansion, and horizontal expansion in dominance. 2) The average height and quantity of buildings in core city were significantly bigger than those in suburbs, but the changing speed of the latter was faster. And 3) urbanization process was the major driving force for the city’s horizontal expansion, while industrial structure improvement was the key driving factor for the vertical expansion. Those two driving forces were simultaneously affected by city’s political factors.