具有内波特性的渤海南部次重力波

次重力波(infragravity waves)是频率范围介于局地平均Brunt-V¾is¾l¾频率和0.05Hz(涌浪频率)之间的一种海洋波动,其能量在深水大洋中一般甚低,但在浅海中却很强.该波动的研究对于浅海海洋内部混合、近岸海洋工程、海洋生态学、海洋沉积学及军事海洋学均有重要的意义.Munk[1]很早就开始研究这类波动,然而主要由于观测技术的限制,对于该类波动的动力学机制的研究进展迟缓.     

不同固有频率比条件下圆柱双自由度涡激振动特性的数值研究

采用RANS方法,结合SST k-ω湍流模型,对不同顺流向与横顺流向固有频率的比值(即固有频率比,fnx/fny)条件下低质量比圆柱体的双自由度涡激振动进行了二维数值模拟。圆柱体的质量比为2.6,雷诺数范围为2 500~18 750,相应的约化速度范围为2~15,包括了经典试验中出现的整个锁定范围。通过研究发现,固有频率比是影响振动特性的重要参数,随着固有频率比的增加,响应幅值逐渐降低且向更高的约化速度偏移;在低约化速度范围内,固有频率比对顺流向和横流向振动之间的相位差以及升力频率有较大影响,从而得到各种不同偏向的8字形轨迹;最后对不同固有频率比条件下的尾涡模式进行了讨论,给出了对应不同约化速度时的尾涡模式。     

基于圆柱多段拟合的隧道中轴线提取方法研究

提出基于圆柱多段拟合的隧道中轴线提取方法。首先对隧道点云数据进行预处理,并将点云按隧道走向分成不同区段;然后对各区段依据轴线与表面点云法线垂直关系,提取精度较低的中轴线;最后对各区段利用圆柱多段拟合,提取精度较高的中轴线。实验表明,隧道中轴线的提取在一定的采样区间具有较高的稳定性,对直线和弯曲的圆形隧道有良好的适用性,算法可靠,精度较高。     

基于UDF的水平轴潮流能水轮机被动旋转水动力性能研究

针对水平轴潮流能水轮机被动旋转问题,基于Fluent 17.0,运用UDF(User Defined Function)控制滑移网格对网格进行动态调整,仿真研究水轮机在不同安放角下被动旋转的水动力特性。通过仿真分析,结果表明:潮流能水轮机随着叶片安放角度的增加,尖速比、输出功率、捕能系数都是先增大后减小,叶片安放角为6°时,叶轮前后速度差最大,对潮流能利用充分,且各项性能均达到最佳;通过分析叶片受力,叶尖叶素在安放角为2°时阻力最大,3°时升力最大,升阻比在6°时最大,此时叶尖叶素升阻比C_L/C_D=6.27、攻角α=3.06°。由仿真结果可知水平轴潮流能叶轮的自启动过程由5个阶段组成,即加速度增大的加速运动段—加速度减小的加速运动段—加速度反向增大的减速运动段—加速度反向减小的减速运动段—稳定运行段,这对潮流能水轮机的设计具有重要的指导意义。     

Experimental and numerical investigation of local scour around a submerged vertical circular cylinder in steady currents

Local scour around a submerged vertical circular cylinder in steady currents was studied both experimentally and numerically. The physical experiments were conducted for two different cylinder diameters with a range of cylinder height-to-diameter ratios. Transient scour depth at the stagnation point (upstream edge) of the cylinder was measured using the so-called conductivity scour probes. Three-dimensional (3D) seabed topography around each model cylinder was measured using a laser profiler. The effect of the height-to-diameter ratio on the scour depth was investigated. The experimental results show that the scour depth at the stagnation point is independent on cylinder height-to-diameter ratio when the later is smaller than 2. The increase rate of equilibrium scour depth with cylinder height increases with an increase in Shields parameter.     

河嘉203H含硫水平气井测试工艺实践

河嘉203H井是川东北河坝构造嘉二高压含硫气藏部署的第一口水平井,具有埋藏深、储层压力高、腐蚀分压高、地层易漏失、水平井压井堵漏难度大的特点,通过开展工具优选、管柱结构优化设计、流程优选,并对替浆、放喷油嘴控制及压井等主要工序的施工工艺参数进行研究,形成了河坝嘉二含硫气藏水平井测试工艺技术体系,并在河嘉203H井获得成功应用。     

Higher harmonics induced by a submerged horizontal plate and a submerged rectangular step in a wave flume

The decomposition of a monochromatic wave over a submerged plate is investigated experimentally in a wave flume. Bound and free higher harmonic modes propagating upstream and downstream the structure are discriminated by means of moving resistive probes. The first-order analysis shows a resonant behaviour linked to the ratio of the plate's width and the fundamental mode wavelength over the plate. The second-order analysis shows an energy transfer from the fundamental mode towards free harmonics propagating downstream the structure. This transfer is linked to the ratio of the width of the plate and the bound harmonic wavelength over the plate. We also performed experiments with a submerged step to compare the efficiency of both structures. The submerged plate is shown to be a more efficient breakwater than the step, at the first as well as the second-order.     

正韵律厚油层剩余油的水平井开发技术研究

与直井相比,水平井开发具有缩短油井井距,扩大泄油面积,提高临界锥流量,更好地控制注入流体、改善波及效率等优势。在相同采液量的情况下,水平井可以降低采液强度,减缓含水上升速度。特高含水期河流相储集层的顶部是剩余油富集区,利用水平井技术挖掘正韵律厚油层顶部剩余油,取得了很好的开发效果,最终采收率较直井开发提高了14个百分点。     

Estimates of global M_2 internal tide energy fluxes using TOPEX/POSEIDON altimeter data

TOPEX/POSEIDON altimeter data from October 1992 to June 2002 are used to calculate the global barotropic M2 tidal currents using long-term tidal harmonic analysis. The tides calculated agree well with ADCP data obtained from the South China Sea (SCS). The maximum tide velocities along the semi-major axis and semi-minor axis can be computed from the tidal ellipse. The global distribution of M2 internal tide vertical energy flux from the sea bottom is calculated based on a linear internal wave generation model. The global vertical energy flux of M2 internal tide is 0.96 TW, with 0.36 TW in the Pacific, 0.31 TW in the Atlantic and 0.29 TW in the Indian Ocean, obtained in this study. The total horizontal energy flux of M2 internal tide radiating into the open ocean from the lateral boundaries is 0.13 TW, with 0.06 TW in the Pacific, 0.04TW in the Atlantic, and 0.03 TW in the Indian Ocean. The result shows that the principal lunar semi-diurnal tide M2 provides enough energy to maintain the large-scale thermohaline circulation of the ocean.     

Urban three-dimensional expansion and its driving forces —A case study of Shanghai, China

Urban expansion is a phenomenon of urban space increase, and an important measuring index of the process of urbanization. Taking Shanghai as an example, the changes of urban average height and built-up area were studied to represent city’s vertical and horizontal increases respectively, and statistical methods were used to analyze the driving forces of urban expansion. The research drew following conclusions: 1) The urban expansion process of Shanghai from 1985 to 2006 had a clear periodic feature, and could be divided into three stages: vertical expansion in dominance, coordinated vertical and horizontal expansion, and horizontal expansion in dominance. 2) The average height and quantity of buildings in core city were significantly bigger than those in suburbs, but the changing speed of the latter was faster. And 3) urbanization process was the major driving force for the city’s horizontal expansion, while industrial structure improvement was the key driving factor for the vertical expansion. Those two driving forces were simultaneously affected by city’s political factors.