全文获取类型
收费全文 | 5095篇 |
免费 | 1143篇 |
国内免费 | 1854篇 |
专业分类
测绘学 | 547篇 |
大气科学 | 1729篇 |
地球物理 | 833篇 |
地质学 | 3059篇 |
海洋学 | 489篇 |
天文学 | 711篇 |
综合类 | 347篇 |
自然地理 | 377篇 |
出版年
2024年 | 29篇 |
2023年 | 86篇 |
2022年 | 186篇 |
2021年 | 274篇 |
2020年 | 228篇 |
2019年 | 288篇 |
2018年 | 250篇 |
2017年 | 232篇 |
2016年 | 259篇 |
2015年 | 288篇 |
2014年 | 354篇 |
2013年 | 354篇 |
2012年 | 381篇 |
2011年 | 332篇 |
2010年 | 309篇 |
2009年 | 362篇 |
2008年 | 355篇 |
2007年 | 438篇 |
2006年 | 441篇 |
2005年 | 374篇 |
2004年 | 345篇 |
2003年 | 302篇 |
2002年 | 245篇 |
2001年 | 226篇 |
2000年 | 195篇 |
1999年 | 180篇 |
1998年 | 179篇 |
1997年 | 130篇 |
1996年 | 111篇 |
1995年 | 71篇 |
1994年 | 82篇 |
1993年 | 58篇 |
1992年 | 30篇 |
1991年 | 27篇 |
1990年 | 24篇 |
1989年 | 19篇 |
1988年 | 16篇 |
1987年 | 12篇 |
1986年 | 5篇 |
1985年 | 3篇 |
1984年 | 5篇 |
1983年 | 2篇 |
1980年 | 2篇 |
1971年 | 1篇 |
1954年 | 2篇 |
排序方式: 共有8092条查询结果,搜索用时 78 毫秒
101.
高压下玄武岩浆的不混溶及其对双峰式火山岩的成因意义 总被引:2,自引:4,他引:2
我们在温度850~1300℃,压力1.0~3.0GPa和含约2%水的条件下的碱性玄武岩熔融实验产物中发现在高于2.0GPa压力下玄武岩熔融后的淬火产物中存在着两种不同成分的玻璃,其中一种呈褐色,另一种为浅色或无色.玻璃的电子探针分析结果表明,褐色玻璃具有相对高的MgO、FeO和相对低的SiO2、K2O、Na2O含量及Na2O>K2O的特征.熔体的不混溶间隙与温度无明显关系,但与压力关系密切,即在大于2.0GPa的压力条件下两种玻璃的不混溶间隙突然增大.因此,由不混溶作用形成的双峰式火山岩应来自大于2.0GPa的上地幔,且是能够提供酸性端员物质以及快速上升的构造环境.这与双峰火山岩可以产生于大陆裂谷环境或主要产于俯冲带的弧后拉张环境而不是岛弧前缘一致. 相似文献
102.
京珠高速公路小塘至甘塘段煤系地层路堑高边坡稳定性分析与防治 总被引:6,自引:0,他引:6
李吉东 《水文地质工程地质》2003,30(5):86-88
京珠高速公路粤境小塘至甘塘段20m以上高度的煤系地层路堑边坡共计11处。岩层以全—强风化层为主,厚度20~40m,其物理力学性质大大降低,边坡可能发生平面破坏和圆弧破坏等2种破坏模式。部分地下水水质中SO2-4含量大于200mg l,具有强烈的硫酸盐侵蚀性。边坡防治对策应在详细勘察工程地质、水文地质的基础上,合理选用设置山坡截水沟、平台截水沟、泄水洞、边坡渗沟、排水仰孔等防、排水措施,减少地表水渗入坡体,疏干边坡表层地下水。 相似文献
103.
由于工程需要,对广梧高速公路(马安—河口段)的地震地质情况进行了考察,马安—河口路段所处大地构造性质为东南地洼区,穿越了三个次级构造分区:白土断陷、思劳断隆、云浮断隆。路段附近发育3条断裂:肇庆断裂、河口断裂和吴川—四会断裂。前两者为非活动断裂,后者为活动断裂且星北东向从思劳附近穿过,是未来5.0级地震发生地段,烈度可达Ⅵ度。但路段附近地震活动水平较低,仅发生过4以—5.0级地震4次,最大烈度为Ⅴ度。白诸立交、河口立交的地震地质环境稳定,思劳立交基本稳定,沿线不易产生滑坡与崩塌。 相似文献
104.
105.
Robert Jankowski 《Bulletin of Earthquake Engineering》2003,1(3):397-403
The accurate analysis of the response of isolated structures requires the application of appropriate models of isolation devices.
The purpose of this paper is to analyse a nonlinear strain rate dependent model of a high damping rubber bearing which simulates
the horizontal behaviour of the device under specified vertical load using a nonlinear elastic spring-dashpot element. The
effectiveness of the model is checked by fitting the experimental data concerning three different rubber bearings. The results
of the study show that the model can simulate the bearing behaviour over a wide shear strain range with small simulation errors.
This revised version was published online in July 2006 with corrections to the Cover Date. 相似文献
106.
Zhao Jinren Zhang Xiankang Zhang Chengke Ren Qingfang Cheng Shuangxi Zhang Jianshi Nie Wenying PAN Shuzhen 《中国地震研究》2003,17(2):103-112
The data from two deep seismic sounding profiles was processed and studied comprehensively. The results show that crnst-mantle structures in the investigated region obviously display layered characteristics and velocity structures and tectonic features have larger distinction in different geological structure blocks. The boundary interface C between the upper and lower crust and Moho fluctuate greatly. The shallowest depths of C (30.0km) and Moho (45.5km) under Jiashi deepen sharply from Jiashi to the western Kunlun mountain areas, where the depths of C and Moho are 44.0km and 70.0km, respectively. The higher velocity structures in the Tarim massif determine its relatively “stable“ characteristics in crust tectonics. The phenomenon in the Jiashi region, where the distribution of earthquake foci mostly range from 20kin to 40kin in depth, may infer that the local uplift of C and Moho interface, anomalonsly lower velocity bodies and deep large faults control earthquake occurrence and seismogenic processes in the Jiashi strong earthquake swarm. 相似文献
107.
This paper concerns the seismic response of structures isolated at the base by means of High Damping Rubber Bearings (HDRB). The analysis is performed by using a stochastic approach, and a Gaussian zero mean filtered non‐stationary stochastic process is used in order to model the seismic acceleration acting at the base of the structure. More precisely, the generalized Kanai–Tajimi model is adopted to describe the non‐stationary amplitude and frequency characteristics of the seismic motion. The hysteretic differential Bouc–Wen model (BWM) is adopted in order to take into account the non‐linear constitutive behaviour both of the base isolation device and of the structure. Moreover, the stochastic linearization method in the time domain is adopted to estimate the statistical moments of the non‐linear system response in the state space. The non‐linear differential equation of the response covariance matrix is then solved by using an iterative procedure which updates the coefficients of the equivalent linear system at each step and searches for the solution of the response covariance matrix equation. After the system response variance is estimated, a sensitivity analysis is carried out. The final aim of the research is to assess the real capacity of base isolation devices in order to protect the structures from seismic actions, by avoiding a non‐linear response, with associated large plastic displacements and, therefore, by limiting related damage phenomena in structural and non‐structural elements. In order to attain this objective the stochastic response of a non‐linear n‐dof shear‐type base‐isolated building is analysed; the constitutive law both of the structure and of the base devices is described, as previously reported, by adopting the BWM and by using appropriate parameters for this model, able to suitably characterize an ordinary building and the base isolators considered in the study. The protection level offered to the structure by the base isolators is then assessed by evaluating the reduction both of the displacement response and the hysteretic dissipated energy. Copyright © 2003 John Wiley & Sons, Ltd. 相似文献
108.
109.
110.
张赤军 《武汉大学学报(信息科学版)》2003,28(4):432-434,443
论述了高精度推求正高的两种方法 ,并对正高精度的推估及其在模型上的试算也作了讨论 ,对于海拔为 5 0 0 0m的高山 ,正高的误差一般不超过± 1 0cm ,这与距青岛水准原点达数千公里的西部高山 (原 )处正常高的精度也比较接近 相似文献