莱芜市主要地质灾害特征易发区划分及防治措施

该文总结了莱芜市地质灾害的总体特征,同时具体分析了各种地质灾害的类型、地理分布和主要影响因素等个体特征。以截至2012底的数据为依据,采用地质灾害综合危险性指数法,对莱芜市地质灾害易发程度进行综合分区评价,划定了莱芜市地质灾害高易发区、中易发区、低易发区和不易发区,针对不同的地质灾害种类提出了相应的防治措施。     

群孔抽水试验在新疆哈密大南湖矿区烧变岩层中的应用研究

新疆哈密大南湖矿区北露天煤矿首采区东南部需要揭露Ⅲ火烧岩区一部分,这使得烧变岩水成为露天煤矿矿井充水的主要水源。资源勘探阶段的水文地质资料表明,烧变岩区赋水空间发育、透水能力强,储存量非常可观,但由于受资源勘探阶段水文地质勘探工程量制约,水文地质条件未能详细查明。因此为达到查明烧变岩地下水水力联系、水质变化情况,充分暴露Ⅲ火烧区烧变岩的水文地质条件的目的,设计了该次群孔抽水试验。该次试验查明了烧变岩含水层的水文地质条件,为烧变岩地质条件下防治水工作提供了依据。综合分析表明Ⅲ火烧区烧变岩为储存量型含水层,其补给条件差。     

江西省入境旅游流时空演变研究

采用旅游流年际变动指数、年际集中指数、地理集中指数、基尼系数及空间重心模型,对2000年至2012年江西入境旅游流时空动态演变进行分析。结果表明:1入境旅游流年际波动较大,港澳客源市场表现最为稳定,其次是台湾和外国客源市场,港澳台近程入境旅游客源市场仍具有重要的开发价值,外国入境客源市场潜力还要进一步激发。2年际集中指数较高的美日韩等国,应在稳定基数效应的基础上,加强针对性营销;年际集中指数较低的新加坡、法国、俄罗斯等国,应进行重点开发,培育新兴市场。3港澳游客地理集中度高,外国游客呈现分散-集中趋势,为分散风险应加大对亚洲邻国市场的开拓力度;而城市入境旅游流空间分布相对均衡,客源结构更加完善,但由于交通、区位、资源禀赋、知名度及其客源国消费结构和水平等因素的影响,旅游流重心移动轨迹存在空间错位。     

重力模型参数空间差异研究——以中国城市间铁路客流为例

重力模型是重要的空间相互作用模型,已经在相关研究和实践中得到了广泛应用.在重力模型应用中,结果对参数的敏感性较高,不同的参数设置就可能导致结果体系的巨大差异,故精确的参数是重力模型应用的基础.许多研究关注了重力模型参数的提取,但限于数据等因素,参数在空间上的差异性尚未得到充分的重视.本文采用2010年城市间铁路客运量作为城市间相互作用强度的反映,以城市市辖区居民总可支配收入作为城市的“质量”,刻画城市本身的吸引力,进而通过回归分析考察重力模型的参数结果;并结合地理信息系统的空间插值工具,分析重力模型中各个参数的空间差异并得到可视化结果.相比于既有研究,本文在变量选取中增加了城市间列车交流频次这一变量,与平均运行时间结合共同反映城市之间的“距离”,使模型拟合结果得到较大改进.结果表明,重力模型参数取值在空间上存在显著差异,对不同区域使用统一的重力模型参数可能使结果出现较大偏差,因此将重力模型应用到具体实践中时,不能忽略参数的空间异质性.     

泥石流源区典型草本植物根系抗拉试验

植被对于泥石流源区的生态修复和物源稳定具有重要意义,其中植物根系的抗拉力学特性是影响植物护坡的主要因素之一。为了探究泥石流源区植物根系的抗拉特性,以都江堰市锅圈岩泥石流源区为研究区,在野外调查的基础上,通过重要值计算确定了源区典型草本植物并进行抗拉强度试验。研究表明,锅圈岩泥石流源区主要分布有寒芒、节节草等对恶劣环境适应性强的乡土植物,它们的根系平均分布深度在30 cm以内;根系抗拉力与根径呈幂函数正相关关系,抗拉力随根径的增大而增大。当根径0.50 mm时,抗拉强度与根径也表现出幂函数关系;当根径0.50 mm时,部分植物根系的抗拉强度值波动较大。不同植物根系的平均抗拉强度从大到小依次为铁杆蒿(106.24 MPa)、节节草(非节点处,30.79 MPa)、草地早熟禾(28.69 MPa)、小飞蓬(20.20 MPa)、多头苦荬(18.77 MPa)、寒芒(老根,14.87 MPa)、节节草(节点处,12.67 MPa)、寒芒(新根,8.29 MPa)。泥石流源区草本植物的根系抗拉力学特性良好,对稳固浅层土体和泥石流物源有积极作用。     

岷江上游“7·10”泥石流对公路的危害方式及成因

2013-07-10,岷江上游暴发大型群发性泥石流灾害,泥石流以淘刷、冲击、淤塞、压顶、磨蚀等方式对地震灾区公路直接造成严重破坏,其引发的溃决洪水、河床上升增大受灾范围,加重了灾害损失。分析了泥石流对道路工程的成灾方式:对桥梁工程破坏包括淤塞、淘蚀基础、冲毁等;对路面路基工程破坏包括淤埋、淘刷路基、冲毁等;对隧道工程破坏包括堵塞隧道洞口,破坏洞口墙体并引起衬砌支护结构破坏,损毁隧道内附属设施等;对明洞、棚洞工程破坏包括堵塞洞口、冲毁洞口结构,磨蚀洞顶,压顶并引起衬砌支护结构破坏,损毁排水、通风、电力附属设施等。分析了泥石流造成道路严重损失的原因,其中,公路工程选址不当、风险估计不足,桥涵过流净空不足,泥石流防灾措施不完善,泥石流的严重冲刷、冲击作用是主要原因。针对泥石流危害公路的特征和地震区泥石流防治中存在问题,提出了地震山区公路在灾后重建与道路规划中的减灾措施。     

环抱式防波堤口门航道横流三维特性研究

环抱式防波堤口门易出现较大横流,且三维特性明显。针对连云港主港区深水航道,建立三维潮流数学模型,并用现场航槽实测资料进行验证,在此基础上计算分析了不同潮差条件下口门段进港航道横流的三维特性。研究结果表明:最大横流约出现在高潮位前1.5 h,自表层至底层相继出现,且表、底层出现时刻仅相差0.5 h;因航道边坡较小,最大横流时未见水流分离现象,航槽底部没有反向流;各层最大横流值均与涨潮潮差有关,且相关程度高;航道内最大横流垂向分布梯度随潮差增加略有增大。     

Research on the critical conditions for clay particle release during saline aquifer freshening process

Water sensitivity phenomenon occurs during saline aquifer freshening process in seawater intrusion area, and clay particles released in the phenomenon can damage the infiltration capacity of the aquifer. In order to find out the factors and mechanisms for clay particle release, laboratory column infiltration experiments simulating saline aquifer freshening process were designed to measure the critical conditions(critical flow velocity, critical salt concentration and critical ionic strength) and force analysis for clay particle according to DLVO electric double layer theory was employed to illustrate the mechanisms for particle release. The research results showed that critical flow velocity for clay particle release is influenced by salt concentration of injecting solution. When salt concentration of injecting solution is very high, clay particles are not released, indicating that there does not exist a critical flow velocity in this situation. As salt concentration of injecting solution decreases, particles start to be released. The critical salt concentration for clay particle release is 0.052 mol L-1 in our work, which was determined by a constant-flux experiment for stepwise displacement of high concentration Na Cl solution. The critical ionic strength for clay particle release decreases as Ca2+ molar content percentage of the mixed solution of Na Cl and Ca Cl2 increases following the first-order exponential decay equation y = 0.0391e-0.266 x + 0.0015.     

A rational approach to seepage flow effects on bottom friction beneath random waves

The bottom friction beneath random waves is predicted taking into account the effect of seepage flow. This is achieved by using wave friction factors for rough turbulent, smooth turbulent and laminar flow valid for regular waves together with a modified Shields parameter which includes the effect of seepage flow. Examples using data typical to field conditions are included to illustrate the approach. The analytical results can be used to make assessment of seepage effects on the bottom friction based on available wave statistics. Generally, it is recommended that a stochastic approach should be used rather than using the rms values in an otherwise deterministic approach.     

琼东南盆地深水区构造热演化特征及其影响因素分析

To reveal the tectonic thermal evolution and influence factors on the present heat flow distribution, based on 154 heat flow data, the present heat flow distribution features of the main tectonic units are first analyzed in detail, then the tectonic thermal evolution histories of 20 profiles are reestablished crossing the main deep-water sags with a structural, thermal and sedimentary coupled numerical model. On the basis of the present geothermal features, the Qiongdongnan Basin could be divided into three regions: the northern shelf and upper slope region with a heat flow of 50–70 m W/m2, most of the central depression zone of 70–85 m W/m2, and a NE trending high heat flow zone of 85–105 m W/m2 lying in the eastern basin. Numerical modeling shows that during the syn-rift phase, the heat flow increases generally with time, and is higher in basement high area than in its adjacent sags. At the end of the syn-rift phase, the heat flow in the deepwater sags was in a range of 60–85 m W/m2, while in the basement high area, it was in a range of 75–100 m W/m2. During the post-rift phase, the heat flow decreased gradually, and tended to be more uniform in the basement highs and sags. However, an extensive magmatism, which equivalently happened at around 5 Ma, has greatly increased the heat flow values, and the relict heat still contributes about 10–25 m W/m2 to the present surface heat flow in the central depression zone and the southern uplift zone. Further analyses suggested that the present high heat flow in the deep-water Qiongdongnan Basin is a combined result of the thermal anomaly in the upper mantle, highly thinning of the lithosphere, and the recent extensive magmatism. Other secondary factors might have affected the heat flow distribution features in some local regions. These factors include basement and seafloor topography, sediment heat generation, thermal blanketing, local magmatic injecting and hydrothermal activities related to faulting and overpressure.