一种新型双磙子FPS隔振系统的动力学模型

本文基于多体动力学理论建立了一种新型双磙子FPS(Friction Pendu lum System)隔振系统动力学模型。在对该系统进行运动学分析的基础上,可将它归结为一个单自由度系统。应用非惯性系中质点系相对动能定理的微分形式可推导出该系统的运动微分方程,它是一个非线性方程。在小角位移的情形下,可近似得到相应的无阻尼线性系统的固有频率,它与观测结果吻合。这一双磙子FPS隔振系统的动力学方程的建立有助于对该系统动力学行为的研究,对方程的直接求解可提高仿真设计中正问题计算的效率,为设计包含该系统的半主动控制奠定了基础。     

免共振沉桩过程对地表振动影响的FLAC3D数值模拟

为研究免共振沉桩过程对地表振动影响,采用密度放大法以消除模型桩弹性模量过大对计算效率的影响,在有限差分软件FLAC^3D中建立了相应的连续振动沉桩模型,并和文献中的现场测试结果进行了比较,分析了激振力幅值和振动频率这两个施工参数对地表振动响应的影响。结果表明：密度放大法可有效提高数值模拟的计算效率,模拟沉桩7.0倍桩径（4.9 m）所需计算时间约为12.0 h,数值结果较好地模拟了现场测试中免共振沉桩的地表振动影响;激振力幅值和振动频率均主要对近场（水平距离为5.0倍桩径范围内）的地表振动有明显影响;临界沉桩深度与地表振动影响峰值相对应,该深度随水平距离先增大后趋于稳定;激振力幅值对临界沉桩深度的改变不明显,振动频率对远场临界沉桩深度则有较明显影响。     

双排隔振屏障对振动波的阻隔作用及动力响应分析

本文采用模拟试验的方法,对分层土地基中双排隔振屏障对振动波的动力响应进行了探讨,并研究了桩长与土层分界面位置关系、激振频率对其隔振效果的影响作用,得出结论:（1）屏障前振动强度远大于屏障后振动强度,并随着振源距、激振频率、桩长的增加而下降,且屏障前出现明显振动增强现象,在激振频率80 Hz时产生振动峰值,振动强度在高频时基本稳定,继续增加激振频率,振动强度并不会发生明显变化。（2）屏障后中线左右2倍桩长范围内为整个隔振区域的薄弱区,其他区域则由包络线围成一个封闭有效隔振区。（3）屏障对中频和高频有更好的隔振效果,且桩长越大有效隔振面积越大,当桩长超过土层分界面时,有效隔振面积可达到53.25%～69.78%,但此时有效隔振面积增幅由原来的14.29%下降到11.64%,增幅降低了约3%。（4）未设屏障区振动强度较小,随激振频率小范围内浮动,在激振频率为30 Hz和80 Hz时取得振动峰值,且随着屏障布置方向减小,即靠近屏障一侧振动强度较强,远离屏障一侧振动强度较弱。     

Numerical benchmark studies on drag and lift coefficients of a marine riser at high Reynolds numbers

Numerical benchmark studies on drag and lift coefficients of a marine riser have been organized by the 27th ITTC Ocean Engineering Committee. The purpose of the studies was to benchmark the capabilities of CFD methods through quantitative comparisons and validation studies against the model test results of a circular cylinder by MARIN. Studies were focused on the drag crisis phenomenon for the stationary smooth cylinder in the critical Reynolds number regime. Eight organizations have participated in the studies by using RANS, DES and LES methods. An overview of the model test results, test cases, submissions and comparison results are presented in this paper. Conclusions and recommendations are made for future studies.     

Determining the location of buried plastic water pipes from measurements of ground surface vibration

‘Mapping the Underworld’ is a UK-based project, which aims to create a multi-sensor device that combines complementary technologies for remote buried utility service detection and location. One of the technologies to be incorporated in the device is low-frequency vibro-acoustics, and techniques for detecting buried infrastructure, in particular plastic water pipes, are being investigated. One of the proposed techniques involves excitation of the pipe at some known location with concurrent vibrational mapping of the ground surface in order to infer the location of the remainder of the pipe. In this paper, measurements made on a dedicated pipe rig are reported. Frequency response measurements relating vibrational velocity on the ground to the input excitation were acquired. Contour plots of the unwrapped phase revealed the location of the pipe to within 0.1-0.2 m. Magnitude contour plots revealed the excitation point and also the location of the pipe end. By examining the unwrapped phase gradients along a line above the pipe, it was possible to identify the wave-type within the pipe responsible for the ground surface vibration. Furthermore, changes in the ground surface phase speed computed using this method enabled the location of the end of the pipe to be confirmed.     

Parametric vibration of submerged floating tunnel tether under random excitation

For the study of the parametric vibration response of submerged floating tunnel tether under random excitation,a nonlinear random parametric vibration equation of coupled tether and tube of submerged floating tunnel is set up.Subsequently,vibration response of tether in the tether-tube system is analyzed by Monte Carlo method.It may be concluded that when the tube is subjected to zero-mean Gaussian white noise random excitation,the displacement and velocity root mean square responses of tether reach the peak if the circular frequency of tube doubles that of tether;the displacement and velocity root mean square responses of tether increase as the random excitation root mean square increases;owing to the damping force of water,the displacement and velocity root mean square responses of tether decrease rapidly compared with tether in air;increasing the damping of the tether or tube reduces the displacement and velocity root mean square responses of tether;the large-amplitude vibration of tether may be avoided by locating dampers on the tether or tube.     

均匀流场中并列圆柱涡激振动的现状与预测

并列圆柱体在均匀流场中的涡激振动十分复杂，但又广泛存在于实际工程之中。当两柱在流体激励作用下产生振动时，由于同时存在着流固耦合作用和柱间干扰作用，而使周围流场变得更加复杂。本文对并列刚性和弹性圆柱的流场分类，Ｓｔｒｏｕｈａｌ数及流体载荷等问题进行了综述，在此基础上提出了进一步研究的建议。     

Efficiency analysis of open trench for impact pile driving through a single-variable method

Abstract

The ground vibrations during pile driving operation have a drastic potential to undermine the surrounding structures both in land and reclaimed land. Particularly, reclaimed land necessitates ample application of pile driving due to the weak land condition. To prevent the structural damage, attenuation of the ground vibrations to an allowable level through active isolation of circular open trench is the scope of this study. In this research, finite element simulations of continuous impact pile driving process from the ground surface was executed with particular attention to the pile-soil interaction, and thereby, the efficiency of open trench application in attenuation of the unsafe distance of different structures was surveyed using the vibration sensitivity degree. Regarding the crucial parameters of an open trench (depth, width, and location), it was concluded that a sufficient high depth can attenuate the unsafe distance up to 68%, the trench width variations are less effective, and an average pile-trench distance is the most efficient option. The excavation volume was also concluded as another crucial parameter in open trench design which takes all three parameters into account. The trench depth equal to the pile’s maximum critical depth of vibration was inferred for an optimum design.     

A new model for the vibration isolation via pile rows consisting of infinite number of piles

In this study, on the basis of the Floquet transform method, a numerical model for the simulation of the vibration isolation via multiple periodic pile rows with infinite number of piles is established. By means of the fictitious pile method due to Muki and Sternberg, the second kind of Fredholm integral equations for the pile rows are developed by using the fundamental solutions for the half‐space and the compatibility conditions between the piles and half‐space. Employing the Floquet transform method, integral equations for the pile rows in the wavenumber domain are then derived. Solution of the integral equations yields the wavenumber domain solution for the pile rows. The space domain solution can then be retrieved by inversion of the Floquet transform. Numerical results show that the proposed model with the Floquet transform method is in a good agreement with those of the conventional direct superposition method. On the basis of the new model, influences of the spacing between neighboring piles, the Young's modulus of the piles, and the pile length on the vibration isolation effect of the pile rows are investigated. Numerical simulations conducted in this study show that compared with the direct superposition method, the efficiency of the proposed model for simulation of the vibration isolation via pile rows is very high. Copyright © 2012 John Wiley & Sons, Ltd.     

Using an inerter‐based device for structural vibration suppression

This paper proposes the use of a novel type of passive vibration control system to reduce vibrations in civil engineering structures subject to base excitation. The new system is based on the inerter, a device that was initially developed for high‐performance suspensions in Formula 1 racing cars. The principal advantage of the inerter is that a high level of vibration isolation can be achieved with low amounts of added mass. This feature makes it an attractive potential alternative to traditional tuned mass dampers (TMDs). In this paper, the inerter system is modelled inside a multi‐storey building and is located on braces between adjacent storeys. Numerical results show that an excellent level of vibration reduction is achieved, potentially offering improvement over TMDs. The inerter‐based system is compared to a TMD system by using a range of base excitation inputs, including an earthquake signal, to demonstrate how the performance could potentially be improved by using an inerter instead of a TMD. Copyright © 2013 John Wiley & Sons, Ltd.