Saturation of the Large Aperture Scintillometer

The saturation aspects of a large aperture (0.3 m) scintillometer operating over a 10-km path were investigated. Measurements were made over mainly forested, hilly terrain with typical maximum sensible heat fluxes of 300–400 W m ⁻², and over flat terrain with mainly grass, and typical maximum heat fluxes of 100–150 W m⁻². Scintillometer-based fluxes were compared with eddy-correlation observations. Two different schemes for calculating the reduction of scintillation caused by saturation were applied: one based on the work of Hill and Clifford, the other based on Frehlich and Ochs. Without saturation correction, the scintillation fluxes were lower than the eddy-correlation fluxes; the saturation correction according to Frehlich and Ochs increased the scintillometer fluxes to an unrealistic level. Correcting the fluxes after the theory of the Hill and Clifford gave satisfying results     

A three-dimensional finite-element model of wind effects upon higher harmonics of the internal tide

A non-linear three-dimensional unstructured grid model of the M₂ tide in the shelf edge area off the west coast of Scotland is used to examine the spatial distribution of the M₂ internal tide and its higher harmonics in the region. In addition, the spatial variability of the tidally induced turbulent kinetic energy and associated mixing in the area are considered. Initial calculations involve only tidal forcing, although subsequent calculations are performed with up-welling and down-welling favourable winds to examine how these influence the tidal distribution (particularly the higher harmonics) and mixing in the region. Both short- and long-duration winds are used in these calculations. Tidal calculations show that there is significant small-scale spatial variability particularly in the higher harmonics of the internal tide in the region. In addition, turbulence energy and mixing exhibit appreciable spatial variability in regions of rapidly changing topography, with increased mixing occurring above seamounts. Wind effects significantly change the distribution of the M₂ internal tide and its higher harmonics, with appreciable differences found between up- and down-welling winds and long- and short-duration winds because of differences in mixing and the presence of wind-induced flows. The implications for model validation, particularly in terms of energy transfer to higher harmonics, and mixing are briefly discussed.     

基于SDS评价模型的区域生态环境地质质量评价——以海南岛西南部为例

文章借鉴SDS(可持续发展系统)评价模型,在生态环境地质调查的基础上,综合考虑了评价区气候条件、区域地质条件、地质灾害、土地资源、植被条件、人类活动强度等控制生态环境地质质量的基本指标,建立区域生态环境地质评价模型,并应用于海南省西南部的生态环境地质评价,结果表明该模型具有简单、实用的特点。     

The topographic bias by analytical continuation in physical geodesy

This study emphasizes that the harmonic downward continuation of an external representation of the Earth’s gravity potential to sea level through the topographic masses implies a topographic bias. It is shown that the bias is only dependent on the topographic density along the geocentric radius at the computation point. The bias corresponds to the combined topographic geoid effect, i.e., the sum of the direct and indirect topographic effects. For a laterally variable topographic density function, the combined geoid effect is proportional to terms of powers two and three of the topographic height, while all higher order terms vanish. The result is useful in geoid determination by analytical continuation, e.g., from an Earth gravity model, Stokes’s formula or a combination thereof.     

德国降水预报产品的应用和检验

利用德国降水预报输出的24和48h降水预报产品,对2005年1—12月巴音郭楞蒙古自治州(简称巴州,下同)9个气象站分别进行了降水预报效果的检验分析,统计分析其在各月、各季、年的降水预报能力,得出其空报率较大,准确率和漏报率较低,但对巴州南部地区的大降水天气有一定的指导意义。     

On the use of microtremor recordings in seismic microzonation

Experimental methods involving microtremor recordings are useful for determining site effects in regions of moderate seismic activity where ground motion records are few, and in urban or industrial contexts where the noise level is high. The aim of this study is to establish a microzonation by using the Nogoshi–Nakamura method,[1, 2] a simple experimental technique based on microtremor recordings. Since the physical phenomena underlying the method are only partially understood, the spectral responses obtained cannot be used alone. We, therefore, complete our experimental results by comparing them with the solutions of a one-dimensional numerical simulation (SHAKE91).[3, 4] The experimental programme was carried out on a plain near the Rhone Delta (South of France). H/V spectral ratios were calculated at 137 noise measurement points. In addition, we were able to compute the numerical transfer functions from soil columns defined by geotechnical characteristics inside the studied region. A comparison of the results obtained by the experimental and numerical methods showed that the fundamental frequencies are in good agreement, but that the amplitudes obtained by the two techniques are sometimes different. The analysis of H/V spectral ratios enabled us to establish maps to characterize the region: a resonance frequency map and maps of amplification levels as a function of frequency range, leading to a seismic microzonation for the whole of the region.     

Comparison of Galerkin-type discretization techniques for two-phase flow in heterogeneous porous media

A comparison of Standard Galerkin, Petrov-Galerkin, and Fully-Upwind Galerkin methods for the simulation of two-phase flow in heterogeneous porous media is presented. On the basis of the coupled pressure-saturation equations, a generalized formulation for all three finite element methods is derived and analysed. For flow in homogeneous media, the Petrov-Galerkin method gives excellent results. But this method fails miserably for problems with heterogeneous media. This is because it is not able to capture correctly processes that take place at interfaces when, for instance, the capillary pressure-saturation relationship after Brooks and Corey is assumed. The Fully-Upwind Galerkin method is superior to the Petrov-Galerkin approach because it is able to give correct results for flow in homogeneous and heterogeneous media for the two models of van Genuchten and Brooks-Corey. The widely used formulation which is correct for the homogeneous case cannot be used for heterogeneous media. Instead the straightforward approach of gradp_c in combination with a chord-slope technique must be utilized.     

Sodium beacon tip–tilt determination with Rayleigh-aided auxiliary telescope technique

The usefulness of tracking the Rayleigh portion of a mesospheric sodium laser guide star as reference for absolute tip–tilt recovery in the frame of the auxiliary telescopes technique is shown. This approach leads to the reduction of the ground occupation needed to attain a given sky coverage by more than one order of magnitude. Speed, tracking precision, and the number of auxiliary telescopes are also reduced, making this new approach a more attractive one. The use of a low-altitude Rayleigh spot reinforces the fundamental limitations affecting this and other techniques, thus degrading significantly the quality of the recovered tip–tilt. However, it is shown that, provided adequate care is taken in the collection and treatment of data, an interesting tilt signal can still be retrieved.     

探讨气候变化的新热点:大气气溶胶的气候效应

气溶胶的气候效应是近年来研究的热点问题。针对这一问题已开展过许多观测研究和模式研究。但是由于气溶胶问题的复杂性以及对气溶胶的观测历史短,至今尚缺少全球范围的气溶胶系统观测资料,所以目前气溶胶的辐射强迫仍是个很不确定的量。这直接影响对全球气候变化的预测。目前国内外正在加强这方面的研究工作,并且有了一些初步的结果。概述了近期国内外对气溶胶的气候效应的研究状况及结果,介绍了今后国际上将要在这一领域开展的研究工作。     

A thermo‐mechanical model for variably saturated soils based on hypoplasticity

The paper presents a mechanical model for non‐isothermal behaviour of unsaturated soils. The model is based on an incrementally non‐linear hypoplastic model for saturated clays and can therefore tackle the non‐linear behaviour of overconsolidated soils. A hypoplastic model for non‐isothermal behaviour of saturated soils was developed and combined with the existing hypoplastic model for unsaturated soils based on the effective stress principle. Features of the soil behaviour that are included into the model, and those that are not, are clearly distinguished. The number of model parameters is kept to a minimum, and they all have a clear physical interpretation, to facilitate the model usefulness for practical applications. The step‐by‐step procedure used for the parameter calibration is described. The model is finally evaluated using a comprehensive set of experimental data for the thermo‐mechanical behaviour of an unsaturated compacted silt. Copyright © 2011 John Wiley & Sons, Ltd.