Spatial-temporal characterization of the San Andreas Fault by fault-zone trapped waves at seismic experiment site,Parkfield, California

In this article, we review our previous research for spatial and temporal characterizations of the San Andreas Fault (SAF) at Parkfield, using the fault-zone trapped wave (FZTW) since the middle 1980s. Parkfield, California has been taken as a scientific seismic experimental site in the USA since the 1970s, and the SAF is the target fault to investigate earthquake physics and forecasting. More than ten types of field experiments (including seismic, geophysical, geochemical, geodetic and so on) have been carried out at this experimental site since then. In the fall of 2003, a pair of scientific wells were drilled at the San Andreas Fault Observatory at Depth (SAFOD) site; the main-hole (MH) passed a ～200-m-wide low-velocity zone (LVZ) with highly fractured rocks of the SAF at a depth of ～3.2 km below the wellhead on the ground level (Hickman et al., 2005; Zoback, 2007; Lockner et al., 2011). Borehole seismographs were installed in the SAFOD MH in 2004, which were located within the LVZ of the fault at ～3-km depth to probe the internal structure and physical properties of the SAF. On September 282004, a M6 earthquake occurred ～15 km southeast of the town of Parkfield. The data recorded in the field experiments before and after the 2004 M6 earthquake provided a unique opportunity to monitor the co-mainshock damage and post-seismic heal of the SAF associated with this strong earthquake. This retrospective review of the results from a sequence of our previous experiments at the Parkfield SAF, California, will be valuable for other researchers who are carrying out seismic experiments at the active faults to develop the community seismic wave velocity models, the fault models and the earthquake forecasting models in global seismogenic regions.     

Upper Ocean Four-Dimensional Variational Data Assimilation in the Arabian Sea and Bay of Bengal

A regional ocean circulation model with four-dimensional variational data assimilation scheme is configured to study the ocean state of the Indian Ocean region (65°E–95°E; 5°N–20°N) covering the Arabian Sea (AS) and Bay of Bengal (BoB). The state estimation setup uses 10 km horizontal resolution and 5 m vertical resolution in the upper ocean. The in-situ temperature and salinity, satellite-derived observations of sea surface height, and blended (in-situ and satellite-derived) observations of sea surface temperature alongwith their associated uncertainties are used for data assimilation with the regionally configured ocean model. The ocean state estimation is carried out for 61 days (1 June to 31 July 2013). The assimilated fields are closer to observations compared to other global state estimates. The mixed layer depth (MLD) of the region shows deepening during the period of assimilation with AS showing higher MLD compared to the BoB. An empirical forecast equation is derived for the prediction of MLD using the air–sea forcing variables as predictors. The surface and sub-surface (50 m) heat and salt budget tendencies of the region are also investigated. It is found that at the sub-surface, only the advection and diffusion temperature and salt tendencies are important.     

非线性波消波及波场分布研究

本文基于雷诺平均N-S方程,并结合RNG k-e方程建立了粘性数值波浪水槽,对不同波陡、不同相对水深、不同相对波高的非线性规则波的阻尼消波问题和波场分布进行研究。文中提出了两种描述消波区内部阻尼变化的阻尼函数,分别适用于小波陡情形和高波陡情形。研究结果表明,小波陡组消波区可设为一个波长,阻尼系数取10~4～10~5即可满足消波要求,计算结果与实验结果及造波理论吻合良好;高波陡组消波区可设为两个波长,阻尼系数取10~4～10~5亦可满足消波要求,计算结果与实验结果吻合良好。此外,当波陡较小时,波场内反射情况的小幅改变即可对整个波场造成影响,特别是当水深较浅时这种影响极为明显,需谨慎考虑。当波陡较大时,水波能量较高,整个波场沿水波传播方向可观测到明显的衰减现象,在具体试验中需进行考虑。     

花海拗陷的热演化和生烃期的磷灰石裂变径迹证据

利用裂变径迹分析方法测量了取自花海拗陷的钻井磷灰石样品的裂变径迹年龄和长度。结果表明,随井深增加年龄减小,平均径迹长度亦变短。取自白垩纪地层的磷灰石样品的裂变径迹年龄都比地层年龄年轻得多,表明沉积后曾长时间处于磷灰石裂变径迹退火带中,沉积前的径迹记录已部分消失,古地温高于今地温。利用蒙特卡罗随机取样的热史模拟方法对裂变径迹数据进行了分析,结果表明白垩纪地层沉积后曾经历过超过110 ℃的加热,达到最高古地温的地质时代是早白垩世晚期—晚白垩世末,为主要生烃期。新生代以来盆地变冷,生油岩的成熟度主要受古地温控制     

基于"山西2015速度模型"的定位方法对比研究

为了确定山西台网基于“山西2015速度模型”的相对固定的定位方法,选择2010~2016年最大空隙角小于45°、参与定位台站数大于40的103个地震事件,分别采用单纯形法、Hypo2000、Hyposat结合PTD等3种方法重新测定。结果显示,单纯形法和Hyposat结合PTD测定的残差以及网缘地震的震中距两方面均优于Hypo2000;在震源深度方面,Hyposat结合PTD的结果较为可信。综合分析认为,基于“山西2015速度模型”定位地震时,山西台网应固定使用Hyposat结合PTD的方法。     

Changes in survivorship,behavior, and morphology in native soft‐shell clams induced by invasive green crab predators

Many studies on invasive species show reduced native densities, but few studies measure trait‐mediated effects as mechanisms for changes in native growth rates and population dynamics. Where native prey face invasive predators, mechanisms for phenotypic change include selective predation, or induced behavioral or morphological plasticity. Invasive green crabs, Carcinus maenas, have contributed to declines in native soft‐shell clams, Mya arenaria, in coastal New England, USA. We tested the hypothesis that clam ability to detect chemical cues from predators or damaged conspecifics would induce greater burrowing depth as a refuge from invasive crabs, and greater burrowing would require increased siphon growth. To determine how crab predation affected clam survivorship and phenotypic traits in the field, clams in exclosure, open, and crab enclosure plots were compared. Crab predation reduced clam density, and surviving clams were deeper and larger, with longer siphons. To determine whether the mechanism for these results was selective predation or induced plasticity, phenotypes were compared between clams exposed to chemical cues from crab predation and clams exposed to seawater in laboratory and field experiments. In response to crab predation cues, clams burrowed deeper, with longer siphons and greater siphon mass. Overall, crab predation removed clams with shorter siphons at shallow depths, and crab predation cues induced greater burrowing depths and longer siphons. Longer siphons and greater siphon mass of deeper clams suggests clams may allocate energy to siphon growth in response to crabs. By determining native behavior and morphological changes in response to an invasive predator, this study adds to our understanding of mechanisms for invasive impacts and illustrates the utility of measuring trait‐mediated effects to investigate predator–prey dynamics.     

深海沉积物分类与命名的参数指标和主成分分析

对于南海中部(118个表层沉积物样,水深82~4 420 m)、东部(106个表层沉积物样,水深700~4 508 m)海域的表层沉积物的粒度资料按小于200 m,200~2 000 m,大于2 000 m水深段对水深、平均粒径、黏土含量进行统计分析,结果表明从陆架到陆坡再到深海,平均粒径和黏土含量随水深增加呈非常有规律的变化;把大于2 000 m水深区域再细分为大于2 500 m,大于3 000 m,大于3 500 m,结果表明平均粒径和黏土含量随水深增加几乎无变化,在南海中部水深大于2 000 m海域平均粒径为3.39~3.54μm,黏土平均含量为54.91%~55.47%;在南海东部水深大于2 000 m海域平均粒径为3.25~3.37μm,黏土平均含量为53.91%~54.56%。研究表明2 000 m水深具有划分深海沉积物的指示意义。南海中部水深大于2 000 m海域黏土平均含量为55.19%,平均粒径为3.39μm;在南海东部水深大于2 000 m海域黏土平均含量为53.91%,平均粒径为3.37μm;在南海中部、东部水深大于2 000 m海域平均粒径均小于4μm,黏土平均含量均大于50%,表明深海沉积物粒度特征是平均粒径小于4μm和黏土平均含量大于50%。黏土含量是非生物组分的代表和划分深海沉积物类型的一个独立参数,钙质生物和硅质生物组分是另外两个独立参数。南海东部海域表层沉积物中55种元素总含量为47.50%,硅、铝、钛、钠、钾、磷、钙、镁、铁、锰十种主元素含量为47.03%,其他45种元素含量为0.47%,虽然沉积物来源复杂、成因不同,但沉积物化学主成分并不复杂,主要由前10种主元素和氧元素组成。沉积物主元素铝、钙、硅分别富集于黏土、钙质沉积、硅质沉积中。通过建立沉积物生源组分与碳酸钙、三氧化二铝、二氧化硅的量化关系,可把碳酸钙、生物二氧化硅作为钙质生物和硅质生物的两个替代参数。     

Extension of high-order harmonics and generation of an isolated attosecond pulse in the chirped laser field

This paper theoretically investigates the high-order harmonic generation cutoff extension using intense few-cycle linearly chirped laser pulses. It shows that the cutoff of the harmonic can be extended remarkably by optimising the chirping parameters. The time-frequency characteristics of high-order harmonics with different chirping parameters are analysed by means of wavelet transform of the dipole acceleration. It also gives out the classical three-step model pictures of electron. By superposing a properly selected range of the harmonic spectrum, it obtains an isolated 65as pulse.     

Compact and tunable mid-infrared source based on a 2 μm dual-wavelength KTiOPO4 intracavity optical parametric oscillator

Using a double resonant KTiOPO₄ (KTP) intracavity optical parametric oscillator operating at degenerated point of 2 μm, we demonstrate a unique mid-infrared source based on difference frequency generation in GaSe crystal. The output tuning range is 8.42-19.52 μm, and a peak power of 834 W for type-I phase matching scheme and 730 W for type-II phase matching scheme are achieved. Experimental results show that this oscillator is a good alternative to the generator of a compact and tabletop mid-infrared radiation with a widely tunable range.     

Remote sensing of water depths in shallow waters via artificial neural networks

Determination of the water depths in coastal zones is a common requirement for the majority of coastal engineering and coastal science applications. However, production of high quality bathymetric maps requires expensive field survey, high technology equipment and expert personnel. Remotely sensed images can be conveniently used to reduce the cost and labor needed for bathymetric measurements and to overcome the difficulties in spatial and temporal depth provision. An Artificial Neural Network (ANN) methodology is introduced in this study to derive bathymetric maps in shallow waters via remote sensing images and sample depth measurements. This methodology provides fast and practical solution for depth estimation in shallow waters, coupling temporal and spatial capabilities of remote sensing imagery with modeling flexibility of ANN. Its main advantage in practice is that it enables to directly use image reflectance values in depth estimations, without refining depth-caused scatterings from other environmental factors (e.g. bottom material and vegetation). Its function-free structure allows evaluating nonlinear relationships between multi-band images and in-situ depth measurements, therefore leads more reliable depth estimations than classical regressive approaches. The west coast of the Foca, Izmir/Turkey was used as a test bed. Aster first three band images and Quickbird pan-sharpened images were used to derive ANN based bathymetric maps of this study area. In-situ depth measurements were supplied from the General Command of Mapping, Turkey (HGK). Two models were set, one for Aster and one for Quickbird image inputs. Bathymetric maps relying solely on in-situ depth measurements were used to evaluate resultant derived bathymetric maps. The efficiency of the methodology was discussed at the end of the paper. It is concluded that the proposed methodology could decrease spatial and repetitive depth measurement requirements in bathymetric mapping especially for preliminary engineering application.