用素土桩挤密法处理陇东湿陷性黄土地基

素土桩挤密地基由桩间挤密土和回填素土夯实的桩体组成，它是一种人工“复合地基”。其作用是通过素土桩挤密法提高地基土的密实度，从而对湿陷性黄土达到消除浅部或深部的部分或全部湿陷性的作用，并改善地基承载能力，减少地基变形。本文通过现场单桩、群桩单元体轻便触探、小环刀深层取样、开剖取样等方法对场地地基土挤密前、后干重度和压实系数进行了对比分析，判定用素土桩挤密法处理陇东湿陷性黄土地基的可行性。     

Design of a high update-rate star sensor for arcsec-level attitude determination from balloon-borne X/γ astronomy platforms

This paper describes the design of a star sensor based upon a high dynamic range CCD in order to reach an arcsec-level attitude determination in balloon-borne missions. A custom star identification software was developed and laboratory-tested on a prototype assembled using commercial components. A set of numerical simulations have been carried out to study the dependence on the pointing precision of the centroid position accuracy, the number of detected stars and the effect of the image focusing. Moreover, the role of the electronic noise and the discrete pixel structure on the light signals is identified by the analysis of numerical simulations. Laboratory tests confirm that the arcsec pointing accuracy with a 1 Hz update rate can be achieved with our combination of custom-developed software and selected hardware components.     

A weak outburst of the millisecond X-ray pulsar SAX J1808.4-3658 in October 1996 as detected from RXTE slew data

Analysis of the RXTE slew data in October 1996 revealed a weak X-ray burst from the millisecond pulsar SAX J 1808.4-3658. The 3–20-keV energy spectrum of the source can be described by a power law with an index of 2.0 and a(3-to 20 keV) luminosity of ～1.4×10³⁵ erg s^?1 (the distance to the source was taken to be 2.5 kpc). Because of the short exposure time, we failed to detect weak pulsations at a frequency of 401 Hz in the source. The (2σ) upper limit of the pulse fraction is ～13%.     

高能偏振能量色散X射线荧光光谱仪应用现状和进展

对高能偏振能量色散X射线荧光光谱仪基本特点及其用于环境、生物、地质样品中痕量元素的分析和RoSH检测等领域的应用现状予以介绍,并对二次靶与滤光片在痕量元素分析中的应用作了探讨。     

能量色散X射线荧光光谱法测定钼矿石中钼铅铁铜

建立了能量色散X射线荧光光谱法测定钼矿石中钼、铅、铁、铜的方法,讨论了粒度效应、矿物效应的影响因素,确定了采取粉末样品,用系列标准样品建立工作曲线,通过元素间相互校正消除基体效应,用内控标准样品考察了方法的精密度(RSD,n=11)为0.44%～15.4%。实际样品的测定结果和化学法相符,可满足日常分析工作需要。     

Room-temperature equation of state of Li<Subscript>2</Subscript>VOSiO<Subscript>4</Subscript> up to 8.5 GPa

High-pressure single-crystal X-ray diffraction measurements of lattice parameters of the compound Li₂VOSiO₄, which crystallises with a natisite-type structure, has been carried out to a pressure of 8.54(5) GPa at room temperature. Unit-cell volume data were fitted with a second-order Birch-Murnaghan EoS (BM-EoS), simultaneously refining V ₀ and K ₀ using the data weighted by the uncertainties in V. The bulk modulus is K ₀ = 99(1) GPa, with K′ fixed to 4. Refinements of third order equations-of-state yielded values of K′ that did not differ significantly from 4. The compressibility of the unit-cell is strongly anisotropic with the c axis (K ₀(c) = 49.7 ± 0.5 GPa) approximately four times more compressible than the a axis (K ₀(a) = 195 ± 3 GPa).     

In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

Optical spectrum based measurement of flotation slurry contents

Monitoring and control of a flotation circuit is mainly based on the information gained by assaying the process slurry lines. In flotation plants, usually an X-ray fluorescence analyzer is used to obtain the on-line assays. This article introduces the visual and near-infrared reflectance spectroscopic analysis of the process slurries as a supplementary method which complements the on-line assay information available from an X-ray fluorescence analyzer. It is shown that the spectral information can be used to accurately predict the element contents in the slurry in between successive XRF analyses. Since the spectral measurements can be taken with high frequency as opposed to the sparse X-ray fluorescence analysis, a practically continuous on-line estimate of the slurry contents is reached. These estimates can be used in the plant control to improve the overall performance of the circuits and to yield also economical savings. Additionally, the frequent monitoring of the grades can provide means to eliminate rapid disturbances in the circuits, thus improving the stability of the process.     

Poisson-Logistic二元复合极值模型在平台甲板标高设计中的应用

考虑到平台所在海区台风出现的频次及其诱发之风、浪、潮、流极端海况联合出现的概率特性，本文推导出Poisson—Logistic二元复合极值模式，并以平台甲板标高进行实例计算。新模式增加了概率模型的物理内涵，解决了Logistic模型阈值选取的任意性。对海洋工程极端海况荷载组合预测具有广泛的应用前景。