不滑移状态下深埋圆形隧道地震响应研究

地下结构的地震响应主要取决于由地震波传播产生的土体变形与土结相互作用。剪切波传播过程中将会引起隧道衬砌的椭圆化变形,进而降低衬砌有效承载力。剪切波作用下的深埋圆形隧道可认为处于均质的纯剪状态,基于相对刚度法的拟静力解析解可充分考虑土结相互作用对隧道结构内力的影响。基于此,本文将通过有限元数值分析获得的自由场地地基变形引入不滑移状态下深埋圆形隧道内力求解公式,并结合二维和三维数值模拟途径,将动力分析结果与解析解结果进行对比分析,以评价各种解析方法的适用性和数值途径的可靠性。     

Effect of irregular structural configuration on floor acceleration demand in hill‐side buildings

A suite of reinforced‐concrete frame buildings located on hill sides, with 2 different structural configurations, viz step‐back and split‐foundation, are analyzed to study their floor response. Both step‐back and split‐foundation structural configurations lead to torsional effects in the direction across the slope due to the presence of shorter columns on the uphill side. Peak floor acceleration and floor response spectra are obtained at each storey's center of rigidity and at both its stiff and flexible edges. As reported in previous studies as well, it is observed that the floor response spectra are better correlated with the ground response spectrum. Therefore, the floor spectral amplification functions are obtained as the ratio of spectral ordinates at different floor levels to the one at the ground level. Peaks are observed in the spectral amplification functions corresponding to the first 2 modes in the upper portion of the hill‐side buildings, whereas a single peak corresponding to a specific kth mode of vibration is observed on the floors below the uppermost foundation level. Based on the numerical study for the step‐back and split‐foundation hill‐side buildings, simple floor spectral amplification functions are proposed and validated. The proposed spectral amplification functions take into account both the buildings' plan and elevation irregularities and can be used for seismic design of acceleration‐sensitive nonstructural components, given that the supporting structure's dynamic characteristics, torsional rotation, ground‐motion response spectrum, and location of the nonstructural components within the supporting structure are known, because current code models are actually not applicable to hill‐side buildings.     

Analytic wave series solution of out-of-plane(SH) waves diffraction by an almost semi-circular shallow cylindrical hill

A closed-form wave equation analytic solution of two-dimensional scattering and diffraction of outof-plane(SH) waves by an almost semi-circular shallow cylindrical hill on a flat, elastic and homogeneous half space is proposed by applying the discrete Fourier series expansions of sine and cosine functions. The semi-circular hill problem is discussed as a special case for the new formulated equation.Compared with the previous semi-circular cases solutions, the present method can give surface displacement amplitudes which agrees well with previous results. Although the proposed equation can only solve the problem of SH-waves diffracted by almost semi-circular shallow hills, the stress and displacement residual amplitudes are numerical insignificantly everywhere. Moreover, the influences of the depth-towidth ratio(a parameter defined in this paper to evaluate the shallowness of the topography of hills) on ground motions are presented and summarized. The limitations and errors of truncation from Graf's addition theorem and Fourier series equations in the present paper are also discussed.     

A small-scale field check on the Fisher–Lehmann and Bakker–Le Heux cliff degradation models

The paper considers the development of initially straight, steep rock cliffs, bounded above and below by horizontal surfaces, in which basal debris removal is zero and degradation occurs by the weathering away of fine debris from the cliff face to form a scree at its foot. Of the slope degradation models available, the two earliest and simplest, namely the Fisher–Lehmann and the Bakker–Le Heux models, are regarded as most relevant and are briefly summarized. The main purpose of the paper is to check the predictions of these models, particularly with regard to the shape of the rock surface buried beneath the scree, against field data. Such data are sparse. It is concluded that the best field case currently available, despite its small scale, is that provided by the 1·75 m deep ditch which forms part of the experimental earthwork in the chalk on Overton Down, Wiltshire. The predictions of the two models are checked against field measurements made of the stage of degradation reached on each face of the ditch by July 1968, eight years after its excavation. These stages were influenced to different degrees by the presence of a surface turf layer. For the NE face, where this influence was least, the agreement of the predictions of the Fisher–Lehmann model with the actual rock profile is excellent and that of the Bakker–Le Heux model only marginally less so. For the SW face, as expected, the agreements are somewhat less close. These results may be to some extent fortuitous because of the influence of the turves and because the scree slopes tend to be concave rather than rectilinear, as assumed. Also, the free faces decline with time in a manner intermediate between those assumed in the two models. Larger scale field checks are clearly desirable before firm general conclusions can be drawn. Rates of crest recession for the Overton Down ditch are logarithmic with time after a very rapid initial phase. Extrapolation from the early phase of this logarithmic behaviour leads to a close estimate of the time needed for the slope to develop fully. The associated ultimate crest recession is also closely predicted by equations derived from both models. © 1998 John Wiley & Sons, Ltd.     

水井测温在地热普查中的应用

利用水井测温方法确定恒温层温度,以恒温层的温度值作为湖顶地热异常区的下限值,用内插法勾绘温度等值线图,高于该下限值范围的即为地热异常区。曹县庄寨地区的地热普查证明该方法是快速有效的。     

宁夏吴忠地区北部的浅部结构和隐伏断裂——地震反射剖面结果

应用浅层地震勘探法对宁夏吴忠地区北部的浅部地壳结构和隐伏活动断裂进行研究。结果表明,该区存在2条隐伏断裂,分别为银川主断层南段和新华桥断层。推测银川主断层南段为近SN走向的W倾正断层,断层下盘地层界面一般呈近水平状展布,而在断层上盘,T_Q及其以下的地层界面向断面方向倾伏并显示出逆牵引现象,断层向上错断了第四系内部。钻孔联合地质剖面及浅层地震探测结果共同揭示新华桥断层为一条走向NE,倾向SW的正断层,深、浅地震测线控制的新华桥断层延伸长度9 km左右,向上错断了第四系内部的T_(02)界面。     

Elastic solutions for a transversely isotropic half-space subjected to buried asymmetric-loads

Elastic closed-form solutions for the displacements and stresses in a transversely isotropic half-space subjected to various buried loading types are presented. The loading types include finite line loads and asymmetric loads (such as uniform and linearly varying rectangular loads, or trapezoidal loads). The planes of transverse isotropy are assumed to be parallel to its horizontal surface. These solutions are directly obtained from integrating the point load solutions in a transversely isotropic half-space, which were derived using the principle of superposition, Fourier and Hankel transformation techniques. The solutions for the displacements and stresses in transversely isotropic half-spaces subjected to linearly variable loads on a rectangular region are never mentioned in literature. These exact solutions indicate that the displacements and stresses are influenced by several factors, such as the buried depth, the loading types, and the degree and type of rock anisotropy. Two illustrative examples, a vertical uniform and a vertical linearly varying rectangular load acting on the surface of transversely isotropic rock masses, are presented to show the effect of various parameters on the vertical surface displacement and vertical stress. The results indicate that the displacement and stress distributions accounted for rock anisotropy are quite different for those calculated from isotropic solutions. Copyright © 1999 John Wiley & Sons, Ltd.     

Burying receivers for improved time‐lapse seismic repeatability: CO2CRC Otway field experiment

4D seismic is widely used to remotely monitor fluid movement in subsurface reservoirs. This technique is especially effective offshore where high survey repeatability can be achieved. It comes as no surprise that the first 4D seismic that successfully monitored the CO₂ sequestration process was recorded offshore in the Sleipner field, North Sea. In the case of land projects, poor repeatability of the land seismic data due to low S/N ratio often obscures the time‐lapse seismic signal. Hence for a successful on shore monitoring program improving seismic repeatability is essential. Stage 2 of the CO2CRC Otway project involves an injection of a small amount (around 15,000 tonnes) of CO₂/CH₄ gas mixture into a saline aquifer at a depth of approximately 1.5 km. Previous studies at this site showed that seismic repeatability is relatively low due to variations in weather conditions, near surface geology and farming activities. In order to improve time‐lapse seismic monitoring capabilities, a permanent receiver array can be utilised to improve signal to noise ratio and hence repeatability. A small‐scale trial of such an array was conducted at the Otway site in June 2012. A set of 25 geophones was installed in 3 m deep boreholes in parallel to the same number of surface geophones. In addition, four geophones were placed into boreholes of 1–12 m depth. In order to assess the gain in the signal‐to‐noise ratio and repeatability, both active and passive seismic surveys were carried out. The surveys were conducted in relatively poor weather conditions, with rain, strong wind and thunderstorms. With such an amplified background noise level, we found that the noise level for buried geophones is on average 20 dB lower compared to the surface geophones. The levels of repeatability for borehole geophones estimated around direct wave, reflected wave and ground roll are twice as high as for the surface geophones. Both borehole and surface geophones produce the best repeatability in the 30–90 Hz frequency range. The influence of burying depth on S/N ratio and repeatability shows that significant improvement in repeatability can be reached at a depth of 3 m. The level of repeatability remains relatively constant between 3 and 12 m depths.     

轴向荷载作用下管与软土相互作用模型试验

开展室内模型试验研究了PE涂层足尺管道在软弱黏土中发生纵向位移时静置时间、加载速率以及土层不排水抗剪强度3个因素对轴向摩擦特性的影响。研究表明,管与软黏土纵向相互作用的抗力-位移曲线存在硬化型和软化型两种形式,前者的峰值摩擦阻力一般出现在加载过程的最后阶段,而后者的峰值摩擦阻力则出现在相对位移为（0.005～0.02）D（D为 管直径）范围内;试验测得的峰值摩擦系数取值介于0.12～0.23之间,且该值比美国API规范推荐值偏小;管土纵向峰值摩擦系数与加载速率成正相关关系,且加载速率对抗力-位移曲线类型无显著影响;常见的不排水抗剪强度范围内,土层的不排水抗剪强度值越低,纵向摩擦系数越大。上述结论可为海底埋设管线与软黏土纵向相互作用摩擦系数的确定提供参考依据。