Flexural performances of prestressed high strength concrete piles reinforced with hybrid GFRP and steel bars

Abstract

This study developed prestressed high-strength concrete (PHC) piles reinforced with high-strength materials (glass fiber-reinforced polymer (GFRP) bars) for flexural performance enhancement. Flexural strengths and behaviors of PHC piles reinforced with hybrid GFRP and steel bars were experimentally investigated, respectively. Large-scale specimens with total lengths of 12,000?mm and diameters of 600?mm were constructed and tested under bending, accompanied by evaluation of effects of non-prestressed reinforcement type and longitudinal reinforcement ratio. J-factors were calculated to evaluate deformability of all the specimens. PHC piles reinforced with GFRP bars were demonstrated to have much higher flexural capacity than those reinforced with steel bars. Moreover, strains at the midspans of cross sections of all the specimens basically conformed to the assumption of plane section. Failure of PHC piles reinforced with GFRP bars was attributable to gradual concrete crushing, while that of PHC piles reinforced with steel bars resulted from steel yielding. Results of this study were expected to provide theoretical basis for wide engineering applications of PHC piles reinforced with hybrid GFRP bars and steel bars in marine structures.     

Dynamic characteristics of marine soft clay under variable phase difference and initial static shear stress

Abstract

Under seismic loading, the soil layer is subjected to multidirectional cyclic shear stress with different amplitudes and frequencies because of the coupling of multiple shear waves and the soil element within a slope or behind a retaining wall is subjected to initial static shear stress before subjected to cyclic loading. Due to the complexity of seismic loading propagation, a phase difference exists between the initial static shear stress and cyclic shear stress. To investigate the influence of the phase difference and initial static shear stress on cyclic shear strain, cyclic modulus, and cyclic strength, a series of laboratory tests are performed on Wenzhou marine soft clay by multi-directional simple shear system, which can simulate the actual state better by controlling the horizontal cyclic stress in the x and y directions simultaneously. As the phase difference varies from 0° to 90°, the dynamic shear modulus increases and cyclic strain accumulation decreases with an increasing number of cycles. The shear strain increases with the initial shear stress.     

Effect of nano-MgO on mechanical performance of cement stabilized silty clay

Abstract

A series of direct shear tests were performed on cement-admixed silty clay to investigate the effect of cement content and nano-magnesia (MgO) on its shear strength properties. For each normal stress, shear strength increased with cement content. However, an obvious increment in shear strength was achieved when the cement content was adjusted from 13% to 17%. Both cohesion and friction angle of cemented soil increased with cement content, and exponential function was adopted to correlate both the factors with cement content. For cement content of 10% investigated in this study, the optimum nano-MgO content was 10‰, wherein the cohesion could reach the peak value. The microstructure of the mixture revealed that the structure of the mixture was compacted for the optimum nano-MgO content. However, micro-cracks were formed when the amount of nano-MgO exceeded its optimum content.     

斜坡平台波浪破碎数值模拟

波浪在斜坡地形上破碎,破波后稳定波高多采用物理模型试验方法进行研究,利用近岸波浪传播变形的抛物型缓坡方程和波能流平衡方程,导出了适用于斜坡上波浪破碎的数值模拟方法。首先根据波能流平衡方程和缓坡方程基本型式分析波浪在破波带内的波能变化和衰减率,推导了波浪传播模型中波能衰减因子和破波能量流衰减因子之间的关系;其次,利用陡坡地形上的高阶抛物型缓坡方程建立了波浪传播和波浪破碎数学模型;最后,根据物理模型试验实测数据对数值模拟的效果进行验证。数值计算与试验资料比较表明,该模型可以较好地模拟斜坡地形的波浪传播波高变化。     

库岸边坡倾角及水位变化对红土型库岸稳定性影响研究

水库库岸失稳对水库安全运行有重大影响。采用土工试验和干湿循环试验,结合数值计算及理论分析,研究红土型库岸边坡倾角和库水位升降与库岸稳定性的关系。结果表明:(1)在一定初始干密度条件下,红土抗剪强度随水位升降循环次数增加而非线性减小,且在水位升降循环约10次时趋于稳定。(2)在一定水位升降速率、升降幅度和升降循环次数条件下,红土型库岸稳定安全系数随库岸边坡倾角的增加总体上呈减小的趋势,且在边坡倾角为50°左右存在稳定安全系数极小值。(3)在一定水位升降循环次数条件下,水位上升到坡高的60%左右为上升阶段的相对危险区域,且水位上升速率对库岸稳定安全系数影响很小;水位下降至坡高的70%左右为库水位下降阶段的相对危险区域,且水位下降速率越大,库岸稳定安全系数越小。(4)针对一定初始干密度,库岸稳定安全系数先随水位升降循环次数的增加而减小,但在水位升降循环次数约10次后逐渐趋于稳定。库岸岩土体性质及库岸边坡倾角、水位变化都会对库岸稳定产生影响。     

不同开口比人工鱼礁体水动力特性及礁体稳定性研究

为研究方型人工鱼礁体开口比的变化对其水动力特性的影响,利用Fluent软件模拟了边长为3m、开口比为0～0.6之间7种不同方型鱼礁体周围水流场,通过分析水流场变化规律得到了礁体流场效应、阻力系数随开口比的变化情况;基于Morison方程计算了礁体在波流作用下的受力及其抗滑移、抗倾覆安全系数。研究结果表明:当礁体开口比小于0.2时,背涡区范围较大,流场效应明显;随着开口比的增大,礁体产生的上升流范围及竖直向最大速度分量逐渐减小;对于方形开口礁体,阻力系数与开口比的关系式为Cd=0.875φ+1.088(R2=0.963,P<0.01);随着开口比的增大,礁体所受最大波流作用力、抗滑移及抗倾覆安全系数逐渐减小,但礁体不会发生滑移和倾覆,可为实际礁体结构的设计提供参考。     

淹没植物对河道糙率的影响

基于河道水动力及植物柔性变形分析,建立淹没状态下的植物河道糙率计算的理论关系,同时,利用试验资料及理论分析成果,进一步获得了植物河道糙率的附加值,借此可以分析与评价河道植物对水流阻力的影响程度.     

概括平差模型的解法探讨

分析了概括平差模型系数矩阵可能出现非列满秩情况的原因,研究了如何使系数矩阵为列满秩矩阵,避免了系数矩阵为非列满秩时的复杂解算过程。     

Discussion of “A simple method to determine breaker height and depth for different deepwater wave height/length ratios and sea floor slopes”, by J.P. Le Roux [Coastal Engineering 54 (2007) 271–277]

In the recent paper by J.P. Le Roux [Coastal Engineering 54 (2007) 271–277], the author provides a simplified approach to calculating the depth, length, and height of waves at the onset of depth-induced breaking (i.e. at the breaker line). However, the proposed methodology and the comparisons to other methods suffer from a large number of inconsistencies and basic calculation errors. In addition, there are a number of erroneous physical interpretations and many of the conclusions are based on erroneous data. The remaining conclusions are either not new or based on circular logic, such as to render them moot. In the following, we will not attempt to point out all the errors or inconsistencies that we found, instead we focus on major points of contention.     

一个波浪破碎散射模型的改进

为了得到与实测数据更为一致的散射模型,对KHCC03散射模型进行了改进.研究了考虑波浪破碎影响的KHCC03散射模型的适用范围.研究结果表明,KHCC03散射模型在入射角为25°～40°范围内,模型结果与实测数据吻合较好,在入射角小于25°和入射角大于40°的情况下,模型结果与实测数据差异较大.针对这一问题,对KHCC03模型进行了改进,结果表明:与原KHCC03模型相比,改进后的模型结果与实测数据吻合程度明显提高.