甫沙-曲吕西地区电磁阵列剖面法研究

通过对塔里木盆地西南缘甫沙-曲吕西地区电法勘探(CEMP),以电性剖面为主,综合地震、重力、地面地质等资料,运用前陆盆地构造分析学理论,对该区构造式样及局部构造进行了研究,摸索了一套研究复杂构造的方法,弥补了地震勘探的不足.     

斯通利波和渗透率的关系分析

理论和实际资料证明,在渗透性地层,低频斯通利波出现的频散和能量衰减与地层渗透率有关,因此可利用斯通利波的传播速度和能量衰减等特性来估算地层渗透率。斯通利波的能量和渗透率负相关。因为斯通利波能量代表了斯通利波的有关信息,因此可以认定斯通利波和渗透率负相关。     

水平井和大斜度井中阵列侧向测井响应数值模拟

针对水平井和大斜度井中阵列侧向电极系的工作原理,利用多电场叠加方式进行电场合成,采用三维有限元方法模拟仿真各个分电场的场分布,进而利用电场线性叠加原理得到阵列侧向测井响应。在基于计算机仿真的基础上,得到阵列侧向五条测井曲线的径向探测深度,阵列侧向径向探测深度要小于深侧向探测深度。考察了三维地层模型下井斜和侵入深度变化对阵列侧向测井响应的影响,分析了水平井和大斜度井中阵列侧向测井响应特征。模拟结果表明,在井斜小于15°时,阵列侧向测井响应受井斜影响小,可以不进行井斜校正;井斜超过60°的大斜度井以及水平井中,阵列侧向测井响应视地层厚度逐渐增大,测井响应值与直井条件下响应值差别较大,必须进行井斜校正。     

阵列相位激电法在弱极化异常区的试验效果

激电相位与极化率反映的都是岩（矿）石的极化特性。在某铜矿已知区上进行了试验工作。对比时间域激电测量和阵列相位激电测量的结果,发现与视极化率相比,相位参数对弱极化异常具有更为明显的反应,适合在弱极化区开展工作。     

Aftershocks series monitoring of the September 18, 2004 M = 4.6 earthquake at the western Pyrenees: A case of reservoir-triggered seismicity?

On September 18, 2004, a 4.6 mbLg earthquake was widely felt in the region around Pamplona, at the western Pyrenees. Preliminary locations reported an epicenter less than 20 km ESE of Pamplona and close to the Itoiz reservoir, which started impounding in January 2004. The area apparently lacks of significant seismic activity in recent times. After the main shock, which was preceded by series of foreshocks reaching magnitudes of 3.3 mbLg, a dense temporal network of 13 seismic stations was deployed there to monitor the aftershocks series and to constrain the hypocentral pattern. Aftershock determinations obtained with a double-difference algorithm define a narrow epicentral zone of less than 10 km², ESE–WNW oriented. The events are mainly concentrated between 3 and 9 km depth. Focal solutions were computed for the main event and 12 aftershocks including the highest secondary one of 3.8 mbLg. They show mainly normal faulting with some strike-slip component and one of the nodal planes oriented NW–SE and dipping to the NE. Cross-correlation techniques applied to detect and associate events with similar waveforms, provided up to 33 families relating the 67% of the 326 relocated aftershocks. Families show event clusters grouped by periods and migrating from NW to SE. Interestingly, the narrow epicentral zone inferred here is located less than 4 km away from the 111-m high Itoiz dam. These hypocentral results, and the correlation observed between fluctuations of the reservoir water level and the seismic activity, favour the explanation of this foreshock–aftershock series as a rapid response case of reservoir-triggered seismicity, burst by the first impoundment of the Itoiz reservoir. The region is folded and affected by shallow dipping thrusts, and the Itoiz reservoir is located on the hangingwall of a low angle southward verging thrust, which might be a case sensible to water level fluctuations. However, continued seismic monitoring in the coming years is mandatory in this area to infer more reliable seismotectonic and hazard assessments.     

相控阵雷达扫描方式对回波强度测量的影响

有源数字阵列雷达的波束设计非常灵活,可变的波束宽度和多波束模式不仅可以满足不同任务的观测需求,还可有效节约扫描时间,但阵列天线参数随波位改变的特性对相控阵天气雷达回波强度的精确定标提出了挑战。2013年4—6月,中国气象科学研究院与安徽四创电子股份有限公司联合研发的X波段一维有源相控阵天气雷达 (X-PAR) 进行了装配后的首次测试观测。对比该雷达与相同位置的C波段双线偏振雷达 (C-POL) 观测资料发现,X-PAR不同宽度的扫描波束均能取得较合理的观测资料。但由于各模式的雷达方程及其标定方法不尽相同,并受到阵列天线照射体积、展宽波束和发射增益的影响,造成X-PAR回波强度存在一定的测量偏差。结合天线参数分析和实际数据统计将测量偏差订正至±1 dB内,为雷达的进一步调试和改进提供了依据。     

Controlling NOx Emission of Crude Rice Bran Oil Blend for Sustainable Environment

The main objective of this work is to investigate the factors influencing the NOx control of a stationary diesel engine fuelled with crude rice bran oil blend with lesser effect on smoke density and brake thermal efficiency (BTE). Fuel injection timing, percentage of EGR, and fuel injection pressure are chosen as the factors for the objective and NOx emission, smoke density, and BTE are considered as the response variables. To critically analyze the effects of the chosen factors on the objective three levels were chosen in each factor and the experiments were designed by following the design of experiments method. Taguchi's L₉ orthogonal array was used to conduct the tests with different combination of factor levels. Through analysis of variance (ANOVA) method, the most influencing factors and also the significance of each factor affecting each response variable were found out. Response graph was drawn for each response variable to determine the optimum combination of factor levels in achieving the objective and the obtained combination was confirmed experimentally.     

Broadband synthetic aperture borehole radar interferometry

Trials in mines have established that wideband VHF borehole radars (BHR), working in the 10–100-MHz band, can be used to probe the rockmass between boreholes over ranges from <5 m to as much as 150 m with submeter resolution. There is evidence that ore bodies reflect these radar signals both specularly and diffusely, much as the ground/air interface does when overflown by synthetic aperture radar (SAR). In both SAR and BHR, multiple flight lines, together with diffuse reflections admit the possibility of developing interferometric 3D images of the object. This paper examines the possibility of imaging buried objects in three dimensions by interferometrically combining broadband VHF borehole radar profiles shot in adjacent pairs of boreholes. Broadbanding in BHR has the advantage of releasing the image from 2nπ phase ambiguities, but practically, interferometric borehole radar (InBHR) needs high signal-to-noise ratios (SNR) to avoid noise capture. This means that 3D InBHR is limited to ranges in wavelengths which are less than the rock's attenuation factor Q. Interferometric methods are developed which are capable of mapping ore bodies and other structures in three dimensions. Tangent plane migration methods are developed here in order to reconstruct surfaces that lie in the near-field of sparse interferometric arrays.     

双偏振相控阵雷达与业务雷达的定量对比及观测精度研究

相控阵天气雷达突破了全机械驱动天线天气雷达的时空分辨率瓶颈,能够提供更加快速、精细的观测资料.但阵列天线存在性能参数随扫描角偏离法向而恶化的情况,使相控阵雷达定量测量存在困难.本文针对中国华南地区最新布网的双偏振相控阵天气雷达,通过与当地S波段业务雷达在相同区域内的定量对比,评估了反射率因子差分反射率因子的误差量级及其...