按新旧规范设计的多层住宅砖房地震易损性的对比

本文采用概率方法借助于拉丁超立方采样技术和非线性地震反应时程分析对按现行规范设计的多层住宅砖房的地震易损性进行分析,并与按上一代规范设计的多层住宅砖房的地震易损性分析结果[1]进行了比较,为进一步研究这类结构的地震安全性、未来地震的损失预测以及防震减灾对策奠定基础。     

耦合地震动下地铁车站的动力响应研究

耦合地震动对地铁车站结构的响应较为复杂,本文运用有限单元法进行动力时程分析,研究地铁车站结构承受水平、竖向和双向耦合地震动作用下的动力响应规律.结果表明:(1)耦合地震动对结构相对水平位移影响较小,但对结构的相对竖向位移影响较大.(2)耦合地震动会减小中柱主应力值,但并未较大程度上改变中柱主应力值大小分布情况.(3)车...     

Lateral dynamic response of a pipe pile in saturated soil layer

This paper presents an analytical solution for the lateral dynamic response of a pipe pile in a saturated soil layer. The wave propagations in the saturated soil and the pipe pile are simulated by Biot's three‐dimensional poroelastic theory and one‐dimensional elastic theory, respectively. The governing equations of soil are solved directly without introducing potential functions. The displacement response and dynamic impedances of the pipe pile are obtained based on the continuous conditions between the pipe pile and both the outer and inner soil. A comparison with an existing solution is performed to verify the proposed solution. Selected numerical results for the lateral dynamic responses and impedances of the pipe pile are presented to reveal the lateral vibration characteristics of the pile‐soil system. Copyright © 2015 John Wiley & Sons, Ltd.     

Screening the current soil drainage class map of Flanders (Belgium) for its predictive quality

The predictive quality of the current drainage class map of Flanders was evaluated using data from two monitoring networks: one with good spatial coverage but poor temporal coverage and another with better temporal but poor spatial coverage. We combine both networks to obtain 1678 point predictions for mean highest water (MHW) and mean lowest water (MLW) tables by applying time series modelling and total least squares regression. The resulting MHW and MLW point data set was used to evaluate the currency of the existing map and to identify regional differences. The quality of the current map is moderate, and large differences occur between regions. Especially the Campine region shows large and systematic differences, whereas the southeastern hills and chalk–loam region is relatively accurate. If more weight is given to errors in the wetter drainage classes, about 50% of the area of Flanders would benefit from remapping. Copyright © 2011 John Wiley & Sons, Ltd.     

A generalized conditional intensity measure approach and holistic ground‐motion selection

A generalized conditional intensity measure (GCIM) approach is proposed for use in the holistic selection of ground motions for any form of seismic response analysis. The essence of the method is the construction of the multivariate distribution of any set of ground‐motion intensity measures conditioned on the occurrence of a specific ground‐motion intensity measure (commonly obtained from probabilistic seismic hazard analysis). The approach therefore allows any number of ground‐motion intensity measures identified as important in a particular seismic response problem to be considered. A holistic method of ground‐motion selection is also proposed based on the statistical comparison, for each intensity measure, of the empirical distribution of the ground‐motion suite with the ‘target’ GCIM distribution. A simple procedure to estimate the magnitude of potential bias in the results of seismic response analyses when the ground‐motion suite does not conform to the GCIM distribution is also demonstrated. The combination of these three features of the approach make it entirely holistic in that: any level of complexity in ground‐motion selection for any seismic response analysis can be exercised; users explicitly understand the simplifications made in the selected suite of ground motions; and an approximate estimate of any bias associated with such simplifications is obtained. Copyright © 2010 John Wiley & Sons, Ltd.     

An answer to an important controversy and the need for caution when using simple models to predict inelastic earthquake response of buildings with torsion

This paper presents evidence that the extension of conclusions based on the widely used simplified, one story, eccentric systems of the shear‐beam type, to actual, nonsymmetric buildings and consequent assessments of the pertinent code provisions, can be quite erroneous, unless special care is taken to match the basic properties of the simplified models to those of the real buildings. The evidence comes from comparisons of results obtained using three variants of simplified models, with results from the inelastic dynamic response of three‐ and five‐story eccentric buildings computed with detailed MDOF systems, where the members are idealized with the well‐known plastic hinge model. In addition, a convincing answer is provided on a pertinent hanging controversy: For frame‐type buildings, designed in accordance with the dynamic provisions of modern codes (such as EC8 or IBC2000), which allow reduced shears at the stiff edge due to torsion, the frames at the flexible sides are the critical elements in terms of ductility demands. Copyright © 2009 John Wiley & Sons, Ltd.     

Dynamic analysis of a cylindrical casing–cement structure in a poroelastic stratum

The transient response of a cylindrical casing–cement structure in a poroelastic stratum under dynamic radial tractions is one of the significant issues during the analysis of downhole operations and the selection of safe material. Based on the Biot theory and general elastic mechanics, this paper gives a set of exact solutions for radial displacement, stresses for the casing–cement system and the pore pressure of the infinite surrounding poroelastic stratum in the Laplace transform space. Solutions are presented for three different types of transient radial loadings acting on the surface of casing, i.e., suddenly applied constant load, gradually applied step load and triangular pulse load. Time domain solutions are obtained using a reliable numerical method of inverse Laplace transforms. A detailed parametric study about the transient response is presented both at the casing–cement interface and the cement–stratum interface, and the distributions of the pore pressure and the effective stresses in the stratum are also examined. Copyright © 2017 John Wiley & Sons, Ltd.     

Understanding and modeling basin hydrology: interpreting the hydrogeological signature

Basin landscapes possess an identifiable spatial structure, fashioned by climate, geology and land use, that affects their hydrologic response. This structure defines a basin's hydrogeological signature and corresponding patterns of runoff and stream chemistry. Interpreting this signature expresses a fundamental understanding of basin hydrology in terms of the dominant hydrologic components: surface, interflow and groundwater runoff. Using spatial analysis techniques, spatially distributed watershed characteristics and measurements of rainfall and runoff, we present an approach for modelling basin hydrology that integrates hydrogeological interpretation and hydrologic response unit concepts, applicable to both new and existing rainfall‐runoff models. The benefits of our modelling approach are a clearly defined distribution of dominant runoff form and behaviour, which is useful for interpreting functions of runoff in the recruitment and transport of sediment and other contaminants, and limited over‐parameterization. Our methods are illustrated in a case study focused on four watersheds (24 to 50 km²) draining the southern coast of California for the period October 1988 though to September 2002. Based on our hydrogeological interpretation, we present a new rainfall‐runoff model developed to simulate both surface and subsurface runoff, where surface runoff is from either urban or rural surfaces and subsurface runoff is either interflow from steep shallow soils or groundwater from bedrock and coarse‐textured fan deposits. Our assertions and model results are supported using streamflow data from seven US Geological Survey stream gauges and measured stream silica concentrations from two Santa Barbara Channel–Long Term Ecological Research Project sampling sites. Copyright © 2004 John Wiley & Sons, Ltd.     

潜水延迟给水理论模型探讨

基于对失饱和带毛管与潜水流间交互作用的分析，提出了以“失水带迟后反应”模式计算延迟给水下的定降深流动①的成因方法。它能自然地解释水位、水头的Ｗａｌｔｏｎ三阶段演变规律，且拟合实测资料，具较强实用性。现行的纽曼代表性模型未能考虑延迟给水作用，因而其水位计算结果与实测线型相反．博尔顿法是经验性的，未予揭示该现象成因。本法基本上解决了上述问题。文后图示了各参变量对水头时空分布的影响。验算表明，将本法用于潜水出流试验推求含水层参数，可获更佳结果。