Winkler model for dynamic response of composite caisson–piles foundations: Seismic response

A simplified method with a dynamic Winkler model to study the seismic response of composite caisson–piles foundations (CCPF¹) is developed. Firstly, with the dynamic Winkler model, the kinematic response of the CCPF subjected to vertically propagating seismic S-wave is analyzed by coupling the responses of caisson part and pile part. Secondly, a simplified model for the foundation–structure system is created with the structure simplified as a lumped mass connected to the foundation with an elastic column, and through the Fast Fourier Transformation (FFT) this model is enabled to solve transient seismic problems. Thirdly, the proposed method for the seismic response of CCPF-structure systems is verified by comparison against 3D dynamic finite element simulation, in which the Domain Reduction Method (DRM²) is utilized. Lastly, the mechanism and significance of adding piles in improving the earthquake resistance of the foundation and structure is analyzed through an example with different soil conditions. Discovered in this study is that adding piles under the caisson is an efficient way to increase seismic resistant capability of the soil–foundation–structure system, and the main mechanism of that is the elimination of the pseudo-resonance.     

Stability of end-bearing piles in a non-homogeneous elastic foundation

The stability of end-bearing piles that are supported laterally along their entire length by an elastic Winkler foundation is investigated for the case when the coefficient of horizontal subgrade reaction varies linearly with depth. A pattern of clustering of buckling modes is shown to occur and the approximate modelling of the elastic foundation by averaging the stiffness of the subgrade is discussed. © 1997 by John Wiley & Sons, Ltd.     

文克尔地基模型下液化土桩基水平振动响应分析

在桩基顶部承受竖向荷载作用的条件下,将完全液化后的上层土体视为流体,将桩基等效为欧拉-伯努利梁模型,探讨了桩底嵌固时桩基顶部的水平振动阻抗。运用流体动力方程模拟顶部液化土层的运动,运用文克尔地基模拟下部非液化分层土的运动。结合传递矩阵法,利用液化土与非液化分层土交界面处的位移、转角和内力连续条件,得到桩基顶部和底部的相关位移?内力表达关系式。根据桩基底部的嵌固条件,求得桩顶阻抗的表达式。与已有文献解进行对比,验证了分析过程的正确性。对阻抗影响条件进行参数分析,表明液化深度、轴力和流体密度大小对桩顶阻抗有不同的影响。     

Winkler弹性地基板梁的自由振动分析

中短型轨道板的几何构型介于梁、板之间,属于宽梁结构。从Mindlin板理论出发,退化得到适用于宽梁的Mindlin板梁控制方程;引入Winkler地基刚度系数,推导得到位移和转角的模态函数表达式。考虑两端简支的边界条件,得到弹性地基板梁的自由振动特征方程。通过无量纲数值算例求解出弹性地基板梁的自振频率,并与Timoshenko梁理论和Mindlin板理论进行对比。研究高跨比、泊松比和弹性地基刚度等参数对结构自振特性的影响,总结出弹性地基板梁方程的特点及适用范围,即宽度效应显著且泊松比较大的宽梁结构。     

边坡土体侧移模式对抗滑桩影响分析

在开挖、降雨或地震等外部因素作用下,边坡土体很容易进入局部或瞬态大变形乃至失稳滑动,使抗滑桩产生附加位移及弯矩。基于两阶段分析方法,采用Winkler模型模拟抗滑单桩与土之间的相互作用,建立单桩水平位移控制方程组,根据内力与位移的连续条件得到考虑不同土体侧移模式下求解桩身响应的矩阵解析表达式,并采用现场监测数据及Poulos弹性理论进行验证,证明该方法是合理可行的,并通过参数分析土体侧移对抗滑桩水平承载性状的影响程度。分析结果表明,土体侧移模式包括最大侧移值、分布形状及重心、侧移势等,对抗滑桩的挠度和弯矩均有显著影响,在工程设计中应予以充分重视。     

双排抗滑桩上滑坡推力近似解析方法

双排抗滑桩是加固大型滑坡的常用工程措施之一,在实际工程设计计算中的关键环节在于简单且合理地确定作用于前后排桩上的滑坡推力。将抗滑桩受荷段前侧坡体视为水平向的温克勒（Winkler）地基,基于弹性地基梁模型,并充分考虑桩体受荷段与锚固段的变形连续性,通过迭代算法确定出后排抗滑桩受荷段前侧坡体抗力,进而可对排间坡体采用传递系数法计算出前排桩桩后滑坡推力,给出了相关的理论计算公式。通过室内模型试验验证了所提方法的合理性,并针对一大型基覆式滑坡实例,具体计算出了前后排桩上的设计滑坡推力荷载。所提计算方法可为实际工程的简化设计提供参考。     

地面超载引起邻近埋地管道的位移分析

地基土承受超载作用时就会产生沉降,在土体沉降作用下埋置于其中的管道,管壁就会产生变形甚至破裂。为分析地面超载对临近地下管线的影响,基于温克勒（Winkler）弹性地基短梁理论,应用Boussinesq解,考虑地面超载引起下卧层的沉降及地基土体的侧向移动对管道的影响,建立地面超载对埋地管道影响的分析计算模型,并采用有限差分法进行求解;通过算例分析了超载大小、位置,管道刚度、埋深、管径以及土体性质对埋地管道位移的影响;结果表明：超载大小、管道的刚度、埋深、管径对地下管道位移的影响较大,而当地基基床系数和超载离管道的距离增大到一定值时,地面超载对其影响将减弱。因此,需要考虑邻近超载对管道的影响,合理制定埋地管道的保护措施。     

双层地基水平受荷桩受力变形分析

基于双层地基中的水平受荷桩的特性,对其受力变形进行了分析。将水平受荷桩视为竖直放置的弹性地基梁,基于Winkler弹性地基梁理论,考虑桩土共同工作得到水平受荷桩位移控制微分方程及其幂级数解答,进而根据内力与位移的连续条件得到了由桩顶受力及变形条件表示任一深度处桩身的水平位移、转角、弯矩及剪力的计算矩阵表达式。通过一具体算例将幂级数解计算结果与《公路桥涵地基与基础设计规范》推荐的简化计算公式计算结果进行了比较。结果表明：当第1层地基土的厚度在某一定值时,《规范》简化计算方法所得结果与幂级数解接近;但当层厚不在该值附近时,两个方法计算结果存在差异。     

Cercis siliquastrum Tree Leaves as an Efficient Adsorbent for Removal of Ag(I): Response Surface Optimization and Characterization of Biosorption

The Cercis siliquastrum tree leaves are introduced as a low cost biosorbent for removal of Ag(I) from aqueous solution in a batch system. FT‐IR, XRD analysis, and potentiometric titration illustrate that the adsorption took place and the acidic functional group (carboxyl) of the sorbent was involved in the biosorption process. In addition, it was observed that the pH beyond pH_pzc 4.4 is favorable for the removal procedure. The effect of operating variables such as initial pH, temperature, initial metal ion concentration, and sorbent mass on the Ag(I) biosorption was analyzed using response surface methodology (RSM). The proposed quadratic model resulting from the central composite design approach (CCD) fitted very well to the experimental data. The optimum condition obtained with RSM was an initial concentration of Ag(I) of 85 mg L^?1, pH = 6.3 and sorbent mass 0.19 g. The applicability of different kinetic and isotherm models for current biosorption process was evaluated. The isotherm, kinetic, and thermodynamic studies showed the details of sorbate‐sorbent behavior. The competitive effect of alkaline and alkaline earth metal ions during the loading of Ag(I) was also considered.     

基于空气介质的光学溶解氧传感器便捷校准方法研究

基于荧光猝灭原理的光学溶解氧传感器可获得海水溶解氧时空数据,被广泛应用于海洋环境长期监测,但因其在贮存期间和布放期间会发生"贮存漂移"和"测量漂移",需要进行校准.现有的实验室校准方法周期长、操作复杂.本文研究了光学溶解氧传感器在空气和水体两种不同介质中的响应特性,提出一种利用空气介质的光学溶解氧传感器现场校准方法,并...