Geochemical characteristics of modern river sediments in Myanmar and Thailand: Implications for provenance and weathering

The elemental composition of organic matter and the major and trace element compositions of stream sediments from Myanmar (Ayeyarwady and Sittaung rivers) and Thailand (Mekong and Chao Phraya rivers, and their tributaries) were determined to examine their distributions, provenance, and chemical weathering processes. Higher total organic carbon (TOC) and total nitrogen (TN) contents in the finer grained sediments indicate hydrodynamic energy may control their distributions. TOC/TN ratios indicate inputs of both aquatic macrophyte and higher vascular plant material to the river sediments. The major element abundances of the sediments are characterized by predominance of SiO₂ in coarser fractions and a marked negative correlation with Al₂O₃, representing primary grain size primarily control on SiO₂ content. Marked depletion of most labile elements (Na₂O, CaO, K₂O, Ba and Sr) relative to UCC (upper continental crust), indicate destruction of feldspar during chemical weathering in the source area or during transport. However, enrichment of some high field strength elements (Zr, Th, Ce and Y) relative to UCC and higher Zr/Sc ratios indicate moderate concentration of resistant heavy minerals in finer-grained samples. Discriminant diagrams and immobile trace element characteristics indicate that the Mekong, and Chao Phraya river sediments were largely derived from felsic sources with compositions close to typical rhyolite, dacite/granodiorite, UCC, I- and S-type granites. Relative enrichment of ferromagnesian elements (e.g. MgO, Cr, Ni) and high Cr/V and low Y/Ni ratios in Ayeyarwady and Sittaung sediments indicate the presence of a mafic or ultramafic component in their sources. The ICV (Index of Compositional Variability), CIA (Chemical Index of Alteration), PIA (Plagioclase Index of Alteration), α^Al, Rb/Sr and K₂O/Rb ratios indicate that the Ayeyarwady and Sittaung sediments record low to moderate degrees of chemical weathering in their source, compared to moderate to intense chemical weathering in the Mekong and Chao Phraya river basins. These results are compatible with existing major ion data for river waters collected at the same locations.     

Detrital record of the denudation of volcanic islands under sub-tropical climate (Cape Verde)

This research is focused on the composition of the sediments produced in volcanic islands when the climate does not favour weathering. The XRD mineralogy (bulk sample and fraction finer than 63 μm), petrography and geochemistry of a set of bedload stream and beach samples collected in the “old” Maio and the “young” Fogo islands of Cape Verde archipelago are used to investigate the compositional transformations promoted by exogenous processes during island denudation. The main factor responsible for the variability in sediment composition is the incorporation of biogenic material derived from the evolving shelves; it largely exceeds the effects of the exhumation of different volcanic and basement units. Given the arid climate (and steep land surface in Fogo), only the most labile components of basaltic rocks, such as volcanic glass, are decomposed. The incipient weathering and sorting processes are responsible for the depletion of Al in bedload deposits. The same happens with other elements usually regarded as non-mobile (namely, Nb, Th, REE, etc.), while Mg is concentrated. Thus, weathering indices grounded on the premise that “mobile” elements are lost and “non-mobile” elements are enriched via weathering are useless in Cape Verde bedload sediments. With time, weathering is able to promote Na leaching and the formation of secondary minerals, which tend to retain non-mobile elements released in the earlier stages of alteration (e.g., LREE, Th, Y, Nb, Ta etc.). Sorting processes are responsible for the selective removal of less-dense grains, explaining local differences between beach and stream deposits. Beach placers are enriched in augitic clinopyroxene (occasionally also in olivine in the Fogo island), and Sc, Cr and Co. Niobium and Ta must be hosted in fine-grained particles that are easily windblown and their abundances in dusts may reveal Cape Verde as a source of airborne material crossing the Atlantic Ocean.     

Interaction of oil and mineral fines on shorelines: review and assessment

The interaction of fine mineral particles with stranded oil in an aqueous medium reduces the adhesion of the oil to solid surfaces, such as sediments or bedrock. The net result is the formation of stable, micron-sized, oil droplets that disperse into the water column. In turn, the increase in surface area makes the oil more available for biodegradation. This interaction, referred to as oil–mineral aggregate (OMA) formation, can explain how oiled shorelines are cleaned naturally in the absence of wave action in very sheltered coastal environments. OMA formation also plays an important role in the efficacy of shoreline treatment techniques, such as physical mixing and sediment relocation that move oiled sediments into the zone of wave action to promote the interaction between oil and mineral fines. Successful application of these shoreline treatment options has been demonstrated at two spill events (the Tampa Bay response in Florida and the Sea Empress operation in Wales) and at a controlled oil spill experiment in the field (the 1997 Svalbard ITOSS program). Sediment relocation harnesses the hydraulic action of waves so that the processes of fine-particle interaction and physical abrasion usually occur in tandem on open coasts. There has been no evidence of significant detrimental side-effects of residual oil in pelagic or benthic environments associated with the use of these treatment options to enhance rates of dispersion and oil biodegradation.     

Hydraulic conductivity and pore fluid chemistry in artificially weathered plastic clay

Triaxial and oedometer tests have examined how freezing–thawing (FT) and drying–wetting (DW) affect the hydraulic conductivity of a natural plastic clay. Because the clay was expansive, FT and DW in the laboratory produced only one order of magnitude increase in hydraulic conductivity above the ‘undisturbed’ value when permeated with water. Permeation with sodium carbonate or dimethyl sulfoxide reduced the hydraulic conductivity towards the undisturbed value, though some increases still remained. Hydraulic conductivities measured by oedometer were lower than those in the triaxial tests and varied strongly with applied pressure.     

海南岛北部玄武岩上土壤发生的化学特性研究

海南岛北部不同时期喷发的玄武岩上发育的土壤构成一个风化成土时间系列。对这一土壤系列的化学特性研究表明，随风化成土时间的增加，pH值不断下降，但至富铁土后，pH趋于稳定，而土壤CEC7，盐基饱和度下降。同时，土体中Al2O3、Fe2O3、TiO2含量增加，而Ca、Mg、K、Na淋失强烈，SiO2含量也不断降低。以土壤中大量元素含量为基础计算多数指标难以反映热带地区碱金属和碱土金属元素迅速而强烈淋失的成土风化过程。常用的土体分子硅铝率和硅铁铝率并不能指示所有土壤的风化成土作用程度。     

晋宁磷矿表生改造型矿床及其判别标志

根据晋宁磷矿次生风化作用过程中磷块岩组成和结构的变化，归纳晋宁磷矿矿床特征及其影响因素，正确确定该矿风化矿石的判别指标。     

9000 years of geochemical evolution of lithogenic major and trace elements in the sediment of an alpine lake – the role of climate, vegetation, and land-use history

A 9000cal. year record of geochemistry was analysed in a sediment core obtained from a Swiss alpine hard-water lake (1937 ma.s.l.) that is located at the present-day tree-line. Geochemical stratigraphies are compared to changes in mineralogy, grain-size, pollen, and macrofossil records. This allows the reconstruction of the effects of changes in vegetation and of 3500 years of land-use in the catchment area on sediment geochemistry. Using principal component analysis, two major geochemical groups are distinguished: (i) Changes in concentrations of Rb, Ti, Zr, Fe, As, and Pb are closely related to corresponding changes in the concentrations of quartz and clay. They are thus considered to represent the silicate fraction which shows an increase from the oldest to the youngest core section. (ii) In contrast, Ca and Sr concentrations are positively correlated with changes in silt, sand, and calcite. They are therefore considered to represent the carbonate fraction which gradually decreased. Based on constrained cluster analysis, the core is divided into two major zones. The oldest zone (A; 9000–6400 cal.BP) is characterised by high concentrations of detrital carbonates. The more open catchment vegetation at that time promoted the physical weathering of these carbonates. The second major zone (B, 6400 cal.BP–1996 AD) is divided into four subsections with boundaries at ca. 3500, 2400, and 160cal. BP. The lower part of this zone, B1, is characterized by a gradual decrease in the carbonate-silt fraction and a pronounced increase in the silicate-clay fraction. This is concurrent with the expansion of Picea in the catchment area, which probably stabilized the soil. The middle part, B2 and B3 (3500–160cal. BP), comprises pronounced fluctuations in all elements, especially Ca, Sr, Mn, and Rb, but also in clay and silt. These changes are related to varying intensities of alpine farming. In the same section, Mn/Fe ratios are highly variable, suggesting changes in the mixing regime of the lake with phases of anoxic bottom water. The uppermost section, B4 (since 160cal. BP), is characterized by a steep decline in the silicate fraction and an increase in Ca and Sr. Despite the decrease in the silicate fraction, Pb increases, due to elevated atmospheric input resulting from early metal pollution, are masked by the high natural variability. Generally, changes in vegetation, which correspond to climate changes in the early Holocene and to human activities since ca. 3700cal. BP, are the controlling factor for variations in the geochemical composition of the sediment of Sägistalsee.     

Sodium sulphate weathering and the disintegration of Mohenjo-Daro,Pakistan

In Pakistan various brick building structures are currently disintegrating in the Indus Valley. These include the Harappan site of Mohenjo-Daro. The environment of this site is described, the nature and speed of the disintegration problem is outlined, and the cause of disintegration is discussed Weathering occurs in association with the development of salt efflorescences and some bricks disintegrate only a few years after being laid down. Chemical and X-ray diffraction analyses show that the predominant salt is the sodium sulphate mineral thenardite. The reasons for its effectiveness are discussed. They include its high solubility, the rapid change of solubility with temperature, and its hydration characteristics.     

Hydrothermal alteration and earth surface rock weathering: A basalt example

Geomorphologists have not devoted sufficient attention to the formation of clay minerals by hydrothermal activity. This paper describes the breakdown of freshly-quarried basalt by cyclic wetting and drying. Breakdown is attributed to the swelling of hydrothermally-derived smectite, and it is argued that the effects of endogenic processes can exert a significant control upon weathering behaviour under earth surface conditions.     

Rock hardness and landform development in the Gunong Mulu National Park,Sarawak, E. Malaysia

Rock hardness, measured by the Schmidt Test Hammer, is an important factor in explaining some of the sharp contrasts in relief and wide variety of landforms in The Gunong Mulu National Park. It is also useful in consideration of contemporary geomorphological processes, such as landsliding.