随县-马鞍山地带地壳与上地幔结构及郯庐构造带南段的某些特征

本义利用1979-1981年中国科学院地球物理研究所在随县-马鞍山所做的人工源地震探测的资料,采用二维射线追踪来拟合地震波的走时和振幅,取得了该地带的地壳与上地慢速度结构.结果表明,该地带地壳厚度为32-37km,莫霍面起伏变化显著.地壳速度的横向变化甚为强烈,地壳中部存在低速层.在巢湖以西宽数10km的范围内,地壳结构与其它地方明显不同,上地壳速度明显偏高,莫霍面上隆并有间断;在其两侧,明显可见有两条深断裂.结合其它地球物理场特征及大地构造概况,对结果进行分析,认为郯庐构造带南段被两条深断裂所夹,构造带宽度可达数10km,并在地质历史时期曾有过地幔物质上涌.     

黄河上游某坝址平硐开挖后岩体变异时间效应规律分析

工程岩体开挖后改变了原来的赋存条件与环境，沿硐壁岩体表面卸荷由于应力的重新调整，表现在波速上升的下降，即岩体性状发生变异。随着时间的增加，变异程度加大，而变异的速率却逐年下降，文章根据黄河上游某水电工程坝址平硐壁不同时间（几个同点位）弹性波速测量结果，拟合了波速年下降率Ｄ（％）与开挖一测定时间间隔Ｎ（ａ）的函数关系。并根据这种关系进行岩体波速的反算，求得了开挖时岩体的波速值，反映其本来的性状，对一     

渭河断陷及邻近地区莫霍界面速度图象

根据陕西省及邻省地震台网的地震记录，利用地震及工矿爆破的首波走时，采用地震层析技术，重建了渭河断陷及邻近地区的莫霍界面速度图象。并对速度横向不均匀性及其与地质构造、地震活动的关系进行了探讨     

Travel-time residuals and three-dimensional velocity structure of Italy

Jeffreys-Bullen P and PKP travel-time residuals observed at more than 50 seismic stations distributed along Italy and surrounding areas in the time interval 1962–1979, indicate the complex velocity pattern of this region. Strong lateral velocity inhomogeneities and low velocity zones are required to explain the observed pattern of residuals. In particular, late arrivals of about 1 sec are observed in the Apenninic mountain range, requiring both greater crustal thickness and low velocity layers, coherent with seismic refraction data and surface wave dispersion measurements. The seismic stations located in the Western and Eastern Alps indicate the presence of high velocities. In the Western Alps the strong azimuthal variation of residuals and the high values of early arrivals have a close relationship to the Ivrea body, an intrusive crustal complex characterized by a velocity as high as 7–7.2 km/sec.A travel-time inversion performed with theAki et al. (1977) block model, confirms the peculiar characteristics and the sharp variations in the lithosphere of the whole Italian region, with values of velocity perturbations between many adjacent blocks, ranging in size from 50 to 100 km, and independent from the earth parametrization chosen, reaching values up to 10% in the lithospheric part and 5% in the asthenosphere. 3-D inversion requires also high velocity along the Tyrrhenian coastal margin, equivalent to an uprise of major crustal and lithospheric discontinuities along this part of the Italian peninsula. Moreover low velocity material must be present in the northern part of the Adriatic foreland, in the lithosphere-asthenosphere system, closely related to the stress and seismicity pattern, and the lateral bending of the lithosphere in the same region.     

Further Studies Of Atmospheric Turbulence In Layers Near The Surface: Scaling The Tke Budget Above The Roughness Sublayer

The second of two experimental studies of the TKE budget conducted on sites of different roughness is described, and results are compared. The first took place within a shallow layer above a small field of mostly bare, cultivated soil; the second was carried out above a roughness sublayer of significant depth on an extensive plain of tall dry grass. Budget terms observed in the second study were scaled with a modified u which compensated for effects of an unusually large stress gradient and ensured that the _m functions would be collinear. By showing that the modification becomes negligible in smaller gradients, it is demonstrated that in normal conditions, budgets observed above significant roughness sublayers should be normalized by scaling in terms of the unreduced Reynolds stress at the sublayer's upper surface. This procedure is shown to be consistent with the expectation that TKE budgets in layers near the surface all scale in fundamentally the same way.Other findings include: (1) the fact that most _m functions previously reported are not quite collinear is attributed to a type of overspeeding known to affect three-cup anemometers; (2) revised _m functions, collinear and largely free of the effects of overspeeding, are determined from a well-established characteristic of the linear _m relation for the stable case; (3) data that define collinear _m functions can also be represented with single hyperbolic curves; (4) dissipation is found to be 10 to 15% too small to balance total TKE production in unstable and neutral conditions and to decrease with increasing z/L in thestable regime; and (5) new relations for based on the observed behaviour of the dissipation deficit provide an improved closure for the set of equations that express the budget terms as functions of _m and z/L.     

Modeling forced pool–riffle hydraulics in a boulder-bed stream, southern California

The mechanisms which control the formation and maintenance of pool–riffles are fundamental aspects of channel form and process. Most of the previous investigations on pool–riffle sequences have focused on alluvial rivers, and relatively few exist on the maintenance of these bedforms in boulder-bed channels. Here, we use a high-resolution two-dimensional flow model to investigate the interactions among large roughness elements, channel hydraulics, and the maintenance of a forced pool–riffle sequence in a boulder-bed stream. Model output indicates that at low discharge, a peak zone of shear stress and velocity occurs over the riffle. At or near bankfull discharge, the peak in velocity and shear stress is found at the pool head because of strong flow convergence created by large roughness elements. The strength of flow convergence is enhanced during model simulations of bankfull flow, resulting in a narrow, high velocity core that is translated through the pool head and pool center. The jet is strengthened by a backwater effect upstream of the constriction and the development of an eddy zone on the lee side of the boulder. The extent of flow convergence and divergence is quantified by identifying the effective width, defined here as the width which conveys 90% of the highest modeled velocities. At low flow, the ratio of effective width between the pool and riffle is roughly 1:1, indicating little flow convergence or divergence. At bankfull discharge, the ratio of effective width is approximately 1:3 between the pool and downstream riffle, illustrating the strong flow convergence at the pool head. The effective width tends to equalize again with a ratio of 1:1 between the pool and riffle during a modeled discharge of a five-year flood, as the large roughness elements above the pool become drowned out. Results suggest that forced pool–riffle sequences in boulder-bed streams are maintained by flows at or near bankfull discharge because of stage-dependent variability in depth-averaged velocity and tractive force.     

Velocity and turbulence variations at the edge of saltmarshes

Saltmarsh vegetation significantly influences tidal currents and sediment deposition by decelerating the water velocity in the canopy. In order to complement previous field results, detailed profiles of velocity and turbulence were measured in a laboratory flume. Natural Spartina anglica plants were installed in a 3 m length test section in a straight, recirculating flume. Different vegetation densities, water depths and surface velocities were investigated. The logarithmic velocity profile, which existed in front of the vegetation, was altered gradually to a skimming-flow profile, typical for submerged saltmarsh vegetation. The flow reduction in the denser part of the canopy also induced an upward flow (the current was partially deflected by the canopy). The skimming flow was accompanied by a zone of high turbulence co-located with the strongest velocity gradient. This gradient moved upward and the turbulence increased with distance from the edge of the vegetation. Below the skimming flow, the velocity and the turbulence were low. The structure of the flow in the canopy was relatively stable 2 m into the vegetation. The roughness length (z₀) of the vegetation depends only on the vegetation characteristics, and is not sensitive to the current velocity or the water depth. Both the reduced turbulence in the dense canopy and the high turbulence at the top of the canopy should increase sediment deposition. On the other hand, the high turbulence zone just beyond the vegetation edge and the oblique upward flow may produce reduced sedimentation; a phenomenon that was observed near the vegetation edge in the field.     

丘陵浅山地区风速幂指数及其在大气环境质量预测中的应用

根据丘陵浅山地区8个测点低空风速实测资料进行风速廓线拟合，求得风速幂指数，将大气环境质量预测中的风速模式化，用来预测大气污染物的浓度分布。     

地震CT在寻找隐伏铜镍矿中的应用

用透射地震ＣＴ方法在金川龙首矿进行了隐伏铜镍矿体的探测试验．试验是在地下５００ｍ的１２８０平面上进行的，覆盖面积３００ｍ×３００ｍ．使用ＥＳ－２４０１Ｘ型４８道高分辨数字地震仪．铜镍矿体为高波速值的超基性侵入岩，采用纵波速度作为层析物理量是敏感的．研究区划分成８１×６４个单元，单元体大小为４ｍ×４ｍ．有效地震射线７６１９条，使用联合迭代重建法（ＳＩＲＴ）求解慢度走时方程．速度图像及地质解释表明测区中西部有一个高波速异常体，推断与含铜镍矿体或花岗体有关；此外还发现一条近东西向的低波速带，推断为断裂．     

利用深井地震速度记录确定震级的初步研究

利用上海遥测地震台网虹桥、南汇台深井地震速度记录资料讨论地震尾波衰减与震级关系.采用统计方法求得了用垂直向地震波持续时间 L 测定震级M_v 的公式M_v 虹桥=-0.981+1.677×log(L)+0.600×log(△)±0.22M_v 南汇=-1.461+1.979×log(L)+0.506×log(△)±0.22结果表明,地震速度记录的持续时间 L 的对数加上震中距(△,单位:km)的对数与震级在近震范围内(△<5°)呈线性关系,说明用地震速度记录同样可以测定地震震级,这有助于提高深井速度记录资料的推广和应用。