Mechanism for the rapid motion of the Qianjiangping landslide during reactivation by the first impoundment of the Three Gorges Dam reservoir, China

The first impoundment of the Three Gorges Dam reservoir in China started from a water surface elevation of 95 m on June 1, 2003 and reached 135 m on June 15, 2003. Shortly after the water level reached 135 m, many slopes began to deform and some landslides occurred. The Qianjiangping landslide is the largest one; it occurred on the early morning of July 14, 2003 and caused great loss of lives and property. Field investigation revealed that, although failure occurred after the reservoir reached 135 m, the stability of the slope was already reduced by preexisting sheared bedding planes. To study the mechanism of the rapid motion of this reactivated landslide, two soil samples were taken from a yellow clay layer and a black silt layer in the sliding zone, respectively, and a series of ring shear tests were conducted on the samples. One series of ring shear tests simulates the creep deformation behavior, while the other series simulates different shear rates. Conclusions drawn from analysis of the ring shear tests indicate that the mechanism of the rapid motion of the reactivated landslide was caused by the rate effect of the black silt layer during the motion phase after the creep failure. The yellow clay layer did not play any important role in the rapid motion in the 2003 event.     

Lithium and lithium isotope profiles through the upper oceanic crust: a study of seawater-basalt exchange at ODP Sites 504B and 896A

Ocean Drilling Program (ODP) Hole 504B near the Costa Rica Rift is the deepest hole drilled in the ocean crust, penetrating a volcanic section, a transition zone and a sheeted dike complex. The distribution of Li and its isotopes through this 1.8-km section of oceanic crust reflects the varying conditions of seawater alteration with depth. The upper volcanic rocks, altered at low temperatures, are enriched in Li (5.6-27.3 ppm) and have heavier isotopic compositions (δ⁷Li=6.6-20.8‰) relative to fresh mid-ocean ridge basalt (MORB) due to uptake of seawater Li into alteration clays. The Li content and isotopic compositions of the deeper volcanic rocks are similar to MORB, reflecting restricted seawater circulation in this section. The transition zone is a region of mixing of seawater with upwelling hydrothermal fluids and sulfide mineralization. Li enrichment in this zone is accompanied by relatively light isotopic compositions (−0.8-2.1‰) which signify influence of basalt-derived Li during mineralization and alteration. Li decreases with depth to 0.6 ppm in the sheeted dike complex as a result of increasing hydrothermal extraction in the high-temperature reaction zone. Rocks in the dike complex have variable isotopic values that range from −1.7 to 7.9‰, depending on the extent of hydrothermal recrystallization and off-axis low-temperature alteration. Hydrothermally altered rocks are isotopically light because ⁶Li is preferentially retained in greenschist and amphibolite facies minerals. The δ⁷Li values of the highly altered rocks of the dike complex are complementary to those of high-temperature mid-ocean ridge vent fluids and compatible to equilibrium control by the alteration mineral assemblage. The inventory of Li in basement rocks permits a reevaluation of the role of oceanic crust in the budget of Li in the ocean. On balance, the upper 1.8 km of oceanic crusts remains a sink for oceanic Li. The observations at 504B and an estimated flux from the underlying 0.5 km of gabbro suggest that the global hydrothermal flux is at most 8×10⁹ mol/yr, compatible with geophysical thermal models. This work defines the distribution of Li and its isotopes in the upper ocean crust and provides a basis to interpret the contribution of subducted lithosphere to arc magmas and cycling of crustal material in the deep mantle.     

A critical state interpretation for the cyclic liquefaction resistance of silty sands

Contrary to many laboratory investigations, common empirical correlations from in situ tests consider that the increase in the percentage of fines leads to an increase of the cyclic liquefaction resistance of sands. This paper draws upon the integrated Critical State Soil Mechanics framework in order to study this seemingly not univocal effect. Firstly the effect of fines on the Critical State Line (CSL) is studied through a statistical analysis of a large data set of published monotonic triaxial tests. The results show that increasing the content of non-plastic fines practically leads to a clockwise rotation of the CSL in (e–ln p) space. The implication of this effect on cyclic liquefaction resistance is subsequently evaluated with the aid of a properly calibrated critical state elasto-plastic constitutive model, as well as a large number of published experimental results and in situ empirical correlations. Both sets of data show clearly that a fines content, less than about 30% by weight, may prove beneficial at relatively small effective stresses (p₀<50–70 kPa), such as the in situ stresses prevailing in most liquefaction case studies, and detrimental at larger confining stresses, i.e. the stresses usually considered in laboratory tests. To the extent of these findings, a correction factor is proposed for the practical evaluation of liquefaction resistance in terms of the fines content and the mean effective confining stress.     

Precise/ Small Sample Size Determinations of Lithium Isotopic Compositions of Geological Reference Materials and Modern Seawater by MC-ICP-MS

The Li isotope ratios of four international rock reference materials, USGS BHVO-2, GSJ JB-2, JG-2, JA-1 and modern seawater (Mediterranean, Pacific and North Atlantic) were determined using multi-collector inductively coupled plasma-mass spectrometry (MC-ICP-MS). These reference materials of natural samples were chosen to span a considerable range in Li isotope ratios and cover several different matrices in order to provide a useful benchmark for future studies. Our new analytical technique achieves significantly higher precision and reproducibility (< ± O.3%o 2s) than previous methods, with the additional advantage of requiring very low sample masses of ca . 2 ng of Li.     

The influence of particle composition on thorium scavenging in the NE Atlantic ocean (POMME experiment)

²³⁰Th, ²³²Th and ²³⁴Th were analyzed in sinking particles collected by moored and drifting sediment traps in the NE Atlantic Ocean (POMME experiment) in order to constrain the phase(s) carrying Th isotopes in the water column. It reveals a contrasted behaviour between ²³⁴Th and ²³⁰Th. ²³⁴Th is correlated to the particulate organic carbon suggesting that it is primarily scavenged by organic compounds in the surface waters. ²³⁰Th_xs is correlated with Mn, Ba and the lithogenic fraction that are enriched in small suspended particles and incorporated in the sinking particulate flux throughout the water column. The lack of correlation between ²³⁰Th_xs and CaCO₃ or biogenic silica (bSi) indicates that CaCO₃ and bSi are not responsible for ²³⁰Th scavenging in the deep waters of this oceanic region. ²³⁰Th is generally correlated with the lithogenic content of the trapped material but this correlation disappears in winter during strong atmospheric dust inputs suggesting that lithogenic matter is not directly responsible for ²³⁰Th scavenging in the deep waters or that sufficient time is required to achieve particle–solution equilibration. MnO₂ could be the prevalent ²³⁰Th_xs-bearing phase. The narrow range of K_{d_MnO2}^Th obtained for very contrasted oceanic environments supports a global control of ²³⁰Th_xs scavenging by MnO₂ and raises the possibility that the ²³⁰Th–²³¹Pa fractionation is controlled by the amount of colloidal MnO₂ in seawater.     

Elastic lateral dynamic impedance functions for a rigid cylindrical shell type foundation

Elastic lateral dynamic impedance functions are defined as the ratio of the lateral dynamic force/moment to the corresponding lateral displacement/rotation at the top ending of a foundation at very small strains. Elastic lateral dynamic impedance functions have a defining influence on the natural frequencies of offshore wind turbines supported on cylindrical shell type foundations, such as suction caissons, bucket foundations, and monopiles. This paper considers the coupled horizontal and rocking vibration of a cylindrical shell type foundation embedded in a fully saturated poroelastic seabed in contact with a seawater half‐space. The formulation of the coupled seawater–shell–seabed vibration problem is simplified by treating the shell as a rigid one. The rigid shell vibration problem is approached by the integral equation method using ring‐load Green's functions for a layered seawater‐seabed half‐space. By considering the boundary conditions at the shell–soil interface, the shell vibration problem is reduced to Fredholm integral equations. Through an analysis of the corresponding Cauchy singular equations, the intrinsic singular characteristics of the problem are rendered explicit. With the singularities incorporated into the solution representation, an effective numerical method involving Gauss–Chebyshev method is developed for the governing Fredholm equations. Selected numerical results for the dynamic contact load distributions, displacements of the shell, and lateral dynamic impedance functions are examined for different shell length–radius ratio, poroelastic materials, and frequencies of excitation. Copyright © 2016 John Wiley & Sons, Ltd.     

Investigation of the elevation of saltwater wedge due to subsurface dams

Subsurface dams are rather effective and used for the prevention of saltwater intrusion in coastal regions around the world. We carried out the laboratory experiments to investigate the elevation of saltwater wedge after the construction of subsurface dams. The elevation of saltwater wedge refers to the upward movement of the downstream saltwater wedge because the subsurface dams obstruct the regional groundwater flow and reduce the freshwater discharge. Consequently, the saltwater wedge cannot further extend in the longitudinal direction but rises in the vertical profile resulting in significant downstream aquifer salinization. In order to quantitatively address this issue, field-scale numerical simulations were conducted to explore the influence of various dam heights, distances, and hydraulic gradients on the elevation of saltwater wedge. Our investigation shows that the upward movement of the saltwater wedge and its areal extension in the vertical domain of the downstream aquifer become more severe with a higher dam and performed a great dependence on the freshwater discharge. Furthermore, the increase of the hydraulic gradient and the dam distance from the sea boundary leads to a more pronounced wedge elevation. This phenomenon comes from the variation of the freshwater discharge due to the modification of dam height, location, and hydraulic gradient. Large freshwater discharge can generate greater repulsive force to restrain the elevation of saltwater wedge. These conclusions provide theoretical references for the behaviour of the freshwater–seawater interface after the construction of subsurface dams and help optimize the design strategy to better utilize the coastal groundwater resources.     

Influence of a coarse interlayer on seawater intrusion and contaminant migration in coastal aquifers

Vertical 2D slice laboratory experiments were carried out in homogenous and layered sand tanks to elucidate the effects of a highly permeable (coarse‐grained sand) interlayer on seawater intrusion and transport of contaminants to a coastal sea. Tidal fluctuations produced oscillations in the seawater–freshwater transition zone, fluctuations of the contaminant infiltration rate and a zigzag contaminant plume outline. The seawater wedge became discontinuous at the (vertical) edges of the interlayer because of increased lateral movement of the seawater–freshwater interface within the interlayer. The contaminant plume formed a tail within the interlayer depending on the tidal stage, and similar to the wedge, its movement was accentuated. A simple analytical model that neglected vertical flow reliably predicted steady‐state seawater intrusion into the coastal aquifer. Numerical modeling was used to gain insight into the groundwater hydrodynamics and contaminant migration. The numerical results confirmed the experimental findings, i.e. that a highly permeable interlayer can provide a rapid transit path for contaminants to reach the seaward boundary and that the interlayer amplifies the effects of tidal fluctuations, resulting in wider transition zones for the seawater wedge and contaminant plume. Numerical simulations further showed that, with increasing interlayer hydraulic conductivity, the maximum seawater intrusion distance inside the interlayer increases approximately linearly. For the fixed‐head contaminant injection condition used, the model showed that contaminant infiltration increases approximately logarithmically with increasing interlayer hydraulic conductivity (other factors held fixed). Copyright © 2013 John Wiley & Sons, Ltd.     

反渗透海水淡化技术现状和展望

反渗透膜技术于20世纪60年代取得突破性进展,促使反渗透海水淡化在近50年间高速发展,淡化产能自20世纪90年代起激增.海水反渗透(SWRO)淡化已成为目前投资最省、成本最低的利用海水制备饮用水的过程.文中主要对海水反渗透淡化的发展状况进行了介绍,如膜和组件的改进,关键设备高压泵和能量回收装置效率的提高,多种工艺过程的不断发展,包括预处理和后处理的新工艺,以及对环境的影响和相应对策等.反渗透技术的发展也推动了其他膜分离技术的进步,并扩展其应用领域.预计在不久的将来,膜技术在海水淡化和水再利用、扩大和保护水资源、循环经济、清洁生产、改造传统产业、节能减排及提高人民生活水平等方面发挥的作用会越来越显著.     

海口湾的溶解氧及海水水质指标限制值问题

海水溶解氧对海洋生物的生存、生长和发育相当重要,与生物活动有着密切的联系,它的含量变化是反映生物生长状况的一个重要标志,同时也是污染监测的重要指标.海口湾是海南省的重点海域,1989年以来,陈春华等对海口湾的环境问题进行了大量的研究[1~6],本论文就海口湾的溶解氧监测结果进行分析,并发现了溶解氧水质标准限制值存在的问题.每年在该湾布设10余个站点进行污染监测,有必要对海口湾近7年监测结果进行综合分析.