低频时码信号场强计的研制

介绍了BPC低频时码信号场强计的设计方案和原理,并结合出仪器硬件设计和控制软件框图,该仪器体积小,重量轻,测量精度高,对低频时码系统工程应用和低频电波传播特征研究具有重要意义。     

小波变换方法及其应用

简要介绍小波变换的方法,并给出了小波变换在地震前兆和爆破识别等方面的一些应用,探讨二进小波分析在地震前兆研究方面的应用前景。     

The underground application of Magnetic Resonance Soundings

The potential application of MRS technology in locating waterbearing fractures in underground mines is studied. The determination of the presence of water ahead of mining is important to prevent accidents and to ensure higher efficiency in mining operations. In the usual surface based measurements, with horizontal loop and water layer, the geometry of the problem can be summarized by the value of the inclination of the Earth magnetic field. For MRS measurements under the geometric conditions associated with underground mining, where the loop is non-horizontal, the geometry can be described in an effective inclination that can be expressed in terms of the Earth magnetic inclination and declination, together with two further parameters that characterize the orientation of the mine wall. We examine the consequences of the different geometries on the MRS signal. Since the loop size is severely restricted in underground conditions, the feasible target depth is also severely limited. The consequences of the fractured hard rock aquifer conditions, typical of deep mining or tunneling environments, are also examined. The overall conclusion is that in underground MRS applications the signal strength is too small to enable the practical identification of fractures containing large volumes of water ahead of the mining face.     

线性方程组与信号流图的相互变换

线性方程组与信号流图可以相互变换。把线性方程组变换为信号流图，利用信号流图运算规则，能简化运算并直观显示信号源和各变量间的因果关系；此外，把描述线性时不变系统的信号流图变换为线性方程组，然后利用线性代数的经典方法，能直接得出各变量的解。     

Dynamic characteristics of a base isolated building from ambient vibration measurements and low level earthquake shaking

Ambient vibration tests were conducted on a base-isolated apartment building in Takamatsu, Japan, to determine the mode shapes and the associated natural frequencies and damping ratios at very low levels of excitation. The latest developments in signal analysis for modal decomposition are used to analyze the ambient response data. A finite element model of the building and isolators was calibrated and refined using the experimental results from the ambient vibration tests. This model was then used to simulate the recorded response of the building under excitation from a small earthquake. The finite element model, calibrated by ambient vibration data and the low level of earthquake shaking, provides the starting point for modelling the non-linear response of the building when subjected to strong shaking.     

提取精密控制震源信号的自适应加权匹配滤波方法

为克服短时突发噪声对提取精密控制震源信号的影响, 本文研究并提出了加权匹配滤波方法。 通过评估记录中的噪声时间分布取得相对应的信号段的权重, 对噪声水平高的时段分配较小的权重, 噪声水平较低的时段分配较大的权重, 进行加权匹配滤波, 达到降低短时突发噪声的影响、 有效提高输出信号信噪比的目的。     

源自多个大电流源的华东地区地电场空间变化特征

在地震电磁学研究中,电流在地下流动特征与构造关系是一个非常重要的问题.多个强电流源的存在和大范围地电场观测站的分布格局为我们研究这个问题提供了更好的机会.本文通过利用上海及其周边地区4个地点不同的高压换流站接地极向地下注入的大电流(1200~4780A)信号,研究了华东地区8个台站组成的地电场观测台网接收到的附加地电场信号,推进了对地电流在地下传播特征的认识.研究显示:1从幅度特征而言,对于源自不同的大电流信号,各台站观测到的附加地电场信号幅度特征有很大不同,而近处的浦东台只能观测到南桥大电流源的信号而观测不到其他3个大电流源发出的信号,存在着所谓的"敏感点"效应;2对于上海地区4个接地极大电流而言,能够观测到源自它们的附加地电场的台站最远为350km,在更远的台站则观测不到.3从均匀度方面而言,在每个台站对于不同的信号源,记录到的附加地电场信号在各方向上的长极距和短极距信号幅度之比可以有很大变化;4在方位特征上,只有崇明台站接收到的同里接地极和华新接地极大电流信号的计算方位度数与实际方位度数误差最小,分别为0.2°和0.8°.而在距离各个信号源最近的青浦台,这种误差要比崇明台站的大;5极化方向特征显示,在青浦台和崇明台所观测到的附加地电场信号中,存在着同一方向上长、短极距信号极化方向是反向的现象,这与常理相悖,怎样解释该现象有待于今后进一步研究.本文从点电流源与台站测线布局构成的装置系统、大区域介质非均匀性、台站测区以及附近地区的介质细结构的影响三个方面,对上述特征进行了较深入的分析和解释.     

地学长江计划安徽实验中低频可控震源地震波信号提取方法评估

可控震源的激发过程精确可控、可重复性高。本文评估了重复激发形成的多道记录的信号增强方法,包括叠加方法和有效信号直接分离方法。相比线性叠加,加权叠加充分利用了有效信号的一致性,能进一步压制噪声,提高叠加记录的信噪比。相比时间域相位加权叠加,Semblance加权叠加更加稳定。时频域相位加权叠加能在时频域压制随机分散分布的噪声信号,叠加信号更加清晰。本文中,采用标准SVD分离获得的信号同线性叠加结果类似。本文利用密集分布的临时台阵评价地学长江计划安徽实验中低频可控震源在庐江第2激发点的激发效果。对比不同的处理流程发现,先互相关检测信号再进行时频域相位加权叠加能够取得最佳的处理效果,通过200多次重复激发,可以在50km范围内提取到较清晰的有效信号。     

与大电流信号有关的华北东部地区地电场空间变化特征的研究

在地震电磁学研究中,电流在地下的流动特征与构造关系是一个非常重要的问题.大范围观测站的分布和强电流源存在的格局为我们研究这个问题提供了机会.本文通过对青岛换流站接地极向地下注入2100~3004 A大电流时华北东部地区21个地电场台站观测的研究,深入认识了地电场信号变化实质.研究表明：①沿着郯庐断裂带方向、跨过郯庐断裂带西南方向、跨过郯庐断裂带北西方向能够记录到地电流信号的特征变化非常大,存在着明显方向性特征和“穴位”现象.②注入大地的电流强度越大,则在观测点记录到的地电流信号强度也越强.③本文研究区域里地电场信号的均匀度并不遵循均匀介质条件下的一般规律,说明地下介质电性非均匀性和各向异性特征明显.④大电流注入地下时能够较正确地反映信号源方位的台站较少,只有安丘台、大山台和新沂台所观测到的方位线可用于确定信号源的位置.本文从点电流源与台站测线布局构成的装置系统、大区域介质非均匀性、台站测区以及附近地区的介质细结构的影响三个方面,通过数值模拟,对上述特征进行了较深入的分析和解释.     

Spectral decomposition and de‐noising via time‐frequency and space‐wavenumber reassignment

The reassignment method remaps the energy of each point in a time‐frequency spectrum to a new coordinate that is closer to the actual time‐frequency location. Two applications of the reassignment method are developed in this paper. We first describe time‐frequency reassignment as a tool for spectral decomposition. The reassignment method helps to generate more clear frequency slices of layers and therefore, it facilitates the interpretation of thin layers. The second application is to seismic data de‐noising. Through thresholding in the reassigned domain rather than in the Gabor domain, random noise is more easily attenuated since seismic events are more compactly represented with a relatively larger energy than the noise. A reconstruction process that permits the recovery of seismic data from a reassigned time‐frequency spectrum is developed. Two approaches of the reassignment method are used in this paper, one of which is referred to as the trace by trace time reassignment that is mainly used for seismic spectral decomposition and another that is the spatial reassignment that is mainly used for seismic de‐noising. Synthetic examples and two field data examples are used to test the proposed method. For comparison, the Gabor transform method, inversion‐based method and common deconvolution method are also used in the examples.