不同填充及加载路径下劈裂砂岩渗流特性研究

采用劈裂宜昌砂岩,对中细砂、粗砂及混合砂砂粒填充条件下加载路径、轴压、围压、填充物颗粒粒径及填充物厚度对渗流速度的影响规律进行探讨。研究结果表明,在不同填充物一定的应力情况下,加力路径发生变化,渗流速度也发生变化,这是工程中测量渗流数据离散的原因之一;轴压与渗流速度成线性关系,当围压?3≤1.5 MPa时,围压对渗流的影响较大,当?3＞1.5 MPa时,围压对渗流的影响极小;粒径与渗流速度呈单调递增关系,围压对无填充物的影响大于对有填充物的影响;渗流速度与填砂厚度在一定范围内呈现指数递增关系、研究中给出特定条件下轴压围压与渗流速度的定量分析公式。     

流体包裹体爆裂法测温技术可靠性讨论——以江西大吉山钨矿为例

爆裂法是一种经济快速的流体包裹体测温技术,由于该技术的影响因素较多且测试精度往往不是很高,历来受到很多学者的质疑。为了讨论爆裂法测温技术的可靠性,在前人研究的基础上,利用冷热台对大吉山钨矿含矿石英脉中的包裹体爆裂温度进行了显微测温,分析了包裹体个体大小对爆裂温度的影响,发现两者之间存在着明显的反相关性;同时,对数据的进一步分析发现爆裂法测温曲线反映的爆裂峰是2期3类包裹体爆裂叠加的结果,但是实验测得的爆裂温度区间与爆裂法测温结果基本上是吻合的,这说明爆裂法测温技术虽然有较多的影响因素,但是在一定程度上是可靠的,尤其是在找矿勘探方面其潜力很大,值得推广应用。     

Application of Seismic Anisotropy Caused by Fissures in Coal Seams to the Detection of Coal-bed Methane Reservoirs

Coal-bed methane is accumulated in micro-fissures and cracks in coal seams. The coal seam is the source terrace and reservoir bed of the coal-bed methane (Qian et al., 1996). Anisotropy of coal seams is caused by the existence of fissures. Based on the theory of S wave splitting: an S wave will be divided into two S waves with nearly orthogonal polarization directions when passing through anisotropic media, i.e. the fast S wave with its direction of propagation parallel to that of the fissure and slow S wave with the direction of propagation perpendicular to that of the fissure.This paper gives the results of laboratory research and field test on the S wave splitting caused by coal-seam fissures: The results show that it is, feasible to detect fissures in coal seams by applying the converted S wave and finally gives the development zone and development direction of these fissures.     

地震动幅值沿深度变化研究

以美国加州强震观测计划(CSMIP)的6个土工台阵和日本Hosokura矿台阵为研究对象, 以323组三分量地表和地下地震动峰值数据为基础, 按照台阵场地的软硬和土层分布, 将其分为基岩、 土层和ldquo;土层/基岩rdquo;台阵. 对于同一类台阵记录的所有地震, 分别按照震级和地表地震动峰值的大小将其分类. 对于同一类台阵的各类地震, 分别对加速度、 速度和位移峰值沿深度的变化进行统计分析, 得到沿深度变化的峰值比, 并且用非线性最小平方法, 采用指数衰减模型, 对峰值比沿深度变化曲线进行拟合. 通过对各类场地的各类地震的分析, 得到了地震动峰值沿深度变化的初步规律.      

地震的多重分形统计特征研究

讨论了地震分布的多重分形统计特征。研究地震多重分形性质的计算方法及其应用于地震预报的可能性。采用推广Ｇｒａｓｓｂｅｒｇｅｒ－Ｐｒｏｃａｃｃｉａ算法从典型震区的地震数据计算地震多重分形分布的广义维数谱以确立较敏感的强震前兆，讨论了该算法的精度，数据量要求及适用范围。     

金刚石压腔结合拉曼光谱技术进行氧同位素分馏的实验研究

应用水热金刚石压腔结合拉曼光谱技术进行石英和方解石间氧同位素的分馏研究。金刚石压腔装置实现体系的高温高压条件,重氧水为提供18O的中间介质。首先给体系加压至500 MPa左右,然后升温至300℃使石英、方解石发生部分溶解,随后快速降至常温使溶解部分重新结晶,从而使矿物和重氧水之间发生同位素交换。拉曼光谱中,物质特征峰的峰强度比值与相应物质的量的比值呈线性相关,结合同位素分馏系数公式计算得出300℃时石英、方解石之间的氧同位素分馏系数为1.0016。此方法操作简便,实验过程采用原位测量方法,不破坏样品,避免了污染,提高了实验精度。实验数据的准确度证明了金刚石压腔结合拉曼光谱法进行稳定同位素分馏的实验研究是可行的。     

衬砌粗糙度对季节冻土区渠基土-衬砌接触面间峰值抗剪强度的影响北大核心CSCD

目前来看,在构筑物与土体表面粗糙度影响土-构筑物接触面间切向冻胀力方面的研究还较少,因此,本研究从川西季节冻土区渠基土-衬砌接触面的切向冻胀力问题出发,着重考虑衬砌表面粗糙度这一因素对接触面间抗剪强度、黏聚力、内摩擦角的影响规律和影响效应,并结合环境温度、含水率及冻结时长,利用正交分析综合探究了4种因素对接触面间峰值抗剪强度影响的相关性和显著性,结果表明:接触面间抗剪强度、黏聚力、内摩擦角随衬砌表面粗糙度变化呈现相同规律,即衬砌表面越粗糙,3项指标随即增大。正交分析中揭示了影响接触面间峰值抗剪强度大小最显著的因素是衬砌粗糙度,其次是环境温度和含水率,冻结时长的影响效应不显著,同时低温、低含水率、较长冻结时长、较高衬砌粗糙程度下的峰值抗剪强度越大。此项结果可为季节冻土区渠系工程防冻胀危害提供理论支撑。     

Oxygen isotope study of quartz-Al2SiO5 pairs from the Mica Creek area, British Columbia: implications for the recovery of peak metamorphic temperatures

Oxygen isotope analyses of quartz-Al₂SiO₅ pairs have been made for samples from the Mica Creek area, British Columbia. We have analysed quartz–kyanite nodules and quartz–kyanite and quartz–sillimanite in multiphase pelitic rocks from the staurolite–kyanite, kyanite, and sillimanite zones. Apparent temperatures calculated from oxygen isotopic fractionation range from 555 °C (staurolite–kyanite zone) to 695 °C (sillimanite zone). Temperatures from the quartz–kyanite nodules range from 630 to 675 °C. Some of the nodules show isotopic disequilibrium. Most of the results confirm predictions that bimineralic rocks will yield an estimate of peak metamorphic temperatures, when the less abundant mineral (an aluminium silicate) is the slower oxygen diffuser. Using cooling rates of 10–100 °C Ma^?1 for the multiphase rocks, measured crystal sizes and modes, the Fast Grain Boundary diffusion model with ‘wet’ diffusion data (P_H2O?1.0 kbar) yields predicted apparent temperatures which are generally lower than the measured apparent temperatures. The agreement is improved if slower diffusion coefficients are used. This suggests that f (H₂O) during cooling was lower than that of the hydrothermal experiments and thus that there was little interaction with aqueous fluids of internal or external origin to modify the isotopic compositions. The measured apparent isotopic temperatures and apparent garnet–biotite Fe–Mg exchange temperatures show very poor agreement for the sillimanite zone samples, with the garnet–biotite Fe–Mg exchange temperatures generally higher than the oxygen isotope temperatures. Compared with the other calibrations that we tested the measured apparent temperatures using the Sharp calibration show the best agreeement with recently published P–T grids, although some variability in agreement is expected due to variable f (H₂O) during cooling.     

The effects of controlled drainage on subsurface outflow from level agricultural fields

Daily outflow frequencies and recession curves were used to identify differences in storage–outflow relationships between two different drainage systems, conventional and controlled drainage. A three‐year (1996–1999) field drainage experiment was carried out on a loamy sand soil in southern Sweden. Plots with an area of 0·2 hectares were drained by conventional subsurface drainage (CD) or by controlled drainage (CWT1 and CWT2). The controlled drainage system allowed the groundwater level in the soil to be varied during the year. It was kept at least 70 cm below the soil surface during the growing season but allowed to rise to a maximum of 20 cm below the soil surface during the rest of the year. Measurements were performed to record precipitation, drain outflow and groundwater levels. Daily values of outflow were divided into 10 categories, based on the size of outflow. Recession curves of hourly measurement of outflow were selected. They behaved like single reservoirs and a linear storage–outflow model was applied. Least squares estimates of the parameters initial outflow, initial storage volume and retention constant were calculated. Controlled drainage had a significant effect on total drain outflow and outflow pattern during the three years of measurement. The total drain outflow was 70% to 90% smaller in CWT than in CD. The analysis revealed that the initial outflows were higher, the retention constant and the temporary storage lower in CWT. The hydrological impacts of the reduction in temporary storage were higher peak flow, shorter lag time and shorter recession time and these effects increased with an increased groundwater level. Copyright © 2003 John Wiley & Sons, Ltd.     

新疆伽师强震群区的横波分裂与应力场特征

利用在新疆伽师地区布设的流动台阵记录到的地方震波形数据,研究了伽师强震群附近各台站横波分裂现象,给出了相应的快波偏振方向的平面场分布. 发现在台阵的塔里木盆地一侧,波偏振方向为近SN向,与塔里木盆地的区域主压应力方向一致,但在塔里木盆地北部边缘的褶皱变形带内,快波偏振方向变为近EW向,特别是在柯坪断裂附近,快波偏振方向与阿图什地震的震源断层方向基本一致. 由于快波偏振方向平行于主压应力方向,给出的快波偏振方向反映了相应的主压应力场特征. 结果表明,伽师强震群的成因很可能是塔里木盆地北缘横向非均匀变形造成的局部张性剪切应变能的释放.