基于可靠性的海洋石油平台维修策略研究

针对海洋石油平台传统维修方式依赖经验的缺陷,从可靠性分析角度来制定维修策略,包括确定最佳维修周期和制定设备的检修顺序。以胜利油田埕岛中心一号海洋石油动力平台电力系统为例,采用基于最小割集的数值仿真方法进行故障树分析,通过任务可靠度推出任务时间,实现以可靠性为中心的最佳预防性维修周期的确定。此外,对系统进行重要度分析,按关键重要度大小进行排序,从而制定设备的检修顺序。     

海底裸置与埋置管线自沉过程对比研究

海底管线是海洋油气输运系统的重要组成成分,其稳定性和安全性尤为重要。通过有限元软件ABAQUS,应用Mohr-Coulomb模型,模拟海底裸置与埋置管线自沉过程。通过平衡初始地应力,设置管土接触,考虑重力和浮力作用,进行土体固结分析,计算裸置与埋置管线的土体与管线竖直位移,并进行管线悬跨研究。计算结果显示,对于裸置管线,参数的改变使土体更容易发生塑性屈服,土体的竖直位移量更大;对于埋置管线,当管线埋深较浅、管线上方土体重量不大时,参数的改变使管线平均密度与周围土体密度相差越大土体越容易发生塑性屈服,土体的竖直位移量越大。当管线悬空时,悬跨长度过大易使管线两端支撑土体被压溃,管线易产生大变形而失稳,因此在管线安装与维护过程中,一定要采取措施降低悬跨长度,保证管线运营安全。     

海洋石油污染及其生物修复

文章根据海洋油污染的现状,介绍了海洋石油污染的来源、危害、转归以及对污染的生物修复等内容。指出了限制微生物降解的因素以及如何提高降解效率的措施。生物修复对环境和人类影响小,修复速度快且费用较低,在海洋油污染治理中该方法具有广阔应用前景。     

渤海的平均余环流

利用72个渤海石油平台、站点测流资料,阐明了渤海的平均余环流特征,并用已有的数值计算结果阐明了其形成机制。观测表明在黄河三角洲近海存在一支北-东北向的流动,可抵达秦皇岛附近水域,数值计算表明该支流动主要是潮生的;在辽东湾北部存在一顺时针向的涡旋运动,在冬半年该涡旋是风生的;在渤海湾北部存在潮生的逆时针向的余环流。     

全极化SAR图像中溢油极化特征研究

相比于单极化SAR图像,全极化SAR图像不仅能体现海面目标的几何特征、后向散射特征,还能体现目标的极化特征。因此,在溢油检测方面,极化SAR更具优势。特征提取作为溢油检测的关键步骤,直接影响到溢油检测的精度。在本文中,我们分析了全极化SAR图像中海面溢油的极化特征,如极化散射熵、平均散射角等。并提出了新的极化特征P,该特征参数能够反映海面目标电磁散射过程中布拉格散射机制和镜面散射机制的比例。为了研究极化特征溢油检测的能力,本文基于SIR-C/X-SAR和Radarsat-2全极化SAR图像开展了相关实验,并对比分析了溢油的多种极化特征。实验结果显示,在中低风速情况下,C波段溢油探测效果优于L波段;本文提出的极化特征P对海面散射机制敏感;基准高度和特征参数P在C波段比其他极化特征更适于溢油检测。     

多参数水质测试仪在海洋环境污染应急监测中的应用

文章以2012年新加坡籍"BARELI"轮触礁事故后的海洋环境污染应急监测为例,对多参数水质测试仪的基本情况、操作步骤、监测结果和质量保证等进行简述。多参数水质测试仪具有便携性、易于操作性、测试快捷性和数据准确性等优势,应用效果良好,适用于海洋环境监测尤其是应急监测,应促进其标准化、规范化和业务化推广使用。     

The influence of Stokes drift on oil spills: Sanchi oil spill case

Spilled oil floats and travels across the water’s surface under the influence of wind, currents, and wave action. Wave-induced Stokes drift is an important physical process that can affect surface water particles but that is currently absent from oil spill analyses. In this study, two methods are applied to determine the velocity of Stokes drift, the first calculates velocity from the wind-related formula based upon a one-dimensional frequency spectrum, while the second determines velocity directly from the wave model that was based on a two-dimensional spectrum. The experimental results of numerous models indicated that: (1) oil simulations that include the influence of Stokes drift are more accurate than that those do not; (2) for medium and long-term simulations longer than two days or more, Stokes drift is a significant factor that should not be ignored, and its magnitude can reach about 2% of the wind speed; (3) the velocity of Stokes drift is related to the wind but is not linear. Therefore, Stokes drift cannot simply be replaced or substituted by simply increasing the wind drift factor, which can cause errors in oil spill projections; (4) the Stokes drift velocity obtained from the two-dimensional wave spectrum makes the oil spill simulation more accurate.     

溢油乳化过程C波段微波散射特性实验研究

本文基于水槽溢油观测实验,研究溢油乳化过程中表面散射特性的变化。利用全极化C波段微波散射计和矢量网络分析仪等测量设备对易发生乳化反应沥青含量小于3%的原油（A型油）、油田中开采出的新鲜原油（B型油）和经过脱水去杂质处理的工业原油（C型油）进行观测。文中详细分析了在C波段微波下乳化油膜与平静水面的后向散射差异,以及油膜乳化过程对后向散射的影响,结果显示在低风速、无浪的条件下（最大波高低于3mm）,原油的乳化反应可通过表面粗糙度和自身介电常数的变化来调制雷达后向散射,并且这两种方式中表面粗糙度的影响占主导地位。对比B型和C型原油在乳化状态和未乳化状态下的表面后向散射,结果显示在各状态下B型油膜表面后向散射均大于C型油,且在VV、HH、HV/VH极化方式下两者后向散射平均差异分别为2.19 dB、2.63 dB、2.21 dB,在20%油膜含水率的乳化状态下差异较未乳化状态时小,平均差异分别为0.98 dB、1.49 dB、1.5 dB,结果表明不同类型油种间由于成分和油膜属性的不同会在一定程度上导致油膜表面粗糙度存在差异,影响油膜表面后向散射。     

Establishment and application of an intelligent treating method for oil spill identification

In the identifying process of an oil spill accident, manual integral and artificial visual comparison are commonly used at present to determine the oil spill sources, these methods are time-consuming and easily affected by human factors. Therefore, it is difficult to achieve the purpose of rapid identification of an oil spill accident. In this paper, an intelligent method of automatic recognition, integration and calculation of diagnostic ratio of Gas Chromatography-Mass Spectrometer (GC/MS) spectrum are established. Firstly, four hundreds of samples collected around the world were analyzed using a standard method and Retention time locking technology (RTL) was applied to reduce the change of retention time of GC/MS spectrum. Secondly, the automatic identification, integration of n-alkanes, biomarker compounds, polycyclic aromatic hydrocarbons and calculation of the diagnostic ratios were realized by MATLAB software. Finally, a database of oil fingerprints were established and applied successfully in a spill oil accident. Based on the new method and database, we could acquire the diagnostic ratios of an oil sample and find out the suspected oil within a few minutes. This method and database can improve the efficiency in spilled oil identification.