Impact of land use covers upon karst processes in a typical Fengcong depression system of Nongla, Guangxi, China

The direction and intensity of karst processes can be deeply affected by soil physical and chemical variations which were resulted from land use. Taking Nongla Fengcong depression area, Mashan County, Guangxi as an example, authors discussed the impact of land use on karst processes based on the data of field limestone tablet. The results showed that the corrosional rates at varied soil depth are quite different. Corrosional rate in woodland and orchard is mostly bigger than 20 mg/a, which is much higher than that in tilled land and shrub. Generally, corrosional rate decreased from orchard, woodland, tilled land, fallow land and shrub successively, in which soil organic matter (OM) and soil pH are two major controlling factors: corrosion process is controlled remarkably by soil OM in woodland and orchard. The higher the organic matter content is and the less the pH value is, the higher the corrosional rate is. Owing to lower organic matter content, the corrosional rate is mainly affected by soil CO₂ in tilled land and shrub.     

Modeling on adsorption–desorption of trace metals to suspended particle matter in the Changjiang Estuary

The uptake and release of trace metals (Cu, Ni, Zn, Cd, and Co) in estuaries are studied using river and sea end-member waters and suspended particulate matter (SPM) collected from the Changjiang Estuary, China. The kinetics of adsorption and desorption were studied in terms of environmental factors (pH, SPM loading, and salinity) and metal concentrations. The uptake of the metals studied onto SPM occurred mostly within 10 h and reached an asymptotic value within 40 h in the Changjiang Estuary. As low pH river water flows into the high pH seawater and the water become more alkaline as it approaches to the seaside of estuary, metals adsorb more on SPM in higher pH water, thus, particulate phase transport of metal become increasingly important in the seaward side of the estuary. The percentage of adsorption recovery and the distribution coefficients for trace metals remained to be relatively invariable and a significant reduction only occurred in very high concentrations of metals (>0.1 mg L⁻¹). The general effect of salinity on metal behavior was to decrease the degree of adsorption of Cu, Zn, Cd, Co, and Ni onto SPM but to increase their adsorption equilibrium pH. The adsorption–desorption kinetics of trace metals were further investigated using Kurbatov adsorption model. The model appears to be most useful for the metals showing the conservative behavior during mixing of river and seawater in the estuary. Our work demonstrates that dissolved concentration of trace metals in estuary can be modeled based on the metal concentration in SPM, pH and salinity using a Kurbatov adsorption model assuming the natural SPM as a simple surfaced molecule.     

Correlations between heavy metals and organic carbon extracted by dry oxidation procedure in urban roadside soils

The organic fraction in soils has a significant influence on heavy metal transport. In this study, the organic carbon content was measured by dry oxidation procedure from 21 Xuzhou urban roadside soils to assess the relationships between the concentrations of heavy metals (Pb, Cu, Zn, and Cr) and the amount of organic carbon. The anthropogenic heavy metals (e.g. Pb, Cu, Zn) were strongly correlated with organic carbon (denoted by C_org−c) extracted by dry oxidation while natural heavy metal (e.g. Cr) showed no correlation to the C_org−c. The anthropogenic heavy metals were also strongly correlated with the amount of the total carbon. These results show that the anthropogenic heavy metals are mainly enriched in the organic matter in the Xuzhou urban roadside soils.     

Development of a 3D GIS and its application to karst areas

There is a growing interest in modeling and analyzing karst phenomena in three dimensions. This paper integrates geology, groundwater hydrology, geographic information system (GIS), database management system (DBMS), visualization and data mining to study karst features in Huaibei, China. The 3D geo-objects retrieved from the karst area are analyzed and mapped into different abstract levels. The spatial relationships among the objects are constructed by a dual-linker. The shapes of the 3D objects and the topological models with attributes are stored and maintained in the DBMS. Spatial analysis was then used to integrate the data in the DBMS and the 3D model to form a virtual reality (VR) to provide analytical functions such as distribution analysis, correlation query, and probability assessment. The research successfully implements 3D modeling and analyses in the karst area, and meanwhile provides an efficient tool for government policy-makers to set out restrictions on water resource development in the area.     

Application of MODFLOW and geographic information system to groundwater flow simulation in North China Plain, China

MODFLOW is a groundwater modeling program. It can be compiled and remedied according to the practical applications. Because of its structure and fixed data format, MODFLOW can be integrated with Geographic Information Systems (GIS) technology for water resource management. The North China Plain (NCP), which is the politic, economic and cultural center of China, is facing with water resources shortage and water pollution. Groundwater is the main water resource for industrial, agricultural and domestic usage. It is necessary to evaluate the groundwater resources of the NCP as an entire aquifer system. With the development of computer and internet information technology it is also necessary to integrate the groundwater model with the GIS technology. Because the geological and hydrogeological data in the NCP was mainly in MAPGIS format, the powerful function of GIS of disposing of and analyzing spatial data and computer languages such as Visual C and Visual Basic were used to define the relationship between the original data and model data. After analyzing the geological and hydrogeological conditions of the NCP, the groundwater flow numerical simulation modeling was constructed with MODFLOW. On the basis of GIS, a dynamic evaluation system for groundwater resources under the internet circumstance was completed. During the process of constructing the groundwater model, a water budget was analyzed, which showed a negative budget in the NCP. The simulation period was from 1 January 2002 to 31 December 2003. During this period, the total recharge of the groundwater system was 49,374 × 10⁶ m³ and the total discharge was 56,530 × 10⁶ m³ the budget deficit was −7,156 × 10⁶ m³. In this integrated system, the original data including graphs and attribution data could be stored in the database. When the process of evaluating and predicting groundwater flow was started, these data were transformed into files that the core program of MODFLOW could read. The calculated water level and drawdown could be displayed and reviewed online.     

Wind wave-forced fine sediment erosion during the slack water periods in Hangzhou Bay,China

The shallow water wave simulation model-SWAN incorporated with a simple fine sediment erosion model is applied to Hangzhou Bay, China, to model the horizontal distribution of the maximum bottom orbital velocity and corresponding fine sediment erosion rates induced by: (1) southeasterly steady winds (5, 20 and 30 m/s), (2) southwesterly steady winds (5 and 20 m/s); (3) northwesterly steady winds (5 and 20 m/s); (4) east-southeasterly steady winds (5 and 20 m/s); (5) easterly steady winds (5 and 20 m/s) under closed and unclosed boundaries; and (6) unsteady winds during the slack water periods. Results suggest: (1) the steady wind wave-induced maximum bottom orbital velocities and corresponding fine sediment erosion rates generally increased with the increasing steady winds; (2) closed and unclosed boundary conditions had more significant influences on modeled fine sediment erosion rates under 5 m/s easterly steady winds than 20 m/s; and (3) steady and unsteady wind wave-induced maximum bottom currents could be significant in eroding fine sediment bed in Hangzhou Bay. The results show implications for geomorphology, sedimentology, coastal erosion, and environmental pollution mitigation in Hangzhou Bay.     

Experimental study on the deterioration and natural remediation of the Ariake Sea tidal mud caused by the sea laver treatment acid practice and the upward seepage of pore water liquid

This study presents a laboratory study of the following two aspects: (1) the influence of sea laver treatment acid on the geoenvironmental properties of Ariake Sea tidal mud, and (2) the natural remediation effect on the sea laver treatment acid contaminated Ariake Sea tidal mud caused by the upward seepage of pore water liquid in the mud. Firstly, the mechanisms of the transport of sea laver treatment acid in the Ariake Sea tidal mud and the generation mechanisms of the upward seepage flow in the Ariake Sea tidal mud are discussed. Secondly, a series of one-dimensional laboratory infiltration tests were carried out to investigate the deterioration of the Ariake Sea tidal mud caused by the sea laver acid treatment practice. Test results reveal that the acid treatment practice caused considerable change in the geochemical properties of the mud in terms of increase in sulfide content and decrease in pH value. After the treatment by the sea laver treatment acid, the sulfide content of the mud even exceeded the safe limit value for the benthos, which represents undesirable living condition for benthos. Thirdly, series of laboratory fresh seawater infiltration tests for the deteriorated Iida site mud were conducted to illustrate this natural remediation efficiency. It is found that with the infiltration of the fresh seawater, the sulfide content of the Iida site mud was considerably reduced and pH value increased to an acceptable range for benthos living in the tidal flat mud. With the increase in the infiltration time and the hydraulic gradient, the remediation efficiency could be increased.     

Geotechnical properties of evaporite soils of the Dead Sea area

The Dead Sea Basin is the lowest point on earth and is tectonically subsiding. During the Holocene Period the climate became much drier with increasing evaporation whereby initially lacustrine sediments were deposited from the non-marine brines, giving a multi-layered stratigraphy of lime carbonate and halite sediments. The lime carbonate sediments are comprised of laminated, clay to silt sized, clastic sediments (calcite) and authigenic aragonite and gypsum. The halite commonly appears as rock salt. Chemical industries, based on harvesting the salts from the Dead Sea, have developed on both the Israeli and the Jordanian sides of the basin. The lime carbonate soils are used for dike construction, and these soils, together with significant salt layers, are encountered in the foundations of structures, dikes, and tailings dams, requiring definition of their geotechnical properties. Use of standard soil mechanics definitions and testing approaches for the lime carbonates have been found inapplicable, particularly in view of their exceptionally high saline content, and it has been necessary to develop new concepts. The rock salt is encountered at shallow depths, with unit weights considerably lower than those usually discussed in the literature, and with correspondingly different mechanical properties. The geotechnical properties of these soils, and approaches used to define them, are discussed in the paper.     

Li-Sr-Nd isotope signatures of the plume and cratonic lithospheric mantle beneath the margin of the rifted Tanzanian craton (Labait)

Lithium concentrations and isotopic compositions of olivine and ⁸⁷Sr/⁸⁶Sr and ¹⁴³Nd/¹⁴⁴Nd of coexisting clinopyroxene from peridotite xenoliths from the Quaternary Labait volcano, Tanzania, document the influence of rift-related metasomatism on the ancient cratonic mantle. Olivines show negative correlations between Fo content and both δ⁷Li and Li concentrations. Olivines in iron-rich peridotites (Fo_85–87) have high Li concentrations (3.2–4.8 ppm) and heavy δ⁷Li (+5.2 to +6.6). In contrast, olivines in ancient, refractory peridotites have lower Li concentrations (∼2 ppm) and relatively light δ⁷Li (+2.6 to +3.5). This reflects mixing between ancient, refractory cratonic lithosphere and asthenosphere-derived rift magmas. A uniquely fertile, deformed, high-temperature garnet lherzolite, interpreted to be from the base of the lithosphere, has a ⁸⁷Sr/⁸⁶Sr of 0.7029 and ¹⁴³Nd/¹⁴⁴Nd of 0.51286, similar to HIMU oceanic basalts. It provides the best estimate of the Sr–Nd isotope composition of the upwelling mantle (i.e., plume, sensu lato) underlying this portion of the East African Rift, and is slightly less radiogenic compared to previous estimates of the plume that were based on rift basalts. Although elevated δ⁷Li are not exclusive to HIMU source regions, the data collectively indicate that the plume beneath Labait has HIMU characteristics in Sr, Nd and Li isotope composition. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

An experimental study of the grain-scale processes of peridotite melting: implications for major and trace element distribution during equilibrium and disequilibrium melting

The grain-scale processes of peridotite melting were examined at 1,340°C and 1.5 GPa using reaction couples formed by juxtaposing pre-synthesized clinopyroxenite against pre-synthesized orthopyroxenite or harzburgite in graphite and platinum-lined molybdenum capsules. Reaction between the clinopyroxene and orthopyroxene-rich aggregates produces a melt-enriched, orthopyroxene-free, olivine + clinopyroxene reactive boundary layer. Major and trace element abundance in clinopyroxene vary systematically across the reactive boundary layer with compositional trends similar to the published clinopyroxene core-to-rim compositional variations in the bulk lherzolite partial melting studies conducted at similar P–T conditions. The growth of the reactive boundary layer takes place at the expense of the orthopyroxenite or harzburgite and is consistent with grain-scale processes that involve dissolution, precipitation, reprecipitation, and diffusive exchange between the interstitial melt and surrounding crystals. An important consequence of dissolution–reprecipitation during crystal-melt interaction is the dramatic decrease in diffusive reequilibration time between coexisting minerals and melt. This effect is especially important for high charged, slow diffusing cations during peridotite melting and melt-rock reaction. Apparent clinopyroxene-melt partition coefficients for REE, Sr, Y, Ti, and Zr, measured from reprecipitated clinopyroxene and coexisting melt in the reactive boundary layer, approach their equilibrium values reported in the literature. Disequilibrium melting models based on volume diffusion in solid limited mechanism are likely to significantly underestimate the rates at which major and trace elements in residual minerals reequilibrate with their surrounding melt. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.