土的边界面本构模型研究进展

简述了土的边界面本构模型国内外研究状况，阐述了其基本思想。对边界面模型作了简要评述，提出了边界面模型研究的发展趋向。     

Geohydrological models and earthquake effects at Yucca Mountain, Nevada

 Yucca Mountain, the proposed site for the high-level nuclear waste repository, is located just south of where the present water table begins a sharp rise in elevation. This large hydraulic gradient is a regional feature that extends for over 100 km. Yucca Mountain and its vicinity are underlain by faulted and fractured tuffs with hydraulic conductivities controlled by flow through the fractures. Close to and parallel with the region of large hydraulic gradient, and surrounding the core of the Timber Mountain Caldera, there is a 10- to 20-km-wide zone containing few faults and thus, most likely, few open fractures. Consequently, this zone should have a relatively low hydraulic conductivity, and this inference is supported by the available conductivity measurements in wells near the large hydraulic gradient. Also, slug injection tests indicate significantly higher pressures for fracture opening in wells located near the large hydraulic gradient compared to the opening pressures in wells further to the south, hence implying that lower extensional stresses prevail to the north with consequently fewer open fractures there. Analytical and numerical modeling shows that such a boundary between media of high and low conductivity can produce the observed, large hydraulic gradient, with the high conductivity medium having a lower elevation than the water table. Further, as fractures can close due to tectonic activity, the conductivity of the Yucca Mountain tuffs can be reduced to a value near that for the hydraulic barrier due to strain release by a moderate earthquake. Under these conditions, simulations show that the elevation of the steady-state water table could rise between 150 and 250 m at the repository site. This elevation rise is due to the projected shift in the location of the large hydraulic gradient to the south in response to a moderate earthquake, near magnitude 6, along one of the major normal faults adjacent to Yucca Mountain. As the proposed repository would only be 200–400 m above the present water table, this predicted rise in the water table indicates a potential hazard involving water intrusion. Received: 7 June 1996 / Accepted: 19 November 1996     

地震和测井资料联合反演储层物性参数的方法

为了充分利用测井资料较高的纵向分辨率及其反映井壁周围物性直接准确的特点和地震资料良好的横向可追踪性，针对厚储层和薄储层地震—地质模型分别提出了利用测井和地震资料联合反演纵横波速度和密度参数的方法。理论模型的计算结果表明，反演方法是切实可行的     

Seismic Hazard Studies in the U.K.: Source Specification Problems of Intraplate Seismicity

Although the U.K. is in an area of only low to moderate seismicity, the seismic hazard is sufficient to pose a threat to sensitive structures such as chemical plants and nuclear facilities. In quantifying the level of hazard by conventional probabilistic methodology, however, some problems arise in attempting to interpret earthquake data in terms of geological structure and faults. In the U.K., not only is it impossible to identify any demonstrably active faults, but also it is extremely difficult to discern any relationship between the pattern of seismicity and local or regional geological structure.This study discusses the use of two zonation approaches which complement each other in such a way that the general character and trend of seismicity is preserved. In one approach, the zonation is informed by the structural geology, where possible; geological zonation is avoided if it produces sources with heterogeneous seismicity. In the other approach, the record of past earthquakes is divided up into very small zones around individual epicentres or groups of epicentres, the size of each zone usually being proportional to the uncertainty in the epicentral determination of the appropriate event. This zonation preserves an observed tendency of some British earthquakes to repeat themselves. It is suggested that, in intraplate areas such as the U.K., it is often inappropriate to attempt to model individual fault sources. No faults in the U.K. are provably active. Because an earthquake of moderate size can occur on a very short fault segment, it is impractical to restrict fault modelling to major features. Even the two largest U.K. faults, suspected to be active, pose problems in attributing historical seismicity to them as distinct features.     

Numerical simulations for coupled rock deformation and gas leak flow in parallel coal seams

Based on the new viewpoint of interaction mechanics for solid and gas, gas leakage in parallel deformable coal seams can be understood. That is, under the action of varied geophysical fields, the methane gas flow in a double deformable coal seam can be essentially considered to be compressible with time-dependent and mixed permeation and diffusion through a pore-cleat deformable, heterogeneous and anisotropic medium. From this new viewpoint, coupled mathematical models for coal seam deformation and gas leak flow in parallel coal seams were formulated and the numerical simulations for slow gas emission from the parallel coal seams are presented. It is found that coupled models might be close to reality. Meanwhile, a coupled model for solid deformation and gas leak flow can be applied to the problems of gas leak flow including mining engineering, gas drainage engineering and mining safety engineering in particular the prediction of the safe range using protective layer mining where coal and gas outbursts can efficiently be prevented. This revised version was published online in July 2006 with corrections to the Cover Date.     

Estimation of regional material yield from coastal landslides based on historical digital terrain modelling

High‐resolution historical (1942) and recent (1994) digital terrain models were derived from aerial photographs along the Big Sur coastline in central California to measure the long‐term volume of material that enters the nearshore environment. During the 52‐year measurement time period, an average of 21 000 ± 3100 m³ km^?1 a^?1 of material was eroded from nine study sections distributed along the coast, with a low yield of 1000 ± 240 m³ km^?1 a^?1 and a high of 46 700 ± 7300 m³ km^?1 a^?1. The results compare well with known volumes from several deep‐seated landslides in the area and suggest that the processes by which material is delivered to the coast are episodic in nature. In addition, a number of parameters are investigated to determine what influences the substantial variation in yield along the coast. It is found that the magnitude of regional coastal landslide sediment yield is primarily related to the physical strength of the slope‐forming material. Coastal Highway 1 runs along the lower portion of the slope along this stretch of coastline, and winter storms frequently damage the highway. The California Department of Transportation is responsible for maintaining this scenic highway while minimizing the impacts to the coastal ecosystems that are part of the Monterey Bay National Marine Sanctuary. This study provides environmental managers with critical background data on the volumes of material that historically enter the nearshore from landslides, as well as demonstrating the application of deriving historical digital terrain data to model landscape evolution. Published in 2005 by John Wiley & Sons, Ltd.     

Geostatistical simulation of random fields with bivariate isofactorial distributions by adding mosaic models

This work deals with the geostatistical simulation of a family of stationary random field models with bivariate isofactorial distributions. Such models are defined as the sum of independent random fields with mosaic-type bivariate distributions and infinitely divisible univariate distributions. For practical applications, dead leaf tessellations are used since they provide a wide range of models and allow conditioning the realizations to a set of data via an iterative procedure (simulated annealing). The model parameters can be determined by comparing the data variogram and madogram, and enable to control the spatial connectivity of the extreme values in the realizations. An illustration to a forest dataset is presented, for which a negative binomial model is used to characterize the distribution of coniferous trees over a wooded area.