Microwave-assisted extraction of organochlorine pesticides from sediments and determination by gas chromatograph with electron capture detection

A simple and rapid procedure to extract organochlorine pesticides （OCPs） from sediments by means of microwave energy is proposed. Sediment samples were irradiated with microwaves in a closed vessel system while immersed in hexane-acetone （1 ： 1, v/v）. The sample extracts were cleaned up using solid phase extraction with Florisil as adsorbent. Pesticides were eluted with hexane-ethyl acetate （80 ： 20, v/v） and determined by gas chromatographic separation with electron capture detection. Three oven programs were assayed with two different solvent mixtures in order to achieve adequate experimental conditions for the complete extraction of organochlorine pesticides from the matrix. Different variables such as the composition of extraction solvent,     

Naturally acidic and metalliferous waters at unmined volcanogenic massive sulfide deposits in the Bonnifield mining district, Alaska Range, east-central Alaska

The Bonnifield district hosts 26 tmmined volcanogenic massive sulfide （VMS） occurrences. Environmental geochemical samples of water and stream sediment were collected at several occurrences, concentrating on the two best-exposed and largest deposits, Red Mountain （RM） and Sheep Creek （SC）. Limited samples were also collected at the poorly exposed WTF deposit. The deposits are Late Devonian to Early Mississippian, and are hosted by felsic metavolcanic and carbonaceous schist members of the Totatlanika Schist or Keevy Peak Fm. Spring and stream waters at RM and SC have pH values commonly 〈3.5 （as low as 2.4 at RM and 2.5 at SC）, high conductivity （up to 11000 μS/cm）, and very high （Is to 100s mg/L） dissolved contents of Al, Cd, Co, Cu, Fe, Ni, and Pb. Waters at RM are characterized by extremely high REE contents （summed REE median 3200 μg/L, n=33）. At both RM and SC, pyrite oxidation and dissolution produce low pH waters that interact with and dissolve bedrock minerals, resulting in acidic, metal-laden, naturally degraded streams that are mostly devoid of aquatic life. Ferricrete is common. In contrast, WTF barely produces a surficial environmental footprint, mostly due to topography and relief. RM and SC are well exposed in the areas of relatively high relief, and both exhibit extensive areas of quartz-sericite-pyrite-alteration. While WTF shares many of the same deposit-and alteration characteristics, it is concealed by tundra in a large, nearly flat area. Surface water at WTF is absent and outcrops are sparse. Even though WTF is roughly the same size as Red Mountain （both around 3 million tonnes） and has similar base- and precious-metal grades, the surficial geochemical manifestation of WTF is minimal. However, exposure through mining of the altered, mineralized rock at WTF potentially could initiate the same processes of pyrite oxidation, acid generation, and mineral dissolution that are observed naturally at RM and SC.     

Effect of polypropylene fibre and lime admixture on engineering properties of clayey soil

In order to reduce the brittleness of soil stabilized by lime only, a recent study of a newly proposed mixture of polypropylene fibre and lime for ground improvement is described and reported in the paper. To investigate and understand the influence of the mixture of polypropylene fibre and lime on the engineering properties of a clayey soil, nine groups of treated soil specimens were prepared and tested at three different percentages of fibre content (i.e. 0.05%, 0.15%, 0.25% by weight of the parent soil) and three different percentages of lime (i.e. 2%, 5%, 8% by weight of the parent soil). These treated specimens were subjected to unconfined compression, direct shear, swelling and shrinkage tests. Through scanning electron microscopy (SEM) analysis of the specimens after shearing, the improving mechanisms of polypropylene fibre and lime in the soil were discussed and the observed test results were explained. It was found that fibre content, lime content and curing duration had significant influence on the engineering properties of the fibre–lime treated soil. An increase in lime content resulted in an initial increase followed by a slight decrease in unconfined compressive strength, cohesion and angle of internal friction of the clayey soil. On the other hand, an increase in lime content led to a reduction of swelling and shrinkage potential. However, an increase in fibre content caused an increase in strength and shrinkage potential but brought on the reduction of swelling potential. An increase in curing duration improved the unconfined compressive strength and shear strength parameters of the stabilized soil significantly. Based on the SEM analysis, it was found that the presence of fibre contributed to physical interaction between fibre and soil whereas the use of lime produced chemical reaction between lime and soil and changed soil fabric significantly.     

Performance of Mortar and Chemical Grout Injection into Surrounding Soil When Slurry Pipe-jacking Method is Used

Small-diameter shallow tunnels are often being built by using the slurry pipe-jacking method. This system involves the pushing or thrusting of a drivage machine and concrete pipes into the ground. Chemical grout injection into the surrounding soil around the tunnel is carried out after the drivage and pushing processes are finished. The purpose of the chemical grout injection is to maintain permanent stability of the surrounding soil. However, the behavior of the chemical grouting material in the surrounding soil around the tunnel and the amount of optimum injection is not clearly understood. From these points of view, this paper discusses the performance of the chemical grouting material, when it is injected into the surrounding soil around the tunnel, by means of 2-D Eulerian–Lagrangian seepage analysis. Moreover, the effectiveness of the chemical grout injection was evaluated by using the non-linear finite element method. This investigation show when the range of the grouted zone is designed; it is necessary that the relationship between Young’s modulus of the soil/grouted zone and the confining stress be taken into consideration in order to establish effective, economical and safe chemical grout injection system. Understanding the performance of the seepage/dispersion behavior of the chemical grout and the characteristics of soil/ grouted zone is also important.     

In situ time resolved synchrotron powder diffraction study of thaumasite

Structural changes during dehydration and subsequent decomposition in thaumasite Ca₃Si(SO₄)(CO₃)(OH)₆·12 H₂O were studied by in situ synchrotron powder diffraction between 303 and 1,098 K. Evolution of the crystal structure was observed through 28 structure refinements, by full profile Rietveld analysis performed in the P6₃ space group, between 300 and 417 K, whereupon the thaumasite structure was observed to breakdown. Within this temperature range, the cell parameters of thaumasite increased as a function of temperature in a nearly linear fashion up to about 393 K, at which temperature, a slight slope change was observed. Above 400 K, the thermogravimetric analysis revealed that the dehydration process proceeded very rapidly while the refined occupancy of water molecules dropped below a critical level, leading to instability in the thaumasite structure. At a same time, a remarkable change in the unit cell parameters occurring at about 417 K indicated that the crystal structure of thaumasite collapsed on losing the crystallization water and it turned amorphous. This result indicated that the dehydration/decomposition of thaumasite was induced by the departure of the crystallization water. At about 950 K, anhydrite and cristobalite crystallized from the thaumasite glass.     

A Practical Procedure for the Measurement of Fragmentation by Blasting by Image Analysis

Summary. The operation of a digital image analysis system in a limestone quarry is described. The calibration of the system, required in order to obtain moderately reliable fragmentation values, is done from muckpile sieving data by tuning the image analysis software settings so that the fragmentation curve obtained matches as close as possible the sieving. The sieving data have also been used to extend the fragment size distribution curves measured to sizes below the system’s optical resolution and to process the results in terms of fragmented rock, discounting the material coming from a loose overburden (natural fines) that is cast together with the fragmented rock. Automatic and manual operation modes of the image analysis are compared. The total fragmentation of a blast is obtained from the analysis of twenty photographs; a criterion for the elimination of outlier photographs has been adopted using a robust statistic. The limitations of the measurement system due to sampling, image processing and fines corrections are discussed and the errors estimated whenever possible. An analysis of consistency of the results based on the known amount of natural fines is made. Blasts with large differences in the amount of fines require a differentiated treatment, as the fine sizes tend to be the more underestimated in the image analysis as they become more abundant; this has been accomplished by means of a variable fines adjustment factor. Despite of the unavoidable errors and the large dispersion always associated with large-scale rock blasting data, the system is sensitive to relative changes in fragmentation.     

Damage Survey of Water Supply Systems and Fragility Curve of PVC Water Pipelines in the Chi–Chi Taiwan Earthquake

Substantial damage to water supply systems, including water delivery pipelines, water treatment plants, reservoirs, and water storage tanks, was reported after the 1999 Chi–Chi Taiwan Earthquake. This paper first summarizes the damage survey and then presents the results of seismic fragility analysis for underground pipelines. Construction blueprints of the water delivery pipelines and repair work orders of 11 townships and cities in the disastrous area were digitized into a Geographical Information System (GIS) for analysis and assessment. With the aid of the GIS system, we found that PVC pipes made up 86% of water delivery pipelines while steel, cast iron, ductile iron, PE and others took the rest. Therefore, this paper focuses on the fragility analysis of PVC pipes. Three different methods were applied to derive the fragility relations between the PVC water pipes having nominal diameters (approximately inner diameters) greater than or equal to 65 mm and earthquake intensity parameters such as peak ground acceleration and peak ground velocity. The results were then examined with those of other countries. The discrepancy between our results and the empirical equation used by HAZUS, an earthquake loss estimation software developed by the Federal Emergency Management Agency was not significant.     

Biofacies of Upper Jurassic and Lower Cretaceous sediments of central West Siberia

Paleontological study of Upper Jurassic and Lower Cretaceous sediments recovered by boreholes in the Agan-Vakh and Nadym-Vengapur interfluves clarified environments of their deposition. As is shown, influx of siliciclastic material to central areas of the West Siberian sea basin varied through time. Taxonomic composition and ecological structure of nektonic and benthic fossil assemblages are analyzed and considered in terms of environmental factors such as hydrodynamics, aeration, temperature, and salinity of seawater.     

Assessing the Vibrational Frequencies of the Cathedral of Cologne (Germany) by Means of Ambient Seismic Noise Analysis

Ambient seismic noise measurements were conducted inside the Cathedral of Cologne (Germany) for assessing its frequencies of vibration and for checking whether these occur in the range where soil amplification is expected. If this is the case, damages may increase in case of an earthquake due to an increased structural response of the building. Analysis of the ratio between the horizontal and vertical components of the spectra recorded at stations located inside the building as well as the ratio between the corresponding components of the spectra recorded simultaneously inside the building and at a reference station placed in the basement of the cathedral indicated several modes of vibration. Facilitated by these results an assessment of the seismic vulnerability was attempted for a 2D ground motion scenario using the finite element method.     

Distribution of cadmium, chromium, copper, lead and zinc in marine sediments in Hong Kong waters

Partitioning of heavy metals (Cd, Cr, Cu, Pb, Zn) in marine sediments collected from various sites in Hong Kong waters were determined using sequential extraction method. Sediments from Kellette Bank, located in Victoria Harbour, had higher metal concentrations especially Cu and Zn than most other sites. Slightly over 20% of total Cu and Cr existed as readily available forms in Peng Chau and Kellette Bank. At most sampling sites, over 15% of the Cu existed as the exchangeable form indicating that Cu could be readily released into the aqueous phase from sediments. A significantly higher percentage of Pb and Zn was associated with the three non-residual fractions. Hence, there is a greater environmental concern for remobilization of Pb and Zn compared with Cr. The high amount of residual Cd (>50%) and the relatively lower Cd content indicate that little environmental concern is warranted for the remobilization of Cd. Distribution of metals in sediments collected from different depth at Kellette Bank shows that metal concentrations decreased with profile depth. The levels of Pb and Zn associated with the two readily available fractions increased sharply in the surface sediment. These metals represented the pollutants, which were introduced into the area in the mid-eighties through early nineties as a result of rapid economic and industrial development in the territory. As significant portions of these metals were bound to the readily available phases in the surface sediments, metal remobilization could be a concern. An erratum to this article can be found at