多通道瞬变电磁法频率域比值算法及视电阻率计算研究

视电阻率在电磁法勘探中起重要作用,可以作为初步解释结果,多通道瞬变电磁法通过大地脉冲响应的峰值时刻定义视电阻率.鉴于传统方法计算峰值时刻视电阻率需要恢复完整大地脉冲响应,本文通过研究大地脉冲响应及其频谱特征,提出一种新的频率域比值法.利用参考谱及其与一般谱的伸缩因子计算一般谱的峰值时刻,进而得到视电阻率.该方法只需大地脉冲响应单个频点幅度谱,从而不用估计整个大地脉冲响应.实际计算时,可以用大地脉冲响应多个频点幅度谱得到平均视电阻率.模拟数据与实测数据结果表明,在一维介质中,频率域比值法可以得到合理的视电阻率.     

使用宽频带地震记录研究2017年6月24日茂县新磨滑坡的动力学过程

北京时间2017年6月24日5时39分左右,四川省茂县叠溪镇新磨村发生大型岩质滑坡.体积约4.3×10⁶ m³的巨型岩体从山顶脱落,顺坡滑行约2.6 km后破碎沉积;碎屑物掩埋了整个新磨村,造成了巨大的人员伤亡和财产损失.本文使用来自滑坡周围的10个地震台站的宽频带观测资料的长周期信号反演了这次滑坡的受力时间函数;同时使用逐步细化的格点搜索方法得到了滑坡的位置,与其真实位置一致;根据反演的受力时间函数计算了滑坡过程中滑体的运动学参数,得到的滑体运动轨迹与实际路径吻合.综合分析地震信号、受力时间函数和运动学参数表明,本次滑坡主运动的持续时间约为79 s;脱落岩体在5∶38∶50.2启动后持续加速,在5∶39∶37.2达到速度峰值,约为52.1 m·s^-1;这段时间内岩体没有明显的破碎;之后,岩体开始铲刮并裹挟古滑坡造成的碎屑沉积物,自身也开始破碎解体,总体开始减速运动,直到5∶40∶9.2主运动停止;此后,小规模的碎屑散落又持续了约10 s的时间.     

Development of a distributed hydrological model to facilitate watershed management

To facilitate precise and cost-effective watershed management, a simple yet spatially and temporally distributed hydrological model (DHM-WM) was developed. The DHM-WM is based on the Mishra-Singh version of the curve number method, with several modifications: The spatial distribution of soil moisture was considered in moisture updating; the travel time of surface runoff was calculated on a grid cell basis for routing; a simple tile flow module was included as an option. The DHM-WM was tested on a tile-drained agricultural watershed in Indiana, USA. The model with the tile flow module performed well in the study area, providing a balanced water budget and reasonable flow partitioning. The daily coefficient of determination and Nash-Sutcliffe coefficient were 0.58 and 0.56, for the calibration period, and 0.63 and 0.62 for the validation period. The DHM-WM also provides detailed information about the source areas of flow components, the travel time and pathways of surface runoff.

EDITOR A. Castellarin; ASSOCIATE EDITOR F.-J. Chang     

Time series analysis for evaluating hydrological responses of pore-water pressure to rainfall in a slope

Characterization of pore-water pressure at the soil–atmosphere interface is a major requirement in relation to slope instability. A rain-gauge and five piezometers (BH1–BH5) were installed on a slope located in a Korean military base. The upper slope (BH4, BH5) was covered with plastic sheets to prevent rainwater from percolating into the slope due to safety issues. Rainfall is matched by prompt changes in the pore-water pressure except at BH5. Due to the plastic cover, the pore water does not show any significant change in the early period by evapotranspiration. From correlation analysis, two wells (BH3, BH5) have longer memory effects due to matrix flow of past precipitation. Two principal components show hydrological responses of pore water to rainfall during intense rainfall, but PC2 does not indicate any important changes in low or no rainfall. This study suggests that correlation analysis with PCA can be a valuable tool for interpreting datasets consisting only of pore-water pressure.     

Investigation of the thermal regime and subsurface properties of a tidally affected,variably saturated streambed

Temperature and moisture content in the variably saturated subsurface are two of the most important physical parameters that govern a wide variety of geochemical and ecological processes. An understanding of thermal and hydraulic processes and properties of transient vadose zones is therefore fundamental in the evaluation of such processes. Here, an investigation of the thermal regime and subsurface properties of a tidally affected, variably saturated streambed is presented. Field and laboratory measurements, as well as a forward numerical model, are jointly employed in the investigation. Temperature, soil moisture, surface level, and water level data were recorded in a transect perpendicular to a tidally driven stream. Frequency‐domain analysis of the subsurface temperature measurements revealed the rapid decay of the tidal temperature driver within the top ～30 cm of sediment. Several techniques were used to evaluate subsurface thermal and hydraulic properties, including thermal conductivity and the soil water retention curve. These properties were used to constrain a forward numerical model that included coupled treatment of relevant variable saturation thermal and hydraulic physics. Even though the investigated vadose zone is intermittent and relatively shallow ( 20 cm), the results illustrate how error can be introduced into heat‐transport calculations if unsaturated conditions are not taken into account.     

基于非结构化网格的最小二乘逆时偏移

相对于传统的逆时偏移,最小二乘逆时偏移具有更高的成像质量,这种改善是通过迭代反演来获得的,另外其精度与效率依赖于求解波动方程算法的精度与效率.本文给出了基于非结构化网格的最小二乘逆时偏移的方法,该方法能够充分结合最小二乘算法与非结构化网格精细刻画地下界面以及随速度自适应剖分的优点;并采用带补偿的拉普拉斯滤波算法,来消除梯度计算中的低频噪声,从而加速目标函数的收敛速度.通过简单倾斜模型以及复杂Marmousi模型测试,显示了该方法的有效性和潜力.     

基于动态图像变形的PP与PS波层位直接匹配

多分量地震资料的矢量偏移、多波地震资料的联合解释与反演均需要估算纵横波的速度比,实现纵波与转换横波在时间或深度域的匹配.基于DTW,本文实现了一种适用于PP与PS波直接匹配的动态图像变形算法.该算法分为三个部分:首先,使用二阶对称动态规划算法逐样点递归计算PP与PS波走时或深度的误差累积和;其次,在以误差累积和为目标函数的回溯阶段设定变形窗,并在纵横波速比约束的变形窗内递归回溯搜索匹配路径;最后,根据最大相关系数判定准则在匹配路径中确定最佳匹配路径,获得使PP与PS波匹配的拉伸或压缩时移量.利用所获得的拉伸压缩时移量计算纵横波速度比就可以实现PP与PS波之间的匹配.模型与实际陆上多分量地震资料测试结果表明:该方法具有较高的匹配精度,且对于信噪比、相似度较低的多分量地震资料,该方法也能产生较好的匹配效果.     

基于平面波加速的VTI介质最小二乘逆时偏移

地震各向异性集中表现为速度各向异性,势必影响地震波运动学特征.传统声波逆时偏移(RTM)和最小二乘逆时偏移(LSRTM)没有考虑介质各向异性特征,导致反射波不能正确归位、同相轴出现扭曲及寻优速度慢或不收敛等,VTI介质逆时偏移(VTI-RTM)矫正了声波成像的不足,但仍存在低频干扰严重、中深部成像不佳、振幅保持差等缺陷.为此,本文首先实现了VTI介质最小二乘逆时偏移(VTI-LSRTM)方法,为了节省I/O及内存需求并提高效率,进一步引入平面波编码技术,提出了一种基于平面波加速的VTI介质最小二乘逆时偏移(VTI-PLSRTM)策略.在此基础上开展了简单模型及复杂Marmousi模型成像试验,并与标准逆时偏移剖面对比表明:本方法能够校正各向异性造成的相位畸变,且在迭代中自动压制串扰及低频噪声、补偿中深部能量,是一种兼具质量与效率的保幅成像策略;对速度误差的敏感性测试说明该方法需要相对正确的偏移速度及Thomsen参数模型.     

基于卷积完全匹配层的非规则网格时域有限元探地雷达数值模拟

复频移完全匹配层(Complex Frequency-Shifted PML,CFS-PML)在长时间时域计算中对凋落波、倏失波具有好的吸收效果,并被广泛应用于时域有限差分模拟中.而本文采用卷积方法将CFS-PML应用于时域有限元求解GPR波动方程的数值模拟中.论文以TM波为例,推导了基于CPML(Convolutional PML)边界的时域有限元GPR波动方程求解公式,采用Newmark-β方法对时间导数进行离散,有效改善了时域有限元GPR数值计算程序的稳定性.并以狭长模型为例,开展了CPML边界中关键参数m、R和κ的选取实验,通过对比反射误差大小确定了综合最优参数组合.相同时刻UPML与CPML波场快照、3个检测点的反射误差比较,说明CPML较UPML具有更好的吸收效果.最后,采用非规则四边形网格对1个复杂GPR模型进行剖分,应用加载CPML边界条件的FETD程序对该模型进行了正演,得到了二维剖面法、宽角法正演GPR剖面图,说明非规则四边形对复杂模型的良好适应性,基于CPML边界条件的FETD可有效减少边界反射误差,能实现对任意复杂不规则模型的正演模拟.     

基于Low-rank分解的复杂TI介质纯qP波正演模拟与逆时偏移

近年来,面向实际应用的TI介质准P波正演模拟与逆时偏移成像技术受到空前的关注.基于常规耦合型传播方程的正演模拟方法不仅存在伪横波及频散假象干扰,而且还遭受模型参数限制(η0)和不稳定影响;而纯qP波方程的推导繁琐,且由于方程中包含拟微分算子造成求解难度大且精度有限.为此,本文首先构建了一种适用于任意TI介质的纯qP波传播算子,然后借助Low-rank分解求取该算子中的空间-波数域矩阵,同时引入Cerjan衰减边界条件来压制边界反射干扰,最终实现了一种间接的纯qP波波场外推方案,并将其成功应用于复杂TI介质正演模拟与逆时偏移成像中.通过开展数值模拟,并与其他方法对比表明:①该方法既避免了纯qP波方程的繁琐推导,又克服了耦合型方程对模型参数的限制;②还彻底消除了残余伪横波噪音及数值频散;③且能适应较大时间或空间步长及高频震源,是一种相对准确且稳定的各向异性纵波正演与成像策略.