Evaluation of distributed recharge in an upland semi-arid karst system: the West Bank Mountain Aquifer,Middle East

Assessment of recharge in a structurally complex upland karst limestone aquifer situated in a semi-arid environment is difficult. Resort to surrogate indicators such as measurement of spring outflow and borehole discharge, is a common alternative, and attempts to apply conventional soil moisture deficit analysis may not adequately account for the intermittent spate conditions that arise in such environments. A modelling approach has been made using the West Bank Mountain Aquifer system in the Middle East as a trial. The model uses object oriented software which allows various objects to be switched on and off. Each of the main recharge processes identified in the West Bank is incorporated. The model allows either conventional soil moisture deficit analysis calculations or wetting threshold calculations to be made as appropriate, and accommodates both direct recharge and secondary recharge. Daily time steps enable recharge and runoff routing to be calculated for each node. Model runs have enabled a series of simulations for each of the three aquifer basins in the West Bank and for the whole of the West Bank. These provide recharge estimates comparable to those prepared by earlier workers by conventional means. The model is adaptable and has been successfully used in other environments.     

Impacts of at-site wastewater disposal systems on the groundwater aquifer in arid regions: case of Sfax City, Southern Tunisia

Groundwater in Sfax City (Tunisia) has been known since the beginning of the century for its deterioration in quality, as a result of wastewater recharge into the aquifer. An average value of 12 × 10⁶ m³ of untreated wastewater reaches the groundwater aquifer each year. This would result not only in a chemical and biological contamination of the groundwater, but also in an increase of the aquifer piezometric level. Quantitative impacts were evaluated by examining the groundwater piezometric level at 57 surface wells and piezometers. The survey showed that, during the last two decades, the groundwater level was ever increasing in the urban area with values reaching 7 m in part; and decreasing in Sidi Abid (agricultural area) with values exceeding −3 m. Groundwater samples for chemical and microbial analysis were collected from 41 wells spread throughout the study area. Results showed significantly elevated levels of sodium, chlorides, nitrates and coliform bacteria all over the urban area. High levels (NO₃: 56–254 mg/l; Na >1,500 mg/l; Coliforms >30/100 ml) can be related to more densely populated areas with a higher density of pit latrine and recharge wells. Alternatively results showed a very variable chemical composition of groundwater, e.g. electrical conductivity ranges from 4,040 to19,620 μs/cm and the dry residual varies between 1.4 and 14 g/l with concentrations increasing downstream. Furthermore a softening of groundwater in Set Ezzit (highly populated sector) was observed.     

Regional distribution pattern of groundwater heavy metals resulting from agricultural activities

Contaminations of groundwater by heavy metals due to agricultural activities are growing recently. The objective of this study was to evaluate and map regional patterns of heavy metals (Cd, Zn and Cu) in groundwater on a plain with high agricultural activities. The study was conducted to investigate the concentration of heavy metals and distribution in groundwater in regions of Shush Danial and Andimeshk aquifers in the southern part of Iran. Presently, groundwater is the only appropriate and widely used source of drinking water for rural and urban communities in this region. The region covers an area of 1,100 km² between the Dez and Karkhe rivers, which lead to the Persian Gulf. For this study, the region was divided into four sub-regions A, B, C and D. Additionally, 168 groundwater samples were collected from 42 water wells during the earlier months of 2004. The flame atomic absorption spectrometry (AAS-Flame) was used to measure the concentration of heavy metals in water samples and the Surfer software was used for determination of the contour map of metal distribution. The results demonstrated that in all of the samples, Cd and Zn concentrations were below the EPA MCLG and EPA secondary standard, respectively. However, the Cu contents of 4.8 % of all samples were higher than EPA MCL. It is also indicated that the concentrations of metals were more pronounced at the southern part of the studied region than at the others. The analysis of fertilizers applied for agricultural activities at this region also indicated that a great majority of the above-mentioned heavy metals were discharged into the environment. Absence of confining layers, proximity to land surface, excess agricultural activities in the southern part and groundwater flow direction that is generally from the north to the southern parts in this area make the southern region of the Shush plain especially vulnerable to pollution by heavy metals than by other contaminants.     

Trace elements in groundwater as indicators of anthropogenic impact

The distribution of several minor and trace elements mainly in fresh (dominating TDS 160–400 mg/l) groundwater of Latvia have been investigated by the Inductively Coupled Plasma-Mass Spectrometry (ICP-MS) technique. An evaluation of results of about 700 analyses leads to the conclusion that concentrations of these elements is influenced by: pH–Eh conditions, groundwater residence time and diffuse contamination, whereas the role of water-bearing sediments is of secondary importance. Most trace elements are characterised by low mobility under alkaline and reducing conditions; concentrations in confined aquifers are much smaller than the Maximum Permissible Values for drinking water. The strongest anomalies of REE, Al and P were found in shallow groundwater around the former agrochemical storehouses.     

Effects of natural attenuation processes on groundwater contamination caused by abandoned waste sites in Berlin

The aim of this research project is to identify, characterize and quantify natural attenuation (NA) processes in groundwater affected by emissions of abandoned waste disposal sites in Berlin-Kladow/Gatow, Germany. It is part of the funding priority called KORA established by the Federal Ministry for Education and Research (BMBF) to explore the extent to which NA can be used for remedial purposes for varied forms of soil and groundwater contamination. Information on the emission behaviour of individual parameters is generated on the basis of hydrogeochemical comparison of 20 years old and new data. Using groundwater-modelling and CFC-analysis, information on the transport and retention of pollutants in groundwater is compiled. The microbial colonization of contaminated aquifers is characterized by molecular biological methods [polymerase chain reaction (PCR) and denaturing gradient gel electrophoresis (DGGE)] to differentiate between contaminated and not contaminated zones.     

Groundwater flow modeling for effective implementation of landslide stability enhancement measures

This paper deals with groundwater hydrology at a prominent fracture zone landslide slope (Nuta–Yone landslides) in Japan with an objective to explore an efficient method for the application of landslide stability enhancement measures. The correlation analyses between the hydrological parameters and ground surface movement data at this landslide resulted in low correlation values indicating that the geological formation of the area is extremely complex. For the purpose of understanding the groundwater flow behavior in the landslide area, a three-dimensional transient groundwater flow model was prepared for a part of the landslide slope, where the levels of effectiveness of applied landslide stability enhancement measures (in the form of multilayered deep horizontal drains) are different, and was calibrated against the measured water surface elevations at different piezometer locations. The parameter distributions in the calibrated model and the general directions of the groundwater flow in terms of flow vectors and the results of particle tracking at the model site were interpreted to understand the reasons for variations in effectiveness of existing landslide stability enhancement measures and to find potentially better locations for the implementation of future landslide stability enhancement measures. From the modeling results, it was also understood that groundwater flow model can be effectively used in better planning and locating the landslide stability enhancement measures.     

Modeling of water–rock interactions in an aquitard of sandy clay in the coastal area near Beihai,China

Unconsolidated sand, gravel and clay deposits near Beihai and in the Leizhou Peninsula in southern China form an unconfined aquifer, aquitard and a confined aquifer. Water and soil samples were collected from the two aquifers in the coastal Beihai area for the determination of chemical compositions, minerals and soluble ions. Hydrogeochemical modeling of three flow paths through the aquitard are carried out using PHREEQC to determine water–rock interactions along the flow paths. The results indicate that the dissolution of anorthite, fluorite, halite, rhodochrosite and CO₂, and precipitation of potash feldspar and kaolinite may be occurring when groundwater leaks through the aquitard from the unconfined aquifer to the confined aquifer. Cation exchanges between Na and Ca can also happen along the flow paths.     

河北平原地下水氘过量参数特征

氘过量参数是由Dansg aar d提出的一个新概念,它被定义为:d= δD-8δ18O。河北平原地下水氘过量参数有三个特征: ( 1)地下热水的氢和氧同位素组成显示出热交换的态势,d 值随地下水年龄增大而减少。( 2)在同一地区,d 值随着地下水埋深加大而增大。( 3)在同一含水层内,沿着地下水的路径,从补给区到承压区, d 值随着地下水年龄增大而增大。我们认为, d 值虽然是地下水年龄的函数,但最好和3 H、3H- 3He、14 C、36 Cl和4 He测年结果结合使用。      

Groundwater contaminant source identification based on iterative local update ensemble smoother

Identification of the location and intensity of groundwater pollution source contributes to the effect of pollution remediation, and is called groundwater contaminant source identifcation. This is a kind of typical groundwater inverse problem, and the solution is usually ill-posed. Especially considering the spatial variability of hydraulic conductivity field, the identification process is more challenging. In this paper, the solution framework of groundwater contaminant source identification is composed with groundwater pollutant transport model (MT3DMS) and a data assimilation method (Iterative local update ensemble smoother, ILUES). In addition, Karhunen-Loève expansion technique is adopted as a PCA method to realize dimension reduction. In practical problems, the geostatistical method is usually used to characterize the hydraulic conductivity feld, and only the contaminant source information is inversely calculated in the identifcation process. In this study, the identification of contaminant source information under Kriging K-field is compared with simultaneous identification of source information and K-field. The results indicate that it is necessary to carry out simultaneous identification under heterogeneous site, and ILUES has good performance in solving high-dimensional parameter inversion problems.