Numerical Prediction of Induced Pressure and Lift of the Planing Surfaces

This paper discusses the numerical prediction of the induced pressure and lift of the planing surfaces in a steady motion based on the potential flow solver as well as the spray drag by use of the practical method.The numerical method for computation of the induced pressure and lift is potential-based boundary element method.Special technique is identified to present upwash geometry and to determine the spray drag.Numerical results of a planing flat plate and planing craft model 4666 are presented.It is shown that the method is robust and efficient and the results agree well with the experimental measurements with various Froude humors.     

浅谈地质灾害治理工程项目管理及质量控制

将地质灾害治理工程项目管理及质量控制分为4个阶段：策划(可行性研究)阶段,准备阶段,施工阶段．验收审查阶段,分别阐述其管理及质量控制的重点内容。     

西安地铁隧道穿越饱和软黄土地段的地表沉降监测

以西安地铁一号线朝阳门站—康复路站区段饱和软黄土地铁隧道为研究对象,通过施工期现场地表沉降变形监测,分析了在饱和软黄土特殊地层条件下隧道浅埋暗挖法施工引起的该区段地表沉降变形规律以及地表沉降槽分布特征。结果表明:在饱和软黄土隧道开挖时,随着掌子面的推进,隧道顶地表沉降可分为沉降微小阶段、沉降显著发展阶段、沉降缓慢阶段和沉降稳定阶段;单线隧道开挖后的最大地表沉降量为18.89mm,双线隧道开挖后的最大地表沉降量为36.4mm;已开挖隧道对围岩土体的扰动作用使得后开挖隧道的地表沉降发展较大;双线隧道的地表沉降槽宽度接近单线隧道沉降槽宽度的2倍,因此可以将其近似为单线隧道地表沉降槽宽度与双线隧道轴线中点距离之和;单线隧道开挖后地表沉降槽宽度为8.4～9.3m,双线隧道开挖后地表沉降槽宽度为16.2～17.5m;隧道开挖施工的沉降槽宽度参数为0.435～0.467,单线隧道开挖后的地层损失率为0.765%～1.324%,双线隧道开挖后的地层损失率为1.231%～2.200%。     

海底入射角对多波束反向散射强度的影响及其改正

综合考虑测船姿态、声线弯曲和海底地形对入射角的影响,推导了计算多波束海底入射角的实用模型。根据Lambert法则,改正海底入射角对反向散射强度的影响。实例计算结果表明,所述模型能精确地计算波束在海底的入射角,有效地改正其对反向散射强度的影响。     

基于YOLOv3深度学习的海雾气象条件下海上船只实时检测

海雾气象条件下船只高精度检测识别面临较大困难,传统的目标识别、定位方法效果差强人意。作者围绕海雾气象条件下不同类型船只的实时检测问题,提出一种基于YOLOv3深度学习的实时海上船只检测新思路。首先构建清晰图片和模糊图片(海雾、雨)的判别方法,实现图片清晰度分类处理;其次为提高海雾气象条件下海上船只的实时检测精度,消除海雾遮挡对目标识别的影响,运用暗通道先验去雾方法对含有海雾的图像实行去雾;最后基于YOLOv3深度学习算法对精细处理后的图像进行船只实时检测。实验结果表明该方法能够在海雾气象条件下高效、准确地检测到船只,对海上复杂环境条件下的船只实时检测研究具有一定的理论指导意义。     

海上油气田工程压裂作业船及装备配置技术探讨

用于海上油气田的压裂作业船具备高效性和安全性,具有优越的操控性能和良好的稳定性,配备了先进的船舶航行系统、动力定位系统和强大的动力系统.全船配备的压裂作业设备包括支撑剂存储装置,酸液和胶液存储装置,搅拌混合系统,各类液体和化学药剂添加系统,压裂作业泵系统,中央控制室以及数据采集系统,完备的质量控制体系,安全的作业管线和快速脱离装置.压裂作业船能连续施工作业,效率高,安全可靠.     

Axial compressive bearing capacity of piles in ‎oil-contaminated sandy soil using FCV

ABSTRACT

Oil and its derivatives contaminate many soils and not only affect their chemical and biological properties but also their geotechnical properties. As oil contamination may deteriorate the functioning of piles, this paper addresses the effects of oil contamination on soil–pile interactions. Axial compressive bearing capacities of two close-ended, instrumented piles were investigated in different oil-contaminated sand using frustum confining vessel. Three different oils (gasoil, crude oil, and used motor oil) at different contamination levels were considered and using some strain gauges, the toe, shaft, and the net total bearing capacity of piles, as well as load distributions along the pile length, were derived. The results show that the presence of oil between soil particles has considerable adverse effects on bearing capacities of model piles, especially the shaft bearing capacity. The oil viscosity and percentage, as well as the contaminated sand bed thickness around the piles, are the most influential parameters. The higher the oil viscosity and oil content, the lower the values of the piles’ bearing capacities in comparison to the uncontaminated sand. With some modifications on the bearing capacity parameters of CFEM method, a good agreement was observed between measured and calculated bearing capacity values.     

Numerical simulation of water flooding into a damaged vessel’s compartment by the volume of fluid method

When a vessel is damaged, seawater floods into the damaged compartments and subsequently influences the motion of the vessel. Furthermore, the vessel’s behaviour affects the floodwater motion. In this paper, a Navier-Stokes (NS) solver with a free surface capturing technique, i.e., the volume of fluid (VOF) method, was developed to numerically simulate water flooding into a damaged vessel. To verify the developed solver, a 2-D and a 3-D dam break problems were tested. The numerical results coincide well with the experimental results and with the published numerical results. Additionally, it was used to solve the problems of linear and non-linear liquid sloshing in a hexahedral tank. The numerical results are satisfactory in comparison with the experimental results and analytical solutions. Finally, the phenomenon of water flooding into a damaged compartment of a Ro-Ro ferry was simulated numerically. The computed results are in good agreement with the experimental data.     

不同水分胁迫下几种春小麦种子根形态结构的研究

实验采用快速冷冻切片法及显微摄像系统观察法对甘肃陇中地区6个品种春小麦在不同水分状况下的种子根进行了形态结构研究。结果表明,在不同程度水分胁迫下的同一品种春小麦,种子根后生木质部导管(中央大导管)直径有显著的差异,但这种变化趋势并不是简单的线性关系。随着水分胁迫的增大,不同品种春小麦种子根中央大导管的直径有不同的变化趋势。不同品种春小麦在不同程度的水分胁迫下,随着胁迫的增大,各品种中央大导管直径的变化都逐渐趋于同一区域,这一区域很可能是春小麦在形态结构上适应水分亏缺在导管直径上表现出的最佳直径范围。