适用于极地海底热流调查的低温段泥温传感器低温工作特性分析

本文基于极地海底地热流调查需求,针对在极地严酷的低温环境下泥温测量电路容易出现的失效、温度漂移等问题进行了分析,并采用了恒流源测温方式,有效降低了自发热和引线电阻干扰,并简化电路结构,增强了电路低温状态工作稳定性。本文阐述了低温段泥温传感器工作原理,结合调查实践确定了泥温传感器的主要设计参数;对电路结构进行详细拆解分析,分析各模块在低温条件下存在的失效风险及低温工作性能;对实际电路进行试验验证,利用数据分析传感器的测量精度,并在低温条件下对泥温传感器进行了实测。测试结果表明,低温段泥温传感器在低温条件下工作稳定,数据稳定性和一致性表现良好。     

PGS型中地层地质剖面仪

ＰＧＳ型中地层地质剖面仪系由中国科学院声学研究所东海研究站和交通部水运规划设计院共同研制和开发的新的海洋地质仪器。本文介绍了该仪器一般性能和特点，以及应用地层剖面仪探测各种类型海底的经验。     

中国近海牡蛎超科的新纪录

中国近海牡蛎的研究始于1845年, Hanley(1845)描述了产于中国近海的新种 Ostrea chemnitzi sp.nov.。我国的张玺教投也在30年代开始进行研究,1956年报道了13种牡蛎,在这之前国内、外学者已先后报道了24种和1亚种(张玺等,1956)其中有很多种鉴定错误,或是同物异名。近年来通过海洋底栖生物调查和附着生物的研究,作者又发现了4种牡蛎，它们是:新硬牡蛎 Neopycnodonte cochlear (Poli),侏儒牡蛎 Nanostrea erigua Harry,褶牡蛎 Alectryonella plicatula ( Gmelin) 和日本巨牡蛎 Crassostrea nippona (Seki),在中国近海都是首次记录。     

第三章 地磁条带与海底扩张

(一)海洋地磁测量与处理 地球磁场总强度的测量使用G-801/3型质子旋进磁力仪。测量工作与多道地震、重力测量等同步进行。探头电缆长500m,以降低船磁的影响。由于船磁影响与探头至船距离的三次方成反比,目前的措施可将此影响降至1nT以下,故可忽略不计。 为消除区域场的影响,理应使用国际地磁参考场IGRF1985来进行改正,但为节约时间起见,本次采用多项式来逼近IGRF,两者的差在整个测区内不足1nT,其结果是可信赖     

海军大连舰艇学院获国际海图制图师A级培训授权认证

海军大连舰艇学院通过国际测量师联合会、国际海道测量组织和国际制图协会三大国际权威组织的国际海图制图师A级培训的联合授权认证，这标志着我国海洋测绘专业教学已全面纳入国际标准化培训体系。海道测量师、海图制图师教育培训的国际标准由国际测量师联合会、国际海道测量组织和国际制图协会共同制定。根据联合国海洋法公约的相关规定，     

他是国内海蓬子产业化种植第一人 让中国海水蔬菜步入国际市场第一人——“海疯子”的“海上农场”

出于对海蓬子的痴迷，张春银的夫人封给他“海疯子”这个“昵称”。而在张春银看来，如果没有这种热情和冲动，海水蔬菜产业化则只是纸上谈兵，也正是凭着这份热情，我国江苏东部广袤而荒凉的盐碱地上，一个真正意义上的“海上农场”正渐渐浮出水面。     

海洋综合测量声学系统间信号干扰的分析

针对海洋综合测量多种声学测量系统间的窄带相干声学干扰现象进行了理论分析，并针对克服窄带干扰提出了一些具有实用价值的建议。     

中国鱼类名录ⅩⅢ——鲽形目、纯形目、海蛾鱼目、鮟鱇目

鲽形目3亚目8科51属142种。鲀形目2亚目9科57属143种。海蛾鱼目1科2属3种，鮟鱇目3亚目11科23属41种。     

海底甲烷逸出处碳酸盐结核的形成

在库页岛东北岛坡出现甲烷水合物的地方，发现碳酸盐结核。提出了碳酸盐结核化学形成硫酸盐还原与甲烷生成作用使孔隙水呈现高碱性，是查出产生结核的必要预备阶段。借助甲烷将溶解于孔隙水中的二氧化碳气体排出，是形成结核的必须条件。     

Photoinduced toxicity single and binary mixtures of four polycyclic aromatic hydrocarbons to the marine diatom Skeletonema costatum

Diatom Skeletonema costatum Cleve is one of the main predominant phytoplankton species in the Changjiang Estuary in China. In order to provide some basic information for future assessment of the potential risk on phytoplankton communities in this estuary caused by polycyclic aromatic hydrocarbons(PAHs), this alga was selected as a representative to investigate the photoinduced toxicity of PAHs, in single and mixture. Four PAHs including three-ring phenanthrene and anthracene, four-ring fluoranthene and pyrene were tested in the laboratory. The single toxicity of each PAH on this microalga was compared with and without the simulated solar UV radiation. The results showed that this microalga was sensitive to PAH's photoinduced toxicity. Ratios of the 72 h median effect concentration obtained for fluorescent and UV light tests were about 8.4 for phenanthrene, 13.0 for anthracene, 6.5 for fluoranthene, and 5.7 for pyrene, indicating that UV light enhanced the PAH toxicity to this alga significantly. Under the fluorescent radiation (lacking UV), the dose-response curves based on chemical concentrations revealed that the order of toxic strength was fluoranthene greater than pyrene greater than anthracene greater than phenanthrene; while under the UV radiation (476 μW/cm2 for UVA, 6.5 μW/cm2 for UVB) it became fluoranthene approximately equaling anthracene greater than pyrene greater than phenanthrene, indicating that the UV light also changed its relative toxicity to this alga. The photoinduced toxicity of PAHs to the marine diatom S. costatum might be a synergistic effect of photosensitization reactions (e.g., generation of single-state oxygen) and photomodification (photooxidation and/or photolysis).The combined effects of six binary mixtures on the marine diatom S. costatum were investigated using the additive-index method. Four binary-mixtures (phenanthrene plus anthracene; phenanthrene plus pyrene; anthracene plus fluoranthene; anthracene plus pyrene) were found to be synergistic joint action mode, while two binary-mixtures (phenanthrene plus fluoranthene; fluoranthene plus pyrene) displayed antagonist, revealing a complex pattern of possible interactions. The combined action mode of PAHs might be related to various factors such as the mixture compounds, mixture ratios and test conditions, etc.