Geostatistical features of streambed vertical hydraulic conductivities in Frenchman Creek Watershed in Western Nebraska

This study evaluated the spatial variability of streambed vertical hydraulic conductivity (K_v) in different stream morphologies in the Frenchman Creek Watershed, Western Nebraska, using different variogram models. Streambed K_v values were determined in situ using permeameter tests at 10 sites in Frenchman, Stinking Water and Spring Creeks during the dry season at baseflow conditions. Measurements were taken both in straight and meandering stream channels during a 5 day period at similar flow conditions. Each test site comprised of at least three transects and each transect comprised of at least three K_v measurements. Linear, Gaussian, exponential and spherical variogram models were used with Kriging gridding method for the 10 sites. As a goodness-of-fit statistic for the variogram models, cross-validation results showed differences in the median absolute deviation and the standard deviation of the cross-validation residuals. Results show that using the geometric means of the 10 sites for gridding performs better than using either all the K_v values from the 93 permeameter tests or 10 K_v values from the middle transects and centre permeameters. Incorporating both the spatial variability and the uncertainty involved in the measurement at a reach segment can yield more accurate grid results that can be useful in calibrating K_v at watershed or sub-watershed scales in distributed hydrological models.     

The relationship between hydrodynamic properties and weathering of soils derived from volcanic rocks,Galapagos Islands (Ecuador)

The aim of this interdisciplinary study is to examine a component of the hydrological cycle in Galapagos by characterizing soil properties. Nine soil profiles were sampled on two islands. Their physical and hydrodynamic properties were analyzed, along with their mineralogical composition. Two groups of soils were identified, with major differences between them. The first group consists of soils located in the highlands (>350 m a.s.l.), characterized by low hydraulic conductivity (<10⁻⁵ m s⁻¹) and low porosity (<25%). These soils are thick (several meters) and homogeneous without coarse components. Their clay fraction is considerable and dominated by gibbsite. The second group includes soils located in the low parts of the islands (<300 m a.s.l.). These soils are characterized by high hydraulic conductivity (>10⁻³ m s⁻¹) and high porosity (>35%). The structure of these soils is heterogeneous and includes coarse materials. The physical properties of the soils are in good agreement with the variations of the rainfall according to the elevation, which appears as the main factor controlling the soil development. The clayey alteration products constrain soils physical and hydrodynamic properties by reducing the porosity and consequently the permeability and also by increasing water retention.     

Field Measurement of Suction, Water Content, and Water Permeability

This paper presents a review of techniques for field measurement of suction, water content, and water hydraulic conductivity (permeability). Main problems in the use of field tensiometers are addressed and hints on how to improve tensiometer performance are given. Advantages and limitations of instruments for indirect measurement of suction including electrical conductivity sensors, thermal conductivity sensors, dielectric permittivity sensors, filter paper, and psychrometer are discussed. Techniques for water content measurement based on dielectric methods are then presented. These include time and amplitude domain reflectometry and capacitance. Finally, a brief overview of methods for measurement of water permeability in the field is presented.     

高精度CTD剖面仪电导率传感器的研究和实验

高精度CTD剖面仪是海洋863项目的重要组成部分，是海洋调查和水文观测必不可少的仪器，本文详细论述了CTD剖面仪中电导率传感器的研制方法和过程，并给出传感器现已达到的水平，提出还需要进一步进行的工作和深入研究的问题。     

高精度CTD剖面仪研制过程中的专用设备

本文介绍了“油水分离压力罐”的主要理论依据及该设备采用的特殊的机械结构，实践证明，利用该设备实现了在实验室条件下，模拟深海重力场检测CTD剖面仪中的某些关键传感器的目的。     

Inter sensor comparison between RESOURCESAT LISS III, LISS IV and AWiFS with reference to coastal landuse/landcover studies

Coastal zone assumes importance due to high productivity of ecosystems, man-made developmental activities, natural hazards and dynamic nature of the coast. As costal ecosystems are unique and fragile, understanding the impact of developmental activities on the sustainability of the coastal zone is very important. Remote sensing, because of repetitive and synoptic nature is an ideal tool for studying this. Time series data analyses for monitoring coastal zone require different type of sensors. Present study deals with atmospheric correction of satellite data, reflectance, selection of coastal features like, mudflat, mangroves, vegetated dune, coastal water, etc. and their inter-comparison using different sensor data of RESOURCESAT sensors. Reflectance values give better separateability for various coastal features in comparison to DN values. LISS IV can be used in place of LISS III or merged (LISS III + PAN) for long-term coastal zone studies.     

土壤吸湿-湿过程中水力传导度的拟合研究

非饱和含水介质在吸湿和脱湿的不同过程中,水力传导度随介质含水率的变化规律是不同的。本文选取大沽河流域两种代表性砂土,对其吸湿-脱湿两个过程分别进行试验观测,并使用VanGenuchten—Mualem模型对其吸湿-脱湿过程进行水力传导度的拟合。研究结果表明：砂土在吸湿过程的非饱和水力传导度与脱湿过程的非饱和水力传导度大小并不相同,在含水率相同的情况下,吸湿过程的水力传导度要比脱湿过程大,在含水率较低时（小于15％）相差可达1个数量级。     

Regional conductance map of Andaman and Nicobar region

To image the electrical conductivity distribution, fluxgate magnetometers are operated at five sites in Andaman and Nicobar region. Transfer functions are estimated for the period range 8–128 min, from nighttime transient geomagnetic variations, using robust regression analysis. The observed induction arrows in Andaman Islands are found to point towards east despite deep sea located towards its west. This indicates that fore-arc basin (Andaman–Nicobar deep) is more conducting than the region of outer non-volcanic Island arc.Thin sheet model requires the conductance of 10,000–35,000 S (with increase conductivity towards the south) for explaining the observed induction pattern. The observed induction pattern at Andaman–Nicobar stations can be explained in terms of high conducting Cretaceous–Tertiary sediments filling the Andaman–Nicobar deep. High conductivity over Invisible bank has been attributed to the partial melts/volatile fluids derived from the subducting Indian plate that are intruding into the eastern margin of fore-arc basin through the West Andaman Fault (WAF).The induction pattern at Great Nicobar station (Campbell Bay) may be related to the highly conducting sediments filling the Mergui basin along with mafic intrusions. Also crustal transition occurs below the Mergui Terrace at the Malayan coast contributing to the enhanced conductivity anomaly.     

Estimating hydraulic conductivity using grain-size analyses, aquifer tests, and numerical modeling in a riverside alluvial system in South Korea

Hydraulic conductivity (K) for an alluvial system in a riverbank filtration area in Changwon City, South Korea, has been studied using grain-size distribution, pumping and slug tests, and numerical modeling. The alluvial system is composed of layers: upper fine sand, medium sand, lower fine sand, and a highly conductive sand/gravel layer at the base. The geometric mean of K for the sand/gravel layer (9.89?×?10^?4 m s^?1), as determined by grain-size analyses, was 3.33 times greater than the geometric mean obtained from pumping tests (2.97?×?10^?4 m s^?1). The geometric mean of K estimates obtained from slug tests (3.08?×?10^?6 m s^?1) was one to two orders of magnitude lower than that from pumping tests and grain-size analyses. K estimates derived from a numerical model were compared to those derived from the grain-size methods, slug tests and pumping tests in order to determine the degree of deviation from the numerical model. It is considered that the K estimates determined by the slug tests resemble the uppermost part of the alluvial deposit, whereas the K estimates obtained by grain-size analyses and pumping tests are similar to those from the numerical model for the sand/gravel layer of the riverside alluvial system.     

The relationship between zooplankton,conductivity and lake-water ionic composition in 111 lakes from the Interior Plateau of British Columbia,Canada

Zooplankton collected from vertical net tows were related to the environmental variables from 98 lakes from the Interior Plateau of British Columbia. Canonical correspondence analysis showed that both salinity and ionic composition (pH and Mg) of the lake-water made major and significant contributions to the first two ordination axes (=0.42 and 0.11 respectively,P<0.05). BothArtemia franciscana andMoina hutchinsoni had their highest relative abundance in meso-hypersaline waters. However,Artemia franciscana preferred waters that were higher in Mg and Ca, whileMoina hutchinsoni was found in waters that were lower in Mg and Ca. Similarly, at intermediate salinities,Daphnia pulex and the calanoid copepods preferred waters slightly lower in Mg and Ca, whereasCeriodaphnia laticaudata andSimocephalus spp. were relatively more common in waters higher in Mg and Ca. Because the freshest lakes studied varied much less in ionic composition, the zooplankton in these lakes did not show a preference to ionic composition. As expected, multi-generic groups, such as the calanoid copepods, cyclopoid copepods and nauplii, had wider tolerances to conductivity than groups identified to lower taxonomic levels. Significant weighted-averaging regression and calibration models of conductivity were developed based on zooplankton species composition from the study lakes (r ²=0.56,P<0.05). Samples composed largely of multi-generic taxa yielded the worst estimates of salinity in the reconstruction model. This study suggests that zooplankton community composition may be developed into a useful proxy for paleosalinity reconstruction.